66 resultados para DRIVING-FORCE
Resumo:
Because of the high resolution, stalagmite laminae can play an important role in the paleoclimate reconstructions. However, few investigations for the formation mechanisms of stalagmite lamilae have been done. Based on two-year observation on calcite growth rate at the drip sites, three-year monitoring of hydrodynamics, physics and chemistry of drip waters at different drip sites and the surrounding environments inside and outside the Beijing Shihua Cave, the seasonal variations of calcite growth rate are revealed and the results can be concluded as follows: 1. The drip waters inside the Cave are mostly sourced from the summer rain, and its minimal response-time to the atmospheric precipitation is less than one day. There are three types of response relationships between the precipitation and the drip rate variations: rapid response type, time-lag response type and stable response type. For rapid response type, the drip discharge is recharged through the flow routes along intensive fractures and interconnectivities; for time-lag response type, the drip discharge is recharged by double-porosity system composed of a high conductivity, low storage capability conduit network and a low-conductivity high-storage capability rock matrix under variable boundary conditions; for stable response type, the drip discharge is mainly recharged by seepage flow and base flow. 2. The observation shows that, inside the Cave, the growth rate of calcite is generally lower in rainy seasons and higher in dry seasons. During the rainy seasons, the drip water is characterized by a lower pH value, higher [Ca2+], [Mg2+], [SO42-] and electrical conductivity (EC) values. According to the calculations of saturation index of calcite (SIc), pCO2 of the drip water, as well as the synthetical analysis of other possible factors, the calcite growth rate is found to be principally influenced by the drip water saturation index of calcite (SIc). And the drip rate and pCO2 in the drip water and in the cave air play the secondly important roles in this process. The recharge mode of heavy rainfall events in the rainy seasons should probably be the main driving force that controls the physicochemical properties and calcite sediment of the drip waters. The abrupt decrease of sedimentary rate and the sharp peak of DOC in drip water in the rainy season probably forms the thin opaque (luminescent under ultraviolet radiation) layers observed in the stalagmites, whereas the relatively higher sedimentary rate in the dry seasons may be responsible for the thicker bright layers. The investigation elucidated here preliminarily reveals the formation mechanism of the stalagmite laminae in Beijing Shihua Cave.
Resumo:
The petroleum migration, happening in the geologic past, is the very important and complex dynamic processes in the petroleum systems. It plays a linking role among all static factors in a system. The accumulation is in fact the result of the petroleum migration. For the petroleum geology, the dynamics research of the petroleum migration refers to the mechanism and process research, as well as the use of the quantitative methods. In this thesis, combining with the qualitative analysis and quantitative modeling, the author manages to discuss theoretically some key problems dealing with migration processes, which have not been solved yet, and to apply the studied results in petroleum system analysis in actual basins. The basin analysis offers the base of the numerical modeling for geological phenomena occurring in sedimentary basins, that consists of the sedimentary facies analysis, the section reconstructing technique, eroded thickness estimating, etc. The methods to construct the geologic model, which is needed in the research of oil and gas migration and accumulation, are discussed. The basin analysis offers also the possibility for the latter modeling works to get and select the parameters, such as stratum's thickness, age, stratigraphy etc. Modeling works were done by using two basin modeling softwares: Basin_Mod and TPC_Mod. The role of compaction during the secondary migration and the heterogeneity of migrating paths within the clastic carrier are modeled. And the conclusions were applied in the migration studies in the Jungaer Basin, lying on the Northwest part of the China. To construct a reliable migration model, the author studied the characteristics of the sedimentation, the pore fluid pressure evolution, as well as the distribution and the evolution of fluid potential, following the tectonic evolution of the Jungaer Basin. The geochemical prospecting results were used to evidence and to calibrate the migration processes: the oil-source correlation, the distribution of the properties of oil, gas and water. Finally, two important petroleum systems, Permian one and Jurassic one were studied and identified, according, principally, to the studies on the petroleum migration within the Jungaer Basin. Since the oil, as well as the gas, moves mainly in separate phase during the secondary migration, their migrating behaviors would be determined by the dynamics conditions of migration, including the driving forces and pathways. Based on such a consideration, the further understandings may be acquired: the roles played by permeable