Prediction of Effective Moduli of Carbon Nanotube-Reinforced Composites with Waviness and Debonding

Carbon nanotubes (CNTs) have been regarded as ideal reinforcements of high-performance composites with enormous applications. However, the waviness of the CNTs and the interfacial bonding condition between them and the matrix are two key factors that influence the reinforcing efficiency. In this paper, the effects of the waviness of the CNTs and the interfacial debonding between them and the matrix on the effective moduli of CNT-reinforced composites are studied. A simple analytical model is presented to investigate the influence of the waviness on the effective moduli. Then, two methods are proposed to examine the influence of the debonding. It is shown that both the waviness and debonding can significantly reduce the stiffening effect of the CNTs. The effective moduli are very sensitive to the waviness when the latter is small, and this sensitivity decreases with the increase of the waviness. (C) 2008 Elsevier Ltd. All rights reserved.

梯度补偿法控温晶体的高功率绿光激光器

研究了平均功率超过30 W的稳定高效全固态绿光激光器,分析得出影响全固态腔内倍频激光器倍频效率和输出稳定性的主要因素是倍频晶体局部温升造成的相位失配和热透镜效应,采用温度梯度补偿控温法对大尺寸倍频晶体进行温度控制,降低激光器工作中倍频晶体内外温度梯度从而有效地克服因晶体局部温升造成的倍频相位匹配角失配和热透镜效应。采用三条60 W的半导体激光二极管阵列板条侧面抽运Nd:YAG激光增益介质棒,采用声光调Q,平凹直腔和腔内倍频结构配合温度梯度补偿控温法对大尺寸倍频晶体进行温度控制,得到了稳定高效的532 nm

A planar waveguide Nd : YAG laser using active Q-switching of a hybrid unstable resonator

A planar waveguide laser operating in a negative branch unstable resonator is Q-switched by an acoustooptic mod latorin anew configuration, providing effective, high-speed switching. The laser using a 200-mu m Nd:YAG core, face pumped by 10 laser diode bars, has produced 100-W output in a good beam quality at 100-kHz pulse rate, and 4.5 mJ at lower frequency with 15-ns pulse duration.

High optical-optical efficiency of 52.5% obtained in high power Nd : YAG ceramic laser

Using a quite uniformly side-around arranged compact pumping system, a high power Nd:YAG ceramic quasi-CW laser has been demonstrated with high optical-to-optical conversion efficiency over 50% for the first time. With 450 W quasi-CW stacked laser diode bars pumping at 808 run. 236 W Output at 1064 run was obtained and no saturation phenomena were observed.

Nd : YAG ceramic laser obtained high slope-efficiency of 62% in high power applications

By using quite uniformly nine-stacks side-around arranged compact pumping system, a high power Nd:YAG ceramic quasi-CW laser with high slope efficiency of 62% has been demonstrated. With 450 W quasi-CW stacked laser diode bars pumping at 808 nm, performance of the Nd: YAG ceramic laser with different output coupling mirrors has been investigated. Optimum output power of 236 W at 1064 nm was obtained and corresponding optical-to-optical conversion efficiency was as high as 52.5%. The laser system operated quite stably and no saturation phenomena have been observed, which means higher output laser power could be obtained if injecting higher pumping power. The still-evolving Nd: YAG ceramics are potential super excellent media for high power practical laser applications. (c) 2005 Optical Society of America.

Dynamic changes in orbitofrontal neuronal activity in rats during opiate administration and withdrawal

The orbitofrontal cortex is involved in the reinforcing effects of drugs of abuse. However, how the dynamic activity in OFC changes during opiate administration and withdrawal period has not been investigated. We first tested the effects of opiates and dr

Schistura cryptofasciata, a new loach (Cypriniformes : Balitoridae) from Salween drainage in Yunnan, Southwestern China

Schistura cryptofasciata is distinguished from its congeners by following combination characters: lateral line complete; 8(1)/(2) branched dorsal-fin rays; 9+8 branched caudal-fin rays; no sexual dimorphism; 8-11 indistinct bars, wider than interspaces; caudal-peduncle length 44.1-16.5% standard length, 68.1-90.4% dorsal head length; anterior portion of body scaleless; air bladder entirely embedded in bony capsule; lateral head length 104-122% dorsal head length; lower jaw with a notch at symphysis; lower lip completely interrupted; interorbital width 1.9-2.2 times eye diameter; pelvic-fin origin ventral to dorsal-fin origin; anus 1.0-1.5 eye diameters in front of anal-fin origin; the widest part of black basal caudal bar is the midlateral, and then the upper and lower ends.

