Two Electron Transfer and Stabilization in Slow O6+ and Rare-Gas Collisions

The stabilization ratios.. for double-electron transfer, i.e., the cross section ratios of true double capture to total double-electron transfer, are measured in O6++ He, Ne and Ar collisions at 6 keV/u. A high.. value about 68% is obtained for the He target, while for the Ar target, the.. value is only 8%. The high R value for the He target is due to the significant direct population of the (2l, nl') configurations with high n For the Ar target, the (quasi) symmetric configurations (3l, nl') lead to the much lower.. value. Neglecting the core effects, the O6+ ion can be taken as a bare ion C6+ except the occupied 1s shell, and then the measured R values are compared with previous experimental results of C6+ projectile ions at similar impact velocity. It yields good agreement with the Ne and Ar target, while the occupied 1s shell for the O6++ He system results in a higher R value than that in C6++He collisions.

The geometry of the NO2- anion: ab initio calculations and Franck-Condon analysis

Geometry optimization and harmonic vibrational frequency calculations have been performed on the (X) over bar (2)A(1) state of NO2 and (X) over bar (1)A(1) state of NO2-. Franck-Condon analyses and spectral simulations were carried out on the NO2((X) over bar (2)A(1))-NO2-((X) over bar (1)A(1)) photo detachment process. In addition, the equilibrium geometry parameters, r(NO)= 1.248 +/- 0.005 Angstrom and angle(ONO) 116.8 +/- 0.5degrees, of the (X) over bar (1)A(1) state of NO2-, are derived by employing an iterative Franck-Condon analysis procedure in the spectral simulation. Our conclusions regarding the anion geometry suggest a reinterpretation of the results of Woo et al. (C) 2004 Published by Elsevier B.V.

Geometries of the Halocarbene anions HCF- and CF2-: ab initio calculation and Franck-Condon analysis

A theoretical method to calculate multidimensional Franck-Condon factors including Duschinsky effects is described and used to simulate the photoelectron spectra of HCF- and CF2- radicals. Geometry optimization and harmonic vibrational frequency calculations have been performed on the (X) over tilde (1)A' state of HCF and (X) over tilde (2)A" state of HCF-, and (X) over tilde (1)A(1) state of CF2 and (X) over tilde B-2(1) state of CF2-. Franck-Condon analyses and spectral simulation were carried out on the first photoelectron band of HCF- and CF2- respectively. The theoretical spectra obtained by employing B3LYP/6-311 + G(2d,p) values are in excellent agreement with the observed ones. In addition, the equilibrium geometry parameters, R(CF) = 0.1475 +/- 0.0005 nm, of the (X) over tilde (2)A" state of HCF-, and r(FC) = 0.1425 +/- 0.0005 nm and angle(FCF) = 100.5 +/- 0.5degrees, of the (X) over tilde B-2(i) state of CF2-, are derived by employing an iterative Franck-Condon analysis procedure in the spectral simulation. (C) 2003 Elsevier B.V. All rights reserved.

Comparison of salt titration and potentiometric titration methods for the determination of zero point of charge

the salt ritration metod was evaluated as a method to determine zpc in comparison with the potentiometric titration method for 26 soil with variable charge clays,i.e.,Oxisols and Ultisols from Thailand and Andisols from Japan. In addition to the determination of ST-pH0 as the zero point of charge, a calculation procedure was adopted here in order to acquire more information from the titration curve . fuithermore, for the purpose of cross-checking of zpc determined by the pt method, the st procedure was successively applied to the samples analyzed by the pt method.

Qualitative and semi-quantitative analysis of quaternary alkaloids in Coptis-scute herb couple by Electrospray mass Spectrometry

A practical solution of qualitatively analyzing quaternary alkaloids in coptis-scute herb couple by electrospray ionization mass spectrometry(ESI-MS) was developed. Without the complicated pretreatment of sample, the active ingredients including berberine, palmatine, coptisine, jatrorrhizine, epiberberine, and columbamine were identified and some relative content changing rules of alkaloids in coptis-scute couple were summarized in this article. The overall profiles of the complex extracts were obtained.

