A simple method for the selective enrichment of endohedral metallofullerenes

The concentration of a polar solvent DMF extract was found to be very effective for the selective enrichment of endohedral metallofullerenes against empty fullerenes. As the solvent evaporated, endohedral metallofullerenes were effectively enriched in the solution, while most of empty fullerenes (especially C-60 and C-70) were precipitated because of their scant solubility in DMF. Matrix-assisted laser-desorption-ionization time-of-fligh mass spectrometry analysis indicated that the purity of endohedral metallofullerenes increased dramatically after concentration of the DMF extract solution. Upon transferring the extract into toluene, a solution containing significantly enriched endohedral metallofullerenes was obtained. The different solubilities of endohedral metallofullerenes versus empty fullerenes are considered to account for this selective enrichment of endohedral metallofullerenes.

A study of dimethylferrocene diffusion and electrode kinetics using microelectrode voltammetry in poly(ethylene glycol) solvent

The heterogeneous electron transfer rate constant (k(s)) of dimethylferrocene (DMFc) was estimated using cyclic voltammetric peak potential separations taken typically in a mixed diffusion geometry regime in a polyelectrolyte, and the diffusion coefficient (D) of DMFc was obtained using a steady-state voltammogram. The heterogeneous electron transfer rate constant and diffusion coefficient are both smaller by about 100-fold in the polymeric solvent than in the monomeric solvent. The results are in agreement with the difference of longitudinal dielectric relaxation time (tau(L)) in the two kinds of solvents, poly(ethylene glycol) (PEG) and CH3CN, indicating that k(s) varies inversely with tau(L); k(s), is proportional to D of DMFc. Both D and k(s) of DMFc in PEG containing different supporting electrolytes and at different temperatures have been estimated. These results show that D and k(s) of DMFc increase with increasing temperature in the polyelectrolyte, whereas they vary only slightly with changing the supporting electrolyte.

High temperature and high pressure extraction of lanthanofullerenes by using different solvents

The traditional Soxhlet extraction of lanthanofullerenes was improved and the high temperature and high pressure method with different extraction solvents was used. It's found that La@C-2n can be efficiently extracted with toluene and pyridine from the insoluble part of the soot after the toluene Soxhlet extraction. Pyridine can more efficiently and selectively extract lanthofullerenes, especially La@C-82, while toluene can extract La@C-74, which is a new member added to the soluble species to lanthanofullerenes.

Separation of Ce(IV) and RE(III) with hollow fiber membrane-based extraction

Separation of Ce(IV) and RE(III) was investigated by hollow fiber membrane-based extraction with contercurrent recirculating operation. The mass transfer coefficients of Ce(IV) and RE(III) and the effective factors to them were tested. The results show the mass transfer coefficient of Ce(IV) is larger than that of RE(III), and their mass transfer mechanism is different. The mass transfer of Ce(IV) was controlled by the resistance in water critical layer due to its more rapid interfacial reaction rate and larger distribution coefficient, which was different from RE(III) mass transfer with a slow interfacial reaction rate and small distribution coefficient. Ce(IV) was separated from the mixed solution of Ce(IV) and RE(III) by means of the difference of their mass transfer rates.

Studies on extraction and mass transfer of samarium and neodymium in hollow fiber membrane (HFM) with HEH/EHP

The membranes of polyvinylidene fluoride, which were synthesized by our laboratory, were used to study the transfer and extraction performances of Nd(III) and Sm(III) with the extraction system of HEH/EHP-kerosene. The results show that the membrane material was suitable to the study on membrane extraction, and could offer a good transfer performance in the membrane construction parameters selected, The extraction reaction in the membrane module was the same as that in liquid-liquid process, HEH/EHP ammoniated for increasing the mass transfer coefficient was almost the same with increasing the concentration of HEH/EHP, and H+ was still transferred first at higher pH range of feed solution when HEH/EHP was ammoniated, The controlling model of the membrane extraction process was the diffusion model accompanied by interfacial reaction, The controlling function of interfacial reaction would increase gradually with the increasing of the membrane pore size. The mass transfer coefficient increased when extraction and stripping were carried out simultaneously.

Synthesis, extraction and electronic structure of Ce@C-2n

In view of the growing interest in endohedral lanthanide fullerenes, Ce, as a typical +4 oxidation state lanthanide element, has been systematically studied. The synthesis, extraction and electronic structure of Ce@C-2n are investigated. Soot containing Ce@C-2n was synthesized in high yield by carbonizing CeO2-containing graphite rods and are back-burning the CeC2-enriched cathode deposit in a DC are plasma apparatus. Ce@C-2n, dominated by Ce@C-82, can be efficiently extracted from the insoluble part of the soot after toluene Soxhlet extraction by pyridine at high temperature and high pressure in a closed vessel. About 60% Ce@C-2n (2n = 82,80,78,76) and 35% Ce@C-82 can be enriched in the pyridine extract. This fact is identified by desorption electron impact mass spectrometry (DEI MS). The electronic structure of Ce@C-2n is analyzed by using X-ray photoemission spectroscopy (XPS) of pyridine-free film. It is suggested that the encapsulated Ce atom is in a charge state close to +3 and was effectively protected from reaction with water and oxygen by the enclosing fullerene cage. Unlike theoretical expectation, the electronic state of Ce@C-82 is formally described as Ce+3@C-82(3-). (C) 1997 Elsevier Science Ltd.

