Monte Carlo simulation of the aggregation of rod-flexible triblock copolymers in a thin film

The aggregation of rod-flexible ABA and BAB triblock (A was rod block and repulsive with block B) copolymers in a thin film was studied as a function of varying the rigidity (eta) and the length of the rod block by Monte Carlo simulation. The rigidity of block A was defined as eta = R-c/R-max in this study. R-c, was the end-to-end distance below which the conformation of the block was not allowed, whereas R-max, was the longest end-to-end distance that the block could be. If eta = 0 the block was flexible, whereas if eta = 1 the block was a straight rod. The simulation results showed that the ABA triblock copolymer film were likely to form lamella structure with increasing the rigidity (eta) of block A. The lamellas were parallel each other and perpendicular to the film surface. However, the aggregation of BAB triblock copolymers tended to change from lamella to cylinder structure with increasing the rigidity (eta) of block A. Typical lamella and cylinder co-exist structure was obtained at eta = 0.504 for the BAB copolymer film. On the other hand, the simulation results indicated that the film changed from disorder to order, then to disorder structure with increasing the relative length of B block for both ABA and BAB copolymer films.

Monte Carlo simulation of miscibility of polymer blends with repulsive interactions: effect of chain structure

The effects of the chain structure and the intramolecular interaction energy of an A/B copolymer on the miscibility of the binary blends of the copolymer and homopolymer C have been studied by means of a Monte Carlo simulation. In the system, the interactions between segments A, B and C are more repulsive than those between themselves. In order to study the effect of the chain structure of the A/B copolymer on the miscibility, the alternating, random and block copolymers were introduced in the simulations, respectively. The simulation results show that the miscibility of the binary blends strongly depends on the intramolecular interaction energy ((ε) over bar (AB)) between segments A and B within the A/B copolymers. The higher the repulsive interaction energy, the more miscible the A/B copolymer and homopolymer C are. For the diblock copolymer/homopolymer blends, they tend to form micro phase domains. However, the phase domains become so small that the blend can be considered as a homogeneous phase for the alternating copolymer/ homopolymer blends. Furthermore, the investigation of the average end-to-end distance ((h) over bar) in different systems indicates that the copolymer chains tend to coil with the decrease Of (ε) over bar (AB) whereas the (h) over bar of the homopolymer chains depends on the chain structure of the copolymers.

AFM studies of DNA structures on mica in the presence of alkaline earth metal ions

As counterions of DNA on mica, Mg2+, Ca2+, Sr2+ and Ba2+ were used for,clarifying whether DNA molecules equilibrate or are trapped on mica surface. End to end distance and contour lengths were determined from statistical analysis of AFM data. It was revealed that DNA molecules can equilibrate on mica when Mg2+, Ca2+ and Sr2+ are counterions. When Ba2+ is present, significantly crossovered DNA molecules indicate that it is most difficult for DNA to equilibrate on mica and the trapping degree is different under different preparation conditions. In the presence of ethanol, using AFM we have also observed the dependence of B A conformational transition on counterion identities. The four alkaline earth metal ions cause the B-A transition in different degrees, in which Sr2+ induces the greatest structural transition.

Monte Carlo simulation of phase behavior of polymer blends with special interactions

Full Paper: The phase, behavior of A-B-random copolymer/C-homopolymer, blends with special interaction was studied by a. Monte, Carlo simulation in two dimensions. The interaction between I segment A and segment C was repulsive, whereas it was attractive between segment B and segment C. The simulation results showed that the blend became two large co-continuous phase domains at lower segment-B component compositions, indicating that the blend showed spinodal decomposition. With an increase of the segment-B component, the miscibility between the copolymer,and the polymer was gradually improved up to being miscible. In addition, it was found that segment B tended to move to the surface of the copolymer phase in the case of a lower component of segment B. On the other hand, if was observed that the average, end-to-end distances ((h) over bar) for both copolymer and polymer changed slowly with increasing segment-B component of the copolymer up to 40%, thereafter they increased considerably with increasing segment B component. Moreover, it was found that the (h) over bar of the copolymer was obviously shorter than that of the homopolymer for the segment-B composition, region from 0% to 80%. Finally, a, phase diagram showing I phase and - II phase regions under the condition of constant-temperature is presented.

