Hyperfine quenching of the 3s3p P-3(0) level in Mg-like ions

Hyperfine quenching rates of the 3s3p P-3(0) level in Mg-like ions were calculated using the GRASP2K package based on the multi-configuration Dirac-Hartree-Fock method. Valence and core-valence correlation effects were accounted for in a systematic way. Breit interactions and QED effects were included in the subsequent relativistic CI calculations. Calculated rates were compared with other theoretical values and with experiment, and a good agreement with the latest experimental value for the Al-27(+) ion (Rosenband et al 2007 Phys. Rev. Lett. 98 220801) was found. Furthermore, we showed in detail the contributions from Breit interaction and QED effects to concerned physical properties. Finally, electronic data were presented in terms of a general scaling law in Z that, given isotopic nuclear spin and magnetic moment, allows hyperfine-induced decay rates to be estimated for any isotope along the isoelectronic sequence.

Isospin dependence of S-1(0) proton and neutron superfluidity in asymmetric nuclear matter

We investigate the S-1(0) neutron and proton superfluidity in isospin-asymmetric nuclear matter. We have concentrated on the isospin dependence of the pairing gaps and the effect of a microscopic three-body force. It is found that as the isospin asymmetry goes higher, the neutron S-1(0) superfluid phase shrinks gradually to a smaller density domain, whereas the proton one extends rapidly to a much wider density domain. The three-body force turns out to weaken the neutron S-1(0) superfluidity slightly, but it suppresses strongly the proton S-1(0) superfluidity at high densities in nuclear matter with large isospin asymmetry.

Inclusive pi(0), eta, and direct photon production at high transverse momentum in p plus p and d plus Au collisions at root s(NN)=200 GeV

We report a measurement of high-p(T) inclusive pi(0), eta, and direct photon production in p + p and d + Au collisions at root s(NN) = 200 GeV at midrapidity (0 < eta < 1). Photons from the decay pi(0) -> gamma gamma were detected in the barrel electromagnetic calorimeter of the STAR experiment at the Relativistic Heavy Ion Collider. The eta -> gamma gamma decay was also observed and constituted the first eta measurement by STAR. The first direct photon cross-section measurement by STAR is also presented; the signal was extracted statistically by subtracting the pi(0), eta, and omega(782) decay background from the inclusive photon distribution observed in the calorimeter. The analysis is described in detail, and the results are found to be in good agreement with earlier measurements and with next-to-leading-order perturbative QCD calculations.

Medium-spin states in Ge-70 and the role of the g(9/2) orbital

Medium-spin states of Ge-70 have been studied via the Ni-60(C-12,2p gamma)Ge-70 reaction at 45 MeV. The ground-state band and the second 0(+) band have been extended to the 12(+) and 8(+) states, respectively. Two negative-parity bands, one of which has a coupled structure and the other has a decoupled structure, have been observed additionally. Although the latter decoupled structure was known up to the (21(-)) state from a previous experiment, the part of the level scheme up to the 15(-) state has been largely modified by the present experiment. Backbendings observed in the positive- and negative-parity yrast bands have been compared with those of the neighboring even Ge isotopes. The experimental level structure has been compared with the shell-model calculations in the model space (2p(3/2), 1f(5/2), 2(p1/2), 1g(9/2)) employing two kinds of effective interactions, one of which is an extended P + QQ interaction with monopole interactions and the other is developed from a renormalized G matrix. Microscopic structures of the observed bands have been discussed with the help of the shell-model calculations.

Electrochemical hydrogen storage in (Ti1-xVx)(2)Ni (x=0.05-0.3) alloys comprising icosahedral quasicrystalline phase

For (Ti1-xVx)(2)Ni (x = 0.05,0.1,0.15,0.2 and 0.3) ribbons, synthesized by arc-melting and subsequent melt-spinning techniques, an icosahedral quasicrystalline phase was present, either in the amorphous matrix or together with the stable Ti2Ni-type phase. With increasing x values, the maximum discharge capacity of the alloy electrodes increased until reached 271.3 mAh/g when x = 0.3. The cycling capacity retention rates for these electrodes were approximately 80% after a preliminary test of 30 consecutive cycles of charging and discharging.

