Direct decomposition of NO activated by microwave discharge

The environmentally friendly removal of NO has been investigated using continuous microwave discharge (CMD) at atmospheric pressure. In these experiments, conversions of NO to N-2 as well as NO2 were mainly observed for both dry and wet feed gas, which showed a great difference from those observed with other discharge methods. The effects of a series of reaction parameters, including microwave input power, O-2 concentration, NO concentration, and gas flow rate, on the product distribution and energy efficiency were also studied. Under all reaction conditions, the conversions of NO to N-2 were higher than those to NO2. The highest conversion of NO to N-2 was 88%. The reaction rate of NO removal and the effects of the different discharge modes on NO conversion and product distribution are also discussed. Through comparison of the results of different discharge modes, it was found that the addition of CH4 apparently increased the conversion of NO to N-2 as well as the energy efficiency. A possible reaction process is suggested.

Nafion/PTFE composite membranes for fuel cell applications

Porous polytetrafluoroethylene (PTFE) membranes were used as support material for Nafion((R))/PTFE composite membranes. The composite membranes were synthesized by impregnating porous PTFE membranes with a self-made Nafion solution. The resulting composite membranes were mechanically durable and quite thin relative to traditional perfluorosulfonated ionomer membranes (PFSI); we expect the composite membranes to be of low resistance and cost. In this study, we used three kinds of porous PTFE films to prepare Nafion/PTFE composite membranes of different thickness. Scanning electron micrographs and oxygen permeabilities showed that Nafion resin is distributed uniformly in the composite membrane and completely plug the micropores, there is a continuous thin Nation film present on the PTFE surface. The variation in water content of the composite and Nafion 115 membranes with temperature was determined. At the same temperature, water content of the composite membranes was smaller than that of the Nafion 115. In both dry and wet conditions, maximum strength and break strength of C-325(#) and C-345(#) were larger than those of Nafion 112 due to the reinforcing effect of the porous PTFE films. And the PEMFC performances and the lifetime of the composite membranes were also tested on the self-made apparatus. Results showed that the bigger the porosity of the substrate PTFE films, the better the fuel cell performance; the fuel cell performances of the thin composite membranes were superior to that of Nation 115 membrane; and after 180 h stability test at 500 mA/cm(2), the cell voltage showed no obvious drop. (C) 2002 Published by Elsevier Science B.V.

黄土高原气候变迁、植被演替与土壤干层的形成

2 .5Ma B.P.以来 ,受地球轨道要素周期性变化和青藏高原阶段性强烈隆升的影响 ,黄土高原地区气候存在着干期与湿润交替出现的现象 ,但总的趋势是向干旱化方向演化。黄土高原第四纪以来草本植物一直较为繁茂 ,木本植物仅在少数几个时期处于优势地位。现代黄土高原人工林草植被普遍存在着土壤干层问题。土壤干层的形成是气候干旱化过程中必然出现的现象 ,它是导致植被演替的直接原因之一。人工植被激发并强化了土壤干层的形成。土壤干层的形成是气候干旱化和人工植被选择不当两个方面综合作用的结果 ,但有望通过有关人工措施使其危害得到缓解

