Preparation and electrical properties of new oxide ion conductors Ce6-xDyxMoO15-delta (0.0 <= x <= 1.8)

Ce6-xDyxMoO15-delta (0.0 <= x <= 1.8) were synthesized by modified sol-gel method. Structural and electrical properties were investigated by means of X-ray diffraction (XRD), Raman, X-ray photoelectron spectroscopy (XPS) and electrochemical impedance spectroscopy (EIS). The XRD patterns showed that the materials were single phase with a cubic fluorite structure. Impedance spectroscopy measurement in the temperature range between 350 degrees C and 800 degrees C indicated a sharp increase in conductivity for the system containing small amount of Dy2O3. The Ce5.6Dy0.4MoO15-delta detected to be the best conducting phase with the highest conductivity (sigma(t) = 8.93 x 10(-3) S cm(-1)) is higher than that of Ce5.6Sm0.4MoO15-delta (sigma(t) = 2.93 x 10(-3) S cm(-1)) at 800 degrees C, and the corresponding activation energy of Ce5.6Dy0.4MoO15-delta (0.994 eV) is lower than that of Ce5.6Sm0.4MoO15-delta (1.002 eV).

Improved optical photoluminescence by charge compensation in the phosphor system CaMoO4: Eu3+

It has been found that charge compensated CaMoO4:Eu3+ phosphors show greatly enhanced red emission under 393 and 467 nm-excitation, compared with CaMoO4:Eu3+ without charge compensation. Two approaches to charge compensation, (a) 2Ca(2+) -> EU3+ + M+, where M+ is a monovalent cation like Li+, Na+ and K+ acting as a charge compensator; (b) 3Ca(2+) -> 2EU(3+) + vacancy, are investigated. The influence of sintering temperature and Eu3+ concentration on the luminescent property of phosphor samples is also discussed.

Monte Carlo simulation of the compatibility of graft copolymer compatibilized two incompatible homopolymer blends: Effect of graft structure

Compatibility of graft copolymer compatibilized two incompatible homopolymer A and B blends was simulated by using Monte Carlo method in a two-dimensional lattice model. The copolymers with various graft structures were introduced in order to study the effect of graft structure on the compatibility. Simulation results showed that incorporation of both A-g-B (A was backbone) and B-g-A (B was backbone) copolymers could much improve the compatibility of the blends. However, A-g-B copolymer was more effective to compatibilize the blend if homopolymer A formed dispersed phase. Furthermore, simulation results indicated that A-g-B copolymers tended to locate at the interface and anchor two immiscible components when the side chain is relatively long. However, most of A-g-B copolymers were likely to be dispersed into the dispersed homopolymer A phase domains if the side chains were relatively short. On the other hand, B-g-A copolymers tended to be dispersed into the matrix formed by homopolymer B. Moreover, it was found that more and more B-g-A copolymers were likely to form thin layers at the phase interface with decreasing the length of side chain.

Evolution of the interfacial tension between polydisperse "immiscible" polymers in the absence and in the presence of a compatibilizer

The interfacial tension sigma between two polyisobutylenes (PIB) of dissimilar polydispersity and two polydisperse samples of poly(dimethylsiloxane) (PDMS) was measured as a function of time by means of a pendent drop apparatus at different temperatures ranging from 30 to 110 degreesC. In addition to three of the four possible binary blends, the time evolution of sigma was also determined for one ternary system, where the PIB phase contained 0.03 wt % of a diblock copolymer poly(isobutylene-b-dimethylsiloxane). The pronounced decrease of sigma with advancing time, observed in all cases, is attributed to the migration of the interfacially active lower molecular weight components of the homopolymers and of the compatibilizer into the interphase. Several days are normally required until a becomes constant. These time independent values are not considered as equilibrium data, but accredited to stationary states. A kinetic model is established for sigma(t), which enables a detailed investigation of the rates of transport of the different migrating species of average molar mass of M.

