Space-frequency coupling, conical waves, and small-scale filamentation in water

Numerical simulations of fs laser propagation in water have been made to explain the small-scale filaments in water we have observed by a nonlinear fluorescence technique. Some analytical descriptions combined with numerical simulations show that a space-frequency coupling mainly from the interplay among self-phase modulation, dispersion and phase mismatching will reshape the laser beam into a conical wave which plays a major role of energy redistribution and can prevent laser beam from self-guiding over a long distance. An effective group velocity dispersion is introduced to explain the pulse broadening and compression in the filamentation. (c) 2005 American Institute of Physics.

Ultrafast electronic excitation in CaF2 crystals

A new pump and probe experimental system was developed, the pump pulse duration of which is stretched and is much longer than that of the probe pulse. Using this system, time-resolved electronic excitation processes and damage mechanisms in CaF2 crystals were studied. The measured reflectivity of the probe pulse begins to increase at the peak of the pump pulse and increases rapidly in the latter half of the pump pulse, when the pump pulse duration is stretched to 580fs. Our experimental results indicate that both multiphoton ionization and impact ionization play important roles in the generation of conduction band electrons, at least they do so when the pump pulse durations are equal to or longer than 580fs.

紧聚焦的超短超强激光脉冲在真空中加速斜入射的相对论电子

研究了紧聚焦的线偏振飞秒超强高斯激光脉冲俘获并剧烈加速斜入射低能相对论电子的效应，发现被俘获的电子在激光脉冲纵向有质动力的强大加速作用下，可以获得GeV量级的能量，并详细研究了入射电子的初能量、斜入射角、电子与激光脉冲的相对延迟时间和激光脉冲宽度等条件对电子能量增益的影响，发现当激光脉宽超过10λ时，脉宽对电子能量增益影响不大．

相对论飞秒激光脉冲在真空中对预加速电子的加速

通过求解电子运动的相对论方程，发现预加速电子在超强超短激光脉冲的作用下可以获得很高的能量增益．飞秒激光脉冲的上升沿在焦点附近的区域有效加速电子后，电子和光脉冲一起传播一段距离（远大于瑞利长度）后，激光强度变得很弱，从而使脉冲下降沿对电子的减速作用可以忽略不计，因此电子只经历加速过程而没有被减速，当电子和光脉冲分离时，电子获得了很高的能量增益．当光强为10^19W／cm^2，电子的初始能量为MeV量级时，电子的能量增益可以达到0．1GeV．进一步讨论了电子的能量增益与电子的初始条件与激光脉冲的参数之间的关系

飞秒激光脉冲在正色散固体材料中的自压缩

实验研究了正色散固体介质中的激光脉冲自压缩现象，证明了无需任何外加色散补偿情况下，固体透明介质中的自聚焦传输过程可使高功率飞秒激光脉冲实现时域脉冲压缩，并详细研究了输出脉冲的时域和频域特性随入射脉冲强度的演化规律．实验结果表明脉冲自压缩量随入射脉冲强度的增加呈递增趋势，然而当入射光强增大到足以引起超连续谱及锥形辐射产生时，脉冲时域形状会发生分裂．此外还发现发散光束入射情况下同样可以观察到脉冲自压缩现象．

飞秒激光作用下透明介质材料的反射率演化

利用800nm抽运和400nm探针技术，测量了CaF2和MgO的时间分辨反射率，研究了材料的电子激发和弛豫超快动力学过程。采用耦合动力学模型，探讨了飞秒激光对透明介质材料的激发，以及材料的激发对抽运激光在材料中的传输、分布和反射特性的影响。根据这个理论模型计算了时间分辨反射率的演化，计算结果和实验结果相吻合。研究表明，多光子电离（MPI）和碰撞电离（II）在介质材料的导带电子激发中起着重要的作用。

利用皮秒脉冲激光驱动瞬态X射线激光

报道了利用皮秒激光驱动产生瞬态类镍银X射线激光的实验结果．采用一路脉冲宽度为数百皮秒的激光作为预脉冲，配合另一路皮秒激光作为主脉冲联合驱动平面靶，获得了一定强度的类镍银X射线激光输出，输出能量约为5-10nJ．

飞秒强激光经氩气和氩团簇的传播

通过数值求解三维电场传播方程，理论模拟了飞秒强激光脉冲（50fs，10^16w／cm^2）在氩气和中等尺寸氩团簇中的传播效应．结果表明，飞秒强激光脉冲经氩气传播将发生频谱蓝移展宽和光束发散；而经中等尺寸氩团簇传播，则存在一定程度的自聚焦效应．