Paracobitis nanpanjiangensis, a new loach (Balitoridae: Nemacheilinae) from Yunnan, China

A new species of the genus Paracobitis, Paracobitis nanpanjiangensis is described from tributaries of the Nanpanjiang River drainage in China. It is distinguished from its congeners, except P. oligolepis and P. wujiangensis, by body scaleless or with rudimentary scales (caudal peduncle with several deeply embedded scales). It can be differentiated from P. wujiangensis by the complete lateral line (vs. incomplete), lower dorsal crest reaching the vertical of origin of anal fin (vs. shorter and higher dorsal crest not reaching the base of anal fin). It is distinguished from P. oligolepis by the following characters: branched dorsal fin with 81/2 (a few 91/2) rays (vs. 91/2), interspaces between bars in front of dorsal fin conspicuously thinner than those behind (vs. vermiform markings), dorsal head without vermiform markings or obscure (vs. clearly vermiform markings on dorsal head), vertebrae 4 + 36-38 (vs. 4 + 39-41).

Acrossocheilus spinifer, a new species of barred cyprinid fish from south China (Pisces : Teleostei)

Acrossocheilus spinifer sp. nov. is described from the river basins in Fujian Province and the Han Jiang basin in Guangdong Province, south China. It is one of the barred Acrossocheihis species sharing five or six vertical bars on the flanks, with each bar being two scales in width. Acrossocheilus spinifer sp. nov. is morphologically most similar to Acrossocheilus wenchowensis. but distinguished from it by: a colour pattern of all vertical bars extending ventrally to the second scale row below the lateral line, and having the second bar placed posterior to the base of the last simple dorsal-fin ray, a blunt snout; and a stout, last simple dorsal-fin ray. Acrossocheilus spinifer sp. nov. resembles Acrossocheilus kreyenbergii and Acrossocheilus stenotaeniatus with which it shares a stout, last simple dorsal-fin ray with a serrated posterior edge, but is separated from both species by having a narrow median interruption in the lower lip, a lower jaw fully covered by the lower lip when viewed ventrally and the second vertical bar placed posterior to the base of the last simple dorsal-fin ray. The absence of a longitudinal stripe extending along the lateral line on the flanks in males readily distinguishes A. spinifer sp. nov. from Four other species, namely Acrossocheilus fasciatus, Acrossocheilus paradoxus, Acrossocheilus parallens, and Acrossocheilus jishouensis. (c) 2006 The Authors Journal compilation (c) 2006 The Fisheries Society of the British Isles.

Revision of the genus Niwaella in China (Pisces, Cobitidae), with description of two new species

Loaches of the genus Niwaella, family Cobitidae, are distributed only in East Asia. At present only in Japan and South Korea have fishes of the genus Niwaella been found. Herein we revise the genus Niwaella in China. Son and He ( 2001) transferred the species Cobitis laterimaculata to the genus Niwaella, but their specimens were not N. laterimaculata, but a new species, N. longibarba sp. n., collected from Cao'ejiang River, Huangzezhen, Chengxian County, Zhejiang Province. The new species is distinguished from N. laterimaculata by its colour pattern of a row of slightly large, and long, scattered dark brown vertical bars on the dorsolateral surface, two or three striations on the caudal fin, and long barbels and undeveloped mental lobes. In this paper we also describe another new species, N. xinjiangensis sp. n., collected from Xinjiang River, Guangfeng County, Jiangxi Province, May 1990, with diagnostic colour pattern of 17 - 20 large and long, dark brown vertical bars on the dorsolateral surface, a dark stripe or rounded black spots along the lateral midline and some blotches below the lateral midline; it is a large-sized species, with shorter barbels, and longer caudal peduncle. Thus five species of the genus Niwaella are known, three are endemic to eastern China and two are endemic to either Japan or South Korea.

