Determination of rare earth elements in biological samples by inductively coupled plasma mass spectrometry

A method for the determiantion of rare earth elements in biological sampels by inductively coupled plasma mass spectrometry was developed. Oxide ion yield of the rare earth elements (RFE) decreased with the increasing of RF power and the sampling depth, or with the decreasing of carrier gas flow rate. The spectral interference arising from (PrO)-Pr-141-O-16 on Gd-157 must be corrected. if the concentration of Ba was high enough, it was necessary to correct the spectral interference arising from (BO)-B-135-O-16 on Eu-151, and it was not necessary to correct spectral interference arising from (NdO)-Nd-143-O-16 on Tb-159 etc. in the biological samples under the selected operation parameters. In the biological sample, the major matrix elements, such as K, Na and Ca, result in the suppression of REEs signals and the suppression degree of the Ca is grezter than that of the K and Na. The mussel sample was digested by thd dry ashing, wet digestion with HNO3 + H2O2 and HNO3 + HClO4, respectively. The analytical results of REEs were consistent with each other. Detection limits for REEs are 0.001 similar to 0.013 mu g/L. Recoveries of standard addition are 91.7% similar to 125%. REEs in biological samples were determined directly without separation and preconcentration procedure.

Electrochemical quartz crystal microbalance study of the electrochemical behavior of riboflavin at gold electrodes

The electrochemical and adsorption behaviors of riboflavin (RF) at gold electrodes has ken studied by using an electrochemical quartz crystal microbalance (EQCM). Useful information is obtained not only about electrochemical behavior but also about mass changes on the electrode surface. The electrochemical properties and frequency shifts were investigated in RF solutions at different pH values, concentrations and scan rates. Reversible voltammograms were observed for pH less than or equal to 9.71. There was no electrochemical reaction for pH > 9.71. The maximum current response was obtained at about pH 8. The current response was proportional to the square root of scan rates when the concentration of RF was lower than 1.0 x 10(-4) mol L-1 (pH 6.92). On the contrary, at concentrations higher than 1.0 x 10(-4) mol L-1 (pH 6.92), it was proportional to the scan rates.

Single-chain single crystals of gutta-percha

Single-chain single crystals of gutta-percha have been observed by transmission electron microscopy of atomizer-sprayed particles deposited from a very dilute solution in chloroform onto a carbon film which had a filter paper wetted with ethanol in contact with its under side. Selected-area electron diffraction patterns of crystals having no definite crystal profiles showed that the crystals were of the low-melting crystalline form and that the chain segments in the single crystals were standing up from the substrate during crystallization. In cases of single crystals showing sharply defined crystal profiles, electron diffraction patterns showed that they were neither of the low-melting form nor the high-melting form. The structure of this new crystalline modification needs further studies.

ESR STUDY OF SUPERHYPERFINE INTERACTION OF I-127 IN [CU(IO5OH)(2)](5-) ION COMPLEX

ESR method has been used to study superhyperfine. interaction of I-127 in [Cu (IO5OH)(2)](5-) ion for Na4KCu(IO5OH)(2) . 12H(2)O single crystal. The main purpose of this paper is to confirm the existence of unpaired electron spin on iodine atom and to find a reasonable explanation for the spin delocalization of CU2+ ions. Based on the ESR parameters of paramagnetic [Cu(IO5OH)(2)](5-) ions, the calculated results show that about 0.77% of the unpaired eletron spin is located on each iodine atom.

XPS Study of the Oxygen State in LaMnyCo1-yO3 Catalysts

A series of LaMnyCo1-yO3 compounds were prepared by the complexation method with citric acid. XPS was used to investigate the oxygen state in perovskite-type (ABO(3)) Complex oxide LaMnyCo1-yO3 catalysts. The result showed that three oxygen species (alpha

A STUDY OF CATALYTIC PROPERTIES OF PEROVSKITE-TYPE OXIDES LAMNYCO1-YO3 .1. THE RELATIONSHIP BETWEEN THE TYPE OF OXYGEN SPECIES AND THE CATALYTIC PROPERTY IN AMMONIA OXIDATION

