Detection of avian influenza virus subtype H5 using a biosensor based on imaging ellipsometry

A novel method is reported for the detection of avian influenza virus subtype H5 using a biosensor based on high spatial resolution imaging ellipsometry (IE). Monoclonal antibodies specific to H5 hemagglutinin protein were immobilized on silicon wafers and used to capture virus particles. Resultant changes on the surface of the wafers were visualized directly in gray-scale on an imaging ellipsometry image. This preliminary study has shown that the assay is rapid and specific for the identification of avian influenza virus subtype H5. Compared with lateral-flow immunoassays, this biosensor not only has better sensitivity, but can also simultaneously perform multiplexed tests. These results suggest that this biosensor might be a valuable diagnostic toot for avian influenza virus detection. (c) 2009 Elsevier B.V. All rights reserved.

Thermally induced evolution of phase transformations in gas hydrate sediment

Thermally induced evolution of phase transformations is a basic physical-chemical process in the dissociation of gas hydrate in sediment (GHS). Heat transfer leads to the weakening of the bed soil and the simultaneous establishment of a time varying stress field accompanied by seepage of fluids and deformation of the soil. As a consequence, ground failure could occur causing engineering damage or/and environmental disaster. This paper presents a simplified analysis of the thermal process by assuming that thermal conduction can be decoupled from the flow and deformation process. It is further assumed that phase transformations take place instantaneously. Analytical and numerical results are given for several examples of simplified geometry. Experiments using Tetra-hydro-furan hydrate sediments were carried out in our laboratory to check the theory. By comparison, the theoretical, numerical and experimental results on the evolution of dissociation fronts and temperature in the sediment are found to be in good agreement.

长白山次生林演替过程中土壤动物群落的变化

通过对长白山白河局不同林龄的次生林土壤动物的组成进行比较 ,探讨了土壤动物群落随森林采伐更新演替的变化以及演替阶段 (增长期、过渡期和稳定期 ) .研究表明 ,不同类群土壤动物的演变趋势是腐食类群数量相对较多 ,其变化趋势接近植被的变化规律 ,均是经过上升、下降 ,最后达到稳定 ;植食类群演替前期在整个群落中所占比例较高 ,随着演替年代的增加 ,比例呈下降的趋势 ;捕食类群经过 10 0年左右的演替 ,数量明显增加 ;从昆虫类群组成来看 ,林龄较短者 ,未稳定的类群数较多 ,林龄较长者 ,未稳定的类群较少 .

翻耙补播对科尔沁碱化草地土壤理化性质和生物活性的影响

对科尔沁地区碱化草甸草地翻耙补播沙打旺后的土壤理化性质和土壤生物活性的变化进行了研究。结果表明,翻耙补播改良后草地综合生产性能得到明显改善,土壤容重、pH、含盐量和碱化度降低,土壤含水量和孔隙度增加,土壤有机质和N、P、K等养分含量增加;同时,土壤微生物C、N的含量以及土壤酶的活性也得到较大幅度提高。

辽北地区农田防护林杨树新无性系的引进与优选

在辽宁省昌图县前双井镇以引进的 6个无性系新品种杨树为材料 ,用乡土杨富杂Ⅱ号为对照作栽培比较试验 ,观察其生长量、抗寒性、感病性、感虫性等指标 ,用评分法评价各品种综合表现的优劣 .结果表明 ,N 119杨各项指标明显地超过对照 ,并优于其它品种 ,可扩大栽培 ;赛路杨生长量明显地超过本地乡土杨 ,且感病性、抗寒性等方面等于或接近对照 ,有一定的引种价值 .

湖北省近500年区域干湿序列重建及其比较分析

在历史旱涝记载资料可靠性检验的基础上,重建了湖北省3个区域近500年来的干湿气候变化序列,并比较分析了各区域干湿气候变化的趋势特征、准周期性及跃变现象。结果表明:在3个区域中,鄂东区1570~1770、1890~1950年两个时段偏湿,1470~1520、1790~1830年则偏干;鄂北区偏湿时期主要在1470~1530、1710~1750、1850~1910年三个时段,1470~1530、1770~1830年则偏干;鄂西南区有1550~1610、1650~1710、1830~1890、1930~1990

Considerable effects of diversity indices and spatial scales on conclusions relating to ecological diversity

The relationships between ecological diversity and ecosystem functions such as stability and productivity have long been debated and have no final conclusion until now. It is ignored that the debate should be firstly based on the same diversity index, which should be theoretically complete, and on same observation scale. For the issue on the scale of ecotope observation, ecosystems should be distinguished according to intensity of human disturbance. For the issue on the scale of species observation, either number diversity or biomass diversity should be identified. This paper takes grassland ecosystems located within the Bayin Xile grassland of Xilin Gol League of Inner Mongolia Autonomous Region as an example to analyze effects of different diversity indices and spatial scales on the conclusions of ecological diversity and its relationships with ecosystem functions. The analysis results both on the scale of ecotope observation and on the scale of species observation show that different diversity indices might give different conclusions and spatial resolution has a great effect on the relative conclusions. (c) 2005 Elsevier B.V. All rights reserved.

