I：新型稀土永磁材料Nd-Fe-B氧化过程及抗氧化新体系研究II：CuO、Y_2Cu_2O_5、BaCuO_2和RBa_2Cu_3O_(7-δ)超导体磁化率及Cu价态研究

本论文由两大部分组成。第一部分是新型稀土永磁材料Nd-Fe-B氧化过程及抗氧化新体系的研究。Nd-Fe-B永磁体是1983年问世的新型稀土永磁材料。和原有的铁氧体及Sm-Co体系相比，具有磁能积高（50MGOe）。价廉源广，制备简单等三大优点；也有居里温度低（310℃），温度系数大（－0.126%/K），易氧化等三大缺点，我们对Nd-Fe-B合金的氧化过程进行研究，发现该材料热稳定性差，容易发生氧化反应，氧化使材料的结构受到破坏，并给材料的磁性造成不可恢复的损失，整个氧化过程是分阶段的。在室温和干燥的空气中材料基本是稳定的。150℃以下材料磁性受到破坏的主要原因是体系中Nd的氧化。230℃以上材料主体成分Fe也开始氧化，温度升高使反应进程大大加快。到800℃左右反应基本结束，最终产物主要为Fe_2O_3, Nd_2O_3·FeNdO_3和NdBO_3。增加体系中B的相对含量和添加某些新的元素均能提高材料的抗氧化能力，新研制的Nd-Fe-B-Si四元体系和原来的Nd-Fe-B体系相比具有下列显著优点：新体系的抗氧化能力大大提高，经过150℃的长期恒温试验，材料的结构，磁性均未受到破坏，某些体系甚至能在更高的温度下使用，另外，新体系的居里温度Tc也大为提高。比原有Nd-Fe-B磁体高40℃左右。因此该体系是一种大有发展前途的新材料。此外，我们用动态热重法研究了Nd-Fe-B合金的氧化动力学过程，但由于我们新合成的体系构相较为复杂，未能达到预期效果。第二部分是CuO，Y_2Cu_2O_5，BaCuO_2和RBa_2Cu_3O_(7-δ)超导体（R稀土元素）磁化率及铜价态研究，铜的氧化物具有复杂的化学计量关系和磁学性质。在对CuO的磁化率研究中，我们发现在低温区（77K－110K）和一定磁场下，CuO由顺磁突变为抗磁。这种转变与磁场强度有很大关系。这一结果与前人的工作有较大的出入。而与超导体的形为极为相似。所不同的是，转变温度与样品的重量也有关系。实验结果重复。由于铜氧性质在R-Ba-Cu-O超导体中起决定作用，因此有必要对CuO的低温磁性作进一步研究。此外，我们对文献尚未报道的Y_2Cu_2O_5的磁化率在77－300K温度区间进行了测量，发现它是顺磁性物质，室温有效磁矩μ_(eff) = 2.13μB。高于Cu~(2+)的理论有效磁矩（1.73μB）。经过碘量法价态分析，发现Y_2Cu_2O_5中有部分Cu~(3+)，这与磁化率的测定相符合。Tc在90K左右的Y-Ba-Cu-O体系是近期才发现的具有超高温超导材料。该体系有着独特的结构和性质。在对R-Ba-Cu-O及R-Ba-Cu-O-Ag超导体的研究中，我们发现此类超导体属II类超导体，在临界温附近该超导体由顺磁转变为抗磁，此种变化与磁场强度有很大关系，当场强大于一定值后，则观察不到这种转变。在对RBa_2Cu_3O_(7-δ) (R = Y, Sm, Eu, Gd, Dy, Ho, Er, Tm)超导体和具有相同配比但由于合成工艺条件不同而不超导的R'Ba_2Cu_3O_(7-δ) (R' = Y, Sm, Eu, Gd)非超导体的铜价态分析中，我们发现此两类化合物中均含有一定量的Cu~(3+)。且超导体中Cu~(3+)的含量高于非超导体中Cu~(3+)的含量（同样比例）。我们还发现Cu~(3+)对水极为敏感，将RBa_2Cu_3O_(7-δ) (除R = Gd, Dy, Er)超导体在未干燥容器中测出的Cu~(3+)量远远低于干燥容器中所测得的值。我们认为这可能是引起超导体不稳定的重要原因。由于尚缺乏用其它手段检测到超导体中Cu~(3+)存在的例证。故对此问题还有待于今后继续作进一步的研究。

