Preliminary study of a niobium quarter-wave prototype cavity for a heavy-ion superconducting linac

Superconducting quarter-wave resonators, due to their compactness and their convenient shape for tuning and coupling, are very attractive for low-beta beam acceleration. In this paper, two types of cavities with different geometry have been numerically simulated: the first type with larger capacitive load in the beam line and the second type of lollipop-shape for 100 MHz, beta=0.06 beams; then the relative electromagnetic parameters and geometric sizes have been compared. It is found that the second type, whose structural design is optimized with the conical stem and shaping drift-tube, can support the better accelerating performance. At the end of the paper, some structural deformation effects on frequency shifts and appropriate solutions have been discussed.

番茄专用肥肥效初步研究

番茄专用肥肥效初步研究刘子江，崔桂霞，武冠云（中国科学院沈阳应用生态研究所）赵彩霞，张玉兴王述麟，王阳（沈阳市于洪区畜牧副食局）（沈阳市东陵区畜牧副食局）随着农业生产的发展和科学施肥技术的实施，专用肥的应用愈来愈广泛。专用肥的使用效果，是肥料研究领域...

黄土高原南部3种农田土壤剖面坚实度的变化规律

为了揭示黄土高原南部地区不同质地类型土壤剖面坚实度的变化及其与土壤含水率的定量关系,以黄墡土、土娄土、裸露在地表的粘化层耕作剖面为研究对象,定位观测其0~45 cm土壤坚实度与含水率的变化。结果表明,黄墡土、土娄土、裸露在地表粘化层耕作剖面的犁底层平均坚实度均大于耕层,犁底层平均坚实度较耕层分别高194.8%,87.3%,10.4%;剖面土壤质地越粘其平均坚实度越大;土壤坚实度与含水率呈负相关关系;土壤坚实度变化速率为0时,以上3种土壤剖面临界含水率分别为0.1712,0.1757,0.1835;质地不同的土壤剖面坚实度时空变化特征有差异,其中黄墡土剖面0~20 cm土层土壤坚实度为350~500 kPa,受土壤含水率变化的影响较小;20~30 cm土层土壤的坚实度为500~1400 kPa,不易受外界环境影响;30 cm以下土层土壤坚实度为700~1600 kPa,受土壤含水率变化影响较大。土娄土剖面0~40 cm土层土壤坚实度为600~1200 kPa,受含水率变化影响较大;40 cm以下土层土壤坚实度稳定在1 800 kPa左右。粘化层剖面0~15 cm土层土壤坚实度在2000 kPa左右,受环境影响较...

Electrochemical impedance detection of DNA hybridization based on dendrimer modified electrode

Bioactive ultrathin films with the incorporation of amino-terminated G4 PAMAM dendrimers have been prepared via layer-by-layer self-assembly methods on a gold electrode and used for the DNA hybridization analysis. Surface plasmon resonance (SPR), X-ray photoelectron spectroscopy (XPS), and electrochemical impedance spectroscopy (EIS) are used to characterize the successful construction of the multicomponent film on the gold substrate. The dendrimer-modified surfaces improve the immobilization capacity of the probe DNA greatly, compared to the AET (2aminoethanethiol) SAM sensor surfaces without dendrimer molecules. DNA hybridization analysis is monitored by EIS. The dendrimer-based electrochemical impedance DNA biosensor shows high sensitivity and selectivity for DNA hybridization assay. The multicomponent films also display a high stability during repeated regeneration and hybridization cycles.

Synthesis and characterization of white-light-emitting polyfluorenes containing orange phosphorescent moieties in the side chain

Two orange phosphorescent iridium complex monomers, 9-hexyl-9-(iridium (III)bis(2-(4'-fluorophenyl)-4-phenylquinoline-N, C-2')(tetradecanedionate-11,13))-2,7-dibromofluorene (Br-PIr) and 9-hexyl-9-(iridium(III)bis(2-(4'-fluorophenyl)-4-methylquinoline-N, C-2')(tetradecanedionate-11,13))-2,7-dibromofluorene (Br-MIr), were successfully synthesized. The Suzuki polycondensation of 2,7-bis(trimethylene boronate)-9,9-dioctylfluorene with 2,7-dibromo-9,9-dioetylfluorene and Br-Plr or Br-MIr afforded two series of copolymers, PIrPFs and MIrPFs, in good yields, in which the concentrations of the phosphorescent moieties were kept small (0.5-3 mol % feed ratio) to realize incomplete energy transfer. The photoluminescence (PL) of the copolymers showed blue- and orange-emission peaks. A white-light-emitting diode with a configuration of indium tin oxide/poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate)/PIr05PF (0.5 mol % feed ratio of Br-PIr)/Ca/Al exhibited a luminous efficiency of 4.49 cd/A and a power efficiency of 2.35 lm/W at 6.0 V with Commission Internationale de L'Eclairage (CIE) coordinates of (0.46, 0.33). The CIE coordinates were improved to (0.34, 0.33) when copolymer MIr10PF (1.0 mol % feed ratio of Br-MIr) was employed as the white-emissive layer. The strong orange emission in the electroluminescence spectra in comparison with PL for these kinds of polymers was attributed to the additional contribution of charge trapping in the phosphorescent dopants.

Soluble 2,5-dimercapto-1,3,4-thiadiazole/poly(o-toluidine) electroactive composite

A poly(o-toluidine) (POT)/2,5-dimercapto-1,3,4-thiadiazole (DMcT) composite was prepared. When POT and DMcT are mixed in a proper solvent, POT in a medium-oxidation state is reduced, and DMcT in turn is oxidized to its soluble dimer when the molar ratio of DMcT to POT is higher than 0.5. Therefore, the composite was soluble in organic solvents such as tetrahydrofuran (THF), dimethylformamide (DMF), and N-methyl-2-pyrrolidone (NMP) and exhibited very high electroactivity, two orders of magnitude higher than that of pure POT and three orders of magnitude higher than that of pure DMcT. Molecular-level contact between POT and DMcT is the reason for the improved catalytic effect of POT on DMcT, compared to that of polyaniline on DMcT. (C) 1999 The Electrochemical Society. S0013-4651(98)08-059-8. All rights reserved.

Cure processing modeling and cure cycle simulation of epoxy-terminated poly(phenylene ether ketone) .4. Cure cycle simulation

Epoxy-terminated poly(phenylene ether ketone) (E-PEK) developed in this Institute is a candidate matrix resin for polymer composites as structural materials. Cure cycles for this reaction system were simulated according to the previously established processing model. It is found that for the E-PEK system, the curing process is best completed by a stepwise cure cycle comprising two isothermal processes at different temperatures, T-1 and T-2. The cure cycles over a wide range of processing parameters simulated, based on the established processing model, indicate that the processing window is width-adjustable. Analysis of the mechanical properties of the composite sheets showed that the simulated cure cycles are acceptable and reliable. (C) 1997 John Wiley & Sons, Inc.

有限线性扩散区域内EC＇反应催化电流

有限线性扩散区域内ＥＣ＇反应催化电流吴志斌，董绍俊，吴浩青（同济大学化学系，上海，２０００９２）（中国科学院长春应用化学研究所）（复旦大学化学系）关键词有限线性扩散空间，ＥＣ＇反应，催化电流化学修饰电极等有关膜电极及薄层池的电极过程动力学问题均涉及到...