显微成像荧光屏用无机闪烁单晶薄膜的研究进展

随着第三代同步辐射源的出现，由荧光屏和CCD耦合组成的、具有亚微米级空间分辨率、快速在线成像功能的探测器在医疗、安检、工业、科研等领域将会得到广泛应用．本文主要综述了成像荧光屏用材料的概况和发展趋势，重点阐述了闪烁单晶薄膜的研究及发展情况．

The stripe-backed weasel Mustela strigidorsa: taxonomy, ecology, distribution and status

1. The stripe-backed weasel Mustela strigidorsa is one of the rarest and least-known mustelids in the world. Its phylogenetic relationships with other Mustela species remain controversial, though several unique morphological features distinguish it from congeners. 2. It probably lives mainly in evergreen forests in hills and mountains, but has also been recorded from plains forest, dense scrub, secondary forest, grassland and farmland. Known sites range in altitude from 90 m to 2500 m. Data are insufficient to distinguish between habitat and altitudes which support populations, and those where only dispersing animals may occur. 3. It has been confirmed from many localities in north-east India, north and central Myanmar, south China, north Thailand, north and central Laos, and north and central Vietnam. Given the limited survey effort, the number of recent records shows that the species is not as rare as hitherto believed. Neither specific nor urgent conservation needs are apparent.

MANDIBULAR MORPHOMETRICS AMONG MACAQUES - THE CASE OF MACACCA-THIBETANA

Recent field studies suggest that Macaca thibetana, a large endemic Chinese macaque, may be quite folivorous, distinguishing it from most other macaque species, which tend to be primarily frugivorous. To understand how this diet affects its masticatory system, we conducted a comparative morphometric study of mandibular dimensions. We took linear measurements from male and female mandibles of this species as well as four other macaques-M. fascicularis, M. nemestrina, M. arctoides, and M. assamensis-and four species of Presbytis-P. obscura, P. rubicunda, P. cristata, and P. phayrei-and subjected to them to a variety of analyses. Based on analyses of variances and discriminant analyses on each sex individually, the mandible of M. thibetana corresponds to expected patterns for folivorous primates with respect to its wide condyles and thick corpora: However, the height of the corpus and symphysis are lower, and the anteroposterior length of the condyle is longer than predicted for a folivore. In addition to interpretations specifically relating to M. thibetana, we also discuss the functional morphology of the other species in light of what is published about their diets.

Non-monophyly of fish in the Sinipercidae (Perciformes) as inferred from cytochrome b gene

The sinipercids represent a group of 12 species of freshwater percoid fish, including nine in Siniperca and three species in Coreoperca. Despite several classification attempts and a preliminary molecular phylogeny, the phylogenetic relationships and systematic position of sinipercids remained still unsolved. The complete cytochrome b gene sequences from nine sinipercid species four non-sinipercid fish species were cloned, and a total of 12 cyt b sequences from 10 species of sinipercids and 11 cyt b sequences from 10 species of non-sinipercid fish also in Perciformes were included in the phylogenetic analysis. As expected, the two genera Siniperca and Coreoperca within sinipercids are recovered as monophyletic. However, nine species representing Moronidae, Serranidae, Centropomidae, Acropomatidae, Emmelichtyidae, Siganidae and Centrarchidae included in the present study are all nested between Coreoperca and Siniperca, which provides marked evidence for a non-monophyly of sinipercid fishes. Coreoperca appears to be closest to Centrachus representing the family Centrarchidae. Coreoperca whiteheadi and C. herzi are sibling species, which together are closely related to C. kawamebari. In the Siniperca, the node between S. roulei and the remaining species is the most ancestral, followed by that of S. fortis. S. chuatsi and S. kneri are sibling species, sister to S. obscura. However, the sinipercids do not seem to have a very clear phylogenetic history, for different methods of phylogenetic reconstruction result in different tree topologies, and the only conclusive result in favor of a paraphyletic origin of the two sinipercid genera is the parametric bootstrap test. The paraphyly of Sinipercidae may suggest that the "synapomorphs" such as cycloid scales, upon which this family is based, were independently derived at least twice within sinipercid fishes, and further study should be carried out to include the other two Siniperca species and to incorporate other genes.

