Extremely active catalysts for the hydrogenation of terminal alkenes

Titanocene complexes combined with nanometer-size sodium hydride are extremely active and selective catalysts for the hydrogenation of terminal alkenes under normal pressure. The initial turnover frequencies (TOFinitial) may reach 100-300 s(-1) in the hydrogenation of 1-hexene. The highest catalytic efficiency turnover (TO) reaches 1.5 x 10(5) in 2 h for the hydrogenation of styrene. These catalytic systems exhibit specific selectivity toward alkene substrates. Only terminal alkenes can be hydrogenated. No isomerization of carbon-carbon double bonds occurs during hydrogenation. A suitable substituent on the cyclopentadienyl ring of titanocene and the use of nanometric sodium hydride are key factors in the high efficiency of these catalytic systems. (C) 2002 Elsevier Science.

Highly enantioselective resolution of terminal epoxides using polymeric catalysts

Poly-salen-Co(III) complexes were employed in the hydrolytic kinetic resolution (HKR) of terminal epoxides and ee's up to 98% were obtained. In the HKR of epichlorohydrin, the polymeric catalysts can be recovered and modified for recycling. The recovered polymer catalyst shows good activity and selectivity. (C) 2002 Elsevier Science Ltd. All rights reserved.

An in-situ modified sol-gel process for monolith catalyst preparation used in the partial oxidation of methane

An in-situ modified sol-gel method for the preparation of a Ni-based monolith-supported catalyst is reported. With the presence of a proper amount of plasticizer and binder, and at an optimized pH value, the stable boehmite sol was modified with metal ions (Ni, Li, La) successfully without distinct growth of the particle size. Monolith-supported Ni-based/gamma-Al2O3 catalysts were obtained using the modified sol as the coating medium with several cycles of dip-coating and calcination. Combined BET, SEM-EDS, XRD and H-2-TPR investigations demonstrated that the derived monolith catalysts had a high specific surface area, a relatively homogeneous surface composition, and a high extent of interaction between the active component and the support. These catalysts showed relatively stable catalytic activities for partial oxidation of methane (POM) to syngas under atmospheric pressure. The monolith catalysts prepared by this sol-gel method also demonstrated an improved resistance to sintering and loss of the active component during the reaction process.

Templateless synthesis of catalysts with narrow mesoporous distribution

In this study, amorphous silica-alumina nanomaterials with narrow mesoporous distribution can be obtained by two novel sol-gel processes, without the use of any templates. The results of our experiments show that the preparation method has a great influence on the precursor sol structure as well as the specific surface area and mesopore volume of the final product, but has no effect on the pore size distribution.

FTIR study of CO and NO adsorbed on nitrided CoMo/Al2O3 catalysts

The states of surface Co and Mo sites on nitrided CoMo supported on Al2O3 were studied by adsorption of CO and NO as IR probe molecules. Three IR bands at 2200, 2060 and 2025 cm(-1) were detected for adsorbed CO. These bands can be respectively attributed to the surface NCO species as a result of CO adsorbed on surface N sites, and linearly adsorbed CO on surface Co and Mo sites in low valence states. The addition of cobalt to the Mo nitride diminishes the band at 2200 cm(-1). This may be due to either the change of the surface structure of the supported nitride, or the formation of a new phase, CoxMoyNz, as suggested in the literature Kim et al., Catal. Lett., 1997, 43, 91 and Logan et al., Catal. Lett., 1998, 56, 165. Comparison of CO and NO adsorption on Mo2N/Al2O3 and CoMoNx/Al2O3 indicates that the presence of cobalt can promote the reduction and nitridation of Mo.