Synthesis and solvent enhanced relaxation property of water-soluble endohedral metallofullerenols

Gadolinium fullerenols, as novel and potential contrast agents for magnetic resonance imaging, were synthesized, which showed excellent efficiency in enhancing water proton relaxation with a relaxivity of 47.0+/-1.0 mM(-1).s(-1).

The effect of substrate and solvent properties on the response of an organic phase tyrosinase electrode

The responses of a cryohydrogel tyrosinase enzyme electrode to four substrates in three pure water immiscible organic solvents were investigated. Kinetic parameters, the maximum kinetic current, I-max, the apparent Michaelis-Menten constant, K-m(app), and I-max/K-m(app), were calculated. The I-max/K-m(app) value was taken as an indicator of the catalytic efficiency of the sensor. The effect of the substrate hydrophobicity on I-max/K-m(app) and response time of the sensor were discussed. The effects of both hydrophobicity (log P) and dielectric constant (epsilon) of the organic solvent on the catalytic efficiency of the enzyme in the organic phase were studied. (C) 1997 Elsevier Science S.A.

Studies on synergistic extraction of Sc(III) with HBTMPTP and Cyanex 925

The synergistic extraction of Sc(III) from H2SO4 solution with bis(2, 4, 4-trimethylpentyl)monothiophosphinic acid(HBTMPTP, HL) and branched chain alkyl phosphine oxide mixture (Cyanex 925, B) in n-hexane has been investigated, The results indicated that synergistic effect was showed in low acidity (c(H2SO4) < 0.25 mol/L). The composition of the extracted complex of Sc(III) has been determined to be Sc(HL2)(2)B-3(SO4)(1/2) by the method of slope analysis, The mechanism of the synergistic extraction of Sc(III) may be : Sc3+ + 2(HL)(2(O)) + 3B((O)) + 1/2SO(4)(2-)reversible arrow(K12)Sc(HL2)(2)B-3(SO4)(1/2(O)) + 2H(+) ScL(HL2)(2(O)) + 3B((O)) + H+ + 1/2SO(4)(2-)reversible arrow(beta')Sc(HL2)(2)B-3(SO4)(1/2(O)) + 1/2(HL)(2(O)) Sc(SO4)(1.5)B-2(O) + B-(O) + 2(HL)(2(O))reversible arrow(beta')Sc(HL2)(2)B-3(SO4)(1/2(O)) + 2H(+) + SO42- Their equilibrium constants have been calculated to be lgK(13)=6.77+/-0.12, lg beta'=7.71, lg beta '' = 0.10, respectively, The IR spectra and FAB-MS of the saturated synergistic extraction complex of Sc(III) have been discussed as well.

High-yield extraction of endohedral rare-earth fullerenes

The technique of high-temperature high-pressure extraction with pyridine has been successfully utilized to extract a wide variety of endohedral rare-earth fullerenes of the type Ln@C-2n (Ln = La, Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Ho, Er, Tm, Yb). Ln@C-80, Ln@C-82, and Ln(2)@C-80 for most of the rare-earth metals can be produced with high-yield and selectively extracted from the carbon-are evaporation soot. Metallofullerenes containing Sm, Eu, and Yb (which could have +2 oxidation states) are especially difficult to extract. Some possible reasons for the high-yield extraction are discussed. The laser desorption mass spectrometric characterization results indicate a relationship between the extraction yields of metallofullerenes and the oxidation states and ionic radii of the rare-earths.

Studies on synergistic extraction of rare earths(III) with HBTMPTP and primary amine N1923

The synergistic extraction of rare earths(III) with binary systems containing HBTMPTP and primary amine N1923 from sulfuric acid medium was observed, The syner gistic extraction factor(R) decreased with increasing atomic number of lanthanides. Through the methods of slope analysis, constant mole and saturation titration, the synergistic extraction stoichiometry was obtained, The thermodynamic function was calculated, The IR spectra of the saturated synergistic extraction completely confirmed the mechanism.

High-yield synthesis and extraction of endohedral metallofullerenes Dy@C-2n

The successful encapsulation of dysprosium(Dy) into fullerene cages by activating the Dy2O3 containing graphite rods in situ, ''back-burning'' carbon-arc evaporation with a high-yield of pyridine extraction technique is reported.

High-temperature, high-pressure extraction of metallofullerenes Gd@C-2n

A high-temperature, high-pressure extraction technique with toluene and pyridine were employed for the extraction of metallofullerenes Gd@C-2n, A series of Gd@C-2n for 2n from 70 to 96 were effectively extracted by toluene. Gd@C-74 was shown to be a new stable soluble metallofullerene species. Pyridine was found to be more useful for the extraction of Gd@C-82 and Gd-2@C-80 from empty fullerenes and other metallofullerene species.

Study on the UCST and LCST in PHB/PBHE-solvent system

Upper and lower critical solution temperature (UCST and LCST) behaviours have been examined for solution of PHB/PBHE blends in chloroform and chlorobenzene. Polymer-Solvent systems prepared with various solvents and concentrations were found to possess UCST and LCST characteristics. PHB/PBHE solution in chloroform displayed greater miscibility temperature region than that of the blend in chlorobenzene, but the relative tendency of both UCST and LCST were similar.