Magnets for HIRFL-CSR rings

The magnet design, fabrication, and measurement of HIRFL-CSR (Heavy Ion Research Facility in Lanzhou Cooling Storage Ring) are presented. All magnets will be laminated And welded with an armor-coated surface between two big endplates made of sticking glue 0.5 mm-thick sheets. The dipole of CSRm was chosen an H type with an air circle on the pole to improve the field uniformity. The dipole of CSRe was chosen the C type with an air circle and two air slots on the pole to improve the field homogeneity. Its reproducibility of magnet to magnet was adjusted with inserting small laminating pieces before demountable pole ends to reach less than +/- 2 x 10(-4) at optimized field level. CSRm quadrupoles diameter is 170 mm and has two different lengths, and its endplates were made with punching pieces after coating with epoxy glue, there is chamfered directly on the pole ends to reduce 12th-order contribution of field and without the demountable pole ends. CSRe main quadrupoles diameter is 240 mm and has two different lengths, and its endplates were also made with punching pieces coated with epoxy glue, there is also chamfered directly on the pole ends to reduce 12th-order contribution of field like CSRm.

Monte Carlo simulation of the neutron detection wall at RIBLL II in HIRFL-CSR

With the construction of the new Radioactive Ion Beam Line in Lanzhou (RIBLL II) which connects the CSRm and the CSRe, an experimental setup for physics research is highly required. A large area neutron detection wall is the main part of the setup. This paper introduced the detection principle of the neutron detection wall and the Monte-Carlo simulation of its design under the environment of the Geant4 toolkit. We presented the final design with the optimized parameters and the performance of the wall.

FIRST ISOCHRONOUS MASS MEASUREMENTS AT CSRe

With the commissioning of the Cooler Storage Ring at the Heavy Ion Research Facility in Lanzhou (HIRFL-CSR), a pilot experiment operating the CSRe in isochronous mode to test the power of HIRFL-CSR for measuring the mass of the short-lived nucleus was performed in December of 2007. The transition point gamma t of CSRe in isochronous mode is 1.395 which corresponds to the energy about 368 MeV/u for the ions with atomic number-to-charge ratio A/q = 2. The fragments with A/q = 2 of Ar-36 were injected into CSRe and their revolution frequencies were measured with a fast time pick-up detector with a thin foil in the circulating path of the ions. A mass resolution of better than 105 for m/Delta m was achieved.

OVERVIEW ON THE HIRFL-CSR FACILITY

The status of the HIRFL (Heavy Ion Facility in Lanzhou) - Cooler Storage Ring (CSR) at the IMP is reported. The main physics goals at the HIRFL-CSR are the researches on nuclear structure and decay property, EOS of nuclear matter, hadron physics, highly charged atomic physics, high energy density physics, nuclear astrophysics, and applications for cancer therapy, space industries, materials and biology sciences. The HIRFL-CSR is the first ion cooler-storage-ring system in China, which consists of a main ring (CSRm), an experimental ring (CSRe) and a radioactive beamline (RIBLL2). The two existing cyclotrons SFC (K=70) and SSC (K=450) are used as its injectors. The 7MeV/u12C6+ ions were stored successfully in CSRm with the stripping injection in January 2006. After that, realized were the accelerations of C-12(6+), Ar-36(18+), Kr-78(28+) and Xe-129(27+) ions with energies of 1GeV/u, 1GeV/u, 450 MeV/u and 235 MeV/u, respectively, including accumulation, electron cooling and acceleration. In 2008, the first two isochronous mass measurement experiments with the primary beams of Ar-36(18+) and Kr-78(28+) were performed at CSRe with the Delta p/p similar to 10(-5).

