A HIGH-RESOLUTION SOLID-STATE NMR-STUDY OF THE MISCIBILITY, MORPHOLOGY, AND TOUGHENING MECHANISM OF POLYSTYRENE WITH POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

An extended Goldman-Shen pulse sequence was used to observe indirectly the proton spin diffusion in the blends of polystyrene (PS) with poly(2,6-dimethyl-1,4-phenylene oxides) (PPO). The results indicate that the average distance between PS and PPO is less than 5 angstrom in the intimately mixed phase, but there are heterogeneous domains on a 100-angstrom scale. The data of spin relaxation of carbons, T1(C), for homopolymers and their blends suggest that there is a strong pi-pi electron conjugation interaction between the aromatic rings of PS and those of PPO, while the aromatic rings of PPO drive the aromatic rings of PS to move cooperatively. It is the cooperative motion that markedly improves the impact strength of PS.

SYNTHESIS AND X-RAY CRYSTAL-STRUCTURE OF [EU(ETA-6-C6ME6)(ALCL4)2]4 - THE 1ST CYCLOTETRAMERIC LANTHANIDE(II) COMPLEX WITH A NEUTRAL PI-LIGAND

The reaction of EuCl3, AlCl3 and C6Me6 in toluene gives the Eu(II) complex [Eu(eta-6-C6Me6)(AlCl4)2]4; X-ray crystal determination shows the molecule to be a cyclotetramer, in which the four Eu(C6Me6)AlCl4 units are connected via four groups of eta-2-AlCl4.

尼龙6,6(PA_(6,6)及其共混物结晶性能的研究

尼龙6,6(PA_(6,6))是一种典型的结晶性工程塑料,被广泛应用于纺织、机械制造等行业,但其加工温度范围较窄,耐热性差。聚醚砜(PES)具有较高的玻璃化转变温度,是非晶聚合物,可以诱发某些结晶聚合物结晶。PES与PA_(6,6)共混体系的研究报道较少,本文用熔融法将PES与PA_(6,6)制成共混物,企图改善PA_(6,6)的结晶性,以提高其耐热性,取得了较理想的结果。

非晶高聚物对聚(ε-己内酯)在其与苯乙烯-丙烯腈共聚物相容共混物中球晶生长速率的影响

本文研究了聚(ε-己内酯)(PCL)在其与苯乙烯-丙烯腈共聚物(SAN)的相容共混物中球晶生长速率与共混组成和结晶温度的关系.发现聚己内酯的球晶生长速率随着SAN的含量增加而下降.由于PCL与SAN是相容共混物,因此在用二次成核动力学方程描述PCL球晶生长速率时,我们引进了相互作用参数X.结果由共混体系的结晶动力学方程计算到的X值与由平衡熔点下降方法计算到的X_(23)值是相同的;而PCL晶体的折叠表面自由能则随着SAN含量的增加而下降.这些结果说明非晶高聚物SAN有碍于PCL球晶的生长.

WATER-SOLUBLE AND AMPHIPHILIC POLYMERS .6. A STUDY ON THE SURFACE-COMPOSITION OF CAST FILMS OF PST/PMAA AND PEO-PST-PEO BLOCK POLYMERS BY XPS

Thin films of PSt/PMAA and PEO-PSt-PEO block polymers were deposited on a polystyrene substrate by solution adsorption (with or without solvent treatment), and the film surfaces were characterized by means of XPS. Direct solvent - casting of PEO-PSt-PEO from benzene solutions resulted in PSt-rich surfaces, whereas PMAA richer surfaces were obtained for PSt/PMAA films cast from DMF solutions. Moreover, solvent treatment after casting had profound effect on the film surface composition. Treatment with water markedly increased the surface concentration of polar PEO segments. In the case of PSt-PMAA block polymers, the PSt content on the surface increased in the order of water < ethanol < cyclohexane < petroleum ether, the last-named giving films with almost pure PSt surface. It is well worth noticing that the bulk composition had little to do with the surface composition for both PSt/PMAA and PEO-PSt-PEO block polymers within the composition range investigated when subsequent solvent treatment was applied.