Study on the two class glass transition and ion transport of a comb polymer electrolyte

The thermal behaviour and ion-transport properties of a comb polymer electrolyte CP350/LiSCN based on methyl vinyl ether/maleic anhydride copolymer with oligo-oxyethylene side chains were studied by means of DSC and ac impedance method. The two glass transition temperatures which can be attributed to side chains and main chains respectively were found to increase with increasing salt concentration. Conductivities which displayed non-Arrhenius behaviour were analyzed by using Vogel-Tammann-Fulcher equation and interpreted on the basis of the configurational entropy model derived by Gibbs and coworkers. The optimum ionic conductivity at 25 degrees C achieved was 2.19x10(-5)S/cm.

MOLECULAR-GEOMETRY AND CHAIN ENTANGLEMENT - PARAMETERS FOR THE TUBE MODEL

The tube diameter in the reptation model is the distance between a given chain segment and its nearest segment in adjacent chains. This dimension is thus related to the cross-sectional area of polymer chains and the nearest approach among chains, without effects of thermal fluctuation and steric repulsion. Prior calculated tube diameters are much larger, about 5 times, than the actual chain cross-sectional areas. This is ascribed to the local freedom required for mutual rearrangement among neighboring chain segments. This tube diameter concept seems to us to infer a relationship to the corresponding entanglement spacing. Indeed, we report here that the critical molecular weight, M(c), for the onset of entanglements is found to be M(c) = 28 A/([R2]0/M), where A is the chain cross-sectional area and [R2]0 the mean-square end-to-end distance of a freely jointed chain of molecular weight M. The new, computed relationship between the critical number of backbone atoms for entanglement and the chain cross-sectional area of polymers, N(c) = A0,44, is concordant with the cross-sectional area of polymer chains being the parameter controlling the critical entanglement number of backbone atoms of flexible polymers.

可重构模块化机器人系统的爬坡能力研究

介绍了一种新型的可重构模块化星球探测机器人系统,详细分析了子机器人组合的三种基本构型:手臂在前,首尾相连成串状;手臂在后,首尾相连成串状;两个子机器人首尾相连成环状。以两个子机器人为例,对爬坡过程中子机器人系统的各种组合形式进行了静力学分析,在此基础上,对机器人组合的爬坡能力进行了仿真研究,结果表明子机器人组合的爬坡能力与其连接构型紧密相关。实际试验很好地验证了仿真结果,同时,以实际试验为基础,得出了如下结论:在爬坡过程中,手臂在前的串状连接的机器人组合的运动稳定性较差,首尾相连的环状连接的机器人组合是子机器人组合爬坡的首选构型。

