27 resultados para 139-858F
Resumo:
本书阐明了板壳断裂理论的基础。论证了Reissner型板壳断裂理论的科学性、经典板壳断裂理论的缺陷及在一定范围内仍具有的实用价值;介绍了作者所创意的研究Reissner型板壳断裂纹尖端场的方法等。
目录
- §1.1 板壳弯曲断裂问题
- §1.2 Kirchhoff经典板壳弯曲断裂理论
- §1.3 Reissner型板壳弯曲断裂理论
- §1.4 Kirchhoff与Reissner型板壳弯曲断裂理论的比较
- §1.5 含裂纹有限尺寸板壳断裂分析的局部-整体法
- §1.6 含表面裂纹板壳
- §2.1 Kirchhoff板的基本概念和基本假定
- §2.2 基本公式与弹性曲面微分方程
- §2.3 边界条件
- §2.4 弹性薄板的应变能
- §2.5 极坐标下的挠曲面微分方程与内力公式
- §2.6 裂纹尖端场特征展开式通项公式
- §2.7 Kirchhoff板弯曲应力强度因子
- §3.1 基本方程和公式的复变函数表示
- §3.2 所引入函数的确定程度与一般形式
- §3.3 坐标变换与边界条件
- §3.4 运用保角变换方法求解孔口问题
- §3.5 应力强度因子与函数Φ(z)的关系
- §3.6 复变-主部分析法之应用简例
- §3.7 共直线裂纹问题的一般解答
- §3.8 典型弯曲裂纹问题的解答及弯曲应力强度因子公式
- §3.9 共圆曲线裂纹问题的解答及弯曲应力强度因子公式
- §4.1 裂纹尖端奇异元的位移模式与弯曲应力强度因子
- §4.2 裂纹尖端奇异元的刚度矩阵
- §4.3 裂纹尖端奇异元与常规单元的连接
- §4.4 解析法与数值法的结果比较与讨论
- §4.5 两共线半无限裂纹问题的定解条件及解的实用价值
- §5.1 Reissner型板的基本假定
- §5.2 Reissner型板的基本公式与平衡微分方程
- §5.3 基本方程的简化
- §5.4 边界条件
- §5.5 极坐标下的基本公式与平衡微分方程
- §5.6 两种平板理论用于无裂纹板时的比较
- §5.7 两种乎板理论用于含裂纹板时的比较
- §6.1 基本方程和一般求解方法
- §9.1 局部-整体法与其它解析和数值法的结果比较
- §9.2 边界对应力强度因子的影响
- §9.3 板的支承条件及长宽比的影响
- §9.5 计算Reissner型板应力强度因子的一组近似方程与近似解法
- §9.4 Reissner型板理论与Kirchhoff板理论所得应力强度因子的比较
- §9.6 关于数值计算的几点讨论
Resumo:
A diode stack end-pumped Nd:YVO4 slab laser at 1342 nm with near-diffraction-limited beam quality by using a hybrid resonator was presented. At a pump power of 139.5 W, laser power of 35.4 W was obtained with a conversion efficiency of 25.4% of the laser diode to laser output. The beam quality M-2 factors were measured to be 1.2 in the unstable direction and 1.3 in the stable direction at the output power of 29 W. (C) 2009 Optical Society of America
Resumo:
The density distribution of inhomogeneous dense deuterium-tritium plasmas in laser fusion is revealed by the energy loss of fast protons going through the plasma. In our simulation of a plasma density diagnostics, the fast protons used for the diagnostics may be generated in the laser-plasma interaction. Dividing a two-dimensional area into grids and knowing the initial and final energies of the protons, we can obtain a large linear and ill-posed equation set. for the densities of all grids, which is solved with the Tikhonov regularization method. We find that the accuracy of the set plan with four proton sources is better than those of the set plans with less than four proton sources. Also we have done the density reconstruction especially. for four proton sources with and without assuming circularly symmetrical density distribution, and find that the accuracy is better for the reconstruction assuming circular symmetry. The error is about 9% when no noise is added to the final energy for the reconstruction of four proton sources assuming circular symmetry. The accuracies for different random noises to final proton energies with four proton sources are also calculated.
Resumo:
介绍了近年来硬X射线位相衬度成像技术的发展状况,详细论述了X射线干涉相衬、衍射增强相衬,类同轴相衬等几种典型的成像原理。
Resumo:
根据菲涅尔全内反射相变理论,给出了双菱体λ/4消色差器的结构设计、性能分析和测量方法.由有效通光孔径和光线追迹设计出BK7玻璃在波长532 nm时相位延迟λ/4的双菱体的结构,用作532 nm至1 064 nm波长范围的标准λ/4相位延迟器.理论分析了入射角变化和波长变化对双菱体相位延迟的影响,当入射角变化限制在±4.3°以内时,其影响得到补偿;波长从532 nm到1 064 nm产生的误差为-0.65°.采用椭偏法中的消光技术,分别实测了双菱体在532 nm和1 064 nm波长下的相位延迟为:90.08±0.14°和88.99±0.1°,可知两不同波长产生的相位延迟误差为-1.09°.
Resumo:
Er3+/Yb3+ cocloped fluorophosphate glasses were prepared and their thermal stabilities, Raman spectra, absorption spectra, and fluorescence spectra were measured. It is found that proper content of NaF or PbF2 is helpful for the increase of stability against crystallization. The variation of AI(PO3)3 or NaF content in the composition affects not the maximum phonon energy but the phonon density. The introduction of PbF2 decreases the phonon energy slightly. Intense green and red upconversion luminescence was observed for the fluorophosphate glass with low phosphate content. A glass matrix for upconversion luminescence requiring neither expensive raw material nor special atmospheric conditioned preparation is provided. Infrared luminescence around 1530 nm was researched. Fluorophosphate glasses with bandwidth properties and stimulated-emission cross sections better than tellurite, germanate and silicate glasses are obtained. Through the introduction of NaF, the bandwidth properties are decreased. Through the introduction of PbF2 the gain properties are increased. On the whole, it is difficult to obtain a material with the best gain properties and bandwidth properties simultaneously. There should be a compromise between them according to the demand. (C) 2006 Elsevier B.V. All rights reserved.
Resumo:
Eu-doped and Eu/Al-codoped high silica glass to investigate the properties of europium ions in high silica glasses were obtained. The porous glasses were immersed into europium nitrate solution or mixed solution of europium nitrate and aluminum nitrate. After dried, the doped porous glasses were sintered at 1200°C to obtain Eu-doped and Eu/Al-codoped high silica glasses. The reduction of Eu3+&rarrEu2+ was observed in Eu/Al-codoped high silica glass. The ratio of trivalent and bivalent europium ions was adjusted by the addition of aluminum ions and then the luminescent color of the glasses was controlled. A detailed mechanism was given to explain this reduction process.
Resumo:
依据Z-scan技术,使用波长532nm的纳秒脉冲,研究了通过聚焦的飞秒脉冲诱导并辅以热处理得到的金纳米粒子析出的玻璃的非线性吸收.观察到金纳米粒子析出的玻璃具有饱和吸收特性.根据局域场效应,对实验结果拟合,得到在接近表面等离子体共振激发情况下,金纳米粒子三阶极化率虚部分别为Imχm^(3)=5.7×10^-7esu.玻璃样品中金纳米粒子的非线性响应主要起源于热电子贡献。