carriers and low-permeable source rock would be very different in compaction, overpressure generation, petroleum migration, and so on. With the numerical method, the effect of the compaction on the secondary migration was analyzed and the results show that the pressure gradient and the flux resulted from compaction are so small that could be neglected by comparing to the buoyancy of oil. The main secondary migration driving forces are therefore buoyancy and capillary within a hydrostatic system. Modeling with the commercial software-Basin_Mod, the migration pathways of petroleum in clastic carriers seem to be inhomogeneous, controlled by heterogeneity of the driving force, which in turn resulted from the topography of seals, the fabrics and the capillary pressure of the clastic carriers. Furthermore, the direct and indirect methods to study fault-sealing properties in the course of migration were systemically summarized. They may be characterized directly by lithological juxtaposition, clay smear and diagenesis, and indirectly the comparing the pressures and fluid properties in the walls at two apartments of a fault. In Jungaer Basin, the abnormal pressures are found in the formations beneath Badaowan or Baijantan Formation. The occurrence of the overpressure seems controlled by the stratigraphy. The rapid sedimentation, tectonic pressuring, clay sealing, chemical diagensis were considered as the principal pressuring mechanisms. The evolution of fluid pressure is influenced differently at different parts of the basin by the tectonic stresses. So the basin appears different pressure evolution cycles from each part to another during the geological history. By coupling the results of thermal evolution, pressure evolution and organic matter maturation, the area and the period of primary migration were acquired and used to determine the secondary migration time and range. The primary migration in Fengcheng Formation happened from latter Triassic to early Jurassic in the main depressions. The main period of lower-Wuerhe Formation was at latter Jurassic in Changji, Shawan and Pen-1-jing-xi Depression, and at the end of early Cretaceous in Mahu Depression. The primary migration in Badaowan and Sangonghe Formation is at the end of early-Cretaceous in Changji Depression. After then, the fluid potential of oil is calculated at the key time determined from area and time of the primary migration. Generally, fluid potential of oil is high in the depressions and low at the uplifts. Synthetically, it is recognized that the petroleum migration in the Jungaer Basin is very complex, that leads us to classify the evolution of petroleum systems in Northwestern China as a primary stage and a reformed one. The remigration of accumulated petroleum, caused by the reformation of the basin, results in the generation of multiple petroleum systems. The faults and unconformities are usually the linkers among the original petroleum systems. The Permian petroleum system in Jungaer Basin is such a multiple petroleum system. However, the Jurassic petroleum system stays still in its primary stage, thought the strong influences of the new tectonic activities.
Resumo:
Facing the problems met in studies on predominant hydrocarbon migration pathways, experiments and numerical simulating were done in this thesis work to discuss the migration mechanisms. The aim is to analyze quantitatively the pathway pattern in basin scale and to estimate the hydrocarbon loss on the pathway that offer useful information for confirming the potential hydrocarbon accumulation. Based on our understandings on hydrocarbon migration and the fluid dynamic theory, a series of migration experiments were designed to observe the phenomena where kerosene is used as draining phase driven only by buoyancy force that expulses pore water. These experiments allow to study the formation of migration pathways, the distribution of non-wetting oil along these pathways, and the re-utilizing of previously existing pathways marked by residual traces etc. The types of pattern for migration pathways may be characterized by a phase diagram using two dimensionless numbers: the capillary number and the Bond number. The NMR technique is used to measure the average saturation of residual oil within the pathways. Based our experiment works and percolation concept, a numerical simulation model were proposed and realized. This model is therefore called as BP (Buoyancy Percolation) simulator, since buoyancy is taken as the main driving force in hydrocarbon migration. To make sure that BP model is applicable to simulate the process of oil secondary migration, the experimental phenomena are compared with those simulated with BP model by fractal method, and the result is positive. After then, we use BP simulator to simulate the process of migration of oil in the porous media saturated with water at different scale. And the results seem similar to those cited in literatures. In addition, our software is applied in Paris basin to predict the pathway of hydrocarbon migration happened in the Middle Jurassic reservoirs. It is found that the results obtained with our BP model are generally agree with Hindle (1997) and Bekeles'(1999), but our simulated migration pathway pattern and migration direction seem more reasonable than theirs.
