Applications of microelectrodes in capillary electrophoresis electrochemical detection

The applications of the microelectrodes for capillary electrophoresis/electrochemical detection are reviewed. The attractive advantages of the microelectrode provide a wide scope for the developments in capillary electrophoresis with electrochemical detection.

Geochemistry of the lava and its implications in Musicians Seamounts

Chemical and isotopic data of the lava samples dredged in the southern Bach Ridge and the northern Italian Ridge of the Musicians Seamounts province, northeast of Hawaii. Although most of the samples analyzed are generally altered, a few are fresh. The latter exhibits similar geochemical and isotopic characteristics to normal MORB (Mid-Ocean Ridge Basalts). There are systematic geochemical trends from hotspot to mid-ocean ridge in the province. Incompatible element and isotopic variations suggest that the flow field had at least two distinct parental magmas, one with higher and one with lower MgO concentrations. The two parental magmas could be related by a magma mixing model. The major and trace element modeling shows that the two parental magmas could not have been produced by different degrees of melting of a homogeneous mantle source, but they are consistent with melting of a generally depleted mantle containing variable volumes of embedded enriched heterogeneity enriched interbeds.

油田高含水期剩余油分布规律研究

After systemic investigation of the techniques，route lines and mechanisms about the remaining oil，the dynamic migration and congregation behavior of the remaining oil are discussed on base of interaction between flowing and enriching of water and oil.After the micro-scope modeling of the fluid flow in porous media and the changes in petrol-physical properties of the flowing system, the characters of fluid fields and the dynamic distribution of oil are discussed, among which the preference-flowing is focused on. Based on the preference-flowing in porous media, the concept of the preference-flowing channels is developed. According to above, heterogeneous distribution of water and oil in the field and dynamic mechanism of remaining oil are all obvious. media can be divided into three kinds, directional, stochastic, arbitrary porous media. The main research results are as following: 1. Treating the characteristic parameters such as permeability, porosity and wettability as regional parameter, the fluid field with high water-cut has been established by geostatistical method, among which the difference of flowing pores and the changes of its petrol-physical properties during flooding are studied. 2. The flow process of water and oil are recurrent in physical simulation experiments, in which the mechanisms and phenomena are caught and analyzed. Fluid flow mechanics in porous media with preference-flowing channels have been studied. 3. The mutual coupling between water and oil is induced and the mathematical evolution equations including this interaction were built. . 4. Through coupling effect between flowing water and oil, the dynamic migration and congregation behavior of remaining oil depend upon this coupling. 5. Coupling between water and oil act as driving force and trapping force for the remaining oil. The coupling model of thesis has been verified by simplified the numerical model and compared results with Ng35 oil reservoir in Gudao oil field, it has important theoretical and application values for improving precision of remaining oil and production performance prediction, and is a new method for studying the mechanics of remaining oil in channeled porous media has been established. Key words：flow field，high water-cut，coupling，dominant flow in porous media，remaining oil

胜坨油田注聚后油藏动态模型及剩余油分布

The topic of Dynamic reservoir model and the distribution of remaining oil after polymer injection of Shengtuo oilfield is a front problem of "the 11th Five-Year Plan" scientific and technological disciplines of Sinopec Corporation. Reservoirs in study area is distributary channel sandstone. After 34 years of water-injection exploitation and 7 years of polymer injection pilot experiments, a highly complex heterogeneous dynamic evolution has been occurred in macro and micro parameters of reservoir model, together with its flow field. Therefore, it’s essential to construct completed reservoir dynamic model for a successfully prediction of the distribution of remaining oil. With a comprehensive application of multidisciplinary theory and technique, using a variety of data and information to maximize the use of computer technology, combining a static and dynamic, macro and micro and 1~4D integration, the research reveals main features, evolution and mechanism, types of geological disasters and their destructivity of reservoir flow field, the macro field, the micro field, the flow field and reservoir development hydrodynamic geological function in different development periods after a long term of polymer injection in Es2 in Shengtuo oilfield. The principle innovation achievements obtained are: 1. Established A, B, C, D four flow units in target formations, revealed the various features and distribution of flow units. 2. Stated environmental pollution and geological disasters induced during oilfield exploitation in study area, and also explained their formation mechanism, controlling factors, destructivity and approaches to disaster reduction. 3. Established dynamic evolution of the macro parameter model, micro-matrix field, pore network field, clay minerals field, seepage dynamic evolution model of six different exploitation stages in study area, also revealed reservoir flow evolution, the law of evolution mechanism after polymer injection. 4. Established macro and micro distribution model of remaining oil after three mining polymer injection during different water cut periods in study area, revealed the formation mechanism and distribution of remaining oil. 5. Established remaining oilforecasting model in study area, and forecasted the formation and distribution of remaining oil in the following six years. 6. It is proposed that reservoir fluid dynamic geological processes are major driving forces for the evolution of different water cut periods, reservoir macro field after the polymer injection and micro seepage field. 7. Established a dynamic reservoir model, proposed matching theory, methods and technology for the description of the remaining oil characterization and prediction, which can deepen the theory and techniques of continental rift basin development geology. Key words: Polymer reservoir; Geological disasters; Dynamic model; Residual oil forecast

