Preparation of Microporous Membranes by Swift Heavy Ion Irradiation and Impedance Characterization

Polypropylene (PP) microporous membranes were successfully prepared by swift heavy ion irradiation and track-etching. Polypropylene foils were irradiated with Au-197 ions of kinetic energy 11.4 MeV.u(-1) (total energy of 2245.8 MeV) and fluence 1x10(8) ions.cm(-2) at normal incidence. The damaged regions produced by the gold ions along the trajectories were etched in H2SO4 and K2Cr2O7 solutions leading to the formation of cylindrical pores in the membranes. The pore diameters of the PP microporous membranes increased from 380 to 1610 nm as the etching time increased from 5 to 30 min. The surface and cross-section morphologies of the porous membranes were characterized by scanning electron microscopy (SEM). The micropores in the membranes were found to be cylindrical in shape, homogeneous in distribution, and equal in size. Some mathematical relations of the porosity of the PP microporous membranes were established by analytic derivation. The microporous membranes were used in lithium-ion batteries to measure their properties as separators. The electrical conductivity of the porous membrane immersed in liquid electrolyte was found to be comparable to that of commercial separators by electrochemical impedance spectroscopy (EIS). The results showed that the porosity and electrical conductivity were dependent on the ion fluence and etching time. By adjusting these two factors, microporous membranes with good porosity and electrical conductivity were made that met the requirements for commercial use.

GIS支持下的辽宁省地表水环境功能区划

辽宁省现执行的地表水环境功能区划存在着环境功能与实际情况的差别,对水功能区目标期望值过高,难以适应当前环境管理需要。在GIS技术支持下,对辽宁省地表水环境功能进行了调整、核定和重新划分。建议将辽宁省地表水主要水系共划分781个水环境功能区,其中源头水域15个,自然保护区7个,饮用水源保护区204个,渔业用水区287个,景观娱乐用水区54个,工业用水区35个,农业用水区179个;采用基于组件的GIS开发技术,设计实现了辽宁省地表水环境功能区划信息系统,从而为辽宁省水环境功能区划信息管理、水资源保护及科学制定水环境管理方案提供决策支持。

长效碳铵特性与应用效益研究

<正>我国现有可耕地面积104.5×10~5km~2,人均耕地面积仅8.67hm~2,化肥在粮食增产中的作用约占33.7%.所产氮肥量约16×10~6t(折纯),其中碳铵约占51%.这是我国特有的氮肥品种,含有氮素和二氧化碳,肥效快,不板结土壤,但存在易挥发损失、不易贮存、肥效期短、氮素利用率低和易结成硬块等缺点.研究长效碳铵的目的是减少碳铵的氨挥发,降低转化为硝态氮的淋溶损失,提高氮素利用率与延长肥效期,在减少施肥量条件下能促进作物生长发育.经多年研究证明,该肥料具有明显的氨稳定作用及增加铵态氮在土壤中的贮存量.该项研究查明了使长效碳铵产生较大经济效益的DCD添加量;创建了系统生产法新工艺,从而实现了生产出新型碳铵的目的.

河北木兰围场油松年轮生态学的初步研究

运用树木年轮气候学方法,研究了河北木兰围场油松的生长与气候要素之间的关系.结果表明:油松生长对环境变化十分敏感,以早材最为敏感.5、6月气温与油松生长存在显著的负相关关系;6月的降水和相对湿度对油松早材的生长有促进作用,上年9月到翌年9月的降水对油松生长有更强的促进作用;12月到翌年3月的相对湿度对油松晚材生长的促进作用较干旱和全轮显著;油松的生长与大尺度气候波动存在一定的相关性.1951—2006年间,围场地区增温明显.随气温的升高,油松生长对温度和降水的敏感性下降,且有向相反方向转变的趋势.百年尺度上5—6月平均气温的重建值与观测值差异较大,说明当地油松的宽度生长对气候因子变化的敏感性波动较大.

开发生产长效碳酸氢铵增强小氮肥企业活力

<正>市场经济的发展使碳铵企业陷入了困境首先,从产品本身来讲,碳铵的化学性质不稳定,含氮量只有17%,氮素利用率低(25%左右),肥效期短(35～45天),

湖北省近500年区域干湿序列重建及其比较分析

在历史旱涝记载资料可靠性检验的基础上,重建了湖北省3个区域近500年来的干湿气候变化序列,并比较分析了各区域干湿气候变化的趋势特征、准周期性及跃变现象。结果表明:在3个区域中,鄂东区1570~1770、1890~1950年两个时段偏湿,1470~1520、1790~1830年则偏干;鄂北区偏湿时期主要在1470~1530、1710~1750、1850~1910年三个时段,1470~1530、1770~1830年则偏干;鄂西南区有1550~1610、1650~1710、1830~1890、1930~1990

The effect of multiwall carbon nanotube on the crystallization, morphology, and rheological properties of nylon1010 nanocomposites

Nanocomposites based on poly(iminosebacoyl imino-decamethylene) (PA1010) and multiwall carbon nanotubes (MWNTs) were successfully prepared by melt blending technique. environmental scanning electron microscope micrographs of the fracture surfaces showed that not only is there an evenly dispersion of MWNTs throughout the PA1010 matrix but also a strongly interfacial adhesion with the matrix. The combined effect of more defects on MWNTs and low temperature buckling fracture is mainly responsible for the broken tubes. Differential scanning calorimeter results showed that the MWNTs acted as a nucleation agent and increased the crystallization rate and decreased crystallite size. In the linear region, rheological measurements showed a distinct change in the frequency dependence of storage modulus, loss modulus, and complex viscosity particularly at low frequencies. We conclude that the rheological percolation threshold might occur when the content of MWNTs is over 2 wt% in the composites.

