含磷杂环化合物的光电子能谱和质谱研究(Ⅰ)

本文用光电子能谱（ＸＰＳ）和质谱（ＭＳ）方法研究了七种新合成的含磷杂环化合物。通过对ＸＰＳ和ＭＳ数据分析，讨论了该类化合物的同分异构体存在的形式及存在的方式，并证实同分异构体只存在于气相和液相中。

甲烷部分氧化制合成气Pt-Ni/Al_2O_3催化剂的研究

研究了Ni/Al_2O_3,Pt/Al_2O_3和一系列Pt-Ni/Al_2O_3催化剂对甲烷部分氧化制合成气的催化作用,发现Pt-Ni/Al_2O_3催化剂显示了比Ni/Al_2O_3和Pt/Al_2O_3更高的活性和稳定性.H_2-TPR,CO-TPD,CO_2-TPD,SEM,XPS和XRD等结果证明:Pt和Ni之间存在较强的相互作用,Pt和部分Ni形成固溶体合金并且Pt在催化剂表面富集.Pt和Ni之间的相互作用提高了催化剂的活性和稳定性,甲烷在Pt-Ni/Al_2O_3上的催化部分氧化具有不同于在Pt/Al_2O_3和Ni/Al_2O_3上的反应性能.

Characterization and catalytic behavior of La2-x(Sr,Th)(x)CuO4+/-lambda in reaction NO+CO

Two mixed oxide systems La2-xSrxCuO4+/-lambda(0.0 less than or equal to x less than or equal to 1.0) and La2+xThxCuO4+/-lambda(0.0 less than or equal to x less than or equal to 0.4) with K2NiF4 structure were prepared by varying re values; Their crystal structures were studied by means of XRD and IR spectra. The average valence of Cu ion at B site, nonstoichiometric oxygen (A) and the chemical composition in the bulk and on the surface of the catalysts were measured by means of chemical analysis and XPS. The catalytic behavior in reaction CO + NO was investigated under the regular change of average valence of Cu ion at B site and nonstoichiometric oxygen (lambda). Meanwhile, the adsorption and activation of the small molecules NO and the mixture of NO + CO over the mixed oxide catalysts were studied by means of MS-TPD. The catalytic mechanism of reaction NO + CO over these oxide catalysts were proposed; and it has been found that, at lower temperatures the activation of NO is the rate determining step and the catalytic activity is related to the lower valent metallic ion and its concentration, while at higher temperatures the adsorption of NO is the rate determining step and the catalytic activity is related to the oxygen vacancy and its concentration.

Abnormal IR spectra of CO adsorbed on the surface of glass carbon electrode modified with polypyrrole film with platinum microparticles

Abnormal IR spectra of CO adsorbed at the surface of glass carbon electrode modified with polypyrrole film with Pt microparticles are reported.

In situ scanning tunneling microscopy studies of nanometer size palladium particles on highly oriented pyrolytic graphite

A special electrodeposition process of palladium was studied by cyclic voltammetry, X-ray photoelectron spectroscopy (XPS) and in situ scanning tunneling microscopy (STM). A kind of palladium(IV) complex was attached to the highly oriented pyrolytic graphite (HOPG) electrode surface by electro-oxidation of palladium(II) complex first, and was then reduced to palladium particles. The surface complexes and particles of palladium were both characterized by in situ STM and XPS. The Pd particles are in the nanometer range of size and exhibit electrocatalytic activity towards the oxidation of hydrazine and hydroxylamine.

Preparation, physico-chemical behavior and catalytic property for ammonia oxidation of perovskite like mixed oxides La2-xSrxCuO4-lambda

A series of Sr2+ doped perovskite like oxides La2-xSrxCuO4-lambda (x = 0 similar to 1) were prepared, the structure, lattice parameters, content of Cu3+, oxygen vacancies created by Sr2+ substitution and composition of these complex oxides were studied by XRD and iodic titration method. The redox ability,active oxygen species and surface image were evaluated and analyzed with TPD, TG, XPS and SEM measurements. The catalytic activity for ammonia oxidation over these oxides was tested, and the relationship among the catalytic properties, structure, nonstoichiometric oxygen,redox ability and surface behavior were correlated and some information on the mechanism of ammonia oxidation was obtained.

A study of the electrochemical characteristics of the Co(salen)-Nafion modified electrode

A Co(salen)-Nafion modified electrode was prepared by immersing a glassy carbon electrode coated with the Nafion film into the aqueous solution with saturated Co(salen), The modified electrode showed a stable electrochemical reaction of Co(salen) at about 0 V(vs, SCE), The result of XPS indicated the valence of cobalt in Co(salen) changes from +2 before to +3 after Co(salen) enters the Nafion film, It is due to forming axis coordination of cobalt with sulfonic group in Nafion film, It was found that the mode of electron transfer in Co(salen)-Nafion modified electrode was controlled by physical diffusion and electron hopping, It was also found that the modified electrode could catalyze the reduction of O-2 to H2O2. The real catalyst may be the adduct of Co-I(salen) and O-2.