Projected shell model description for high-spin states in neutron-rich Fe isotopes

A systematic study of neutron-rich even-even Fe isotopes with a neutron number from 32 to 42 is carried out by using the projected shell model. Calculations are performed up to the spin I=20 state. Irregularities found in the yrast spectra and in B (E2) values are discussed in terms of neutron excitations to the high-j orbital g(9/2). Furthermore, the neutron two-quasiparticle structure of a low-K negative-parity band and the proton two-quasiparticle structure of a high-K positive-parity band are predicted to exist near the yrast region. Our study reveals a soft nature for the ground state of N approximate to 40 isotopes and emphasizes the important role of the neutron g(9/2) orbital in determining the structure properties for both low- and high-spin states in these nuclei.

Modification of Fe/Cu multilayers under 400 keV Xe20+ irradiation

Two kinds of Fe/Cu multilayers with different modulation wavelength were deposited on cleaved Si(100) substrates and then irradiated at room temperature using 400 keV Xe20+ in a wide range of irradiation fluences. As a comparison, thermal annealing at 300-900 degrees C was also carried out in vacuum. Then the samples were analyzed by XRD and the evolution of crystallite structures induced by irradiation was investigated. The obtained XRD patterns showed that, with increase of the irradiation fluence, the peaks of Fe became weaker, the peaks related to Cu-based fcc solid solution and Fe-based bcc solid solution phase became visible and the former became strong gradually. This implied that the intermixing at the Fe/Cu interface induced by ion irradiation resulted in the formation of the new phases which could not be achieved by thermal annealing. The possible intermixing mechanism of Fe/Cu multilayers induced by energetic ion irradiation was briefly discussed.

Melting of Au and Al in nanometer Fe/Au and Fe/Al multilayers under swift heavy ions: A thermal spike study

Knowing that Fe is sensitive to swift heavy ion irradiations whereas Au and Al are not, the behavior of nanometric metallic multilayer systems, like [Fe(3 nm)/Au(x)](y) and [Fe(3 nm)/Al(x)](y) with x ranging between 1 and 10 mn, were studied within the inelastic thermal spike model. In addition to the usual cylindrical geometry of energy dissipation perpendicular to the ion projectile direction, the heat transport along the ion path was implemented in the electronic and atomic sub-systems. The simulations were performed using three different values of linear energy transfer corresponding to 3 MeV/u of Pb-208, Xe-132 and Kr-84 ions. For the Fe/Au system, evidence of appearance of a molten phase was found in the entire Au layer, provided the Au thickness is less than 7 nm and 3 nm for Pb and Xe ions, respectively. For the Fe/Al(x) system irradiated with Pb ions, the Al layers with a thickness less than 4 nm melt along the entire ion track. Surprisingly, the Fe layer does not melt if the Al thickness is larger than 2 nm, although the deposited energy surpasses the electronic stopping power threshold of track formation in Fe. For Kr ions melting does not occur in any of the multilayer systems.

Hydrothermal synthesis of Fe and Mn doped SnO2 and its magnetic structures

The dilute magnetic semiconductor of Sn1-x-yMnxFeyO2 (0 <= x <= 0.10, 0 <= y <= 0.10) Were syhthesized with the hydrothermal method using SnCl4, Mn(CH3COO)(2) center dot 4H(2)O and FeCl3 center dot 6H(2)O as the raw materials. The structure, morphologies and magnetic properties of the sample were characterized via X-ray powder diffractometer(XRD), transmission electron microscopy(TEM), Raman spectrum and superconducting and quantum interference device(SQUIT), and Mossbeaur spectrum. No secondary phase was found in the XRD spectrum. The morphology of the samples is affected by the kind or the mount of transition metal. The local vibrating model-of Mn Positioned SnO2 sites was found in Raman spectrum. The measured magnetic results indicate that when x = 0.10, y = 0, the sample exhibits strong magnetization in low-temperature (5 K), but the magnetization decrease rapidly at room. temperature; In contrast, when x = 0, y = 0.1, the sample's magnetization and coercivity are both small, but being temperature independent. Mossbeaur spectra indicates that part of the Fe is ferromagnetic coupled, and the simulating results indicate that the ferromagnetic character is intrinsic.