Low-density polyethylene superhydrophobic surface by control of its crystallization behavior

A simple and inexpensive method for forming a low-density polyethylene (LDPE) superhydrophobic surface by controlling the crystallization behavior of LDPE by adjusting the crystallization time and nucleation rate has been proposed. The resulting porous surface, with hierarchical micro- and nanostructures on the beautiful floral designs, has a water contact angle of 173.0degrees +/- 2.5degrees.

The influence of nucleating agent on crystallization behavior and properties of polypropylene and its copolymer with ethylene

The influences of nucleating agent EDBS on crystallization behavior and properties of polypropylene UP) and its copolymer with a small amount (4. 48 %, molar fraction) of ethylene (CPP) were studied. DSC results indicated that the crystallization temperature of iPP and CPP samples with 0.5 % (mass fraction) EDBS obviously increased and the degree of crystallinity of these samples became higher. In addition, adding small amount of EDBS enhanced the crystallization of the low isotacticity and low molecular weight segments of the CPP. PLM results showed that their spherulite size decreased markedly, and as a result, the transmittance and haze of the films were all improved.

成核剂对聚丙烯及其共聚物的结晶行为和性能的影响

研究了成核剂 1 ,3∶ 2 ,4-对二乙基苄叉山梨醇 (EDBS)对聚丙烯及其乙烯共聚物的结晶行为和结晶形态的影响 ,并对其薄膜进行了光学性能的表征 .结果表明 ,添加少量 (质量分数 0 .5 % )的成核剂 ,使聚丙烯样品的结晶温度大大提高 ,结晶度明显增加 .而对于乙烯共聚聚丙烯样品 ,添加少量 (质量分数 0 .5 % )成核剂 ,不仅使其整体结晶温度大大提高 ,结晶度增加 ,而且明显强化了低有序部分的结晶 .少量成核剂的加入 ,使聚丙烯及其共聚物的球晶尺寸明显缩小 ,薄膜的透光性和雾度显著改善

MF_2:Eu,Ce(M=Ca,Sr,Ba)中稀土离子的价态变化

我们已经实验证明并报道了Eu-Tb之间、Ce-Yb之间的电荷转移.本文首次实验证实了Ce~(3+)离子和Eu~(3+)离子之间电荷转移现象的存在,进一步阐述了稀土价态与其电子组态共轭特征的相关性.1 实验部分1.1 试剂CaF_2,SrF_2,BaF_2,NH_4HF_2、氢氟酸、盐酸均为分析纯,EuF_3和CeF_3分别由高纯Eu_2O_3(99.95%)及CeO_2(99.99%)自制.1.2 MF_2:Eu,Ce体系的合成按化学计量比(MF_2:X%CeF_2,y%EuF_3;X=1,y=0,0.1,0.3,0.5,1;X=0,0.05,0.1,0.3,0.5,y=1)准确称取原料,放人玛瑙研钵中充分研混后装入刚玉柑涡中,置于管状炉内(用氢气

钐原子激发态自然辐射寿命的测量

稀土元素钐(Sm)的基组态是4f~66s~2,其4f壳层未添满,s电子及f电子都有可能被激发,产生复杂的光谱性质。早在1969年,Handrich等人就采用能级交叉的方法测量了钐原子的4个低激发态的寿命。之后,由于寿命测量技术的发展,人们采用各种不同的方法与技

Chromosomal localization and molecular marker development of the lipopolysaccharide and beta-1,3-glucan binding protein gene in the Zhikong scallop Chlamys farreri (Jones et Preston) (Pectinoida, Pectinidae)

Zhikong scallop Chlamys farreri(Jones et Preston) is an economically important species in China. Understanding its immune system would be of great help in controlling diseases. In the present study, an important immunity-related gene, the Lipopolysaccharide and Beta-1,3-glucan Binding Protein (LGBP) gene, was located on C. farreri chromosomes by mapping several lgbp-containing BAC clones through fluorescence in situ hybridization (FISH). Through the localization of various BAC clones, it was shown that only one locus of this gene existed in the genome of C. farreri, and that this was located on the long arm of a pair of homologous chromosomes. Molecular markers, consisting of eight single nucleotide polymorphism (SNPs) markers and one insertion-deletion (indel), were developed from the LGBP gene. Indel marker testing in an F1 family revealed slightly distorted segregation (p = 0.0472). These markers can be used to map the LGBP gene to the linkage map and assign the linkage group to the corresponding chromosome. Segregation distortion of the indel marker indicated genes with deleterious alleles might exist in the surrounding region of the LGBP gene.