An asymmetric MOSFET-C band-pass filter with on-chip charge pump auto-tuning

An asymmetric MOSFET-C band-pass filter(BPF)with on chip charge pump auto-tuning is presented.It is implemented in UMC (United Manufacturing Corporation)0.18μm CMOS process technology. The filter system with auto-tuning uses a master-slave technique for continuous tuning in which the charge pump OUtputs 2.663 V, much higher than the power supply voltage, to improve the linearity of the filter. The main filter with third order low-pass and second order high-pass properties is an asymmetric band-pass filter with bandwidth of 2.730-5.340 MHz. The in-band third order harmonic input intercept point(HP3) is 16.621 dBm,wim 50 Ω as the source impedance. The input referred noise iS about 47.455μVrms. The main filter dissipates 3.528 mW while the auto-tuning system dissipates 2.412 mW from a 1.8 V power supply. The filter with the auto-tuning system occupies 0.592 mm~2 and it can be utilized in GPS (global positioning system)and Bluetooth systems.

Study of intensity-dependent nonlinear optical coefficients of GaP optical crystal at 800 nm by femtosecond pump-probe experiment

The intensity-dependent two-photon absorption and nonlinear refraction coefficients of GaP optical crystal at 800 nm were measured with time-resolved femtosecond pump-probe technique. A nonlinear refraction coefficient of 1.7*10^(-17) m2/W and a two-photon absorption coefficient of 1.5*10^(-12) m/W of GaP crystal were obtained at a pump intensity of 3.5*10^(12) W/m2. The nonlinear refraction coefficient saturates at 3.5*10^(12) W/m2, while the two-photon absorption coefficient keeps linear increase at 6*10^(12) W/m2. Furthermore, fifth-order nonlinear refraction of the GaP optical crystal was revealed to occur above pump intensity of 3.5*10^(12) W/m2.

新型HIRFL-800低温泵的设计及热负荷的计算

介绍了近代物理研究所自行研制的新型HIRFL 80 0低温泵。对其抽速、低温冷凝板和屏蔽板的热负荷进行了具体的分析和计算。肯定了新型HIRFL 80 0低温泵的设计方案

HIRFL前束线真空系统的改造与HIRFL-800低温泵的设计及热负荷的计算

本论文首先介绍真空技术涉及的物理基础和真空获得的有关知识，然后讲述，了H_RFL（兰州重离子加速器研究装置）真空系统的基本概况，在此基础上阐述了本论文主要的两部分：H_RFL前束线真空系统的改造；新型H_RFL佩800低温泵的设计一及热负荷的计算。其中H工RF［前束线真空系统的改造已经于2001年9月份完成并为兰州重离子加速器的正常运行提供了必要的真空条件。新型111佩又FL佩800低温泵正在加工生产中，并将用于大型超高真空系统H工R凡厂SSC（兰州重离子加速器研究装置主加速器）的抽空。H工RFL前束线真空系统的改造介绍了兰州重离子加速器前束线真空系统的基本结构，详细说明了H工RFL前束线真空系统改造前的流导、气体负荷及压力分布情况。提出了具体的改造措施。真空系统达到了预计要求：泵口压强小于5只10-6Pa，两泵之间束运管道中心平面压强小于1x10-5Pa.结果表明H工RFL前束线真空系统的改造方案是有效的。新型HIRFL一800低温泵的设计及热负荷的计算介绍了近代物理研究所自行研制的新型H工RFL一800低温泵。对其抽速，低温冷凝板和屏蔽板的热负荷进行了具体的分析和计算。肯定了新型H工RFL佩800低温泵的设计方案。

Rapid synthesis of Mn0.65Zn0.35Fe2O4/SiO2 homogeneous nanocomposites by modified sol-gel auto-combustion method

MnZn-ferrite/SiO2 nanocomposites with different silica content were successfully fabricated by a novel modified sol-gel auto-combustion method using citric acid as a chelating agent and tetraethyl orthosilicate (TEOS) as the source of silica matrix. The auto-combustion nature of the dried gel was studied by X-ray diffraction (XRD), Infrared spectra (IR), thermogravimetry (TG) and differential thermal analysis (DTA). Transmission electron microscope (TEM) observation shows that the MnZn-ferrite particles are homogeneously dispersed in silica matrix after auto-combustion of the dried gels. The magnetic properties vary with the silica content. The transition from the ferromagnetic to paramagnetic state is observed by Mossbauer spectra measurement with the increasing silica content. Vibrating sample magnetometer (VSM) shows that the magnetic properties of Mn0.65Zn0.35Fe2O4/SiO2 nanocomposites strongly depend on the silica content.