基于流域—库区—坝区模型“三重边界嵌套”方法的河南济源蟒河口水库渗漏数值模拟研究

Constructing reservoir in mountain area, in order to avoid dangerous reservoir and ensure long-term stable reservoir storage, study on reservoir leakage has been one of research hotspots. How to accurately predict the capacity of leakage and the effect of anti-seepage after reservoir impoundment under different anti-seepage measures is one of the most difficult problems of study on reservoir leakage. The paper took Manghekou Reservoir as a case study, which is located in Jiyuan City, Henan Province, China. Based on the system analysis of the geological and hydrogeological characters in the research area, the hydrogeological conceptual model was established. Then, according to the triplex boundary nested grid model method, using three-dimensional numerical simulation technique, the 3-D groundwater seepage flow numerical model was established in the study area. Based on the model, the change of seepage flow field, the capacity of leakage and the effect of anti-seepage are predicted after Manghekou reservoir impoundment under different condition. The reasonable and reliable anti-seepage measure is selected according to the model. All these provides scientific basis for the design and assessment of anti-seepage measure for the reservoir in mountain area.

胜坨油田沙二段油藏流场剩余油形成机理和分布模式

By applying multi-discipline theory and methods comprehensively and with full use of computer, the paper deeps into studying changing rule and control factor of fluid field of ES2 Shengtuo oil field during waterflood development, physical and chemical function, and stress. Matrix field, network field, fluid field, stress field and physical chemistry field and fluid model for dynamic function were established. Macroscopic and microscopic genesis mechanics, distribution rule and control factor of remaining oil were revealed. Remaining oil and emulate model were established. Macroscopic and microscopic distribution rule of mover remaining oil were predicted, several results were achieved as following: The distribution of remaining oil was controlled by micro-structure. At the same development stage, remaining oil saturation of the wells located in higher position of micro-structure is higher than the average saturation in the same layer. The water content ratio has same law. It is the enrichment district that the high position of micro-structure controlled by seal faults. The remaining oil distribution was affected by sedimentary micro-facies, micro-structure, fault sealing, reservoir heterogeneity and affusion-oil extraction. On the plane, the zone owning higher saturation of remaining oil is the area that at the edge miacro-facies and sand-body distribution discontinuously; on the section, the content of waterflood of the upper or middle-upper oil layer of positive rhythm and positive comprehensive rhythm is lower, middle and weak waterflood is main, remaining oil is in enrichment relatively. The remaining oil is relative enrichment at the zones of well network of affusion and oil extraction not affected. 4D dynamic model of reservoir of Es2in Shengtuo oil field was established. Macroscopic and microscopic forming mechanics, distribution rule and control factor were revealed. The emulate model of dynamic function of Shengtuo oil field was established, the space distribution of remaining oil were predicted. Reservoir flow field, matrix field, network field, seep field, physical and chemical field, stress field and fluid field models were established. Reservoir flow field character and distribution were revealed. An improvement of the development geology theory in continental fault depression continental basin was brought on.

Effect of non-uniform magnetic field on crystal growth by floating-zone method in microgravity

The magnetic damping effect of the non-uniform magnetic field on the floating-zone crystal growth process in microgravity is studied by numerical simulation. The results show that the non-uniform magnetic field with designed configuration can effectively reduce the flow near the free surface and then in the melt zone. At the same time, the designed magnetic field can improve the impurity concentration non-uniformity along the solidification interface. The primary principles of the magnetic field configuration design are also discussed.

