紫花苜蓿和短花针茅根系分布与土壤水分研究

以陕北农牧交错带人工草种紫花苜蓿(Medicago sativa L.)和天然草种短花针茅(Stipa breviflora Griseb.)为对象,采用根钻法调查两个草种的根系垂直分布以及刈割后苜蓿根系变化特征,并通过定位观测研究土壤水分动态变化。结果表明:紫花苜蓿和短花针茅根系密度随土壤深度增加而减少,而且均以直径小于等于1 mm的须根为主;0~50 cm土层紫花苜蓿和短花针茅根系量分别占0~100 cm剖面总量的67%和84%。紫花苜蓿和短花针茅根系分布与土壤水分消耗特征吻合。生长旺盛期苜蓿大量消耗0~140 cm土层土壤水分,5-9月平均有效土壤储水不足10 mm;生长季末深层(140~280 cm)土壤储水也逐渐降低,约为裸地储水量的50%。短花针茅0~280cm剖面土壤水分状况明显好于苜蓿地,比苜蓿地多储水100 mm左右;主要消耗浅层(0~50 cm)土壤水分,深层水分利用较少。

岷江上游土地利用/覆被变化及其驱动力

岷江上游具有自然环境的复杂性、生态系统的脆弱性、经济发展的边缘性、社会文化的过渡性等特性,其土地利用/土地覆盖变化的特点可以代表我国西南山地土地资源及利用中所存在的普遍问题.林地和草地是岷江上游地区的主要土地利用类型.从1974~2000年间各个土地利用类型均发生了不同程度的变化,林地面积持续减少,其它类型面积均有不同程度的增加.类型间的面积变化均为双向,主要发生在有林地、灌木林地、经济林地、草地、居民用地和耕地之间,且主要在林地和草地两个类型之间.其中1974~1986年的变化大于1986~2000年.人口和经济是该区土地利用变化的主要驱动因素.自实施天然林保护工程和退耕还林还草工程以来,该区土地利用状况有所好转,正在向好的方向发展.

沈阳城市森林常见树种的物候特征

城市绿化树种的物候配置是城市园林的一个重要组成部分。本文以沈阳城市森林常见树种为对象,利用6年的物候观测数据,绘出了28种主要乔灌木的物候谱。分析各物候现象之间关系,将其划分成4大组:萌动展叶现象组、叶变色现象组、落叶现象组和花果现象组;并根据叶变色和开花早晚对其进行聚类分组,为城市森林树种选择、树种组成和效益评价,提供科学依据。

植物固沙工程对土壤生物活性的影响

通过采集半流动沙丘、5年、10年和22年生小叶锦鸡儿人工固沙植被的土壤样品,对各类型土壤的养分状况、微生物和主要土壤酶活性进行对比研究。土壤按5层取样:0～10,10～20,20～30,30～40,40～50cm。结果表明,采用植物固沙工程固定沙丘后,表层土壤(0～10cm)有机C和全N含量显著增加,同时土壤生物活性也大幅度提高,土壤微生物生物量C和N的含量以及土壤脲酶、蔗糖酶、磷酸单酯酶和多酚氧化酶活性均明显提高。这种改良效应随着年龄增长而逐渐增加。土壤微生物生物量C与土壤总有机C含量,微生物生物量N与土壤全N之间均存在着明显的正相关性。

Preparation and characterization of cationic corn starch with a high degree of substitution in dioxane-THF-water media

Cationic corn starch derivatives with a high degree of substitution are prepared in alkaline solution or in mixed media of organic solvent and water with different levels of the cationic reagent, 2,3-epoxypropyltrimethylammonium chloride. The starch cationization yield is investigated, and the results indicate that the degree of substitution (DS) of the samples depends on the reaction conditions and reaction media. The maximum DS values are up to 1.37 in 1,4-dioxane alkali ne-aqueous solution. Meanwhile, the structures of the cationic starch derivatives are characterized by elemental analyses, FTIR spectroscopy, X-ray diffraction, and C-13 NMR spectroscopy, as well as by SEM techniques.