Resumo:
The historical land use and land cover changes is one of the key issues in LUCC research. However, the achievement of China in this field doesn't match her position in the world yet. And the reliability of the quantitive records in Chinese historical literature, the basic data for historical land use research, has been doubted. This research focuses on Re-Cha-Sui, a typical area for the farming-pastoral region in the north of China, to make a detailed case study in this field. Based on a deep mining and calibration on the data from massive historical documents and land-use surveys, the author gives a detailed analysis on the administrative region evolution, historical population dynamics, reclamation policy, and the land statistic system. According to textual researches, parallel validation and physical geographical analysis, a unified land use series for recent 300 years, which founded on the results of modern land-use surveys, is constructed. And the thematic maps on the cultivation index for different counties in several temporal sections are plotted. Based on the endeavor above, the dynamic of forest and steppe is reconstructed as well. The temporal-spatial patterns of land use/land cover changes in the area is analyzed. And the influence of different driving forces are discussed. The main conclusions of the research are as followed: 1. The quantitive records in literatures on Re-Cha-Sui area are reflection of real amounts of croplands. It is practical to reconstruct a result comparable with the modern land-use surveys, based of a deep mining and considerate validation on historical documents. The unexceptional negative attitude towards the numerical records in historical documents is unnecessary. 2. In recent 300 years, 3 climax of reclamation appeared in Re-Cha-Sui area and altered the pure pastoral area into a farming-pastoral region. The interval were respectively the early time till mid time of the Qing dynasty, the end of the Qing dynasty till early time of the Republic of China(ROC), and the time after A.D. 1949. After the first expansion, the area of cropland in this region reached 2.0 million ha. Among them, Guisui area, which was most densely cultivated, had a cultivation index over 30%, which is similar with modern situation. The second expansion covered broader area, and the amount of cropland reached 3.5 million ha. The increase of farming area after 1949 is due to the recultivation of abandoned farmland. The current area of cropland in this region is 5.6 million ha. In the southern area where the land was reclaimed early, the amount on of the cropland has some fluctuation in 300 years. While in the new reclaimed area in the north, the area of cropland has kept the trend of increasing. 3. Due to the different natural conditions, most forests in Re-Cha-Sui area distribute in the mountain area of North Hebei province, and the upland of West Liaoning province, especially the former, which has a forest coverage near 70%. However, most of these forests were destroyed before the end of the Qing dynasty. In 1949, the natural forest near Chengde was nearly cleared up. They were partly renewed after 1949 due to plantation. 4. In the steppe zone such as northern Rehe, Suiyuan and Chahar, the area of steppe has a negative correlation with that of cropland. With the expansion of cropland, the percentage of steppe has shrunk from over 80% to 53%. In the mountain area of North Hebei province, steppe expanded with the shrinkage of forest, though cropland was expanding. The percentage once reached 60%, and then fell with the renew of forest. However, in the upland of West Liaoning province, the steppe shrink slowly from original 50% to current 26%, with the expansion of cropland. 5. The land use and land cover change in Re-Cha-Sui area in recent 300 years is driven by various factors, including human dimensions such as population, policy of the government, disorder of the society, cultural tradition, and natural factors such as climate change and natural disasters. Among them, pressure from surplus population is the basic driving force.
Resumo:
A perovskite-type oxide of Ba0.5Sr0.5Co0.8Fe0.2O3-delta (BSCFO) with mixed electronic and oxygen ionic conductivity at high temperatures was used as an oxygen-permeable membrane. A tubular membrane of BSCFO made by extrusion method has been used in the membrane reactor to exclusively transport oxygen for the partial oxidation of ethane (POE) to syngas with catalyst of LiLaNiO/gamma-Al2O3 at temperatures of 800-900 degreesC. After only 30 min POE reaction in the membrane reactor, the oxygen permeation flux reached at 8.2 ml cm(-2) min(-1). After that, the oxygen permeation flux increased slowly and it took 12 h to reach at 11.0 ml cm(-2) min(-1). SEM and EDS analysis showed that Sr and Ba segregations occurred on the used membrane surface exposed to air while Co slightly enriched on the membrane surface exposed to ethane. The oxygen permeation flux increased with increasing of concentration of C2H6, which was attributed to increasing of the driving force resulting from the more reducing conditions produced with an increase of concentration of C2H6 in the feed gas. The tubular membrane reactor was successfully operated for POE reaction at 875 degreesC for more than 100 h without failure, with ethane conversion of similar to 100%, CO selectivity of >91% and oxygen permeation fluxes of 10-11 ml cm(-2) min(-1). (C) 2002 Elsevier Science B.V. All rights reserved.
Resumo:
When the atomic force microscopy (AFM) in tapping mode is in intermittent contact with a soft substrate, the contact time can be a significant portion of a cycle, resulting in invalidity of the impact oscillator model, where the contact time is assumed to be infinitely small. Furthermore, we demonstrate that the AFM intermittent contact with soft substrate can induce the motion of higher modes in the AFM dynamic response. Traditional ways of modeling AFM (one degree of freedom (DOF) system or single mode analysis) are shown to have serious mistakes when applied to this kind of problem. A more reasonable displacement criterion on contact is proposed, where the contact time is a function of the mechanical properties of AFM and substrate, driving frequencies/amplitude, initial conditions, etc. Multi-modal analysis is presented and mode coupling is also shown. (c) 2006 Published by Elsevier Ltd.