激光淬火基体对镀铬层抵抗接触变形的影响

提出先激光离散淬火预处理基体后再镀铬的复合工艺,利用划痕仪沿垂直激光扫描方向对铬层表面进行接触载荷模拟实验.结果表明:激光淬火基体能够提高镀铬层抵抗接触变形能力.利用基体化学腐蚀法制备自由铬层和纳米硬度仪对初始镀铬层力学性质进行分析表明:激光淬火基体不但通过提高基体的硬度增强了电镀铬层抵抗接触变形能力,而且也提高了铬层自身的抵抗接触变形能力.

多环环间混杂复合材料飞轮离心应力分析

采用平面应力假设,给出了计算多环环间混杂复合材料飞轮的离心应力和初始极限转速的方法,并采用二维轴对称的有限元分析验证了计算方法的合理性,可作为初步设计多环环间混杂复合材料飞轮的依据.本文的算例分析还表明,无论单一纤维或混杂的复合材料飞轮,空心结构的初始极限转速和储能密度均高于相应的实心结构的结果;且对于空心结构,有利于通过选择合适的混杂方案,实现一定意义上的"等强度"设计.

Plastic Deformation Of Nanocrystalline Nickel

A high-resolution electron microscopy study has uncovered the plastic behavior of accommodating large strains in nanocrystalline (NC) Ni subject to cold rolling at liquid nitrogen temperature. The activation of grain-boundary-mediated-plasticity is evidenced in NC-Ni, including twinning and formation of stacking fault via partial dislocation slips from the grain boundary. The formation and storage of 60A degrees full dislocations are observed inside NC-grains. The grain/twin boundaries act as the barriers of dislocation slips, leading to dislocation pile-up, severe lattice distortion, and formation of sub-grain boundary. The vicinity of grain/twin boundary is where defects preferentially accumulate and likely the favorable place for onset of plastic deformation. The present results indicate the heterogeneous and multiple natures of accommodating plastic strains in NC-grains.

Study on the Capacity Degradation of Bucket Foundation in Liquefied Sand Layer under Cyclic Loads

The capacity degradation of bucket foundation in liquefied sand layer under cyclic loads such as equivalent dynamic ice-induced loads is studied. A simplified numerical model of liquefied sand layer has been presented based on the dynamic centrifuge experiment results. The ice-induced dynamic loads are modeled as equivalent sine cyclic loads, the liquefaction degree in different position of sand layer and effects of main factors are investigated. Subsequently, the sand resistance is represented by uncoupled, non-linear sand springs which describe the sub-failure behavior of the local sand resistance as well as the peak capacity of bucket foundation under some failure criterion. The capacity of bucket foundation is determined in liquefied sand layer and the rule of capacity degradation is analyzed. The capacity degradation in liquefied sand layer is analyzed comparing with that in non-liquefied sand layer. The results show that the liquefaction degree is 0.9 at the top and is only 0.06 at the bottom of liquefied sand layer. The numerical results are agreement well with the centrifugal experimental results. The value of the degradation of bucket capacity is 12% in numerical simulating whereas it is 17% in centrifugal experiments.

Active phase control and frequency chirp effects on supercontinuum generation in high birefringence photonic crystal fiber

An acoustic-optics programmable dispersive filter (AOPDF) was first employed to actively control the linearly polarized femtosecond pump pulse frequency chirp for supercontinuum (SC) generation in a high birefringence photonic crystal fiber (PCF). By accurately controlling the second order phase distortion and polarization direction of incident pulses, the output SC spectrum can be tuned to various spectral energy distributions and bandwidths. The pump pulse energy and bandwidth are preserved in our experiment. It is found that SC with broader bandwidth can be generated with positive chirped pump pulses except when the chirp value is larger than the optimal value, and the same optimal value exists for the pump pulses polarized along the two principal axes. With optimal positive chirp, more than 78% of the pump energy can be transferred to below 750 nm. Otherwise, negative chirp will weaken the blue-shift broadening and the SC bandwidth. (C) 2007 Elsevier B.V. All rights reserved.

全息位相差放大技术研究进展

位相差放大技术是提高位相分辨率和测量精度的一种手段,在干涉计量领域,可用来检测光学元件的微弱畸变和由于物场变化引起的系统位相的变化等.本文介绍了位相差放大基本原理和研究进展.

共焦扫描系统扫描深度与厚度失真分析

采用几何光学方法对共焦系统扫描时产生的扫描深度与厚度失真进行了理论分析，对名义扫描深度与实际扫描深度之间的关系进行了研究．以若丹明6G薄膜与玻片组成的多层样品为模型，对其进行了模拟计算，得到了扫描深度与厚度失真与系统数值孔径、折射率和样品厚度之间的关系．在实验上分别采用单光子荧光和双光子荧光作为检测信号，在反射式共焦扫描系统上进行了纵向扫描实验，并与模拟计算的结果进行了比较和分析．

用反射式达曼光栅产生飞秒激光双脉冲

采用反射式达曼光栅建立了一种产生飞秒激光双脉冲的新装置．由于采用反射式结构，避免了材料色散和吸收导致的脉冲畸变，并构建了一台二次谐波一频率分辨光学开关装置对产生的双脉冲进行了测量．实验结果表明可以实现脉冲强度相等、时间宽度相同、不同间隔的双脉冲输出．产生双脉冲的装置在飞秒激光领域有着应用的价值．

The effect of the rotating double-prism wide-angle laser beam scanner on the beam shape

In this paper, we describe a wide-angle laser beam scanner and the rigorous result of the wide-angle laser beam scanner was obtained with the help of the vector refraction theory. Using the rigorous results, the distortion of the beam shape was discussed. The distortion of the beam shape is varying with the different relative angles of the double prisms. According to the conservation of the energy, the distribution of the laser intensity is changed too. (c) 2005 Elsevier GmbH. All rights reserved.