北极Gakkel超慢速扩张脊大洋橄榄岩的地球化学特征及其意义

Gakkel Ridge in Arctic Ocean is the ulstraslow spreading ridge in the world with a full spreading rate decreasing from 14 mm/yr in the western end to 7mm/yr in the eastern end. To study the histories of partial melting and melt referilization occurred in the oceanic mantle beneath Gakkel Ridge, both extremely fresh and altered abyssal peridotites from two dredge hauls (PS66-238 and HLY0102-D70) have been selected in this research. Major and trace element data of the residual minerals suggest that all samples have been refertilized by late enriched melts after low to moderate degrees (3-12%) of partial melting in the stability field of spinel, whereas some samples also inherited signatures of partial melting in stability field of garnet. Os isotopic compositions of Gakkel samples have not been significantly affected by late processes, e.g., seawater alteration and melt refertilzaiton. Samples from both dredge hauls have similar range of 187Os/188Os, from strongly unradiogenic (~0.114) in the harzburgites to approximating the inferred values of PUM (primitive upper mantle) in some lherzolites (~0.129). Inherited ancient depletion events in the harzburgites with Re-depletion age up to 2 billion years are unrelevant to the recent genesis of MORB (mid-ocean ridge basalts) beneath Gakkel Ridge. Comparisons of highly siderophile elements (HSEs) between the fresh and altered samples suggested both Pd and Re were affected and thus are mobile during seawater alteration, whereas the other HSEs (i.e., Os, Ir, Ru an Pt) are stable. The fractionated HSEs patterns in the harzburgites suggest both PPGEs (Pt and Pd) and Re can be fractionated from IPGEs (Os, Ir and Ru) at low degree of partial melting, which might be due to physical dredging of sulfide melts by silicate melts rather than equilibrium partitioning between residues and silicate melts. Inferred HSEs budget of the PUM confirm the previous study that both Ru/Ir and Pd/Ir are suprachondritic in the PUM. Some modifications of late-veneer hypothesis are required in light of the unique PUM composition. HSEs and Os isotopic compositions of Gakkel abyssal peridotites indicate the oceanic mantle is highly heterogeneous within a scale of one dredge haul (<5 km). Both depleted and fertile mantle domains are likely to be mechanically juxtaposed in the asthenosphere in a state of ‘plum pudding’. Widely distribution of ancient depleted components in the asthenosphere suggests that DMM (depleted MORB mantle) should not be synonymous with the MORB source. The later is just the fertile part of the former, i.e., the depleted components in the DMM do not or contribute little to the genesis of MORB.

On a novel method of impact by a front-end-coated bullet to evaluate the interface adhesion between film and substrate

A preliminary experiment was carried out to validate the feasibility of the method of impact by a front-end-coated bullet to evaluate the interface adhesion between film and substrate. The theoretical description of the initiation, propagation and evolution of the stress pulse during impact was generalized and formulized. The effects of the crucial parameters on the interface stress were further investigated with FEM. The results found the promising prospect of the application of such a method and provided useful guidance for experimental design.

Is the genus Digramma synonymous to the genus Ligula (Cestoda : Pseudophyllidea)? Evidence from ITS and 5 ' end 28S rDNA sequences

The genus Digramma (Cestoda: Pseudophyllidea) described by Cholodkovsky in 1915 differs from the genus Ligula only by the number of the reproductive organs per proglottis. However, the occurrence of transitional forms in Digramma raises much confusion concerning its generic validity. In the present study, cestodes previously designated as Digramma and Ligula were collected from lakes in the lower and middle reaches of the Yangtze River, and also from Qinghai Lake on Qingzang plateau, China. The entire internal transcribed spacer of the ribosomal DNA (ITS rDNA) and 5' end of 28S rDNA were compared between the Digramma and Ligula specimens. The low level of nucleotide variation between the two genera may imply that cestodes in the genus Digramma are paraphyletic to the Ligula genus, and Digramma is a synonym of Ligula. However, whether previously identified Digramma cestodes represent different species in the genus Ligula requires further investigation.

Assembly of side-functional monomers with inorganic nanometer particles

Monomers of methacrylate with various pi -conjugated pendants were designed and prepared in our laboratory, The monomer with suitable end-group was successfully assembled with nano-scale inorganic particles to form an orderly-aligned structure that showed special optical properties, both absorption and emission band were much red-shifted compared with the monomer, A new type of organic/inorganic hybrid materials was obtained by in situ polymerization of the assembly, The hybrid materials could also show special optical properties as the assembly, This might open a new route to tune the emission color.

Compatibilization of side-chain, thermotropic, liquid-crystalline ionomers to blends of polyamide-1010 and polypropylene

A novel side-chain, liquid-crystalline ionomer (SLCI) with a poly(methyl hydrosiloxane) main chain and side chains containing sulfonic acid groups was used in blends of polyamide-1010 (PA1010) and polypropylene (PP) as a compatibilizer. The morphological structure, thermal behavior, and liquid-crystalline properties of the blends were investigated by Fourier transform infrared, differential scanning calorimetry, thermogravimetric analysis, and scanning electron microscopy. The morphological structure of the interface of the blends containing SLCI was improved with respect to the blend without SLCI. The compatibilization effect of greater than 8 wt % SLCI for the two phases, PA1010 and PP, was better than the effects of other SLCI contents in the blends.