In situ synthesis of terbium-benzoic acid complex in sol-gel derived silica by a two-step sol-gel method

Terbium complexes with benzoic acid and its derivatives o-hydroxybenzoic acid and p-hydroxybenzoic acid were in situ synthesized in sol-gel derived silica matrix via a two-step sol-gel process. The formation process of the complex was characterized by fluorescence spectra, absorption spectra and IR spectra. The gels that contain in situ synthesized complexes exhibit the characteristic emission bands of terbium ion. The fluorescence lifetimes of Tb3+ in the silica gels are longer than those in the pure complexes and in the solutions that contain the corresponding complexes. (C) 2000 Elsevier Science Ltd. All rights reserved.

DETERMINATION OF PARAMETERS OF FAST CHEMICAL REACTION OF ALIZARIN RED S BY SPECTROELECTROCHEMICAL METHOD WITH LOPTLC

The rate constant of very fast chemical reaction generally can be measured by electrochemical methods, but can not by the thin layer electrochemical methods because of the influence of diffusion effect. Long optical path length thin layer cell (LOPTLC) with large ratio of electrode area to solution volume can be used to monitor the fist chemical reaction in situ with high sensitivity and accuracy. It enable the adsorption spectra to be measured without the influence of diffusion effect. In the present paper, a fast chemical reaction of Alizarin Red S (ARS) with its oxidative state has been studied. The reaction equilibrium constant (K) under different potentials can be determined by single step potential-absorption spectra in LOPTLC. An equilibrium constant of 7.94 x 10(5) l.mol(-1) for the chemical reaction has been obtained from the plot of lgK vs. (E - E-1(0)'). Rate constant (k) under different potentials can be measured by single step potential-chronoabsorptiometry. A rate constant of 426.6 l.mol(-1).s(-1) for the chemical reaction has been obtained from the plot of lgK vs. (E - E-1(0)') with (E - E-1(0)') = 0.

Purification of R-phycoerythrin from Porphyra haitanensis (Bangiales, Rhodophyta) using expanded-bed absorption

R-phycoerythrin (R-PE) was purified from leafy gametophyte of Porphyra haitanensis T. J. Chang et B. F. Zheng (Bangiales, Rhodophyta) by a simple, scaleable procedure. Initially, phycobiliproteins were extracted by repeated freeze-thaw cycles, resulting in release from the algal cells by osmotic shock. Next, R-PE was recovered by applying the crude extract with a high concentration of (NH4)(2)SO4 salt directly to the expanded-bed columns loaded with phenyl-sepharose. An expanded-bed volume twice the settled-bed volume was maintained; then low (NH4)(2)SO4 concentration was used to develop the column. After two rounds of hydrophobic interaction chromatography (HIC), R-PE was purified by anion-exchange column. The method was also successful with free-living conchocelis of P. haitanensis. The purified R-PE was identified with electrophoresis, and absorption and fluorescence emission spectroscopy. The results were in agreement with those previously reported. The yield with a spectroscopic purity (OD565/OD280) higher than 3.2 (the ratio of A(565)/A(620) <= 0.02) was 1.4 mg . g(-1) of leafy gametophyte of P. haitanensis. For the free-living conchocelis of P. haitanensis extract, R-PE could be purified successfully with only one round of HIC. The yield with a spectroscopic purity (OD565/OD280) higher than 3.2 (the ratio of A(565)/A(620) <= 0.02) was 5.0 mg . g(-1) of free-living conchocelis of P. haitanensis. The method described here is a scaleable technology that allows a large quantity of R-PE to be recovered from the unclarified P. haitanensis crude extract. It is also a high protein recovery technology, reducing both processing costs and times, which enhances the value of this endemic Porphyra of China.

One-step chromatography method for efficient separation and purification of R-phycoerythrin from Polysiphonia urceolata

Phycoerythrins have been widely used in food, cosmetics., immunodiagnostics and analytical reagents. An efficient one-step chromatography method for purification of R-phycoerythrins from Polysiphonia urceolata was described in this paper. Pure R-phycoerythrin was obtained with an absorbance ratio A(565)/A(280) of 5.6 and a high recovery yield of 67-33%, using a DEAE-Sepharose Fast Flow chromatography with a gradient elution of pH, alternative to common gradient elution of ionic strength. The absorption spectrum of R-phycoerythrin was characterized with three absorbance maxima at 565, 539 and 498 mum, respectively and the fluorescence emission spectrum at room temperature was measured to be 580nm. The results of native-PAGE. and SDS-PAGE showed no contamination by other proteins in the phycoerythrin solution. which suggests an efficient method for the separation and purification of R-phycoerythrins from Polysiphonia urceolata. (C) 2004 Elsevier B.V. All rights reserved.

Isolation of the main light-harvesting chlorophyll a/b-protein complex from thylakoid membranes of marine alga, Bryopsis corticulans by a direct method

The main chlorophyll a/b light-harvesting complex (LHC 11) has been isolated directly from thylakoid membranes of marine green alga (Bryopsis corticulans Setch.) by two consecutive runs of anion exchange and gel-filtration chromatography. LHC 11 proteins in the membrane extracts treated with 3% n-Octyl-b-D-glucopyranoside (OG) obtained specific binding ability on Q Sepharose column, and thus were isolated from the thylakoid membranes in a highly selective fraction. The monomeric, trimeric and oligomeric subcomplexes of LHC 11 have been obtained by fractionation of the LHC 11 mixes with sucrose density gradient ultracentrifugation. The SDS-PAGE analysis of peptide composition and absorption spectrum showed that LHC 11 monomers, trimers and oligomers prepared through this work were intact and in high purity. Our report is the first to show that it is possible to purify LHC If directly from thylakoid membranes without extensively biochemical purification.

