Analysis of the interfaces of [NiFe/Mo](30) and [Fe/Mo](30) multilayers

The interface states of [NiFe/Mo](30) and [Fe/Mo](30) multilayers have been investigated by x-ray small angle reflection and diffuse scattering. Significant interface roughness correlation was observed in both ultrathin [NiFe/Mo](30) and [Fe/Mo](30) multilayers. An uncorrelated roughness of about 27-3.1 Angstrom was revealed in the [NiPe/Mo](30) multilayers, which is explained as originating from a transition layer between the NiFe and the Mo layers. By the technique of diffuse scattering, it is clearly indicated that the interfacial roughness of NiFe/Mo is much smaller than that of Fe/Mo although the lattice mismatch is the same in both multilayers.

Study on the hydrolysis/precipitation behavior of Keggin Al-13 and Al-30 polymers in polyaluminum solutions

The hydrolysis/precipitation behaviors of Al3+, Al-13 and Al-30 under conditions typical for flocculation in water treatment were investigated by studying the particulates' size development, charge characteristics, chemical species and speciation transformation of coagulant hydrolysis precipitates. The optimal pH conditions for hydrolysis precipitates formation for AlCl3, PAC(A113) and PAC(A130) were 6.5-7.5, 8.5-9.5, and 7.5-9.5, respectively. The precipitates' formation rate increased with the increase in dosage, and the relative rates were AlCl3 >> PAC(A130) > PACA113. The precipitates' size increased when the dosage increased from 50 mu M to 200 mu M, but it decreased when the dosage increased to 800 AM. The Zeta potential of coagulant hydrolysis precipitates decreased with the increase in pH for the three coagulants. The isoelectric points of the freshly formed precipitates for AlCl3, PAC(A113) and PAC(A130) were 7.3, 9.6 and 9.2, respectively. The Zeta potentials of AlCl3 hydrolysis precipitates were lower than those of PAC(A113) and PAC(A130) when pH > 5.0. The Zeta potential of PAC(A130) hydrolysis precipitates was higher than that of PACA113 at the acidic side, but lower at the alkaline side. The dosage had no obvious effect on the Zeta potential of hydrolysis precipitates under fixed pH conditions. The increase in Zeta potential with the increase in dosage under uncontrolled pH conditions was due to the pH depression caused by coagulant addition. Al-Ferron research indicated that the hydrolysis precipitates of AlCl3 were composed of amorphous AI(OH)3 precipitates, but those of PACA113 and PACA130 were composed of aggregates of Al-13 and Al-30, respectively. Al3+ was the most un-stable species in coagulants, and its hydrolysis was remarkably influenced by solution pH. Al-13 and Al-30 species were very stable, and solution pH and aging had little effect on the chemical species of their hydrolysis products. The research method involving coagulant hydrolysis precipitates based on Al-Ferron reaction kinetics was studied in detail. The Al species classification based on complex reaction kinetic of hydrolysis precipitates and Ferron reagent was different from that measured in a conventional coagulant assay using the Al--Ferron method. The chemical composition of Al-a, Al-b and Al-c depended on coagulant and solution pH. The Al-b measured in the current case was different from Keggin Al-13, and the high Alb content in the AlCl3 hydrolysis precipitates could not used as testimony that most of the Al3+ Was converted to highly charged Al-13 species during AlCl3 coagulation.

On the acid-base stability of Keggin Al-13 and Al-30 polymers in polyaluminum coagulants