基于P2P技术的CSRe冷却装置控制系统设计；Design of Control System for CSRe Cooling Equipment Based on P2P Technology

HIRFL-CSR工程对CSRe冷却装置电子冷却部分的控制系统在实时性和可靠性方面提出了非常高的要求。电子冷却工作环境复杂,各种干扰难以预测。从电子冷却的控制系统改进出发,以实现电子冷却的自动调束为目标,以高端FPGA和ARM嵌入式系统为基础,采用P2P通讯技术和神经元网络算法来实现对电子冷却的自动控制。该控制系统对电子冷却控制的完善提供了先进的硬件平台和软件实现方案。

HIRFL大型真空系统；The vacuum system of HIRFL

HIRFL是兰州重离子加速器装置的英文首字母缩写,其真空系统是一个大型综合性系统。HIRFL由离子源、扇聚焦回旋加速器SFC、分离扇回旋加速器SSC和多用途的重离子冷却储存环(HIRFL-CSR)组成。多条束流运输线将这些加速器连接在一起,同时将各种重离子束流送往10多个实验终端。根据加速离子和束流寿命的需要,对各加速器真空度的要求是不同的:SFC已有50多年的历史,经过3次升级改造,真空度从10-4 Pa提高到10-6 Pa;建于上世纪八十年代的SSC真空度也为10-6 Pa;而两个重离子冷却储存环(CSRm和CSRe)的真空度达到10-10Pa以保证重离子有足够长的储存寿命。多条连接束运线根据不同实验终端的要求,其真空系统的设计方案也不同,文中列举了微束实验终端采取的防振措施;为充气反冲谱仪设计的清洁、大流量真空差分系统及为重离子治癌等终端设计的超薄壁扫描磁铁真空管道等。

CSRe团簇内靶温度闭环控制器设计；Design of Closed Loop Temperature Controller for CSRe Internal Target System

介绍了国家重大科学工程项目——兰州重离子加速器冷却存储环(HIRFL-CSR)的实验环(CSRe)团簇内靶温度闭环控制器的设计。该控制器给气体喷嘴处测温电阻提供长时间稳定度为0.1%的1mA恒定电流,通过12位ADC得到喷嘴温度,并通过混合信号处理器MSP430F149来实现制冷/加热闭环操作。在多种不同实验气体的情况下,该控制器的温度控制精度小于0.5K。目前,该控制器在现场工作良好。

A high performance Time-of-Flight detector applied to isochronous mass measurement at CSRe

A high performance Time-of-Flight detector has been designed and constructed for isochronous mass spectrometry at the experimental Cooler Storage Ring (CSRe) The detector has been successfully used in an experiment to measure the masses of the N approximate to Z approximate to 33 nuclides near the proton drip-line Of particular interest is the mass of As-65 A maximum detection efficiency of 70% and a time resolution of 118 +/- 8 Ps (FWHM) have been achieved in the experiment The dependence of detection efficiency and signal average pulse height (APH) on atomic number Z has been studied The potential of APH for Z identification has been discussed (C) 2010 Elsevier B V All rights reserved

Commissioning of electron cooling in CSRe

The 400 MeV/u C-12(6+) ion beam was successfully cooled by the intensive electron beam near 1 A in CSRe. The momentum cooling time was estimated near 15 s. The cooling force was measured in the cases of different electron beam profiles, and the different angles between the ion beam and electron beam. The lifetime of the ion beam in CSRe was over 80 h. The dispersion in the cooling section was confirmed as positive close to zero. The beam sizes before cooling and after cooling were measured by the moving screen. The beam diameter after cooling was about 1 mm. The bunch length was measured with the help of the signals from the beam position monitor. The diffusion was studied in the absence of the electron beam.

STATUS AND PROSPECTS OF HIRFL EXPERIMENTS ON NUCLEAR PHYSICS

HIRFL is an accelerator complex consisting of 3 accelerators, 2 radioactive beams lines, 1 storage rings and a number of experimental setups. The research activities at HIRFL cover the fields of radio-biology, material science, atomic physics, and nuclear physics. This report mainly concentrates on the experiments of nuclear physics with the existing and planned experimental setups such as SHANS, RIBLL1, ETF, CSRe, PISA and HPLUS at HIRFL.