Computation of Viscous Incompressible Flow using Pressure Correction Method on Unstructured Chimera Grid

In this paper, a pressure correction algorithm for computing incompressible flows is modified and implemented on unstructured Chimera grid. Schwarz method is used to couple the solutions of different sub-domains. A new interpolation to ensure consistency between primary variables and auxiliary variables is proposed. Other important issues such as global mass conservation and order of accuracy in the interpolations are also discussed. Two numerical simulations are successfully performed. They include one steady case, the lid-driven cavity and one unsteady case, the flow around a circular cylinder. The results demonstrate a very good performance of the proposed scheme on unstructured Chimera grids. It prevents the decoupling of pressure field in the overlapping region and requires only little modification to the existing unstructured Navier–Stokes (NS) solver. The numerical experiments show the reliability and potential of this method in applying to practical problems.

Anisotropic thermopiezoelectric solids with an elliptic inclusion or a hole under uniform heat flow

The two-dimensional problem of a thermopiezoelectric material containing an elliptic inclusion or a hole subjected to a remote uniform heat flow is studied. Based on the extended Lekhnitskii formulation for thermopiezoelectricity, conformal mapping and Laurent series expansion, the explicit and closed-form solutions are obtained both inside and outside the inclusion (or hole). For a hole problem, the exact electric boundary conditions on the hole surface are used. The results show that the electroelastic fields inside the inclusion or the electric field inside the hole are linear functions of the coordinates. When the elliptic hole degenerates into a slit crack, the electroelastic fields and the intensity factors are obtained. The effect of the heat how direction and the dielectric constant of air inside the crack on the thermal electroelastic fields are discussed. Comparison is made with two special cases of which the closed solutions exist and it is shown that our results are valid.

Numerical simulation of magnetic field design for damping thermocapillary convection in a floating half-zone

The magnetic fields produced by electrical coils are designed for damping the the thermocapillary convection in a floating half-zone in microgravity. The fields are designed specially to reduce the flow near the free surface and then in the melt zone by adjusting the longitudinal coil positions close to the melt zone. The effects of the designed magnetic fields on reducing the flow velocity and temperature distribution non-uniformity in the melt zone are stronger than those of the case of an uniform longitudinal magnetic field obtained by numerical simulation, particularly at the melt-rod interface. It brings fundamental insights into the heat and mass transfer control at the solidification interface by the magnetic field design for crystal growth by the floating full-zone method.

Numerical Solutions for the Transient Flow in the Homogenous Closed Circle Reservoirs

There are many fault block fields in China. A fault block field consists of fault pools. The small fault pools can be viewed as the closed circle reservoirs in some case. In order to know the pressure change of the developed formation and provide the formation data for developing the fault block fields reasonably, the transient flow should be researched. In this paper, we use the automatic mesh generation technology and the finite element method to solve the transient flow problem for the well located in the closed circle reservoir, especially for the well located in an arbitrary position in the closed circle reservoir. The pressure diffusion process is visualized and the well-location factor concept is first proposed in this paper. The typical curves of pressure vs time for the well with different well-location factors are presented. By comparing numerical results with the analytical solutions of the well located in the center of the closed circle reservoir, the numerical method is verified.

A Numerical Study for Turbulent Flow and Thermal Influence Over Inhomogenous Canopy of Roughness Elements

A large-eddy simulation with transitional structure function(TSF) subgrid model we previously proposed was performed to investigate the turbulent flow with thermal influence over an inhomogeneous canopy, which was represented as alternative large and small roughness elements. The aerodynamic and thermodynamic effects of the presence of a layer of large roughness elements were modelled by adding a drag term to the three-dimensional Navier-Stokes equations and a heat source/sink term to the scalar equation, respectively. The layer of small roughness elements was simply treated using the method as described in paper (Moeng 1984, J. Atmos Sci. 41, 2052-2062) for homogeneous rough surface. The horizontally averaged statistics such as mean vertical profiles of wind velocity, air temperature, et al., are in reasonable agreement with Gao et al.(1989, Boundary layer meteorol. 47, 349-377) field observation (homogeneous canopy). Not surprisingly, the calculated instantaneous velocity and temperature fields show that the roughness elements considerably changed the turbulent structure within the canopy. The adjustment of the mean vertical profiles of velocity and temperature was studied, which was found qualitatively comparable with Belcher et al. (2003, J Fluid Mech. 488, 369-398)'s theoretical results. The urban heat island(UHI) was investigated imposing heat source in the region of large roughness elements. An elevated inversion layer, a phenomenon often observed in the urban area (Sang et al., J Wind Eng. Ind. Aesodyn. 87, 243-258)'s was successfully simulated above the canopy. The cool island(CI) was also investigated imposing heat sink to simply model the evaporation of plant canopy. An inversion layer was found very stable and robust within the canopy.