激光熔覆TiC_p/Ni合金涂层中界面结构及界面硬度与弹性模量分布

利用激光熔覆制备了两类TiC_P/Ni合金涂层。与自生TiC_P涂层不同，在添加TiC_P涂层中，TiC_P与基体界面处观察到TiC外延生长及CrB。相利用纳米硬度仪研究了涂层中TiC_P与基体的界面硬度H及弹性模量E的分布。添加TiC_P与基体相界面加载的曲线存在位移突进(pop-in)现象；原位TiC_P界面附近加载曲线不存在pop-in现象。原位TiC_P相界面附近H及E较高并呈现连续梯度分布特征，表明原位TiC_P界面具有高的刚度与强韧性。

Deformation Twinning in Nanocrystalline NI

Deformation twinning is observed upon large plastic deformation in nanocrystalline (nc) Ni by transmission electron microscopy examinations. New and compelling evidence has been obtained for several twinning mechanisms that operate in nc grains, with the gain boundary emission of partial dislocations determined as the most proficient. Deformation twinning in nc Ni is discussed in comparison with molecular dynamics simulation results, based on generalized planar fault energy curves.

Dislocations and twins in nanocrystalline Ni after severe plastic deformation: the effects of grain size

Deformation microstructures have been investigated in nanocrystalline (nc) Ni with grain sizes in the 50-100 nm range. It was found that deformation twinning started to occur in grains of similar to 90 nm, and its propensity increased with decreasing grain size. In most of the nc grains dislocations were observed as well, in the form of individual dislocations and dipoles. It is concluded that dislocation-mediated plasticity dominates for grain sizes in the upper half, i.e. 50-100 nm, of the nanocrystalline regime. (C) 2007 Published by Elsevier B.V.

Size-dependent elastic properties of Ni nanofilms by molecular dynamics simulation

Size-dependent elastic properties of Ni nanofilms are investigated by molecular dynamics ( MD) simulations with embedded atom method (EAM). The surface effects are considered by calculating the surface relaxation, surface energy, and surface stress. The Young's modulus and yield stress are obtained as functions of thickness and crystallographic orientation. It is shown that the surface relaxation has important effects on the the elastic properties at nanoscale. When the surface relaxation is outward, the Young's modulus decreases with the film thickness decreasing, and vice versa. The results also show that the yield stresses of the films increase with the films becoming thinner. With the thickness of the nanofilms decreasing, the surface effects on the elastic properties become dominant.

纳米晶Ni疲劳行为的实验研究

系统研究了纳米晶Ni与粗晶Ni的疲劳行为。通过疲劳实验获得了这2种材料的疲劳应力--寿命曲线，并采用AFM对纳米晶Ni样品表面进行观察以研究其裂纹萌生的微观机制，利用纳米压痕仪对疲劳实验前后样品的力学性能和显微组织变化进行了研究。结果表明，纳米晶Ni具有比粗晶Ni更高的疲劳极限。AFM观察表明纳米晶疲劳后样品表面出现平均尺寸为73 nm的胞状起伏，疲劳后样品的晶粒尺寸没有发生明显改变。压痕硬度结果表明疲劳过程材料的力学性能也未发生明显变化。

纳米晶Ni晶间断裂的数值模拟

提出了一种针对超细晶和纳米晶金属(主要是fcc金属)晶间断裂的微结构计算模型,即采用基于机制的应变梯度塑性(CMSG)理论描述晶粒内部材料塑性变形过程中的变形、强化和尺度效应;采用黏聚力界面模型来模拟晶界的滑移和分离现象,以及晶间裂纹的萌生和演化,直至晶间断裂导致的材料失效.利用该计算模型模拟了纳米晶Ni的拉伸实验过程,对纳米晶Ni宏观力学行为和晶间微裂纹萌生与扩展之间的关系进行了研究,验证了针对超细晶和纳米晶力学性能的计算模型的有效性;同时,模拟结果表明,非均匀塑性变形导致高应变梯度效应,晶粒塑性变形强化显著,使晶界主导的变形机制对纳米晶金属的整体力学性能产生重要影响.

Development And Characterization Of Composite Ni-Cr-C-Caf2 Laser Cladding On Gamma-Tial Intermetallic Alloy

A process of laser cladding Ni-CF-C-CaF2 mixed powders to form a multifunctional composite coatingd on gamma-TiAl substrate was carried out. The microstructure of the coating was examined using XRD, SEM and EDS. The coating has a unique microstructure consisting of primary dendrite or short-stick TiC and block Al4C3 carbides reinforcement as well as fine isolated spherical CaF2 solid lubrication particles uniformly dispersed in the NiCrAlTi (gamma) matrix. The average microhardness of the composite coatings is approximately HV 650 and it is 2-factor greater than that of the TiAl substrate. (C) 2008 Elsevier B.V. All rights reserved.

