关于弹性体固有频率的两个变分原理

<正> 对于几何形狀较复雜的彈性体,要嚴格地根据彈性体力学的全部方程來决定它的固有频率是有很大的困难的,因此在实际上常常采用了各式各样的近似解法,其中最有名的近似解法要算根据萊瑞原理的变分解法(称为萊瑞黎茲法)。在許多問題中,萊瑞黎兹法給出了滿意的結果。但是这个方法在实用上及理論上遺留下两个問題:第一、在許多問題中,我們往往能对应力分布的情況作适当的估計,可是这些估計在萊瑞黎兹法中不能加以充分利用;第二、在各种近似理論中,例如在梁、板、壳的近似理論中,虽然都各有自己的萊瑞原理,可是这些原理并不是彈性体力学中的萊瑞原理的直接的特殊形式。

Diffusion dominated process for the crystal growth of a binary alloy

The pure diffusion process has been often used to study the crystal growth of a binary alloy in the microgravity environment. In the present paper, a geometric parameter, the ratio of the maximum deviation distance of curved solidification and melting interfaces from the plane to the radius of the crystal rod, was adopted as a small parameter, and the analytical solution was obtained based on the perturbation theory. The radial segregation of a diffusion dominated process was obtained for cases of arbitrary Peclet number in a region of finite extension with both a curved solidification interface and a curved melting interface. Two types of boundary conditions at the melting interface were analyzed. Some special cases such as infinite extension in the longitudinal direction and special range of Peclet number were reduced from the general solution and discussed in detail.

Experiment on the thermocapillary convection of a mercury liquid bridge in a floating half zone

A liquid bridge of a floating half zone consisting of liquid mercury sealed in a glass tube with nitrogen atmosphere was used for the experiment of thermocapillary convection with a low Prandtl number liquid. A non-contacted diagnostic method was developed to monitor the surface flow and the surface oscillation. A growing surface film (or skin) is a crucial source to suppress thermocapillary convection, and is discussed in this paper. For the case of a mercury Liquid bridge, the critical Marangoni number was obtained as 900, and the oscillatory frequency was around 5 Hz.

不可压缩流体三维Rayleigh-Taylor不稳定性的大涡模拟

对不可压缩流体三维Rayleigh-Taylor不稳定性问题建立被动标量输运模型，用大涡模拟方法计算了正弦初始扰动和随机初始扰动下不稳定性发展各个阶段的瞬时速度度场和标量场，以及混合过程中计算尺度和亚格子尺度上的平均湍流脉动能、平均剪切应力和被动标量通量；分析了 界面形状、被动标量浓度分布的演化规律及气泡、尖钉速度和混合层宽度随时间的变化规律，计算结果与其他数值模拟和实验结果相吻合，验证了大涡模拟方法应用于该问题的可行性。

民航客机防爆箱的研制

本文简介研制民航客舱防爆箱遇到的困难,指出这是爆炸火球区内抗爆容器的设计问题。在实验和理论分析基础上,就爆炸火球区内抗爆措施提出了建议并得到验证。

Propagation of Explosion Wave in Hard-Soft-Hard Layered Media

The paper presents a reasonable analysis for dynamic response and failure process of a plane multi-layered media, which are subjected to a blast loading. This blast loading is induced by a cylindric explosive put on the center of top surface of the layered media. With the help of numerical simulation technique provided by LS-DYNA software, the whole process of explosion wave propagation and attenuation can be revealed. The feature of local failure around the blasting site is also discussed in some detail. Our focus will be on the explosion wave attenuation for the hard-soft-hard sandwich layers. As seen in the paper, the computational results are delivered in a feasible way by comparing with experimental data.

Discontinuous growth mechanisms of mode II crack under high-speed impact conditions

A recoverable plate impact testing technology has been used for studying the growth mechanisms of mode II crack. The results show that interactions of microcracks ahead of a crack tip cause the crack growth unsteadily. Failure mode transitions of materials were observed. Based on the observations, a discontinuous crack growth model was established. Analysis shows that the shear crack grows unsteady as the growth speed is between the Rayleigh wave speed c(R) and the shear wave speed c(s); however, when the growth speed approaches root 2c(s), the crack grows steadily. The transient microcrack growth makes the main crack speed to jump from subsonic to intersonic and the steady growth of all the sub-cracks leads the main crack to grow stably at an intersonic speed.