CSRe Schottky 质量谱仪研究

HIRFL-CSR 联合Schottky信号诊断的方法为高精度测量离子质量提供了一个新的途径，本论文研究了CSRe Schottky 质量谱仪的原理,电子冷却模式下进行质量测量时的磁铁设置，各种系统误差以及能达到的精度估计。首先研究了CSRe的线性lattice中动量压缩因子对动量色散的依赖，以及动量压缩因子的高阶项的存在会对常用的线性质量刻度造成多大的系统误差。讨论了利用六级铁的适当设置减小这种系统误差的方法，给出利用MAD程序的模拟的CSRe六级铁的适当设置数值以及动量压缩因子对动量分散的依赖曲线。接着详细讨论了其他的几种主要的系统误差以及消除方法，给出了一种新的准确度更高的非线性的质量刻度方法。最后研究了电子冷却模式下CSRe Schottky质量谱仪精度的决定因素，调研了在CSRe上进行对190Ir和188Os可行性以及估计了在现有条件下，能够达到的精度,探讨了进一步提高质量刻度的精度和准确度的实现途径

Experimental verification of therapeutic doses for the superficially-placed tumor radiotherapy with heavy ions at HIRFL

Up to now, clinical trials of heavy-ion radiotherapy for superficially placed tumors have been carried out for six times and over 60 selected patients have been treated with 80—100 MeV/u carbon ions supplied by the Heavy Ion Research Facility in Lanzhou (HIRFL) at the Institute of Modern Physics, Chinese Academy of Sciences since November, 2006. A passive irradiation system and a dose optimization method for radiotherapy with carbon-ion beams have been developed. Experimental verification of longitudinally ...

Research for HIRFL new improvement project

According to the newest matching mode between the two cyclotrons at HIRFL, the beam obit properties were researched, especially for the harm of existing ‘over-magnetic shim’ in SSC as well as the trajectory in the new mode. The results obtained are encouraging.

HIRFL-CSR频谱现象：中心频率突变分析研究

In commissioning the HIRFL-CSR (Cooler Storage Ring of Heavy Ion Research Facility in Lanzhou),with the spectrum analyzer monitoring the beams on-line, we measured many parameters of the beam status for improving quality of the heavy ion beams. In this paper, the sudden change of the beam center frequency is analyzed.A theoretical analysis is done mainly on instabilities of the electron voltage and the neutralization factor. Simulations were made for the problem. According to the simulation result, we can conclude that it is the instability of neutralization factor that caused the problem. 中文摘要：HIRFL-CSR调试过程中，利用频谱分析仪实时监测束流，根据其上测的数据进行相关参数调整，改善束流的品质。本文对分析仪上观测到的现象一束流的中心频率发生突变进行了研究，主要就电子束的高压不稳定性和中性化因子的突变做了理论分析，并进行了相关的模拟计算 ，根据模拟结果初步断定该现象的出现由电子束的中性化因子导致。

HIRFL-CSR前端总线控制器的SD驱动

The HIRFL-CSR EVME bus controller, which runs Embedded Linux OS, is based on AT91RM9200 microprocessor, whose core is ARM920T. There are hardware interface electronic circuits connecting AT91RM9200 microprocessor and Security Digital Memory Card (SD Card). This article analyzes Operation System kernel and Linux device driver’s structure, designs SD Card driver based on Embedded Linux, which runs on AT91RM9200 microprocessor.中文文摘：简要论述了用于兰州重离子加速器冷却储存环(HIRFL-CSR)控制系统的前端总线控制器。该控制器是基于ARM920T核心的AT91RM9200处理器,运行嵌入式Linux操作系统。描述了AT91RM9200处理器与Security Digital MemoryCard(SD卡)的硬件接口电路,分析了操作系统内核和Linux驱动程序结构,设计和实现了嵌入式Linux下基于AT91RM9200处理器的SD卡驱动程序。