Syntheses of Ag, PbSe, and PbTe nanocrystals and their binary self-assembly exploration at low size-ratio

Nanocrystals of Ag, PbSe, and PbTe were prepared via a high-temperature organic solution approach, respectively. Using a size-selection technique, the size-distribution of each set of nanocrystals could be fine-tuned and finally monodisperse products were achieved. Superlattice structure of binary self-assemblies in low size-ratio were also explored and characterized by transmission electron microscopy. It is realized that a success of achieving binary self-assembly pattern is greatly dependent on several key factors including particle size-distributions, relative concentrations of both components, as well as the size-ratios between Ag and PbSe (or PbTe) nanocrystals.

Synthesis of 2-benzylthio-5-phenyl-3,4-disubstituted thiophenes by intramolecular condensation of alpha-oxo ketene dibenzylthioacetals

A facile route to 2-benzylthio-5-phenyl-3,4-disubstituted thiophenes was described. Catalyzed by sodium hydroxide, the title compounds were synthesized in moderate to good yields simply from the intramolecular aldol type condensation of alpha-oxo ketene dibenzylthioacetals. The chemical selectivity for this annulation reaction was studied and discussed.

Studies of methane reforming with carbon dioxide on hexaaluminates

In this paper, a series of Sr1-xLaxNiAl11O19 catalysts were synthesized and their chemical and physical properties were investigated by XRD, UV-DRS, H-2-O-2 titration, TPR and Py-IR techniques. The experimental results show that the Sr1-xLaxNiAl11O19 catalysts have a magnetoplumbite structure and Ni ion is shared between tetrahedral and octahedral sites of the spinel blocks, and the amount of nickel ions in the tetrahedral environment increases with the increase of x value in Sr1-xLaxNiAl11O19. The TPR study revealed that the reducibility of the series of the catalysts depends strongly on the substitution value x, that is, a low temperature peak appears for samples without substitution, in case of samples with x = 1 high temperature peak appears, and for samples with 0

六铝酸盐催化剂上甲烷与二氧化碳重整反应的研究

合成了具有磁铅石结构的Ｓｒ１－ｘＬａｘＮｉＡｌ１１Ｏ１９系列催化剂，并用ＸＲＤ、ＵＶ－ＤＲＳ、Ｈ２－Ｏ２滴定及Ｐｙ－ＩＲ等方法对其体相及表面性质进行了表征，考察了甲烷与二氧化碳重整反应活性及积炭性．结果表明，Ｌａ３＋离子能够同晶取代Ｓｒ２＋离子进入催化剂晶格内部，使催化剂的结晶度提高，还原性降低，同时降低了催化剂表面的酸性，有助于提高催化剂的抗积炭能力.

一种简易长光程可见紫外、圆二色薄层光谱电化学池

设计了一种简易实用的长光程薄层光谱电化学池,该池以10mm石英比色槽为光学窗,2块5×10×50mm的聚四氟乙烯块为电极支承体,玻碳片为工作电极,且薄层厚度可调。以K_3Fe(CN)_6和L-酪氨酸为工作体系进行光谱和电化学实验表明,该池具有良好的薄层电化学特征。对于水溶液,在大于220nm波长内给出良好的光谱和较快的光谱电化学响应,可方便地用于圆二色谱-电化学研究。

Assessing genetic identity of sporophytic offspring of the brown alga Undaria pinnatifida derived from mono-crossing of gametophyte clones by use of amplified fragment length polymorphism and microsatellite markers

The haploid stage of gametophytes of the subtidal brown alga Undaria pinnatifida can be vegetatively propagated under favorable conditions. This unique characteristic makes it possible to establish independent gametophyte cell lines that are zoospore-derived. Sporophytic offspring can be generated through hybridizing the male and female gametophytes, which are derived from different cell lines. Accumulated experiences in this and other species in Laminariales demonstrated the applicability of this novel way to breed desired strains for open-sea cultivation. Sporophytic offspring originated from mono-crossing of male and female gametophyte clones were shown to have similar morphological characteristics under identical ambient conditions. However, there has been no report to relate this similarity on molecular levels. In this report, amplified fragment length polymorphism (AFLP) and microsatellite markers were used to analyze the genetic identity of sporophytic offspring of U. pinnatifida originated from two mono-crossing lines (M1 and M2), two self-breeding lines (S1 and S2) and one wild population (W). Totally 318 AFLP loci were revealed by use of 11 primer sets, of which 4.7%, 0.3%, 17.9%, 16.4% and 36.5% were polymorphic in M1, M2, S1, S2 and W, respectively. The pairwise genetic identity among the individuals of the same line was assessed. It was shown that offspring from mono-crossing lines had a higher degree of identity (95.6-100%) than self-breeding lines (87.7-98.4%) and the wild population (81.5-92.1%). Analysis by use of six microsatellite loci also revealed a higher genetic identity among individuals of the mono-crossing line, further confirming the results of AFLP analysis. Results from this investigation support, on molecular levels, the novel way to produce and maintain strains in U. pinnatifida by use of different gametophyte cell lines.