The Yangtze River dolphin or baiji (Lipotes vexillifer): population status and conservation issues in the Yangtze River, China

1. Baiji were sighted 17 times during three recent simultaneous multi-vessel surveys in the Yangtze River, China (November 4-10, 1997; December 4-9, 1998; October 31-November 5, 1999). There were 11 sightings in 1997 (consisting of 17 animals), five in 1998 (seven animals), and two in 1999 (four animals). It was concluded that 13 individuals Could be considered as a minimum number of the baiji currently in the Yangtze River. 2. An annual rate of population decrease was roughly estimated as 10%. From the body sizes observed, the proportions of old, adult and immature individuals were approximately estimated at 57, 26, and 17% respectively. 3. Baiji showed a significant attraction to confluences and sand bars with large eddies. The present distribution range of the baiji is less than 1400 km in length in the Yangtze main river. Distances between the two nearest groups of baiji appear to be increasing. 4. Two typical sightings are described, in which surfacing and movements of baiji were recorded. Baiji were often found swimming together with finless porpoise. In the surveys they occurred in the same group in 63% of occurrences. Interactions between baiji and finless porpoise are described and discussed. 5. Human activities are the main threats to the baiji. Illegal electrical fishing accounted for 40% of known mortalities during the 1990s. Engineering explosions for maintaining navigation channels have become another main cause of baiji deaths. The last hope of saving the species may be to translocate the remaining baiji into a semi-captive reserve. known as the 'Baiji Semi-natural Reserve'. Copyright (C) 2003 John Wiley Sons, Ltd.

Advances in high power semiconductor diode lasers - art. no. 682402

High power semiconductor lasers have broad applications in the fields of military and industry. Recent advances in high power semiconductor lasers are reviewed mainly in two aspects: improvements of diode lasers performance and optimization of packaging architectures of diode laser bars. Factors which determine the performance of diode lasers, such as power conversion efficiency, temperature of operation, reliability, wavelength stabilization etc., result from a combination of new semiconductor materials, new diode structures, careful material processing of bars. the latest progress of today's high-power diode lasers at home and abroad is briefly discussed and typical data are presented. The packaging process is of decisive importance for the applicability of high-power diode laser bars, not only technically but also economically. The packaging techniques include the material choosing and the structure optimizing of heat-sinks, the bonding between the array and the heat-sink, the cooling and the fiber coupling, etc. The status of packaging techniques is stressed. There are basically three different diode package architectural options according to the integration grade. Since the package design is dominated by the cooling aspect,. different effective cooling techniques are promoted by different package architectures and specific demands. The benefit and utility of each package are strongly dependent upon the fundamental optoelectronic properties of the individual diode laser bars. Factors which influence these properties are outlined and comparisons of packaging approaches for these materials are made. Modularity of package for special application requirements is an important developing tendency for high power diode lasers.

808-nm fiber coupled module with a CW output power up to 130 W

A fiber coupled module is fabricated with integrating the emitting light from four laser diode bars into multimode fiber bundle. The continuous wave (CW) output power of the module is about 130 W with a coupling efficiency of around 80%. The output power is very stable after the temperature cycling and vibration test. No apparent power decrease has been observed as the device working continuously for 500 h.

AIN Monolithic Microchannel Cooled Heatsink for High Power Laser Diode Array

A novel AIN monolithic microchannel cooled heatsink for high power laser diode array is introduced.The high power stack laser diode array with an AIN monolithic microchannel heatsink is fabricated and tested.The thermal impedance of a 10 stack laser diode array is 0.121℃/W.The pitch between two adjacent bars is 1.17mm.The power level of 611W is achieved under the 20% duty factor condition at an emission wavelength around 808nm.

Applications of dielectric thin film by electron cyclotron resonance plasma chemical vapor deposition for semiconductor photoelectronic devices

The paper reports a method of depositing SiO2, SiNx, a:Si, Si3N4 and SiOxNy dielectric thin films by electron cyclotron resonance plasma chemical vapor deposition (ECR CVD) on InP, InGaAs and other compound semiconductor optoelectronic devices,and give a technology of depositing dielectric thin films and optical coatings by ECR CVD on Laser's Bars. The experiment results show the dielectric thin films and optical coatings are stable at thermomechanical property,optical properties and the other properties. In addition, the dielectric thin film deposition that there is low leakage current is reported for using as diffusion and ion implatation masks in the paper. In the finally, the dielectric film refractive index can be accurately controlled by the N-2/O-2/Ar gas flow rate.