1，2，4－三氯苯在土壤中的降解

在好氧和厌氧两种条件下研究了１，２，４－三氯苯的降解，结果表明，１，２，４－三氯苯的好氧降解和厌氧降解均遵循一级反应动力学在同样水分、温度及初始浓度条件下，１，２，４－三氯苯的好氧降解比厌氧降解迅速，其半衰期分别为１．８９～５．８６和５．０７～１９．０８ｄ土壤中１，２，４－三氯苯的初始浓度对于其降解也有显著影响，在０～１００μｇ·ｇ－１的范围内，浓度增高时，其降解加快，说明污染物浓度对降解的影响；在１０～３０℃范围内，温度增高导致降解过程加快，归因于温度升高对微生物酶活性的激活作用．

超声波法提取土壤样品中1,2,4-三氯苯和GC测定

本方法采用超声波振荡提取，用10％的丙酮正已烷混合溶液作为提取剂，对易挥发的1，2，4－三氯苯的分析具有简单、快速、灵敏、可靠、节省试剂的特点，也适用于土壤环境样品氯苯类化合物的测定。

水、土壤及植物样品中1,2,4-三氯苯的提取和GC测定

<正> 1 引言三氯苯(1,2,4-TCB)是化学工业和合成农药的重要原料,但同时也是环境中广泛存在的污染物。早在1979年,1,2,4-TCB就被美国环保局列入129种优先控制的污染物之一。在我国1,2,4-TCB也是常见的一种有机污染物。水体和土壤中1,2,4-TCB的分析方法国内已见报道。但这些方法大多步骤复杂、操作困难,而且费时、试剂消耗量大。另外,目前尚没有植物样品中1,2,4-TCB分析方法的报道。本文建立了步骤简单、易操作、节约试剂的水、土壤、植物和作物籽实中1,2,4-TCB的提取和分析方法。

1,1 '-dimethyl-4,4 '-(propane-1,3-diyl)-dipyridinium tetrabromidocadmate(II)

In the cation of the title compound, (C15H20N2)[CdBr4], the dihedral angle between the two pyridine rings is 70.85 (5)degrees. An intermolecular pi-pi interaction between the pyridine rings [centroid - centroid distance = 3.900 (4) angstrom] is observed. The Cd-II atom has a distorted tetrahedral coordination.

Vertical structure p-type permeable metal-base organic transistors based on N,N '-diphentyl-N,N '-bis(1-naphthylphenyl)-1,1 '-biphenyl-4,4 '-diamine

In this article, vertical structure p-type permeable-base organic transistors were proposed and demonstrated. A hole-type organic semiconductor N,N-'-diphentyl-N,N-'-bis(1-naphthylphenyl)-1,1(')-biphenyl-4,4(')-diamine was used as emitter and collector. In the permeable-base transistors, the metal base was formed by firstly coevaporating Al and Ca in vacuum and then annealing at 120 degrees C for 5 min in air, followed by a thin Al deposition. These devices show a common-base current gain of near 1.0 and a common-emitter current gain of similar to 270.

Microstructures, mechanical properties and corrosion behavior of high-pressure die-cast Mg-4Al-0.4Mn-xPr (x=1, 2, 4, 6) alloys

Mg-4Al-0.4Mn-xPr (x = 1, 2, 4 and 6 wt.%) magnesium alloys were prepared successfully by the high-pressure die-casting technique. The microstructures, mechanical properties, corrosion behavior as well as strengthening mechanism were investigated. The die-cast alloys were mainly composed of small equiaxed dendrites and the matrix. The fine rigid skin region was related to the high cooling rate and the aggregation of alloying elements, such as Pr. With the Pr content increasing, the alpha-Mg grain sizes were reduced gradually and the amounts of the Al2Pr phase and All, Pr-3 phase which mainly concentrated along the grain boundaries were increased and the relative volume ratio of above two phases was changed. Considering the performance-price ratio, the Pr content added around 4 wt.% was suitable to obtain the optimal mechanical properties which can keep well until 200 degrees C as well as good corrosion resistance. The outstanding mechanical properties were mainly attributed to the rigid casting surface layer, grain refinement, grain boundary strengthening obtained by an amount of precipitates as well as solid solution strengthening.