Near-infrared luminescent properties and natural lifetime calculation of a novel Er3+ complex

in this communication, a novel Er3+ complex Er(PT)(3)TPPO [PT = 1-phenyl-3-methyl-4-tert-butylbenzoyl-5-pyrazolone, TPPO = triphenyl phosphine oxide] is successfully synthesized and characterized by elemental analysis and single-crystal X-ray diffraction. Its optical properties and the energy transfer process from the ligand PT to the Er3+ ion are investigated, the typical near-infrared (NIR) luminescence (centered at around 1530 nm) is attributed to the I-4(13/2) -> I-4(15/2) transition of Er3+ ion which results from the efficient energy transfer from PT to Er3+ ion (an antenna effect). The wider full width at half maximum (78 nm) peaked at 1530 nm in the emission spectrum and the Judd-Ofelt theory calculation on the radiative properties suggest that Er(PT)(3)TPPO should be a promising candidate for tunable lasers and planar optical amplifiers.

Crystallization Behavior and Mechanical Properties of Crosslinked Plasticized Poly(L-lactic acid)

Enhancing the stability of plasticized poly(L-lactic acid) (PLLA) with poly (ethylene glycol) (PEG) is necessary for its practical application. In this study, plasticized PLLA (PLLA/PEG 80/20 wt/wt) was crosslinked under I-ray (Co-60) in the presence of triallyl isocyanurate (TALC) as crosslinking agent. FTIR analysis revealed that PLLA, PEG, and TALC formed a cocrosslinking structure. Crystallization behavior and mechanical properties of the crosslinked plasticized PLLA were investigated by differential scanning calorimetry (DSC), wide-angle X-ray diffraction (WAXD), scanning electron microscopy (SEM), and tensile tests. Experimental results indicated that the crystallization behaviors of both PEG and PLLA in the blends were restrained after irradiation. The melting peak of PEG in the crystallized samples disappeared at a low irradiation doses about 10 kGy. Although PLLA still owned the behavior of crystallize, its cold crystallization temperature and glass transition temperature shifted to higher temperature. Mechanical properties of the plasticized PLLA were strengthened through crosslinking. Both yield strength and elastic modulus of the samples increased after crosslinking.

Sol-ogel deposition and luminescence properties of lanthanide ion-doped Y2(1-x)Gd2xSiWO8 (0 <= x <= 1) phosphor films

Y2(1-x) Gd2xSiWO8 : A ( 0 <= x <= 1; A= Eu3+, Dy3+, Sm3+, Er3+) phosphor films have been prepared on silica glass substrates through the sol - gel dip-coating process. X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), thermogravimetric and differential thermal analysis (TG-DTA), atomic force microscope (AFM), scanning electron microscopy (SEM) and photoluminescence spectra as well as lifetimes were used to characterize the resulting films. The results of the XRD indicated that the films began to crystallize at 800 degrees C and crystallized completely at 1000 degrees C. The AFM and SEM study revealed that the phosphor films, which mainly consisted of closely packed grains with an average size of 90 - 120 nm with a thickness of 660 nm, were uniform and crack free. Owing to an efficient energy transfer from the WO42- groups to the activators, the doped lanthanide ion ( A) showed its characteristic f - f transition emissions in crystalline Y2(1-x) Gd2xSiWO8 (0 <= x <= 1) films. The optimum concentrations for Eu3+, Dy3+, Sm3+, Er3+ were determined to be 21, 5, 3 and 7 mol% of Y3+ in Y2SiWO8 films, respectively.

Study of electron transfer across the liquid/ice-like matrix interface by scanning electrochemical microscopy

In this work, we report the findings of a study on scanning electrochemical microscopy (SECM) to investigate the interfacial electron-transfer (ET) reaction between the 7,7,8,8-tetracyanoquinodimethane radical anion (TCNQ(.-)) in 1,2-dichloroethane and ferricyanide in an ice-like matrix (a mixture of insulting ice and conductive liquid) under low temperatures. Experimental results indicate that the formed liquid/ice-like matrix interface is superficially similar in electrochemical characteristics to a liquid/liquid interface at temperatures above -20 degreesC. Furthermore, imaging data show that the surface of the ice-like matrix is microscopically flat and physically stable and can be applied as either a conductive or an insulting substrate for SECM studies. Perchlorate ion was selected as the common ion in both phases, the concentrations of which controlled the interfacial potential difference. The effect of perchlorate concentration in the DCE phase on interfacial reactions has been studied in detail. The apparent heterogeneous rate constants for TCNQ(.-) oxidation by Fe(CN)(6)(3-) in another phase under different temperatures have been calculated by a best-fit analysis, where the experimental approach curves are compared with the theoretically derived relationships. Reaction rate data obey Butler-Volmer formulation before and after the freezing point, which is similar to most other known cases of ET reactions at liquid/liquid interfaces. However, there is a sharp change observed for heterogeneous rate constants around the freezing point of the aqueous phase, which reflects the phase transition. At temperatures below -20 degreesC, surface-confined voltammograms for the reduction of ferricyanide were obtained, and the ice-like matrix became an insulating one, which indicates that the aqueous phase is really a frozen phase.

Preparation and characteristics of polyimide-TiO2 nanocomposite film

A sol-gel approach has been developed to prepare polyimide-TiO2, hybrid films fi om soluble polyimides and a modified titanium precursor. The rate of the hydrolysis reaction of titanium alkoxide can be controlled by using acetic acid as a modifier. FTIR and XPS indicated that TiO2, particles were well distributed in polyimide matrixes with particle size small per than 60 nm. Polyimide hybrid films having the TiO2, component less than or equal to 10% exhibited high thermal stability, high optical transparency and good mechanical properties and possessed higher dielectric constants than correspondingly polyimides. (C) 2000 Society of Chemical Industry.