The acid-base stabilities of Al-13 and Al-30 in polyaluminum coagulants during aging and after dosing into water were studied systematically using batch and flow-through acid-base titration experiments. The acid decomposition rates of both Al-13 and Al-30 increase rapidly with the decrease in solution pH. The acid decompositions of Al-13 and Al-30 with respect to H+ concentration are composed of two parallel first-order and second-order reactions, and the reaction orders are 1.169 and 1.005, respectively. The acid decomposition rates of Al-13 and Al-30 increase slightly when the temperature increases from 20 to ca. 35 A degrees C, but decrease when the temperature increases further. Al-30 is more stable than Al-13 in acidic solution, and the stability difference increases as the pH decreases. Al-30 is more possible to become the dominant species in polyaluminum coagulants than Al-13. The acid catalyzed decomposition and followed by recrystallization to form bayerite is one of the main processes that are responsible for the decrease of Al-13 and Al-30 in polyaluminum coagulants during storage. The deprotonation and polymerization of Al-13 and Al-30 depend on solution pH. The hydrolysis products are positively charged, and consist mainly of repeated Al-13 and Al-30 units rather than amorphous Al(OH)(3) precipitates. Al-30 is less stable than Al-13 upon alkaline hydrolysis. Al-13 is stable at pH < 5.9, while Al-30 lose one proton at the pH 4.6-5.75. Al-13 and Al-30 lose respective 5 and 10 protons and form [Al-13] (n) and [Al-30] (n) clusters within the pH region of 5.9-6.25 and 5.75-6.65, respectively. This indicates that Al-30 is easier to aggregate than Al-13 at the acidic side, but [Al-13] (n) is much easier to convert to Alsol-gel than [Al-30] (n) . Al-30 possesses better characteristics than Al-13 when used as coagulant because the hydrolysis products of Al-30 possess higher charges than that of Al-13, and [Al-30] (n) clusters exist within a wider pH range.

30.4nm极紫成像探测器实验研究

中国科学院知识创新方向性项目(061Z291213) 资助课题

The Kiloparsec-scale structure of 3C 286

We present radio images of the compact steep spectrum (CSS) quasar 3C 286 acquired with the Very Large Array (VLA) at 8.4 and 22.5 GHz. The source exhibits a two-sided core-jet structure with a bright central component and two extended components one to the east (P.A. 100degrees) and another to the southwest (P.A. -116degrees). From the compact core, an extension runs towards the southwest component up to similar to 0.7 arcsecond. The emission between the primary central component and the southwest component exhibits a knotty structure. A gradual change of the jet position angles from -135degrees to -120degrees in the inner southwest jet suggests a local bend. The position angle changes of the major eastern components E2 and E1 suggest that the eastern jet likely follows a curved trace. The bends in the jet trace may be associated with a relativistic precession or some interaction between the jet and the ambient matter. A mean spectral index of alpha(8.4)(22.5) similar to -0.76 (S-nu proportional to nu(alpha)) is estimated for the core component. Steep spectra are also obtained for the extended southwest component (2.6", P.A. -116degrees) and eastern component (0.8", P.A. 100degrees), with alpha(8.4)(22.5) similar to -0.88 and alpha(8.4)(22.5) similar to -1.79, respectively. The radio morphologies and spectral index distributions suggest that the core seen in our images is likely to be the beamed inner jet while the real nucleus is dimmed by it beaming away from us.

近30年来陕北黄土高原土地利用动态变化分析

基于1975年的LandsatMSS影像,1986年、1997年和2006年的Landsat TM影像,利用遥感影像的计算机自动分类和目视解译,得到这4a的土地利用信息。利用ERDAS中的GIS分析模块和统计方法对这4a的土地利用图进行统计分析,得到1975-1986年、1986-1997年和1997-2006年这3个时间段的土地利用变化的数量、速度、幅度、空间格局特征。结果表明:耕地经历了一个先增加后减少的过程,草地、林地先减少后增加,居民地一直处于增加状态,未利用地从整体上来说处于减少状态,只不过在中期有一定数量的波动;在前期和中期土地利用类型间的相互转化基本一致,后期土地利用类型间的相互转化有所增强;耕地、草地、林地和未利用地是该地区土地利用变化的主导类型,主要是耕地、草地与其它土地利用类型间的相互转化。

纳秒激光诱导C_(60)分子碎裂中轻碎片离子C_n~+(n<30)的产生机理研究

采用飞行时间质谱计测量了纳秒激光诱导C60分子碎裂中轻碎片离子Cn+(n≤11)的初始平均动能,结果显示轻碎片离子具有相同的初始平均动能(约为0.34 eV),并且该动能在一定范围内不随激光通量的变化而明显改变.结合前人的实验结果,对纳秒激光诱导C60分子碎裂中轻碎片离子Cn+(n<30)的主要产生模式作了新的阐述,即C60分子级联发射15个C2分子和一个电子形成自身不稳定的C3+0离子,在皮秒时间尺度内C3+0离子的笼形结构塌陷,进而轻碎片离子产生.