Novel, highly efficient blue-emitting heteroleptic iridium(III) complexes based on fluorinated 1,3,4-oxadiazole: tuning to blue by dithiolate ancillary ligands

Novel blue-emitting phosphorescent iridium(III) complexes with fluorinated 1,3,4-oxadiazole derivatives as cyclometalated ligands and dithiolates as ancillary ligands have been synthesized and fully characterized; highly efficient OLEDs have been achieved using these complexes in the light-blue to blueemitting region.

Supramolecular architectures, photophysics, and electroluminescence of 1,3,4-oxadiazole-based iridium(III) complexes: From mu-dichloro bridged dimer to mononuclear complexes

One mu-dichloro bridged diiridium complex and three mononuclear iridium(III) complexes based on the 1,3,4-oxadiazole derivatives as cyclometalated ligands and acetylacetonate (acac) or dithiolates O,O'-diethyldithiophosphate (Et(2)dtp) or N,N'-diethyldithiocarbamate (Et(2)dtc) as ancillary ligands have been synthesized and systematically studied by X-ray diffraction analysis. The results reveal that three mononuclear complexes all adopt distorted octahedral coordination geometry around the iridium center by two chelating ligands with cis-C-C and trans-N-N dispositions, which have the same coordination mode as the diiridium dimer. The dinuclear complex crystallizes in the monoclinic system and space group C2/c, whereas three mononuclear iridium complexes are all triclinic system and space group P(1) over bar. In the stacking structure of the dimer, one-dimensional tape-like chains along the b-axis are formed by hydrogen bondings, which are strengthened by pi stacking interactions between phenyl rings of 1,3,4-oxadiazole ligands. Then these chains assemble a three-dimensional alternating peak and valley fused wave-shape structure. In each stacking structure of three mononuclear complexes, two molecules form a dimer by the C-H center dot center dot center dot O hydrogen bondings, and these dimers are connected by pi stacking interactions along the b-axis, constructing a zigzag chain.

1-苯基-3-甲基-4-苯甲酰基-吡唑酮-5与中性磷(膦)萃取剂协同萃取镧B

研究了 1 苯基 3 甲基 4 苯甲酰基 -吡唑酮 5 (HPMBP)和中性有机磷 (膦 )类萃取剂Cyanex 4 71X(TIBPS ,B)在硝酸介质中对稀土元素La 的萃取 ,用斜率法和恒摩尔法探讨了萃取机理 ,确定了萃合物的组成为La(NO3 ) 2 ·PMBP·B ,计算了萃取平衡常数。比较了HPMBP与Cyanex 4 71X、Cyanex 92 1、Cyanex 92 3、Cyanex 92 5、DEH/EHP、P35 0及TBP的单独及混合体系萃取La 的性能 ,结果表明 :所有混合体系对La 均有协同效应 ,其中HPMBP与Cyanex 92 3、Cyanex 92 1、Cyanex 92 5的混合体系是萃取La 的有效体系。

Synthesis, structure, electrochemistry, photophysics and electroluminescence of 1,3,4-oxadiazole-based ortho-metalated iridium(III) complexes

Four new iridium(III) complexes 1-4, with 1,3,4-oxadiazole derivative as cyclometalated ligand for the first time, have been synthesized and structurally characterized by NMR, EA, MS and X-ray diffraction analysis (except 1). The stronger ligand field strength of the dithiolate ancillary ligands results in higher oxidation potentials and lower HOMO energy levels of complexes than acetylacetone. The absorption spectra of these complexes display low-energy metal-to-ligand charge transfer transition ranging from 350 to 500 nm. Complexes with dithiolate ancillary ligand emit at maximum wavelengths of ca. 500 nm, blue shifting 17 and 11 nm with respect to their counterpart with acetylacetone ligand. The electrophosphorescent devices with 2-4 as phosphorescent dopant in emitting layer have been fabricated. All devices have a low turn-on voltage in the range of 4.5 and 4.9 V. A high-efficiency green emission with maximum luminous efficiency of 5.28 cd/A at current density of 1.37 mA/cm(2) and a maximum brightness of 2592 cd/m(2) at 15.2 V has been achieved in device using 2 as emitter.

