NO reduction and CO oxidation over Cu/Ce/Mg/Al mixed oxide catalyst in FCC operation

Simultaneous NO reduction and CO oxidation in the presence of O-2,H2O and SO2 over Cu/Mg/AUO (Cu-cat), Ce/Mg/Al/O (Ce-cat) and Cu/Ce/Mg/Al/O (CuCe-cat) were studied. At low temperatures (<340 degreesC), the presence of O-2 or H2O enhanced the activity of CuCe-cat for NO and CO conversions, but significantly suppressed the activity of Cu-cat and Ce-cat, At high temperature (720 degreesC), the presence of O-2 or H2O had no adverse effect on the NO and CO conversions over these catalysts. The addition of SO2 to NO + CO + O-2 + H2O system had no effect on the, reaction of CO + O-2 over Cu-cat, but deactivated this catalyst for NO + CO and CO + H2O reactions; over Ce-cat, all of these reactions of NO + CO, CO + O-2 and CO + H2O were suppressed significantly; over CuCe-cat, NO + CO and CO + O-2 reactions were not affected while the reaction of CO + H2O was slightly inhibited. (C) 2002 Elsevier Science B.V. All rights reserved.

Partial oxidation of ethane to syngas in an oxygen-permeable membrane reactor

A perovskite-type oxide of Ba0.5Sr0.5Co0.8Fe0.2O3-delta (BSCFO) with mixed electronic and oxygen ionic conductivity at high temperatures was used as an oxygen-permeable membrane. A tubular membrane of BSCFO made by extrusion method has been used in the membrane reactor to exclusively transport oxygen for the partial oxidation of ethane (POE) to syngas with catalyst of LiLaNiO/gamma-Al2O3 at temperatures of 800-900 degreesC. After only 30 min POE reaction in the membrane reactor, the oxygen permeation flux reached at 8.2 ml cm(-2) min(-1). After that, the oxygen permeation flux increased slowly and it took 12 h to reach at 11.0 ml cm(-2) min(-1). SEM and EDS analysis showed that Sr and Ba segregations occurred on the used membrane surface exposed to air while Co slightly enriched on the membrane surface exposed to ethane. The oxygen permeation flux increased with increasing of concentration of C2H6, which was attributed to increasing of the driving force resulting from the more reducing conditions produced with an increase of concentration of C2H6 in the feed gas. The tubular membrane reactor was successfully operated for POE reaction at 875 degreesC for more than 100 h without failure, with ethane conversion of similar to 100%, CO selectivity of >91% and oxygen permeation fluxes of 10-11 ml cm(-2) min(-1). (C) 2002 Elsevier Science B.V. All rights reserved.

FT-IR spectroscopic study of the oxidation of chlorobenzene over Mn-based catalyst

Adsorption and oxidation of chlorobenzene on Al(2)O(3), TiO(2)-Al(2)O(3), and MnO(x)/TiO(2)-Al(2)O(3) have been studied by in situ Fourier transform infrared (FT-IR) spectroscopy. At room temperature, chlorobenzene is only physisorbed on Al(2)O(3), TiO(2)-Al(2)O(3), and MnO(x)/TiO(2)-Al(2)O(3), and gives the same IR spectrum as that for liquid-phase chlorobenzene. On Al(2)O(3) no further interaction and reaction take place with treatment, at higher temperatures (up to 773 K), while phenolates are observed for TiO(2)-Al(2)O(3) and MnO(x)/TiO(2)-Al(2)O(3) at 773 K. When the adsorbed chlorobenzene coexists with oxygen, formates are detected for Al(2)O(3), while acetates are additionally observed for TiO(2-)Al(2)O(3) above 573 K. For MnO(x)/TiO(2-)Al(2)O(3), maleates are present at 573 And 673 K, while formates and acetates develop at 473 and 573 K. Almost all IR bands due to formates, acetates, and maleates disappear at 773 K, indicating that these oxygen-containing species are potential intermediates for the total oxidation of chlorobenzene.

One-step heterogeneously catalytic oxidation of o-cresol by oxygen to salicylaldehyde

Salicylaldehyde (selectivity = 57.3% at a conversion = 73.8%) was prepared for the first time by the oxidation of o-cresol in a single step using impregnated CuCo/C catalysts.