The type of oxygen species in perovskite-type oxides LaMnyCo1-yO3 (y = 0.0, 0.1, 0.3, 0.5, 0.7, 0.9, 1.0) has been studied by means of XRD, XPS and TPD. The catalytic activity in ammonia oxidation was also investigated. It was found that there were three desorption peaks in TPD curve corresponding to three types of oxygen species (alpha, beta, beta'). The desorption temperatures were 293 K less-than-or-equal-to T(alpha) less-than-or-equal-to 773 K, 773 K less-than-or-equal-to T(beta) less-than-or-equal-to K and T(beta') greater-than-or-equal-to 1073 K respectively. The relationship among the composition, structure and the catalytic property of.the catalyst was correlated and could be explainned with a model based on solid defect reaction and the interaction between Co and Mn ions. The adsorption strength and quantity of a oxygen are proportional to the catalytic activity. The, result indicates that the synergetic effect between B-site ions seems to the benefit of the ammonis oxidation reaction.

乙烯基三甲基硅烷与苯、苯乙烯及六氟丙烯等离子体共聚物的结构表征

采用外部电极电容耦合的RF辉光放电装置研究了乙烯基三甲基硅烷(VTMS)与苯(Bz)、苯乙烯(St)以及六氟丙烯(HFP)的等离子体共聚合。用IR、ESCA、PGC/MS和X射线对聚合物结构进行表征,证明乙烯基三甲基硅烷与苯、苯乙烯以及六氟丙烯可进行共聚合。C/Si比的增加表明苯、苯乙烯和六氟丙烯的嵌入导致聚合物组成的变化,Si含量相对较低。共聚物中无Si-H键的形成。

VTMS与Bz、St及HFP等离子体共聚物的性能研究

采用外部电极电容耦合的RF辉光放电装置,对乙烯基三甲基硅烷(VTMS)与苯(Bz)、苯乙烯(St)以及六氟丙烯(HFP)进行共聚合。通过IR、TG、防潮试验、接触角测试研究了共聚物膜的性能。发现VTMS与Bz、St的共聚物膜具有优良的防潮性。

XPS STUDY OF CORROSION BEHAVIOUR OF TITANIUM IN H2C2O4 SOLUTION

The corrosion behaviour of titanium substance and the XPS characterization of Ti surface in the H2C2O4 solution have been first studied by X-ray photoelectron spectroscopy, The experimental results show that there am mile Ti-2 and Ti2+ on sample surface in 10% H2C2O4 solution for two boars corrosion at 80 degrees C, but if corrosion is extended to 4 hones, the surface composition is mainly TiO2 with a small amount of Ti2+. This result corresponds to the structure of TiH1.642 composion in sample surface found by XRD analysis. Since bath TiO2 and the surface coating RuO2 are of Gald-Redstone structure, therefore electrode materials of Ti-Ru are stable in chemical industry.

稀土元素对LD31挤压型材的组织和性能的影响

采用金相法和扫描电镜研究了稀土元素在LD31RCS铝型材合金中的分布、存在状态及其对合金金相组织和性能的影响。结果表明,适量稀土主要富集在晶界上,它使合金组织细化,强度、硬度及挤压速度明显提高。过量稀土会形成Al-Si-Fe-RF多元球团状质点,促进韧窝的形核和发展,但它使合金组织粗化,强度和硬度下降。对掺法生产RE-LD31合金的稀土含量以0.2wt％为宜。

On the relationships between the radial tidal current field and the radial sand ridges in the southern Yellow Sea: a numerical simulation

The ori-in of the radial sand ridges (RSRs) in the southern Yellow Sea has been a controversial problem since they were discovered in the early 1960s. To resolve the problem, two key questions need to be answered: (1) was the radial tidal current field in the RSR area generated by the submarine topography, or (2) did it exist before the RSRs occurred? In this study, the M-2 tide and tidal currents in the RSR area were simulated with a two-dimensional tidal model using a flat bottom and a shelving slope topography, the results being then compared with the field data. It is demonstrated that the radial tidal current field in the southern Yellow Sea is independent of bottom topography, and may thus be the controlling factor generating the RSRs. The radial tidal current field probably existed before the RSRs were formed.