燃烧物理学基础

Inherent Shear-Dilatation Coexistence In Metallic Glass

Shear deformation can induce normal stress or hydrostatic stress in metallic glasses [ Nature Mater. 2 ( 2003) 449, Intermetallics 14 ( 2006) 1033]. We perform the bulk deformation of three-dimensional Cu46Zr54 metallic glass (MG) and Cu single crystal model systems using molecular dynamics simulation. The results indicate that hydrostatic stress can incur shear stress in MG, but not in crystal. The resultant pronounced asymmetry between tension and compression originates from this inherent shear-dilatation coexistence in MG.

Detection of hepatitis B virus markers using a biosensor based on imaging ellipsometry

A biosensor based on imaging ellipsometry (BIE) has been developed and validated in 169 patients for detecting five markers of hepatitis B virus (HBV) infection. The methodology has been established to pave the way for clinical diagnosis, including ligand screening, determination of the sensitivity, set-up of cut-off values (CoVs) and comparison with other clinical methods. A matrix assay method was established for ligand screening. The CoVs of HBV markers were derived with the help of receiver operating characteristic curves. Enzyme-linked immunosorbent assay (ELISA) was the reference method. Ligands with high bioactivity were selected and sensitivities of 1 ng/mL and 1 IU/mL for hepatitis B surface antigen (HBsAg) and surface antibody (anti-HBs) were obtained respectively. The CoVs of HBsAg, anti-HBs, hepatitis B e antigen, hepatitis B e antibody and core antibody were as follows: 15%, 18%, 15%, 20% and 15%, respectively, which were the percentages over the values of corresponding ligand controls. BIE can simultaneously detect up to five markers within 1 h with results in acceptable agreement with ELISA, and thus shows a potential for diagnosing hepatitis B with high throughput.

Numerical and Experimental Investigation On The Prevention of Co Deflagration

The exhaust gases from industrial furnaces contain a huge amount of heat and chemical enthalpy. However, it is hard to recover this energy since exhaust gases invariably contain combustible components such as carbon monoxide (CC). If the CO is unexpectedly ignited during the heat recovery process, deflagration or even detonation could occur, with serious consequences such as complete destruction of the equipment. In order to safely utilize the heat energy contained in exhaust gas, danger of its explosion must be fully avoided. The mechanism of gas deflagration and its prevention must therefore be studied. In this paper, we describe a numerical and experimental investigation of the deflagration process in a semi-opened tube. The results show that, upon ignition, a low-pressure wave initially spreads within the tube and then deflagration begins. For the purpose of preventing deflagration, an appropriate amount of nitrogen was injected into the tube at a fixed position. Both simulation and experimental results have shown that the injection of inert gas can successfully interrupt the deflagration process. The peak value of the deflagration pressure can thereby be reduced by around 50%. (C) 2008 Elsevier Ltd. All rights reserved.

超短激光脉冲的绝对相位对三能级Λ型原子布居的影响

通过数值求解含时薛定谔方程,研究超短激光脉冲与三能级Λ型原子相互作用过程中影响原子电离态跃迁几率的几个因素,如：绝对相位,啁啾率等。研究结果表明激光绝对相位、啁啾率的大小是关系态跃迁几率的重要因素,通过调节超短激光脉冲的绝对相位和啁啾率,可以将态跃迁几率控制到较大的水平。本文研究结果为实验上对态跃迁几率的控制提供了相关理论基础。

硬X射线相位衬度成像的实验研究

介绍了硬X射线(类同轴)相位衬度成像的工作原理及其实验研究结果。X射线波长为0．08860nm,样品为未经任何处理的飞蛾，记录介质为X射线胶片。胶片经处理以后，用光学显微镜读出，可以看出样品的许多细节,尤其在折射率突变处。而同样条件下基于吸收衬度机制的硬X射线吸收成像，由于是弱吸收样品．没有观察到任何图像。