超声波法提取土壤样品中1,2,4-三氯苯和GC测定

本方法采用超声波振荡提取，用10％的丙酮正已烷混合溶液作为提取剂，对易挥发的1，2，4－三氯苯的分析具有简单、快速、灵敏、可靠、节省试剂的特点，也适用于土壤环境样品氯苯类化合物的测定。

稻田除草剂2甲4氯的分析

采用气相色谱法 ,测定水体中2甲4氯含量。方法为用乙醚提取水体中的2甲4氯 ,然后将提取液浓缩至1mL左右 ,甲酯化 ,用正己烷萃取 ,取正己烷层进行气相色谱测定。结果表明 ,本方法简便、快速 ,结果稳定 ,平均回收率为 (76.8±3.82) %。

水、土壤及植物样品中1,2,4-三氯苯的提取和GC测定

<正> 1 引言三氯苯(1,2,4-TCB)是化学工业和合成农药的重要原料,但同时也是环境中广泛存在的污染物。早在1979年,1,2,4-TCB就被美国环保局列入129种优先控制的污染物之一。在我国1,2,4-TCB也是常见的一种有机污染物。水体和土壤中1,2,4-TCB的分析方法国内已见报道。但这些方法大多步骤复杂、操作困难,而且费时、试剂消耗量大。另外,目前尚没有植物样品中1,2,4-TCB分析方法的报道。本文建立了步骤简单、易操作、节约试剂的水、土壤、植物和作物籽实中1,2,4-TCB的提取和分析方法。

A Facile One-pot Synthesis of Substituted Pyridine-2,4(1H,3H)-diones from α-Acyl-α-carbamoyl Ketene-S,S-acetals

A facile and efficient one-pot synthesis of substituted pyridine-2,4(1H,3H)-diones has been developed. Subjected to N,N-dimethylformamide dimethyl acetal (DMFDMA) in N,N-dimethylformamide at 120 ˚C, a series of acyl(carbamoyl)ketene S,S-acetals were converted into the corresponding substituted pyridine-2,4(1H,3H)-diones in high yields.

Effect of the nucleating agent 1,3 : 2,4-di(3,4-dimethylbenzylidene) sorbitol on the gamma phase content of propylene/ethylene copolymer

The influence of the concentration of a nucleating agent (NA), namely 1,3:2,4-di(3,4-dimethylbenzylidene) sorbitol (DMDBS), on the gamma phase content in a propylene/ethylene copolymer was investigated by means of Differential Scanning Calorimetry (DSC), Wide-Angle X-ray Diffraction (WAXD), Small- Angle X-ray Scatter (SAXS) and Polarized Optical Microscopy (POM).

Enantioselective Iodolactonizations of 4-Pentenoic Acid Derivatives Mediated by Chiral Salen-Co(II) Complex

This work presents the salen-Co(II) complex catalyzed enantioselective iodolactonizations of various 4-pentenoic acid derivatives with good enantioselectivities (up to 83% ee).

Microstructures, mechanical properties and corrosion behavior of high-pressure die-cast Mg-4Al-0.4Mn-xPr (x=1, 2, 4, 6) alloys

Mg-4Al-0.4Mn-xPr (x = 1, 2, 4 and 6 wt.%) magnesium alloys were prepared successfully by the high-pressure die-casting technique. The microstructures, mechanical properties, corrosion behavior as well as strengthening mechanism were investigated. The die-cast alloys were mainly composed of small equiaxed dendrites and the matrix. The fine rigid skin region was related to the high cooling rate and the aggregation of alloying elements, such as Pr. With the Pr content increasing, the alpha-Mg grain sizes were reduced gradually and the amounts of the Al2Pr phase and All, Pr-3 phase which mainly concentrated along the grain boundaries were increased and the relative volume ratio of above two phases was changed. Considering the performance-price ratio, the Pr content added around 4 wt.% was suitable to obtain the optimal mechanical properties which can keep well until 200 degrees C as well as good corrosion resistance. The outstanding mechanical properties were mainly attributed to the rigid casting surface layer, grain refinement, grain boundary strengthening obtained by an amount of precipitates as well as solid solution strengthening.

Alternating copolymerization of carbon dioxide and propylene oxide catalyzed by (R,R)-SalenCo(III)-(2,4-dinitrophenoxy) and Lewis-basic cocatalyst

A binary catalyst system of a chiral (R,R)-SalenCo(III)(2,4-dinitrophenoxy) (salen = N,N-bis(3,5-di-tert-butylsalicylidene)-1,2-diphenylethylenediimine) in conjunction with (4-dimethylamino)pyridine (DMAP) was developed to generate the copolymerization of carbon dioxide (CO2) and racemic propylene oxide (rac-PO). The influence of the molar ratio of catalyst components, the operating temperature, and reaction pressure on the yield as well as the molecular weight of polycarbonate were systematically investigated. High yield of turnover frequency (TOF) 501.2 h(-1) and high molecular weight of 70,400 were achieved at an appropriate combination of all variables. The structures of as-prepared products were characterized by the IR, H-1 NMR, C-13 NMR measurements. The linear carbonate linkage, highly regionselectivity and almost 100% carbonate content of the resulting polycarbonate were obtained with the help of these effective catalyst systems under facile conditions.

成核剂1,3:2,4-二(亚苄基)-D山梨醇对PET/PEN共混体系结构和结晶形态影响

利用差示扫描量热仪、X射线衍射仪、正交偏光显微镜研究了成核剂 1,3 :2 ,4-二 (亚苄基 ) -D山梨醇(DBS)对聚对苯二甲酸乙二醇酯 (PET) /聚 2 ,6-萘二甲酸乙二醇酯 (PEN)共混体系的结构及结晶形态的影响。结果表明 :成核剂的加入 ,使PET/PEN共混体系熔融起始温度升高 10℃左右 ,结晶峰形变尖锐 ,说明加入成核剂后有效促进了PET/PEN共混体系的结晶。实验结果表明 :成核剂含量低于 1%时 ,PET/PEN共混体系晶体的球晶完整。成核剂含量大于 3 %时 ,PET/PEN /DBS共混体系晶体的球晶碎小。成核剂的加入 ,能够有效地减小球晶尺寸和降低球晶的完善性

Copper hexacyanoferrate multilayer films on glassy carbon electrode modified with 4-aminobenzoic acid in aqueous solution

4-Aminobenzoic acid (4-ABA) was covalently grafted on a glassy carbon electrode (GCE) by amine cation radical formation during the electrooxidation process in 0.1 M KCl aqueous Solution. X-ray photoelectron spectroscopy (XPS) measurement proves the presence of 4-carboxylphenylamine on the GCE. Electron transfer processes of Fe(CN)(6)(3-) in solutions of various pHs at the modified electrode are studied by both cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). Changing the solution pH would result in the variation of the terminal group's charge state, based on which the surface pK(a) values were estimated. The copper hexacyanoferrate (CuHCF) multilayer films were formed on 4-ABA/GCE prepared in aqueous solution, and which exhibit good electrochemical behavior with high stability.

2-(4-chloroanilino)carbonylmethyl piperidine-1-carbodithioate

The crystal structure of the title compound, C14H17ClN2OS2, is stabilized by intermolecular N-(HS)-S-... hydrogen bonds and pi-pi stacking interactions.