双色激光场中激光强度和脉宽对线性多原子分子离子电离的影响

利用强激光场电离和离解分子来研究分子激发态的波包结构是强场物理的重要研究方向。利用短时指数传播子对称分割法和快速傅里叶变换技术。数值求解了一维含时Schr（oe）dinger方程，探讨了双色激光场中激光的基波和谐波强度之间的不同配比以及脉宽对线性多原子分子离子电离的影响。理论计算结果表明：基波和谐波的相对相位为π时，尽管随着激光的基波和谐波强度之间配比的变化，电离几率随原子间距变化的趋势基本保持不变，但在一定的激光基波强度下(1．2×10^13～1．2×10^15W／cm^2)，激光基波强度的变化可以明显

超短激光脉冲在不同色散参量光子晶体光纤中传输的数值模拟

为了使得数值模拟更为精确, 采用广义非线性薛定谔方程(GNSE)描述超短激光脉冲在光子晶体光纤中的传输演化过程, 并利用二阶分步傅里叶方法通过求解方程, 数值计算了相同脉宽和能量的超短脉冲在不同色散参量的光子晶体光纤中非线性传输和超连续谱的产生。比较了超短脉冲在光纤不同色散区传输时, 高阶色散和非线性效应对超连续谱的产生以及对脉冲波形演化的影响。结果表明, 相对于超短脉冲中心波长位于光子晶体光纤的正常和反常色散区, 可以相应获得短波波段和长波波段的超连续谱输出, 当超短脉冲中心波长位于零色散波长点时, 通

极紫外阿秒脉冲在高次谐波产生过程中引起的非偶极效应

当红外强激光和极紫外（XUV）阿秒脉冲共同作用于原子分子时，电离出去的电子通常会吸收和辐射激光光子而发生能量扩展．讨论了由于XUV阿秒脉冲的短波长与扩展后的电子波包尺度可相比拟时在高次谐波产生过程中引起的非偶极效应．采用彤作为模型分子，并把分子轴置于激光场的传播方向，通过解二维含时薛定谔方程并比较考虑非偶极效应和采用偶极近似两种方法计算得到的结果，两者相比，前者的谐波强度降低，谐波频率向低级次稍有移动，电子能谱的能带内出现了更多的光电子峰．在相同的光电子能量处，两种方法计算得到的信号强度相差2—5倍．并且

用钛宝石再生放大器产生高重复率啁啾脉冲列

针对啁啾脉冲放大技术建成的钛宝石激光装置，提出一种获得高重复率激光脉冲列的方法．通过改变钛宝石再生放大器中泡克耳斯盒电光开关的传统工作模式，使得腔内放大的脉冲从某特定时刻起，每当在腔内往返一次就以一定的倒出比例（倒出率）倒出腔内脉冲能量的一部分，从而可以在有限的时间段内产生高重复率的啁啾激光脉冲列．基于Franz-Nodvik放大理论，建立了该高重复率再生放大器的理论模型，通过数值计算，系统地分析了初始增益、倒出时刻、倒出率对输出的脉冲序列的影响．在抽运功率为35mJ、倒出率为1／2的实验条件下，通过腔外

Conical Emission Patterns by Femtosecond Pulses with Different Spectral Bandwidths

Different conical emission (CE) patterns are obtained experimentally at various incident powers and beam sizes of pump laser pulses with pulse durations of 7 fs, 44 fs and 100 fs. The results show that it is the incident power but not the incident power density that determines a certain CE pattern. In addition, the critical powers for similar CE patterns are nearly the same for the laser pulses with the same spectral bandwidth. Furthermore, as far as a certain CE pattern is concerned, the wider the spectral bandwidth of pump laser pulse is, the higher the critical power is. This will hopefully provide new insights for the generation of CE pattern in optical medium.

Red-shift conical emission by femtosecond pulses at low input power

Red-shift conical emission (CE) is observed by femtosecond laser pulse propagating in BK7 at a low input power (compared to those input powers for generation of blue-shift CE). With the increasing input power the blue-shift CE begins to appear whereas the red-shift CE ring (902 nm in our experiment) disappears accompanied by the augment of the central white spot size synchronously. The disappearing of red-shift CE in our experiment is explained such that the increase of axial intensity is much higher than that of ring emission and the augment of the central white spot size with the increasing input laser power.

Spectral analysis and control to obtain sub-5 fs pulses by femtosecond filamentation

A spectral-filter method is numerically demonstrated to obtain sub-5 fs pulses by using femtosecond filamentation in fused silica. Instead of employing spectral phase compensation, by properly employing a high-pass filter to select the broadened high-frequency spectra that are located almost in phase in the tailing edge of the self-compressed pulses owing to self-steepening, as short as single-cycle pulses can be obtained. For instance, for an input pulse with a duration of 50 fs and energy 2.2 mu J, the minimum pulse duration can reach to similar to 4 fs (about 1.5 cycles) by applying a proper spectral filter. (C) 2008 Optical Society of America