K_5LnLi_2F_(10)(Ln=La,Gd,Y)的合成和Ce~(3+)在其中的发光

在Ar气氛中,采用高温固相反应法合成了K_5LnLi_2F_(10)(Ln=La,Ce,Gd,Y)化合物。X射线衍射图表明:除K_5YLi_2F_(10)外,均具有与K_5NdLi_2F_(10)(KNLF)相同的结构。计算了K_5LnLi_2F_(10)(Ln=La,Ce,Gd)的晶胞参数和晶胞体积,它们随着La~(3+),Ce(3+),Gd~(3+)的离子半径减小而有规律地减小。测定了K_5Ce_?Ln_(1-?)Li_2F_(10)化合物的激发光谱和荧光光谱。发现Ce~(3+)的激发波长和发射波长随着La~(3+),Gd~(3+),Y~(3+)离子的改变几乎不变,并对这种现象进行了讨论。

CE determination of 2-(9-carbazole)ethyl chloroformate-labeled oligopeptides

A pre-column derivatization method for sensitive determination of oligopeptides, using the tagging reagent 2-(9-carbazole)ethyl chloroformate (CEOC-Cl) followed by capillary electrophoresis (CE) with diode-array detection, has been developed. Maximum yield close to 100% were observed when a three to fourfold molar excess of reagent was used at pH 9.0-10.0. Excess reagent was extracted with n-hexane-ethyl acetate 9:1-10:1 (v/v); this enabled direct analysis using CE with no significant disturbance from the major fluorescent reagent degradation by-products. The effects on the results of buffer pH and of SDS and organic modifier concentrations were examined. Good baseline resolution in the separation of five CEOC-peptides was achieved with a 48.5-cm total length (effective length 40 cm) 50-mu m inner diameter capillary column.

Comparative analysis of allantoin quercetin, and 1-methyl-1,2,3,4-tetrahydro-beta-carboline-3-carboxylic acid in Nitraria tangutorum Bobr. Seed by HPLC-APCI-MS and CE

This paper describes the simultaneous determination of allantoin, quercetin, and 1-methyl-1,2,3,4-tetrahydro-beta-carboline-3-carboxylic acid (MTCCA) in Nitraria tangutorum Bobr seed by HPLC-APCI-MS and CE (capillary electrophoresis) methods. The final optimized chromatographic conditions were investigated in a reversed-phase Eclipse XDB-C8 column (150 x 4.6 mm, 5 mu m). A seventeen-minute gradient elution, (A: aqueous acetonitrile 20% (v/v); B: aqueous acetonitrile 60% (v/v); C: pure acetonitrile 100%) at a flow rate of 1.0 mL/min was selected for the separation of three natural products with diode array detection (DAD) at 220 nm. A CE experiment was carried out in a fused silica capillary with 32 mmol/L boric acid (pH 10), 32 mmol/L SDS and acetonitrile (10.0%, v/v). The applied potential and temperature was, respectively, set at 19 kV and 25 degrees C. After development, the validation was performed in parallel for HPLC and CE, with the same standards and sample to avoid differences due to the manipulation. The validation parameters of both techniques were adequate for the intended purpose.

CE环境下面向产品竞争力设计与经营决策集成系统研究

从提升产品市场竞争力的角度,提出了面向产品竞争力设计和经营决策的理念,建立了有关的结构模型和框架模型。在此基础上,进一步提出了并行工程环境下实现基于产品开发周期的面向产品竞争力设计与经营决策一体化的设想;研究了面向产品竞争力设计与经营决策集成系统的特征、结构和功能。最后以汽车车身为例对并行工程环境下的车身设计与经营决策集成系统进行了应用研究。

碳酸盐岩风化成土过程中REE超常富集及Ce强烈亏损的地球化学机理

碳酸盐岩的REE含量极低，但最近在贵州一些碳酸盐岩风化表土层底部首次发现了REE的超常富集层，REE总量最高可达近31000μg/g;Ce强烈亏损，δCe值最低达0.007。这种低背景、高富集、强分异的REE富集现象在贵州碳酸盐岩风化壳中具有一定的普遍性。选取发育在下三叠统花溪灰岩和平坝白云岩之上的两个较具代表性的碳酸盐岩风化壳进行研究，结果表明，这种富集现象与碳酸盐岩风化成土的两阶段性密切相关。（1）在残积土形成阶段（风化早期），碳酸盐的快速溶解导致风化前缘形成一个垂直方向相对狭窄、突变的碱性障(pH值为8左右）。此障既能有效地将碳酸盐岩分解释放的REE以及下渗水携带的REE分解沉淀和以吸附于粘土矿物上的方式富集，也容易使Ce^3+氧化成Ce^4+，与HCO3^-形成稳定的可溶性络合物随下渗雨水流走，从而使Ce进一步亏损。（2）残积土演化阶段，轻、重稀土发生明显分异，Ce^3+氧化成Ce^4+并发生水解沉淀，致使下渗水富重稀土而贫Ce，最终使REE在剖面上显示出一般风化壳共有的分异特征。另外，根据对碳酸盐岩中的酸不溶物、可溶性稀土的提取以及质量平衡计算，碳酸盐岩能够提供足够的REE物源；以可溶态为主的赋存状态有利于REE的淋滤（活化）。

NO reduction and CO oxidation over Cu/Ce/Mg/Al mixed oxide catalyst in FCC operation

Simultaneous NO reduction and CO oxidation in the presence of O-2,H2O and SO2 over Cu/Mg/AUO (Cu-cat), Ce/Mg/Al/O (Ce-cat) and Cu/Ce/Mg/Al/O (CuCe-cat) were studied. At low temperatures (<340 degreesC), the presence of O-2 or H2O enhanced the activity of CuCe-cat for NO and CO conversions, but significantly suppressed the activity of Cu-cat and Ce-cat, At high temperature (720 degreesC), the presence of O-2 or H2O had no adverse effect on the NO and CO conversions over these catalysts. The addition of SO2 to NO + CO + O-2 + H2O system had no effect on the, reaction of CO + O-2 over Cu-cat, but deactivated this catalyst for NO + CO and CO + H2O reactions; over Ce-cat, all of these reactions of NO + CO, CO + O-2 and CO + H2O were suppressed significantly; over CuCe-cat, NO + CO and CO + O-2 reactions were not affected while the reaction of CO + H2O was slightly inhibited. (C) 2002 Elsevier Science B.V. All rights reserved.

Interface of chip-based capillary electrophoresis-inductively coupled plasma-atomic emission spectrometry (CE-ICP-AES)

An interface of chip-based capillary electrophoresis (CE)-inductively coupled plasma-atomic emission spectrometry (ICP-AES) that is based on cross-flow nebulization has been developed. A polydimethylsiloxane (PDMS) CE-chip with conventional cross channel layout was used. A stainless steel tube was placed orthogonal to the exit of the CE separation channel for cross flow nebulization. A supplementary flow of buffer solution at the channel exit was used to improve nebulization efficiency. Two capillaries were inserted into the CE chip near the inlet of the separation channel for sample and buffer solution injection. Syringe pumps were used to manipulate the flow rate and flow direction of the sample, buffer, and supplementary buffer solution. Peak broadening due to the shape (bulb and tube-shaped) and size of the spray chambers was studied. The smaller tube-shaped spray chamber was used because of smaller peak broadening effect due to aerosol transport. The nebulization and transport efficiency of the CE-ICP interface was approximately 10%. Ba2+ and Mg2+ ions were eluted from the CE-chip within 30 s. Resolution of the Ba2+ and Mg2+ peaks was 0.7 using the chip-based CE-ICP-AES system.