Harvesting Excitons Via Two Parallel Channels for Efficient White Organic LEDs with Nearly 100% Internal Quantum Efficiency: Fabrication and Emission-Mechanism Analysis

By incorporating two phosphorescent dyes, namely, iridium(III)[bis(4,6-difluorophenyl)-pyridinato-N,C-2']picolinate (Flrpic) for blue emission and bis(2-(9,9-diethyl-9H-fluoren-2-yl)-1-phenyl-1 H-benzoimidazol-N,C-3) iridium(acetylacetonate) ((fbi)(2)Ir(acac)) for orange emission, into a single-energy well-like emissive layer, an extremely high-efficiency white organic light-emitting diode (WOLED) with excellent color stability is demonstrated. This device can achieve a peak forward-viewing power efficiency of 42.5 lm W-1, corresponding to an external quantum efficiency (EQE) of 19.3% and a current efficiency of 52.8 cd A(-1). Systematic studies of the dopants, host and dopant-doped host films in terms of photophysical properties (including absorption, photoluminescence, and excitation spectra), transient photoluminescence, current density-voltage characteristics, and temperature-dependent electroluminescence spectra are subsequently performed, from which it is concluded that the emission natures of Flrpic and (fbi)(2)Ir(acac) are, respectively, host-guest energy transfer and a direct exciton formation process. These two parallel pathways serve to channel the overall excitons to both dopants, greatly reducing unfavorable energy losses.

Miniaturized tris(2,2 '-bipyridyl)ruthenium(II) electrochemiluminescence detection cell for capillary electrophoresis and flow injection analysis

The design and performance of a miniaturized chip-type tris(2,2'-bipyridyl)ruthenium(II) [Ru(bpy)(3)(2+)] electrochemiluminescence (ECL) detection cell suitable for both capillary electrophoresis (CE) and flow injection (FI) analysis are described. The cell was fabricated from two pieces of glass (20 x 15 x 1.7 mm), and the 0.5-mm-diameter platinum disk was used as working electrode held at +1.15 V (vs silver wire quasi-reference), the stainless steel guide tubing as counter electrode, and the silver wire as quasi-reference electrode. The performance traits of the cell in both CE and FI modes were evaluated using tripropylamine, proline, and oxalate and compared favorably to those reported for CE and FI detection cells. The advantages of versatility, sensitivity, and accuracy make the device attractive for the routine analysis of amine-containing species or oxalate by CE and FI with Ru(bPY)(3)(2divided by) ECL detection.

Alternating LB film of ferric oxide nanoparticles-copper phthalocyanine derivative and its gas sensitivity

Nanoparticulate ferric oxide - tris - (2,4-di-t-amylphenoxy) - (8-quinolinolyl) copper phthalocyanine Langmuir-Blodgett Z-type multilayers were obtained by using monodisperse nanoparticle ferric oxide hydrosol as the subphase. XPS data reveal that the nanoparticle ferric oxide exist as alpha -Fe2O3 phase in the films. Transition electron microscopic (TEM) image of the alternating monolayer shows that the film was highly covered by the copper phthalocyanine derivative and the nanoparticles were arranged rather closely. IR and visible spectra all give the results that the nanoparticles were deposited onto the substrate with the copper phthalocyanine derivative. The gas-sensing measurements show that the alternating LB film had very fast response-recovery characteristic to 2 ppm C2H5OH gas, and also sensitive to larger than 200 ppm NH3.

Molecular orientation of copper phthalocyanine in thin films and their gas-sensing properties

Copper phthalocyanine derivative Langmuir-Blodgett (LB) films were prepared by vertical dipping and horizontal lifting methods. Molecular orientation of copper phthalocyanine derivative in thin films was studied by polarized UV-Vis spectra. The relationship between the molecular orientation of copper phthalocyanine in LB films and their gas-sensing properties was investigated.

Selection for variables in quantitative structure-activity/property relationship studies - Comparison between methods of orthogonal descriptors and leaps-and-bounds regression analysis

In this paper, the comparison of orthogonal descriptors and Leaps-and-Bounds regression analysis is performed. The results obtained by using orthogonal descriptors are better than that obtained by using Leaps-and-Bounds regression for the data set of nitrobenzenes used in this study. Leaps-and-Bounds regression can be used effectively for selection of variables in quantitative structure-activity/property relationship(QSAR/QSPR) studies. Consequently, orthogonalisation of descriptors is also a good method for variable selection for studies on QSAR/QSPR.

NMR titration and molecular model MOPAC calculation of protonation processes of two MRI ligands

The protonation process of two DTPA bis(amide) derivatives, DTPA-BDMA and DTPA-BDEA, was studied by using H-1 NMR titration and MOPAC calculation. Their protonation process was proposed in the order of the central amine, the terminal amines, the central carboxyl, the terminal carboxyl, the other terminal carboxyl and central amine. During the protonation of the terminal amine, there existed a large fraction of proton transfer from the central amine to the other terminal amine.