Dibenzyl bromophenols with diverse dimerization patterns from the brown alga Leathesia nana

Six novel dibenzyl bromophenols (1-6) with different dimerization patterns and two propyl bromophenol derivatives (7 and 8), together with 11 known bromophenol derivatives, were isolated from the ethanolic extract of the brown alga Leathesia nana. On the basis of spectroscopic methods the structures of the new compounds were determined as 5,6'-diethyloxymethyl-3,4,2'-tribromo-2,3',4'-trihydroxydiphenyl ether (1), 2-(2,3-dibromo-4,5-dihydroxybenzyl)-3,5-dihydroxy-4-methoxybenzyl alcohol (2), 6-(2,3-dibromo-4,5dihydroxybenzyl)-2,3-dibromo-4,5-dihydroxy benzyl methyl ether (3), 9,10-dihydro-9,10-dimethoxy-3,4,7,8-tetrabromo-1,2,5,6-tetrahydroxyanthracene (4), (+)-3-(2,3-dibromo-4,5-dihydroxyphenyl)-4-bromo-5,6-dihydroxy-1,3-dihydroisobenzofuran (5), rel-(4aS*,10aR*)-(+/-)-6,7-dibromo-4a-hydroxy-3,8-dihydroxymethyl-10a-methoxy- 1,4,4a, 10a-tetrahydrodibenzo[b,e][1,4]dioxin-1-one (6), (E)-2-methyl-3-(2,3-dibromo-4,5-dihydroxyphenyl)propenal (7), and 2-methyl-3-(2,3-dibromo-4,5-dihydroxyphenyl)-1-propanol (8). Some compounds including 3 showed in vitro selective cytotoxicity against several human cancer cell lines. This is the first brown alga to be reported containing bromophenols.

Light energy conversion into H-2 by Anabaena variabilis mutant PK84 dense cultures exposed to nitrogen limitations

Concentrated cultures (25-86 mg Chl a l(-1)) of Anabaena variabilis PK84 were incubated under 99% Ar+1% CO2 atmosphere in the photobioreactor made of coaxial cylinders. Under illumination equal to 353 mu E m(-2) s(-1) they produced hydrogen with the rate more than 20 ml l(-1) h(-1) for several days. The efficiency of light energy conversion into H-2 was approx. 1% and did not depend significantly on initial Chl a concentration. H-2/O-2 ratio reached 41.5% of theoretical value for water photolysis. Data indicate that dense cultures might be used for outdoor systems under direct sun light. Supra-optimal temperatures 36 degrees C were not harmful for cultures even for 2 days period. Short-term incubation of cultures under 36 degrees C even increased H2 production rate and efficiency of light energy bioconversion by 1.25 times. (c) 2006 International Association for Hydrogen Energy. Published by Elsevier Ltd. All rights reserved.

过去5000年西太平洋副热带高压活动的泥炭纤维素碳同位素记录

文章以金川和红原两组泥炭纤维素Δδ13C 时间序列值的反向变化来指示西太平洋副热带高压活动变化。结果表明,在过去5 000 年中,西太平洋副热带高压的活动可分为4 个阶段,即西太平洋副热带高压位置在2800～2200 B. C. 期间持续偏北,2200～600 B. C. 期间持续偏南,600 B. C. ～ 1200 A.D. 期间在北进与南移之间频繁波动,以及1200 ～1900A. D. 期间再次持续偏北,它们导致降雨量在中国大陆上不同的分布。从约1900A. D. 起西太平洋副热带高压的活动似乎又开始一个新的偏南阶段,值得进一步加强研究。