Study on the microstructure and properties of nanosized stannic oxide powders

Stannic oxide xerogel was prepared by a forced hydrolysis method using SnCl4 as the precursor. The average grain sizes of the nanosized stannic oxide powders varied with the sintering temperatures. The powders were characterized by several different physico-chemical techniques. TEM was employed for the direct observation on grain sizes, shape and state of aggregation of the particles. XRD technique was used for the determination of the crystalline structure. Microstructural parameters of average crystallite size () and mean-square root microstrain (epsilon(2)>(1/2)) for the samples were calculated from the broadened values of the half-peak intensity of XRD. The atomic ratio between oxygen and tin in the surface region of the particles was estimated through the analysis of XPS. Attributing to lots of oxygen vacancies in the surface region of the nanoparticulates and the 'trapped electrons' in the vacancies, an ESR signal was observed in the sample sintered at 300 degrees C for 2 h. FTIR of the powders showed that intensity of the transverse optical mode of Sn-O stretching vibration increased with the sintering temperature while the bending vibration of O-Sn-O showed a blue shift. For Raman spectra, very important spectral characteristics such as variations of intensity and width of the bands were observed. A new Raman vibrational band located at 572 cm(-1) was identified in the samples of nanosized stannic oxide powders. Variation of these spectroscopic properties were strongly affected by grain size, shape and state of aggregation of the nanosized particulates.

锡、锗化合物的光电子能谱和质谱研究

用光电子能谱（ＸＰＳ）和质谱（ＭＳ）分别研究了９种锗、锡的化合物Ｇｅ３ｄ、Ｓｎ３ｄ轨道电子结合能化学位移与其所处不同化学环境的关系。着重讨论了取代基团电负性对Ｇｅ３ｄ、Ｓｎ３ｄ结合能化学位移的影响。

La_(2-x)Sr_xCuO_(4-λ)复合氧化物的合成、表征和氨的氧化催化性能的研究

合成了x值不同的La_(2-x)Sr_xCuO_(4-λ)(x=0～1)系列复合氧化物,用XRD研究了这一系列氧化物的结构,结果表明x在0～0.3之间可形成K_2NiF_4结构单相化合物.用化学分析方法测定了过渡金属Cu的价态及含量,并计算出复合氧化物中的非计量氧数.用TPD,TPR,TG,XPS,SEM等方法研究了这类复合氧化物的氧化还原性能,所含氧种及表面形态,考察了对NH3氧化的催化活性,并对其催化活性与化学组成及结构的关系进行了讨论.

杂多阴离子柱撑水滑石层柱相互作用(Ⅰ)

杂多阴离子柱撑水滑石层柱相互作用（Ⅰ）李兴林＊佘益民郭军蒋大振（中国科学院长春应用化学研究所长春１３００２２）（吉林大学化学系长春）关键词杂多阴离子，柱撑水滑石，ＸＰＳ，ＩＲ，ＸＲＤ１９９６－０６－１８收稿，１９９６－１０－１２修回国家自然科学基金资...

钙离子取代对Y_2Cu_2O_5的导电性能的影响及三价铜的表征

本文主要研究了Ca~(2+)取代Y~(3+)后对Y_2Cu_2O_5的导电性能和铜价态的影响。Ca~(2+)取代Y~(3+),使Y_(2-x)Ca_xCu_2O_5中铜的价态升高、样品的电阻率降低。与La_(2-x)Sr_xCuO_4作比较,利用化学滴定法、X—射线光电于能谱(XPS)和磁化率测量对Y_(2-x)Ca_xCu_2O_5中的三价铜的存在及其自旋状态进行了表征。

Roles of oxygen vacancy and lower valence metallic ion in direct decomposition of NO over La-2-x(Sr,Th)(x)CuO4+/-lambda

Two systems of La2-xSrxCuO4+/-lambda and La2-xThxCuO4+/-lambda, mixed oxides with K2NiF4 structure were synthesized. The compositions and structures of the catalysts were characterized by means of XRD, XPS, chemical analysis and so on. The catalytic behavior for the direct decomposition of NO has been investigated. The results show that the catalytic activity is closely related to the oxygen vacancy and lower valence metallic ion in the direct decomposition of NO. The presence of oxygen vacancy is necessary for mixed oxide to have steady activity in NO decomposition.

Comb polymer electrolytes - Ionic conductivity and cation-polymer interaction

Three comb polymers(CP) with oligo-oxyethylene side chains of the type -O(CH2CH2O)(n)CH3 were prepared from methyl vinyl ether/maleic anhydride alternating copolymer. Homogeneous amorphous polymer electrolytes were made from CP and LiCF3SO3 or LiClO4 by solvent-casting method, and their conductivities were measured as a function of temperature and salt concentration. The conductivity which displayed non-Arrhenius behaviour was analyzed using the Vogel-Tammann-Fulcher equation. The conductivity maximum appears at lower salt concentration when CP has longer side chains. XPS was used to study the cation-polymer interaction.

Miscibility of linear low density polyethylene (LLDPE)-graft-poly(methyl methacrylate) with poly(vinylidene fluoride) (PVF2) and its application as compatibilizer LLDPE/PVF2 blends

Differential scanning calorimetry (DSC), Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS) were used to study the miscibility of blends of a graft copolymer of poly(methyl methacrylate) on linear low density polyethylene (LLDPE-g-PMMA, G-3) with poly(vinylidene fluoride)(b) (PVF2) and the compatibilization of blends of LLDPE/PVF2. The specific interaction between PMMA side chains and PVF2 in G-3/PVF2 binary blends is weaker than that between the homopolymers PMMA and PVF2. There are two states of PVF2 in the melt of a G-3/PVF2 (60/40, w/w) blend, one as pure PVF2 and the other interacting with PMMA side chains. The miscibility between PMMA side chains and PVF2 affects the crystallization of PVF2. LLDPE-g-PMMA was demonstrated to be a good compatibilizer in LLDPE/PVF2 blends, improving the interfacial adhesion and dispersion in the latter. Diffusion of PMMA side chains into PVF2 in the interfacial region reduces the crystallization rate and lowers the melting point (T-m) and the crystallization temperature (T-c) of PVF2 in the blends.