北天山新生代构造演化与古环境演变

The Tianshan Mountains is located about 1000-2000 km north of the India-Asia suture and is the most outstanding topography in central Asia, with transmeridional length of nearly 2500 km, north-southern wideness of ~ 300-500 km, peaks exceeding 7000 m above sea level (asl.), and average altitude of over 4000 m asl. Much of the modern relief of the Tianshan Range is a result of contraction driven by the collision of the India subcontinent with the southern margin of Asia, which began in early Tertiary and continues today. Understanding where, when and how the deformation of the Tianshan Mountains occurred is essential to decipher the mechanism of intracontinental tectonics, the process of foreland basin evolution and mountain building, and the history of climate change in central Asia. In order to better constrain the Cenozoic building history of the Tianshan Mountains and the climate change in the southern margin of the Junggar Basin, we carried out multiple studies of magnetostratigraphy, sedimentology, and stable isotopes of paleosol carbonate at the Jingou River section, which is located at the Huoerguosi anticline, the westernest one of the second folds and thrust faults zone in the northern piedmont of the Tianshan Mountains. The Jingou River section with a thickness of about 4160 m is continuous in deposits according to the observed gradual change in sedimentary environments and can be divided into five formations: Anjihaihe, Shawan, Taxihe, Dushanzi and Xiyu in upward sequence. Characteristic remamences were isolated by progressive thermal demagnetization, generally between 300 and 680℃. A total of 1133 out of 1607 samples yielded well-defined ChRMs and were used to establish the magnetostratigraphic column of a 3270-m-thick section from the exposed base of the Anjihaihe Formation to the middle of the Xiyu Formation. Two vertebrate fossil sites and a good correlation with the CK95 geomagnetic polarity time scale suggest that the section was deposited from ~30.5 to ~4.6 Ma and the age of the top of the Xiyu formation is ~2.6 Ma based on an extrapolation of the sedimentation rates. A plot of magnetostratigraphic age vs. height at the Jingou River section shows that significant increases in sedimentation rates as well as notable changes in depositional environments occurred at ~26-22.5 Ma, ~13-11 Ma and ~7 Ma, which represent the initial uplift of the Tianshan Mountains and two subsequent rapid uplift events. In addition, changes in sedimentation rates display characteristic alternations between increases and decreases, which probably indicate that the uplift of the Tianshan Mountains was episodic. We discussed the history of C4 biomass and climatic conditions in the southern margin of the Junggur Basin using the stable carbon and oxygen isotope composition of paleosol carbonates from the Jingou River section during ~17.5-6.5 Ma. The δ13C values indicate that the proportion of C4 biomass was uniform and moderate (15-20 %) during the interval of ~17.5-6.5 Ma. We proposed three hypotheses for this pattern of C4 biomass: (1) counteraction of two opposed factors (global cooling since ~15 Ma and thereafter increased dry and seasonality in central Asia) controlling the growth of C4 grasses, (2) variability in abundance of C3 grasses relative to C3 trees and shrubs if vegetation had ever changed in ecosystems, and (3) the higher latitude of the studied region. The δ18O values show a stepwise negative trend since ~13 Ma which may be attributed to three factors: (1) the temperature decreasing gradually after the middle Miocene (~15 Ma), (2) the increasing contribution of the moistures carried by the polar air masses from the Arctic Ocean to precipitation, and (3) the gradual retreat westward and disappearance of the Paratethys Ocean. Among them, which one played a more important role will need further study of the paleoclimate in central Asia.

离散裂缝诱导各向异性粘弹性地震波模拟与特征分析

The real media always attenuate and distort seismic waves as they propagate in the earth. This behavior can be modeled with a viscoelastic and anisotropic wave equation. The real media can be described as fractured media. In this thesis, we present a high-order staggered grid finite-difference scheme for 2-D viscoelastic wave propagation in a medium containing a large number of small finite length fractures. We use the effective medium approach to compute the anisotropic parameters in each grid cell. By comparing our synthetic seismogram by staggered-grid finite-difference with that by complex-ray parameter ray tracing method, we conclude that the high-order staggered-grid finite-difference technique can effectively used to simulate seismic propagation in viscoelastic-anisotropic media. Synthetic seismograms demonstrate that strong attenuation and significant frequency dispersion due to viscosity are important factors of reducing amplitude and delaying arrival time varying with incidence angle or offset. On the other hand, the amount of scattered energy not only provides an indicator of orientation of fracture sets, but can also provide information about the fracture spacing. Analysis of synthetic seismograms from dry- and fluid-filled fractures indicates that dry-filled fractures show more significant scattering on seismic wavefields than fluid-filled ones, and offset-variations in P-wave amplitude are observable. We also analyze seismic response of an anticlinal trap model that includes a gas-filled fractured reservoir with high attenuation, which attenuates and distorts the so-called bright spot.