Highly sensitive wave-front sensor with a non-zero-order phase plate

We propose a novel highly sensitive wave front detection method for a quick check of a flat wave front by taking advantage of a non-zero-order pi phase plate that yields a non-zero-order diffraction pattern. When a light beam with a flat wave front illuminates a phase plate, the zero-order intensity is zero. When there is a slight distortion of the wave front, the zero-order intensity increases. The ratio of first-order intensity to that of zero-order intensity is used as the criterion with which to judge whether the wave front under test is flat, eliminating the influence of background light. Experimental results demonstrate that this method is efficient, robust, and cost-effective and should be highly interesting for a quick check of a flat wave front of a large-aperture laser beam and adaptive optical systems. (c) 2005 Optical Society of America.

Composite second-order performance improvement in optical fibre CATV transmission system using chirped fibre grating

Theoretically, we analyse the dispersion compensation characteristics of the chirped fibre grating (CFG) in an optical fibre cable television (CATV) system and obtain the analytic expression of the composite second-order (CSO) distortion using the time-domain form of the field envelope wave equation. The obtained result is in good agreement with the numerical simulation result. Experimentally, we verify the result by making use of the tunable characteristics of CFG to change the dispersion compensation amount and obtain an optimal CSO performance in a 125km fibre transmission link. Both the theoretical and experimental results show that the CSO performance can be improved by properly choosing the dispersion compensation amount for a certain fibre transmission link.

Analysis of dispersion compensation for position-dependence in externally modulated CATV lightwave systems by using chirped fiber grating

The dispersion compensation characteristics of the chirped fiber grating (CFG) for different dispersion compensation positions are analyzed in externally modulated cable television (CATV) lightwave system and the analytic expression of the composite second order (CSO) distortion is derived. The analyses give a reasonable explanation for the position-dependent effect of CFG dispersion compensator, which was found in practical systems. Moreover, the theoretical result is also verified by an experiment. It is believed that the theory will be helpful in designing optical CATV fiber links with nodes at proper positions both for intensity amplification and dispersion compensation.

基于频域相位共轭技术的交叉相位调制所致失真的复原

理论分析和讨论了基于频域相位共轭技术的交叉相位调制所致信号失真的复原和补偿机理，数值模拟了在交叉相位调制作用下，高斯脉冲在中距相位共轭光纤系统中的传输演化过程．结果表明，频域相位共轭技术能够抑制交叉相位调制对光纤系统中传输信号的损害，复原其所导致的信号失真，并能够同步补偿群速度色散和自相位调制非线性效应所导致的信号失真．合适的初始脉冲时延和初始脉冲啁啾有利于频域相位共轭技术对交叉相位调制所致信号失真的抑制．

自陡峭效应对相位共轭系统脉冲传输的影响

光学相位共轭(OPC)技术能够同时且高效地补偿光纤传输过程中色散及非线性效应所导致的信号失真，且该技术同脉冲调制方式无关。从理论上分析了在自陡峭效应(SS)作用下高斯脉冲信号在中距相位共轭系统中的传输演化特性，数值模拟了在其作用下超短飞秒高斯脉冲的动态传输过程，讨论了自陡峭效应对中距相位共轭系统复原性能的影响。结果表明自陡峭效应将导致高斯脉冲信号发生峰值漂移和脉冲后沿变陡，相位共轭系统不能补偿由此导致的脉冲失真和畸变。引入合适的色散可以减小这种信号失真，并使得相位共轭系统能够同时补偿由于色散、自相位调制和

Three-dimensional coupled wave study for finite-sized anisotropic volume holographic gratings under ultrashort pulsed beam readout

The three-dimensional coupled wave theory is extended to systematically investigate the diffraction properties of finite-sized anisotropic volume holographic gratings (VHGs) under ultrashort pulsed beam (UPB) readout. The effects of the grating geometrical size and the polarizations of the recording and readout beams on the diffraction properties are presented, in particular under the influence of grating material dispersion. The wavelength selectivity of the finite-sized VHG is analyzed. The wavelength selectivity determines the intensity distributions of the transmitted and diffracted pulsed beams along the output face of the VHG. The distortion and widening of the diffracted pulsed beams are different for different points on the output face, as is numerically shown for a VHG recorded in a LiNbO3 crystal. The beam quality is analyzed, and the variations of the total diffraction efficiency are shown in relation to the geometrical size of the grating and the temporal width of the readout UPB. In addition, the diffraction properties of the finite-sized and one-dimensional VHG for pulsed and continuous-wave readout are compared. The study shows the potential application of VHGs in controlling spatial and temporal features of UPBs simultaneously. (C) 2007 Optical Society of America