Method for large-scale isolation and purification of R-phycoerythrin from red alga Polysiphonia urceolata Grev

R-phycoerythrin was isolated and purified from a red alga, Polysiphonia urceolata Grev, using Streamline column combined with ion-exchange chromatography or hydroxyapatite chromatography. The purity of R-phycoerythrin isolated by Streamline column was up to 1.66 and the yield of R-phycoerythrin could be as high as 0.68 mg/g frozen P. urceolata. All the eluates from Streamline column were divided into two equivalent parts, respectively. One part was pumped into the ion-exchange column loaded with Q-Sepharose and the other was applied to the adsorption column loaded with hydroxyapatite. The purities of R-phycoerythrin purified using these two methods were both up to 3.26, more than 3.2 the commonly accepted criterion. The yield of purified R-phycoerythrin from the ion-exchange chromatography was 0.40 mg/g frozen P. urceolata and that from the hydroxyapatite chromatography could reach 0.34 mg/g frozen P. urceolata. The purified protein had three absorption peaks at 498, 535, and 565 nm and displayed a fluorescence maximum at 580 nm, which was consistent with the typical spectrum of R-phycoerythrin. The purified R-PE was also identified with electrophoresis. Only one single protein band appeared on native-PAGE with silver staining. SDS-PAGE demonstrated the presence of one 20 kDa major subunit, and one low intensity band corresponding to 33 kDa subunit. The results indicate that using the expanded bed adsorption combined with ion-exchange chromatography or hydroxyapatite chromatography, R-phycoerythrin can be purified from frozen P. urceolata on large scale. (c) 2006 Elsevier Inc. All rights reserved.

Pretreatment Method for Nitrogen Isotopic Analysis of Nitrate in Seawater

A suitable method for the pretreutment of dissolved nitrate samples in seawaters for nitrogen isotopic analysis was established. First, the seawater samples were processed by removing nitrite and amonium. Then Devard's alloy was added in sample for conversion of dissolved nitrate to ammonium. The sample was distilled, and then the ammonium condensate was collected with zeolite. after distillation, the collected condensate was filtered and prepared for determining nitropic values. Some tests of the method were conducted. The distillation condition, the influence of salinity on nitrogen isotopic analysis, absorption of ammonium onto zeolite and an improved method on a large volume of seawater were discussed in this study. The results showed that the distillation step had an average recovery of (104.9 +/- 4.2) % (n = 6) when distillating every 300 mL aliquot of the sample under a strong alkaline condition with 0.5 g devard's alloy and a distillation time of 30 min. The nitrogen isotopic fractionation decreased markedly when salinity was increased from 0% to 0.5%; further increase(1% - 3.5%) showed little effect. The adsorption rate of ammonium onto zeolite had a high yield of (95.96 +/- 1.08) % (n = 6) in average. An improved collection method was used to process a large volume of seawater with several distillations, and had good effect on analysis. The method had been applied to analyze water samples collected from Changjiang estuary. The analytical results indicate that the method is suitable for delta N-15 analysis of dissolved nitrate in seawaters. The present method could provide valuable information about the source and cycle mechanism of dissolved nitrogen in estuary waters.

A simple and accurate method for determining accurately dissolved inorganic carbon in seawaters

Dissolved inorganic carbon (DIC) account for more than 95% of total carbon in seawater, so it is necessary to make reliable and precise measurements of DIC to study marine carbon cycling. In order to establish a simple and speed method, an airproof device of gas extraction-absorption was designed. Finally a simple method was developed for the determination of DIC in seawater through a large mount of experiments. The determination procedure is as follows: 100 similar to 150 mL seawater was put into conical flask, then add 10% H3PO4, the DIC in seawater sample was dissolved to form CO2 gas and carried by pure N-2, then the CO2 gas was absorbed by two grades 0.1 mol/L NaOH solution. Finally the absorbed solution was titrated by HCl standard solution of 0.01000 mol/L with the end points detected with the indicator phenolphthalein and bromocresol green-methyl red mixture. The precision and accuracy of the method were satisfied. This method was used to analyse seawater samples from Jiaozhou bay in June, 2003. The result shows that the average DIC in surface seawater is 2066 mumol/L, DIC in bottom seawater is 2075 mumol/L inside bay, but the average DIC in surface seawater is 1949 mumol/L, DIC in bottom seawater is 2147 mumol/L outside bay.

Boundary Element Method (BEM) Analysis for Galvanic Corrosion of Hot Dip Galvanized Steel Immersed in Seawater

A numerical analysis of galvanic corrosion of hot-dip galvanized steel immersed in seawater was presented. The analysis was based on the boundary element methods (BEMs) coupled with Newton-Raphson iterative technique to treat the nonlinear boundary conditions, which were determined by the experimental polarization curves. Results showed that galvanic current density concentrates on the boundary of steel substrate and zinc coating, and the sacrificial protection of zinc coating to steel substrate results in overprotection of steel cathode. Not only oxygen reduction but also hydrogen reduction could occur as cathode reactions, which probably led up to the adsorption and absorption of hydrogen atoms. Flat galvanized steel tensile sample shows a brittle behavior similar to hydrogen embrittlement according to the SSRT (show strain rate test) in seawater.