Novel highly selective anion chemosensors based on 2,5-bis(2-hydroxyphenyl)-1,3,4-oxadiazole

2-(2-Hydroxyphenyl)-5-phenyl-1,3,4-oxadiazole 1 and 2,5-bis(2-hydroxyphenyl)-1,3,4-oxadiazole 2 were used as anion fluorescent and colorimetric chemosensors with high selectivity for H2PO4- and F- over Cl-, while 2 can even distinguish H2PO4- from F-. (C) 2002 Elsevier Science Ltd. All rights reserved.

3{1-[2-(-3-羟基-1-甲基-2-亚丁烯氨基)-苯亚氨基]-乙基}4-甲硫基-2,4-戊二烯-2-醇的不对称Schiff碱镍(Ⅱ)配合物的合成、结构和性质

由 5-(2-乙酰基-1-甲硫基-3-羰基-亚丁基)-丙二酸亚异丙酯 (1)与邻苯二胺及乙酸镍()经一步反应合成了3{1-[2-( -3-羟基-1-甲基-2-亚丁烯氨基)-苯亚氨基 ]-乙基} 4-甲硫基-2,4-戊二烯-2-醇(3)的不对称四齿 Schiff碱镍()配合物(2),X射线衍射结果表明,配合物 2属单斜晶系,P21/C空间群.a=1.1476(2)nm,b=1.1782(2)nm,c=1.4810(3)nm;β=111.73(2)°,V=1.8602(7)nm3,Z=4,Rf=0.0535.电化学(循环伏安)测定结果表明,该配合物在测定条件下(阳极峰电位为1.1)发生了不可逆的氧化-还原反应.

Adsorption studies of divalent metal ions with extraction resin containing 1-hexyl-4-ethyloctyl isopropylphosphonic acid

Equilibrium distributions of cobalt(II), nickel(II), zinc(II), cadmium(II), and copper(II) have been studied in the adsorption with extraction resin containing 1-hexyl-4-ethyloctyl isopropylphosphonic acid (HEOPPA) as an extractant from chloride medium. The distribution coefficients are determined as a function of pH. The data are analyzed both graphically and numerically. The extraction of the metal ions can be explained assuming the formation of metal complexes in the resin phase with a general composition ML2(HL)(q). The adsorbed species of the metal ions are proposed to be ML2 and the equilibrium constants are calculated. The efficiency of the resin in the separation of the metal ions is provided according to the separation factors values. The separation of Zn from Ni, Cd, Cu, Co, and Co from Ni, Cd, Cu with the resin is determined to be available. Furthermore, Freundlich's isothermal adsorption equations and thermodynamic quantities, i.e., DeltaG, DeltaH, and DeltaS are determined.

Separation of heavy rare earth elements with extraction resin containing 1-hexyl-4-ethyloctyl isopropylphosphonic acid

This paper presents the results of the adsorption of heavy rare earth ions (Gd(III), Tb(III), Dy(III), Ho(III), Er(III), Tm(III), Yb(III), Lu(III) and Y(III)) from hydrochloric acid solutions at 30 degreesC by the extraction resin containing 1-hexyl-4-ethyloctyl isopropylphosphonic acid (HEOPPA), which has higher steric hindrance, higher selectivities and lower extraction and stripping acidity than di(2-ethylhexyl)phosphoric acid (DERPA) or 2-ethylhexyl phosphonic acid mono-2-ethylhexyl ester (HEH/EHP). The dependence of acid concentration, flow rate and amounts of rare earth ions sorbed on the separation of Er-Tm, Tm-Yb and Er-Tm-Yb mixtures has been studied. The baseline chromatographic separation of Er-Tm-Yb mixture has been observed. Satisfactory results with purity and yield of Tm2O3>99.71% and >71.25%, Er2O3>99-81% and >94.17%, and Yb2O3>99.74% and >89.83%, respectively, have been obtained. The parameters such,as resolution, separation factors and efficiencies have been determined as a function of acidity, loading of rare earth elements and flow rates. The stoichiometry of the extraction of rare earth ions has been suggested as well.