THE CATALYTIC BEHAVIOR AND REACTION-MECHANISM OF THE BI-CE-O SYSTEM CATALYSTS IN THE OXIDATIVE DEHYDROAROMATIZATION OF PROPYLENE

Oxidative dehydroaromatization of propylene was investigated by the pulse technique over two kinds of single oxide catalysts. With the Bi2O3 catalyst, the main dimer product was 1,5-hexadiene, and the dimerization activity was stable to pulse number even if the catalyst was partly reduced to the bulk. With the CeO2 catalyst, benzene was mainly formed instead of 1,5-hexadiene, but the activity decreased rapidly with increasing pulse number, indicating that only the lattice oxygen near the catalyst surface could be used for oxidative dimerization and the further aromatization. The Bi-Ce-O system catalyst was found in this study to give higher aromatization activity and showed better stability, compared to the Bi-Sn-O catalyst. Although the Bi-Ce-O catalyst was only a mixture of the two component oxides from X-ray diffraction analysis, there was a significant combination effect on the selectivity to benzene. The highest and the most stable selectivity of benzene was obtained at Bi/Ce = 1. In the TPD spectrum of Bi-Ce-O catalyst, there are not only the lattice oxygen (beta-oxygen) over 620-degrees-C due to the reduction of Bi2O3, but also a great deal of the alpha-oxygen desorbed about 400-degrees-C, which is considered the absorbed oxygen in the bulk. This absorbed oxygen could probably be a compensation of the lattice oxygen through the route of gaseous --> absorbed --> lattice oxygen in the binary catalyst system. By the kinetic study on the Bi-Ce-O catalyst, the dimer formation rate was the first-order with respect to the partial pressure of propylene and zero-order of oxygen. Although detail investigation would be made further, it was considered that the complete oxidation of propylene would mainly take place parallelly on some different sites, and the rate-determining step of propylene dimerization occurred probably between an adosrbed propylene and a gaseous one by an Eley-Rideal type mechanism.

Determination of Rate Constants of Catalytic Reaction by Spectroelectrochemistry with Microelectrodes

The at constants of catalytic reaction of ferrocyanide ascorbic acid and ferro cyanide histidine system were determined by transmitted spectroelectrochemistry using a group of cyclindrical microelectrodes, It is the first time to find that the reaction can still be considered as the pseudo first order reaction when tilt concentration of ascorbic acid or histidine is close to and even slightly lower than the concentration of ferrocyanide. The determined rate constants are in agreement with the reported values, A reasonable explanation was given,

STUDY OF THE CHLORINATION REACTION OF Li2CO3 WITH NH4Cl

The chlorination reaction of Li2CO3 with NH4Cl has been studied in detail by a series of thermal analysis methods. When NH4Cl/Li2CO3 mole ratio equals 4, Li2CO3 can be transformed into LiCl quantitatively in a stream of Ar gas flow. All residual NH4Cl is decomposed completely at 400 degrees C and carried away from the reaction cell by Ar gas.Analysis by X-Ray diffraction and Ion Chromatography show that there are almost no NH4Cl remained in The LiCl product. It is interested that the chlorination reaction can be applied to the determinations of phase diagram by thermal analysis method and the preparation of Al-Li alloy by electrolysis in molten salt.

DIELS-ALDER REACTION CATALYZED BY RARE-EARTH CHLORIDES

Rare earth chlorides were used to catalyze the synthesis of 2-butoxy-3, 4-dihydro-2H-pyran using equimolar acrolein and vinyl butyl either. The cycloadduct is unstable which undergoes catalytic ring opening oligomerization. The way to stabilize the cyclo adduct has been studied, thus high yields of 90-95% were obtained.

ELECTROCATALYSIS OF POLYPYRROLE-METHYLENE BLUE FILM MODIFIED ELECTRODE FOR DIRECT REDOX REACTION OF CYTOCHROME-C

The electron transfer process of hemeproteins on the electrode surface is considered a promising subject in the area of bioelectrochemistry. Electrochemists believe that electron transfer between electroactive proteins and electrode surface might be expected to simulate the electron transfer between proteins. This research provides information about the electron transfer mechanism in biological system. Cytochrome c is a typical electron transferring protein,

THE REVERSIBLE ELECTRON-TRANSFER REACTION OF MYOGLOBIN AT BRILLIANT CRESYL BLUE MODIFIED PLATINUM GAUZE ELECTRODE

The electrochemical behavior of myoglobin at a Brilliant Cresyl Blue (BCB) modified platinum gauze electrode and spiral pt wire in the BCB solution in optically transparent thin layer cell base been investigated by using cyclic potential-absorbance method and double potential step chronoabsorptometry. The results reveal a reversible electron transfer resection of myoglobin. Exhaustive reductive and oxidative electrolyses are achieved at the modified platinum surface in 20 and 100s respectively. The formal h...