The research of range-gated laser night vision system on cars - art. no. 68351V

The characteristic of several night imaging and display technologies on cars are introduced. Compared with the current night vision technologies on cars, Range-gated technology can eliminate backscattered light and increase the SNR of system. The theory of range-gated image technology is described. The plan of range-gated system on cars is designed; the divergence angle of laser can be designed to change automatically, this allows overfilling of the camera field of view to effectively attenuate the laser when necessary. Safety range of the driver is calculated according to the theory analysis. Observation distance of the designed system is about 500m which is satisfied with the need of safety driver range.

Transient flow patterns and bubble slug lengths in parallel microchannels with oxygen gas bubbles produced by catalytic chemical reactions

Transient flow patterns and bubble slug lengths were investigated with oxygen gas (O-2) bubbles produced by catalytic chemical reactions using a high speed camera bonded with a microscope. The microreactor consists of an inlet liquid plenum, nine parallel rectangular microchannels followed by a micronozzle, using the MEMS fabrication technique. The etched surface was deposited by the thin platinum film, which is acted as the catalyst. Experiments were performed with the inlet mass concentration of the hydrogen peroxide from 50% to 90% and the pressure drop across the silicon chip from 2.5 to 20.0 kPa. The silicon chip is directly exposed in the environment thus the heat released via the catalytic chemical reactions is dissipated into the environment and the experiment was performed at the room temperature level. It is found that the two-phase flow with the catalytic chemical reactions display the cyclic behavior. A full cycle consists of a short fresh liquid refilling stage, a liquid decomposition stage followed by the bubble slug flow stage. At the beginning of the bubble slug flow stage, the liquid slug number reaches maximum, while at the end of the bubble slug flow stage the liquid slugs are quickly flushed out of the microchannels. Two or three large bubbles are observed in the inlet liquid plenum, affecting the two-phase distributions in microchannels. The bubble slug lengths, cycle periods as well as the mass flow rates are analyzed with different mass concentrations of hydrogen peroxide and pressure drops. The bubble slug length is helpful for the selection of the future microreactor length ensuring the complete hydrogen peroxide decomposition. Future studies on the temperature effect on the transient two-phase flow with chemical reactions are recommended.

Large depth-of-view portable three-dimensional laser scanner and its segmental calibration for robot vision

A portable 3D laser scanning system has been designed and built for robot vision. By tilting the charge coupled device (CCD) plane of portable 3D scanning system according to the Scheimpflug condition, the depth-of-view is successfully extended from less than 40 to 100 mm. Based on the tilted camera model, the traditional two-step camera calibration method is modified by introducing the angle factor. Meanwhile, a novel segmental calibration approach, i.e., dividing the whole work range into two parts and calibrating, respectively, with corresponding system parameters, is proposed to effectively improve the measurement accuracy of the large depth-of-view 3D laser scanner. In the process of 3D reconstruction, different calibration parameters are used to transform the 2D coordinates into 3D coordinates according to the different positions of the image in the CCD plane, and the measurement accuracy of 60 mu m is obtained experimentally. Finally, the experiment of scanning a lamina by the large depth-of-view portable 3D laser scanner used by an industrial robot IRB 4400 is also employed to demonstrate the effectiveness and high measurement accuracy of our scanning system. (C) 2007 Elsevier Ltd. All rights reserved.

Experimental study on K alpha X-ray emission from intense femtosecond laser-solid interactions

The characteristics of K alpha X-ray sources generated by p-polarized femtosecond laser-solid interactions are experimentally studied in the relativistic regime. By use of knife-edge image technique and a single-photon-counting X-ray CCD camera, we obtaine the source size, the spectrum and the conversion efficiency of the Ka X-ray sources. The experimental results show that the conversion efficiency of Ka photons reaches an optimum value of 7.08 x 10(-6)/sr at the laser intensity of 1.6 x 10(18) W/cm(2), which is different from the Reich's simulation results (Reich et al., 2000 Phys. Rev. Lett. 84 4846). We find that about 10% of laser energy is converted into the forward hot electrons at the laser intensity of 1.6 x 10(18) W/cm(2).

Two-dimensional photonic lattices in polymer-dispersed liquid crystal composites

The relationship between liquid crystal orientational ordering and optical diffraction properties is investigated for a two-dimensional square photonic lattice fabricated in a polymer-dispersed liquid crystal (PDLC) composite. Modifications of the nematic director field in the liquid crystal domains were induced by an external applied voltage and by heating over the nematic-isotropic (N-I) phase transition. They were studied by optical polarization microscopy and by analysing far-field optical diffraction patterns. The intensities of various diffraction orders (from the zeroth up to the eighth diffraction order) were monitored with a CCD camera, and their variations were correlated with the modifications of the director field.