Synthesis, structure and optical properties of different dimensional organic-inorganic perovskites

By varying the substituent position of aminomethyl on pyridine ring in acid solution, different dimensional lead bromide frameworks ranging from zero-dimension and one-dimension to two-dimension were obtained. 2-(Aminomethyl)pyridine (2-AMP) or 3-(aminomethyl)pyridine (3-AMP) and PbBr2 construct hybrid perovskites, of which (H(2)2-AMP)PbBr4 (1) exhibits two-dimensional perovskite sheets with special hydrogen bonds and (H(2)3-AMP)PbBr6 (2) shows an uncommon zero-dimensional inorganic framework with isolated octahedra. The characteristic exciton peaks in absorption spectra are located at 431 nm for compound 1 and at 428 nm for compound 2. (H(2)4-AMP)PbBr4 (3) with one-dimensional zigzag edge-sharing octahedral PbBr(4)(2-)chains can be obtained using 4-(aminomethyl)pyridine (4-AMP) as organic component under the same experimental conditions as those for 2-AMP and 3-AMP.

Electrochemical properties of amorphous and icosahedral quasicrystalline Ti45Zr35Ni17Cu3 powders

Ti45Zr35Ni17Cu3 amorphous and single icosahedral quasicrystalline powders were synthesized by mechanical alloying and subsequent annealing at 855 K. Microstructure and electrochemical properties of two alloy electrodes were characterized. When the temperature was enhanced from 303 to 343 K, the maximum discharge capacities increased from 86 to 329 mAh g(-1) and 76 to 312 mAh g(-1) for the amorphous and quasicrystalline alloy electrodes, respectively. Discharge capacities of two electrodes decrease distinctly with increasing cycle number. The I-phase is stable during charge/discharge cycles, and the main factors for its discharge capacity loss are the increase of the charge-transfer resistance and the pulverization of alloy particles. Besides the factors mentioned above, the formation of TiH2 and ZrH2 hydrides is another primary reason for the discharge capacity loss of the amorphous alloy electrode.

Studies of non-covalent protein complexes by MALDI methods

Several specific non-covalent protein complexes were successfully observed by matrix assisted desorption ionization mass spectrometry(MALDI MS). The methods described in this paper include the matrixes use of sinapinic acid(SA) and 6-aza-2-thiothymine (ATT) in neutral pH solution, as well as the improvement of two-layer sample preparation method to achieve a high sensitivity detection of stable non-covalent complexes, Myoglobin-heme complex was found simultaneously with the sinapinic acid matrix in the various pH solution(pH=2 or pH=5), The RNase S complex showed a striking intensity at the first shot, which was decreased with more laser shots. Most importantly, the observation of specific non-covalent complex in the brome mosaic virus(BMV) coat proteins would open up a new possibility to investigate the assembly and disassembly of viral capsids.

MALDI方法研究蛋白质的非共价复合物

飞行时间质谱仪(TOFMS)在理论上无质量范围的限制，可实现大分子蛋白质与核酸的非共价复合物的直接检测．特别是在近中性溶液条件下通过对芥子酸和6-氮杂-2-硫代胸腺嘧啶基质的使用及双层样品制备方法的改善，获得了稳定复合物的高灵敏度质谱检测．肌红蛋白-血红素复合物能够在芥子酸基质的不同PH条件下(PH2.0或PH5.0)同时观察到．而运用双层样品制备方法，获得了核糖核酸酶复合物(RnaseS)在第一次激光照射下的突出质谱峰，但其丰度均随更多的激光打击而减弱

Reactivity of Pt/Al2O3 and Pt/CeO2/Al2O3 catalysts for partial oxidation of methane to syngas

The ceria modified Pt/CeO2/Al2O3 and Pt/Al2O3 catalysts were studied in the partial oxidation of methane to syngas. The SEM, XRD, TPR and TPD techniques were used for the catalyst characterization. The addition of ceria could enhance the Pt dispersion and decrease the Pt crystallise size; the activity and selectivity of catalyst for partial oxidation were improved significantly, and the methane total oxidation was suppressed sharply. The ceria effect was also discussed in a detailed way.

Synthesis and luminescence characteristics of LiMgAlF6:Ln(3+) (Ln = Ce, Eu, Tb)

By solid state reaction, LiMgAlF6 and LiMgAlF6:Ln(3+) are synthetized with the ratio 120/100/110 of LiF/MgF2/AlF3, at 1008 K, in high-purity Ar stream. Their crystal structure which belongs to hexagonal system are determined by X-Ray-Diffraction (XRD). Luminescence characteristics of Ce3+, Eu3+, Tb3+ and sensitization of Ce3+ to Tb3+ in LiMgAlF6 are studied. It is shown that the sensitization of Ce3+ to Tb3+ is efficient and a bright green emission is observed.