Structure and electrochemical characteristics of TiV1.1Mn0.9Nix (x=0.1-0.7) alloys

The structure and electrochemical properties of TiV1.1Mn0.9Nix (x = 0.1-0.7) solid solution electrode alloys have been investigated. It is found that these alloys mainly consist of a solid solution phase with body centered cubic (bcc) structure and a C14 Laves secondary phase. The solid solution alloys show easy activation behavior, high temperature dischargeability, high discharge capacity and favorable high-rate dischargeability as a negative electrode material in Ni-MH battery. The maximum discharge capacity is 502 mAh g(-1) at 303 K when x = 0.4. Electrochemical impedance spectroscopy (EIS) test shows that the charge-transfer resistance at the surface of the alloy electrodes decreases obviously with increasing Ni content.

PP-g-AA接枝共聚物的制备及表征

以部分预辐照聚丙烯(rPP)作为聚丙烯反应挤出接枝丙烯酸(AA)的引发剂,制备了PP-g-AA接枝共聚物。考察了预辐照剂量、预辐照聚丙烯用量以及单体浓度等因素对接枝反应的影响。采用红外光谱、差热扫描量热仪和偏光显微镜等测试技术对接枝产物的形态、结构及性能进行了研究。结果表明,这种新的PP-g-AA共聚物制备方法能有效抑制聚丙烯的降解并获得较高力学性能的接枝产物。研究发现,当rPP的预辐照剂量为4 kGy,反应原料的组成为m(PP)∶m(rPP)∶m(AA)=90∶10∶0.8时,得到的产物有较高的接枝率(0.19%),并且具有相对最佳的力学性能;这种接枝产物与铝板有很强的粘接效果,其剥离强度达4.88 kN/m。

CPE-g-HEA/TDI热塑性弹性体的制备和性能研究

采用氯化原位接枝法合成主链为氯化聚乙烯(CPE)、支链为丙烯酸-2-羟基乙酯（HEA）的官能化接枝聚合 物(CPE-g-HEA),制备CPE-g-HEA/2,4-二异氰酸甲苯酯（TDI）热塑性弹性体,并对其性能进行研究。结果表明, CPE-g-HEA/TDI热塑性弹性体的物理性能较好;与溶液法产物相比,共混法CPE-g-HEA/TDI热塑性弹性体的强度 较大、相对分子质量较小、相对分子质量分布较宽,热行为基本无变化;共混法CPE-g-HEA/TDI热塑性弹性体的反 应温度应控制在60～70℃,共混次数(即打三角包次数) 为150次时拉伸强度较高、80次时拉断伸长率较高,HEA/TDI摩尔比为1/0.5时拉伸强度较高。

Properties of complex of Tb(III) and poly(N-isopropylacrylamide)-g-poly(N-isopropylacrylamide-co-styrene) core-shell nanoparticles

We successfully prepared a new kind of thermoresponsive and fluorescent complex of Tb(III) and PNIPAM-g-P(NIPAM-co-St) (PNNS) core-shell nanoparticle. It was found that Tb(III) mainly bonded to 0 of the carbonyl groups of PNNS, forming the novel (PNIPAM-g-P(NIPAM-co-St))-Tb(III) (PNNS-Tb(III)) complex. The maximum emission intensity of the complex at 545 nm is enhanced about 223 times comparing to that of the pure Tb(III). The intramolecular energy transfer efficiency from PNNS to Tb(III) reaches 50%. When the weight ratio of Tb(III) and the PNNS-Tb(III) complex is 1.2 wt.%, the enhancement of the emission fluorescence intensity at 545 nm is highest.

