Euler Solution Using Adaptive Cartesian Grid With A Gridless Boundary Treatment

A quadtree-based adaptive Cartesian grid generator and flow solver were developed. The grid adaptation based on pressure or density gradient was performed and a gridless method based on the least-square fashion was used to treat the wall surface boundary condition, which is generally difficult to be handled for the common Cartesian grid. First, to validate the technique of grid adaptation, the benchmarks over a forward-facing step and double Mach reflection were computed. Second, the flows over the NACA 0012 airfoil and a two-element airfoil were calculated to validate the developed gridless method. The computational results indicate the developed method is reasonable for complex flows.

A Simple Model For Predicting The Void Fraction Of Gas/Non-Newtonian Fluid Intermittent Flows In Upward Inclined Pipes

In this work, a simple correlation, which incorporates the mixture velocity, drift velocity, and the correction factor of Farooqi and Richardson, was proposed to predict the void fraction of gas/non-Newtonian intermittent flow in upward inclined pipes. The correlation was based on 352 data points covering a wide range of flow rates for different CMC solutions at diverse angles. A good agreement was obtained between the predicted and experimental results. These results substantiated the general validity of the model presented for gas/non-Newtonian two-phase intermittent flows.

Energetic protons emitted from coulomb explosion dynamics of large-sized hydrogen clusters driven by an ultrashort intense laser pulse

Protons with very high kinetic energy of about 10keV and the saturation effect of proton energy for laser intensity have been observed in the interaction of an ultrashort intense laser pulse with large-sized hydrogen clusters. Including the cluster-size distribution as well as the laser-intensity distribution on the focus spot, the theoretical calculations based on a simplified Coulomb explosion model have been compared with our experimental measurements, which are in good agreement with each other.

掺杂Nd对GdFeCo薄膜的磁光性能的影响

制备了三元GdFeCo合金薄膜和四元NdGdFeCo合金薄膜,测量了其磁饱和磁化强度对温度的依赖关系、磁滞回线以及可见光范围内的克尔谱.研究了轻稀土Nd掺杂对GdFeCo磁光薄膜的克尔旋转角的影响,发现在一定掺杂范围内能够有效提高薄膜在短波长下的克尔旋转角.掺入适量的轻稀土Nd可以使GdFeCo薄膜在短波长下的磁光性能提高,更好的适用于作为中心孔探测磁超分辨的短波长磁光读出层材料.

硬边非稳腔平面波导激光器的光束特性

基于衍射理论和坐标变换,采用数值模拟的方法分析了硬边非稳腔平面波导激光器的光束特性,研究了存在非均匀抽运和增益饱和时,输出激光的光束质量.在端面抽运和边缘抽运时,比较了正支和负支非稳腔的输出光束特性.结果表明：利用优化的离轴硬边非稳腔可以得到近衍射极限的输出.在相同的抽运不均匀性情况下,对于边缘抽运和端面抽运,正支非稳腔的光束质量因子M^2分别为3.9和2.3,而相同条件下负支非稳腔的M^2因子为1.8和1.7.

TeO2-AlF3氟碲酸盐玻璃的性质和结构

制备了不同氟化物含量的（1-x）TeO2-AlF3（x=10％，20％，30％，按摩尔计）透明氟碲酸盐玻璃。利用差热分析和Raman光谱对玻璃的性质和结构进行研究。结果显示：当x达到30％时，氟化铝以Al-F多面体的形式进入玻璃网络结构。随着氟化物含量增加，玻璃在中红外区的透过率提高，玻璃结构单元从[Te（O，F）4]三方双锥向[Te（O，F）3]三方锥转变。Raman光谱显示：1个宽的强峰出现在750～840cm^-1，表明玻璃中Te-O键长介于0．185-0．196nm之间。

不同退火气氛下γ-LiAlO2形貌和结构研究

研究了温度梯度法生长的γ-LiAlO2晶体在1100℃下富Li气氛和空气中退火处理后的表面形貌、表面结构以及吸收光谱。发现γ-LiAlO2晶体的抛光面在1100℃空气中退火后变为粗糙面，X射线衍射(XRD)分析表明此粗糙面为单相的LiAl5O8。而γ-LiAlO2晶体的抛光面在1100℃富Li气氛中处理后几乎没有变化。同时对不同气氛下热处理的γ-LiAlO2晶体进行了光谱分析，确认了晶片中196nm的吸收峰是由Li空位引起的。

Study on growth and properties of novel gamma-LiAlO2 substrate

Transparent gamma-LiAlO2 single crystal has been grown by Temperature Gradient technique. The surface of the wafer annealed in O-2-atmosphere at 1100 degrees C for 70 h became opaque and Li-poor phase (LiAl5O8); while, that annealed in Li-rich atmosphere kept transparent and smooth. The full-width at half maximum value dropped to 30 arcsecs when the wafer was annealed in Li-rich atmosphere. That annealed in O-2-atmosphere increased to 78 arcsec. Compared with absorption spectra, we can conclude that the 196 nm absorption peak was caused by Li vacancies and the 736 nm peak was caused by O vacancies.

窄带干涉滤光片抗击不同输出方式激光的损伤特性研究

利用Nd：YAG调Q单脉冲激光和自由脉冲激光对硬膜窄带干涉滤光片进行激光损伤阈值的测试，并且采用表面热透镜技术测量了滤光片的吸收率。实验发现：窄带干涉滤光片的吸收率和激光损伤阈值强烈依赖于辐照激光波长与窄带干涉滤光片通带的相对位置；在调Q单脉冲激光作用下，不同中心波长的滤光片损伤形貌存在明显的差别，而在自由脉冲激光作用下，各滤光片的损伤形貌则趋于相同．均表现为典型的热熔烧蚀破坏。根据实验结果，结合损伤形貌，通过驻波场理论对激光作用下滤光片内电场分布的分析与模拟．探讨了两种激光模式作用下滤光片的损伤特征和损

用于钕玻璃啁啾脉冲放大系统光谱整形的多层介质膜反射镜

在千焦拍瓦高功率啁啾脉冲放大系统设计中,为了尽量消除增益窄化和增益饱和效应的影响,同时尽可能提高高功率激光输出脉冲信噪比参数,激光脉冲时空和光谱的整形问题备受关注.提出一种光谱整形新方法,利用特定结构的多层介质膜反射镜,可实现对大能量高功率啁啾脉冲钕玻璃放大系统中啁啾脉冲的光谱整形.研究结果表明,只要合理选择多层介质膜系的结构参数,可有效地控制其反射率分布,且在保证反射相位基本不变的条件下其调制度可超过60%.针对钕玻璃1053nm波长设计而成的光谱整形反射镜,反射带宽可达到196nm,色分辨率约为0.1nm,在几十纳米波长范围所对应的相位偏差小于12mrad,相当于λ/524,能够满足"神光Ⅱ"千焦拍瓦改造的技术指标要求.