DETERMINATION OF PARAMETERS OF FAST CHEMICAL REACTION OF ALIZARIN RED S BY SPECTROELECTROCHEMICAL METHOD WITH LOPTLC

The rate constant of very fast chemical reaction generally can be measured by electrochemical methods, but can not by the thin layer electrochemical methods because of the influence of diffusion effect. Long optical path length thin layer cell (LOPTLC) with large ratio of electrode area to solution volume can be used to monitor the fist chemical reaction in situ with high sensitivity and accuracy. It enable the adsorption spectra to be measured without the influence of diffusion effect. In the present paper, a fast chemical reaction of Alizarin Red S (ARS) with its oxidative state has been studied. The reaction equilibrium constant (K) under different potentials can be determined by single step potential-absorption spectra in LOPTLC. An equilibrium constant of 7.94 x 10(5) l.mol(-1) for the chemical reaction has been obtained from the plot of lgK vs. (E - E-1(0)'). Rate constant (k) under different potentials can be measured by single step potential-chronoabsorptiometry. A rate constant of 426.6 l.mol(-1).s(-1) for the chemical reaction has been obtained from the plot of lgK vs. (E - E-1(0)') with (E - E-1(0)') = 0.

羟基自由基降解琼胶及其产物的活性研究

琼胶是一种从石花菜等红藻中提取的，目前生产工艺和结构等方面研究比较成熟的海藻多糖，广泛应用于医药、仪器等行业。但是，海藻多糖因为具有分子量大，粘度大，溶解度较小的等特点，而使其应用范围受到限制。利用降解的手段对其进行修饰，降低分子量和粘度，改善溶解性，可以拓展其应用范围。并且根据文献报道，琼 胶寡糖具有一些特殊的生物活性，如抗氧化性，抗炎症等。因此，对琼胶降解的研究具有生要意义。本研究中，为了选择一种合适的降解方法，进行了几种水解方法的尝试，其中包括在不同湿度和酸度下盐酸水解，过氧化氢和醋酸催化水解，Fenton体系羟基自由基降解。对于酸水解和Fenton体系氧化还原降解方法，通过粘度法对反应的速度进行了比较，表明氧化还原降解反应中琼胶的粘度降低比较快，并且具有代表性和新意，确定为本实验的降解琼胶的方法并对氧化还原降解所得的产物进行了活性实验。通过模仿自然界普遍存在的氧化还原降解反应，利用Vc诱导的Fenton体系产生的羟基自由基氧化还原降解琼胶得到低分子量的琼胶。降解产物经过高速离心、60％乙醇沉淀，除去分子量比较大的降解产物和磷酸盐，得到可溶于60％乙醇的分子量估计小于3000的降争产物，其产率为85％。利用经Sephadex-G25凝胶色谱分离所香的不同分子量的级分进行分子量和α－葡萄糖苷酶抑制活性关系的实验。降解产物对α－葡萄糖苷酶的抑制率和各级分的浓度呈线性正相关，并且各级分的IC_(50)则随着分子量的降低而降低。另外，对所得的降解产物混合物进行了红外吸收光谱、质子去偶核磁共震碳谱和负离子基质辅助激光诱导－飞行时间质谱结构分析。结果表明，氧化还原降解反应的专一性差，在得到寡糖的同时，在光谱图中出现一些比较复杂的副产物的结构信息。最后，根据MTT法的原理，以有体皮肤成纤维细胞为材料，通过紫外线辐射产生自由基造成氧化损伤，研究降解产物对成纤维细胞的保护作用。当无紫外线辐射时，降解产物对成纤维细胞具有显著的促进生长增殖作用：当经UVa、UBb辐射时则可以显著地表现出对损伤的保护作用，并且这种促进生长和保护作用呈显著的量效关系，表明降解产物具有清除基自由基的作用。但是，因为氧化还原降解以应的机理尚不十分明的以及琼羟胶的特殊结构，使得反应的副产物很难预测，也就使得分离工作难以进行，所以，根据目前所得的信息，尚不能确定是降解产物的什么级分产生的以上两种生物活性。

Electrochemical impedance spectroscopy analysis for oxygen reduction reaction in 3.5% NaCl solution

The electrochemical impedance spectroscopy (EIS) at different potentials has been used to study the oxygen reduction reaction (ORR) in 3.5% NaCl solution on glassy carbon (GC) electrode in this work. Results show that ORR consists of three two-electron reaction steps and both superoxide ion (O-2(-)) and hydrogen peroxide (H2O2), which are produced by ORR, obstruct the diffusion of oxygen to the surface of the electrode and make the EIS results change into a transmissive finite diffusion process with the real part contraction and a reflective finite diffusion process from a semi-infinite diffusion process. The values of electron transfer resistance (R-t) and diffusion resistance (R-d) were calculated from EIS. O-2(-) influenced strongly on the Rt values and induced a maximum at -0.45 V.

The electrochemical reduction reaction of dissolved oxygen on Q235 carbon steel in alkaline solution containing chloride ions

Cyclic voltammetry, electrochemical impedance spectroscopy, and rotating disk electrode voltammetry have been used to study the effect of chloride ions on the dissolved oxygen reduction reaction (ORR) on Q235 carbon steel electrode in a 0.02 M calcium hydroxide (Ca(OH)(2)) solutions imitating the liquid phase in concrete pores. The results indicate that the cathodic process on Q235 carbon steel electrode in oxygen-saturated 0.02 M Ca(OH)(2) with different concentrations of chloride ions contain three reactions except hydrogen evolution: dissolved oxygen reduction, the reduction of Fe(III) to Fe(II), and then the reduction of Fe(II) to Fe. The peak potential of ORR shifts to the positive direction as the chloride ion concentration increases. The oxygen molecule adsorption can be inhibited by the chloride ion adsorption, and the rate of ORR decreases as the concentration of chloride ions increases. The mechanism of ORR is changed from 2e(-) and 4e(-) reactions, occurring simultaneously, to quietly 4e(-) reaction with the increasing chloride ion concentration.