Effect of La/Ce ratio on the structure and electrochemical characteristics of La0.7-xCexMg0.3Ni2.8Co0.5 (x=0. 1-0.5) hydrogen storage alloys

The effect of La/Ce ratio on the structure and electrochemical characteristics of the La0.7-xCexMg0.3Ni2.8Co0.5 (x = 0.1, 0.2, 0.3, 0.4, 0.5) alloys has been studied systematically. The result of the Rietveld analyses shows that, except for small amount of impurity phases including LaNi and LaNi2, all these alloys mainly consist of two phases: the La(La, Mg)(2)Ni-9 phase with the rhombohedral PuNi3-type structure and the LaNi5 phase with the hexagonal CaCU5-type structure. The abundance of the La(La, Mg)(2)Ni-9 phase decreases with increasing cerium content whereas the LaNi5 phase increases with increasing Ce content, moreover, both the a and cell volumes of the two phases decrease with the increase of Ce content. The maximum discharge capacity decreases from 367.5 mAh g(-1) (x = 0.1) to 68.3 mAh g(-1) (x = 0.5) but the cycling life gradually improve. As the discharge current density is 1200 mA g(-1), the HRD increases from 55.4% (x = 0.1) to 67.5% (x = 0.3) and then decreases to 52.1% (x = 0.5). The cell volume reduction with increasing x is detrimental to hydrogen diffusion D and accordingly decreases the low temperature dischargeability of the La0.7-xCexMg0.3Ni2.8Co0.5 (x = 0.1-0.5) alloy electrodes.

Crystallographic and electrochemical characteristics of icosahedral quasicrysyalline Ti45-xZr35-xNi17+2xCu3 (x=0-8) powders

Ti45--xZr35--xNi17+2rCU3 (x=0, 2, 4, 6 and 8) icosahedral quasicrystalline phase (I-phase) alloy powders are synthesized by mechanical alloying and subsequent annealing techniques, and the crystallographic and electrochemical characteristics are investigated. The alloy powders are I-phase, and the quasi-lattice constant decreases with increasing x value. The maximum discharge capacity of the I-phase alloy electrodes first increases and then decreases with increasing x value, and the Ti39Zr26Ni29Cu3 I-phase electrode exhibits the highest discharge capacity of 274 mAh g(--1). The high-rate dischargeability at the discharge current density of 240mA g(--1) increases from 55.31 % (x= 0) to 74.24% (x= 8). Cycling stability also increases with increasing x value. The improvement in electrochemical characteristics may be ascribed to the added nickel, which not only improves the electrochemical activity, but also makes the alloy more resistant to oxidation.

Crystallographic and electrochemical characteristics of La0.7Mg0.3Ni3.5-x (Al0.5Mo0.5)(x) (x=0-0.8) hydrogen storage alloys

The crystal structure, hydrogen storage property and electrochemical characteristics of the La0.7Mg0.3Ni3.5-x(Al0.5Mo0.5), (x=0-0.8) alloys have been investigated systematically. It can be found that with X-ray powder diffraction and Rietveld analysis the alloys are of multiphase alloy and consisted of impurity LaNi phase and two main crystallographic phases, namely the La(La, Mg)(2)Ni-9 phase and the LaNi5 phase, and the lattice parameter and the cell volume of both the La(La, Mg)(2)Ni-9 phase and the LaNi5 phase increases with increasing A] and Mo content in the alloys. The P-C isotherms curves indicate that the hydrogen storage capacity of the alloy first increases and then decreases with increasing x, and the equilibrium pressure decreases with increasing x. The electrochemical measurements show that the maximum discharge capacity first increases from 354.2 (v = 0) to 397.6 mAh g(-1) (x = 0.6) and then decreases to 370.4 mAh g(-1) (x= 0.8). The high-rate dischargeability of the alloy electrode increases lineally from 55.7% (x=0) to 73.8% (x=0.8) at the discharge current density of 1200 mA g(-1). Moreover, the exchange current density of the alloy electrodes also increases monotonously with increasing x.