COMPATIBILIZING EFFECT OF POLY(ETHYLENE OXIDE)-B-POLYSTYRENE-B-POLY(ETHYLENE OXIDE) IN PHENOLPHTHALEIN POLY(ETHER ETHER KETONE) POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

The morphology and mechanical behaviour of phenolphthalein poly(ether ether ketone) (PEK-C)/poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) blends has been investigated. A poly(ethylene oxide)-b-polystyrene-b-poly(ethylene oxide) (PEO-PS-PEO) triblock copolymer was used as compatibilizer. It was found that PEO-PS-PEO has a compatibilizing effect on the PEK-C/PPO blends. The addition of PEO-PS-PEO to the blends greatly improves phase dispersion and interfacial interfacial adhesion and also enhances the ultimate tensile strength and Young's modulus at compositions ranging from 30 to 70% PEK-C. However, all the values of the ultimate tensile strength within the whole composition range are lower than those expected by simple additivity, probably owing to the poor mechanical properties of PEO-PS-PEO copolymer.

η~6—芳烃希土有机配合物的合成、结构及性能研究——Ⅰ.Sm(η~6—C_6H_6)(AlCl_4)_3的合成及晶体结构

经过铝粉加热活化的AlCl_3与SmCl_3在苯中反应,得到了Sm(η~6—C_6H_6)(AlCl_4)_3·C_6H_6单晶.其晶体属于三斜晶系,P1空间群,晶胞参数a=9.456(2)(?),b=9.765(3)(?),c=16.776(4)(?),α=96.00(2)°,β=93.76(2)°,γ=111.66(2)°,V=1422.55(?)~3,Z=2.晶体结构是采用Patterson和Fourier合成法解出的,所有非氢原子的坐标及各向异性热振动参数经块矩阵最小二乘法修正,最后偏离因子R=0.031,R_ω=0.035.分子结构中,中心离子Sm(Ⅲ)与六个Cl原子及一个苯环上的六个C原子成键.Sm-C键平均距离2.92(?),Sm-Cl平均距离2.83(?).与希土相连的六个Cl原子,其中之五构成平面五边形,整个分子呈大致的五角双锥形.

XPS STUDY OF CORROSION BEHAVIOUR OF TITANIUM IN H2C2O4 SOLUTION

The corrosion behaviour of titanium substance and the XPS characterization of Ti surface in the H2C2O4 solution have been first studied by X-ray photoelectron spectroscopy, The experimental results show that there am mile Ti-2 and Ti2+ on sample surface in 10% H2C2O4 solution for two boars corrosion at 80 degrees C, but if corrosion is extended to 4 hones, the surface composition is mainly TiO2 with a small amount of Ti2+. This result corresponds to the structure of TiH1.642 composion in sample surface found by XRD analysis. Since bath TiO2 and the surface coating RuO2 are of Gald-Redstone structure, therefore electrode materials of Ti-Ru are stable in chemical industry.

聚甲基丙烯酸甲酯辐射裂解和消旋的空间立构效应

本文研究了三种不同空间立构聚甲基丙烯酸甲酯的辐射效应,提出裂解过程是一种裂解与重合的动态平衡过程。分子量降低和消旋作用对温度的依赖性,是由于分子运动和笼罩效应以及重合的空间位阻效应所致。辐照温度愈高,裂解产额愈大。相同条件下辐照,全同立构比无规立构试样的裂解产额更大。 全同立构聚甲基丙烯酸甲酯辐照后,不仅分子链断裂,而且空间立构也发生很大变化。随着辐照剂量的增加,全同立构含量逐渐减少,而无规立构含量和间同立构含量却逐渐增加。

中性Ⅱ配体稀土有机配合物Sm(η~6(CH_3)_2C_6H_4)(η~2AlCl_4)_3的合成及晶体结构

中性Π配体过渡金属,特别是钛的有机配合物的合成和结构已有较深入的研究。但是含中性Π配体的稀土有机配合物的合成研究刚刚开始。1986年,Cotton等人报道了第一个这种类型的配合物Sm(η~6C_6Me_6)(η~2AlCl_4)_3。研究中性π配体稀土有机配合物的合成、结构及性能,对于揭示f元素的成

钛在草酸溶液中腐蚀行为的XPS研究

本文首次用X-光电子能谱(XPS)技术研究了H_2C_2O_4溶液中钛基的腐蚀行为,对Ti基片的表面和界面进行了XPS表征.实验结果表明:Ti基在80℃,10%的草酸溶液中腐蚀两小时,样品的表面只有Ti~0和TiO存在;经过四小时腐蚀的样品表面主要是TiO_2和少部分Ti~(2+).这与X-衍射分析认为有TiH_(1.042)的结构看法相符。同时,Ti0_2与表面涂层RuO_2都属金红石型结构,因而完全有可能形成牢固的金属阳极材料。