鄂尔多斯盆地东部地区奥陶系马家沟组沉积相与储层特征研究

Ordos Basin is one of the primary bases for petroleum exploration in our country. A series of Ordovician large gas fields were discovered, which suggest that the Lower Paleozoic carbonate, especiallly for Ordovician carbonate rocks, preserve plenty of hydrocarbon resources. Well Longtong 1 is studied as the typical exploration well. Acorrding to the specific research on the type of lithology, texture, structure and sedimentary sequence in Ordovician Majiagou Formation as well as additional data from another 20 wells, the sedimentary model has been built in Majiagou Formation. The sedimentary characteristics for each Member in Majiagou Formaiton and the feature of distribution are well understood as below: It suggests that period of Member 1, Member 3 and Member 5 in Majiagou Formation characterize with dry and hot climate as well as drop of the sea level. The area of Well Longtan 1 in the eastern basin is abundant of platform evaporite lithofacies with the depositional anhyrock and salt rock, whereas yield a suite of dolomite intercalated by the thin layers of anhyrock from the anhyrcok-dolomite platform sediment. It deposits muddy dolomite, dolomitic limestone and fine-grain dolomite in limestone-dolomite platform and restricted sea. During the stage of Member 2 and Member 4 in Majiagou Formation, the climate is wet and hot with increasing sea level. The study region occurs limestone with little dolomite in the open sea environment; but the margin area is the restricted sea settings with interbeding dolomite and limestone. Based on the thin section identification, element and isotope analysis as well as the study of texture and structure, it sugguests that the main reserviors are dolomite while the gypsum are major cap rocks. The Member 2 in Majiagou Formation is both the source rocks and the resveroirs; gypsum rocks widely occur in Member 3 as the better cap; similar to the Member 2, the Member 4 in Majiagou Formation is both the source rocks and the resveroirs; there are two source-reservoir-cap assemblages in the Member 5 alone and the cap is gypsum with high quality and great thickness, which is a favorite source-reservoir-cap assemblage.

水对辉绿岩脆延性转化的影响

Transition from brittle fracture to ductile creep of the Gaojiabian diabase is investigated as a function of temperature and water content. Experiments are conducted at 500 MPa confining pressure, with strain rate being 1 * 10~(-4) and temperature from 300 ℃ to 800 ℃. The transition from semibrittle to ductile flow of dry diabase occurs at temperatures between 700 ℃ and 750 ℃, while the transition of wet diabase takes place at about 500 ℃. The transition temperature in the wet diabase is about 200 ℃ lower than in the dry diabase. The strength of both dry and wet samples is temperature insensitive in brittle-semibrittle regime and temperature sensitive in ductile regime. At the same conditions, water within the sample could weaken the strength of wet samples. The microstructures of dry and wet samples are different. In experimental conditions, feldspars show two different deformation mechanisms, the first acting in brittle and semibrittle regime and the second acting in plastic regime, and water must have greatly affected the two mechanisms. Strength of pyroxene is lower than that of feldspar at low temperature. Pyroxene can be transformed to hornblende in deformation process and this transformation is quite temperature and water dependent. Feldspar plays a key role in the deformation in its first mechanism regime, and no dominant minerals are identified in the second mechanism regime of feldspar. The result of FTIR analysis show that water exists in wet sample in the form of -OH.

我国北方沙质沉积物气候代用指标对比研究

In this study we examined samples of sandy sediments along the north-south transects crossing the Taklimakan Desert, the Badain Jaran Desert and the Hunshandake Sandy Land respectively. The grain size was measured via dry sieving, and the carbonate content by means of an Eijkelkamp instrument. The analyses of grain size and carbonate contents show: (1) The sand grains of the Badain Jaran Desert are coarsest and best sorted, this should be associated with the strongest usual wind among these three regions. (2) The different desert have its special wind condition in their own regions. The Badain Jaran Desert and the Taklimakan Desert both show that the wind is getting weaker from north towards south, but the Hunshandake Sandy Land have the similar wind stress from north towards south. (3) The frequency curves of the sandy sediments from the Badain Jaran Desert show a kind of distinct double peaks, presumably associated with the alternative transportations of summer and winter monsoons in the north boundaries of the summer monsoon. (4) There are great differences of the carbonate contents among these three regions, this maybe associated with the humidity, the humidity of Hunshandake Sandy Land is the best, and the one of the Taklimakan Desert would be the worst among them. Analyses of The three profiles about grain size and carbonate contents show: (1) From 8ka BP, the winter-monsoon was getting weaker, and the summer-monsoon accordingly became stronger, and about 1 ka later, the winter-monsoon was getting stronger again. (2) In the stage of the profiles, there maybe show two circles of dry and wet climate, and the climate changes in those three regions show the similar trend.