Ni^2＋掺杂透明ZnO-Al2O3-SiO2系微晶玻璃的光学性质

采用传统熔融冷却的方法制备了透明Ni^2＋掺杂ZnO-Al2O3-SiO2系玻璃，结合X-射线、吸收和荧光等测试手段，研究了不同热处理温度对Ni^2＋掺杂透明ZnO-Al2O3-SiO2系微晶玻璃光学性质的影响。由X-射线衍射谱鉴定出微晶玻璃中析出的晶相为ZnAl2O4微晶，其尺寸在13nm以下。玻璃中没有发现近红外发光，而在微晶玻璃中存在宽带近红外发光，其可归属为八面体六配位Ni^2＋离子的^3T2g（^3F）激发态向^3A2g（^3F）基态的跃迁。随热处理温度升高发光强度增强，而发射峰位则发生蓝移；荧

LiNbO3：Fe：Ni晶体非挥发全息存储研究

采用三种不同的双光记录方案进行了LiNbO3：Fe：Ni晶体全息存储实验．详细研究了饱和衍射效率、固定衍射效率、动态范围和记录灵敏度，以及退火条件对记录的影响。结果表明，氧化LiNbO3：Fe：Ni晶体的饱和衍射效率、固定衍射效率和记录灵敏度比其他报道的双掺杂LiNbO3晶体高。结合掺杂能级图，理论分析了LiNbO3双掺杂晶体深陷阱中心能级的相对位置及其微观光学参量对全息记录性能的影响。LiNbO3：Fe：Ni晶体有望成为一种新的高效率非挥发全息存储材料。

敏化光波长对（Fe，Ni）：LiNbO3晶体全息记录性能的影响

分别采用514nm绿光、488nm蓝光和390nm紫外光作为敏化光，633nm红光作为记录光，详细研究了敏化光波长对氧化（Fe，Ni）：LiNbO3晶体全息记录性能的影响。结果表明：随着敏化光波长的逐渐减小，氧化（Fe，Ni）：LiNbO3晶体的非挥发全息记录性能逐渐优化，390nm紫外光是这三种敏化光中最优的敏化光。考虑敏化光的吸收，为了在双中心全息记录中获得最优的性能，应当选择合适波长的敏化光：一方面短波长敏化光能有效地敏化深中心；另一方面短波长敏化光的吸收太强（如对光折变效应无用的基质吸收），不能沿

Effect of wavelength of sensitizing light on holographic storage properties in LiNbO3 : Fe : Ni crystal

By sensitizing with 514 nm green light, 488 nm blue light and 390 nm ultraviolet light, respectively, recording with 633 nm red light, effect of wavelength of sensitizing light on holographic storage properties in LiNbO3:Fe:Ni crystal is investigated in detail. It is shown that by shortening the wavelength of sensitizing light gradually, nonvolatile holographic recording properties of oxidized LiNbO3:Fe:Ni crystal is optimized gradually, 390 nm ultraviolet light is the best as the sensitizing light. Considering the absorption of sensitizing light, to obtain the best performance in two-center holographic recording we must choose a sensitizing wavelength that is long enough to prevent unwanted absorptions (band-to-band, etc.) and short enough to result in efficient sensitization from the deep traps. So in practice a trade-off is always needed. Explanation is presented theoretically. (c) 2005 Elsevier GmbH. All rights reserved.

用MATLAB控制NI采集卡实现高精度数据采集与分析功能

本文结合测试分析光学一机械桁架悬臂结构的振动特性，为用MATLAB控制NI采集卡实现高精度数据采集与分析功能提供了实例参考，也为MATLAB控制其它高性能采集卡提供了有益的操作思路。

Synthesis, spectral, and thermal characterizations of Ni(II) and Cu(II) beta-diketone complexes with thenoyltrifluoroacetone ligand

Two kinds of nickel(II) and copper(II) P-diketone complexes derived from thenoyltrifluoroacetone ligand with blue-violet light absorption were synthesized by reacting free ligand and different metal(II) ions in sodium methoxide solution. Their structures were postulated based on elemental analysis, ESI-MS, FT-IR spectra and UV-vis electronic absorption spectra. Smooth films on K9 glass substrates were prepared using the spin-coating method. Their solubility in organic solvents, absorption properties of thin film and thermal stability of these complexes were evaluated. (c) 2006 Elsevier B.V. All rights reserved.