土壤羟胺还原酶活性测定方法的改进

对传统土壤羟胺还原酶活性的测定方法进行了部分改进。用煮沸并密封冷却的蒸馏水形成3～5cm的液封,同时用N2气流排除液面以上的空气,能够创造测定土壤中羟胺还原酶活性所需要的厌氧环境。与传统方法相比,该方法减少了厌氧程度的不确定性和试验步骤的复杂性,增加了培养试验的可操作性。以碘量法为对照,对4种不同的测量浸提液中羟胺浓度的分光光度法进行了对比筛选,结果表明,硫酸铁铵-邻菲罗啉法具有较高的准确度和精密度,是测定土壤中羟胺还原酶活性的理想方法。

杨树落叶前后重金属元素内外迁移循环规律研究

供试元素在杨树各部位的含量和贮量为Ｚｎ＞Ｃｕ＞Ａｓ＞Ｐｂ＞Ｃｄ，并与环境中相应元素浓度呈正相关．落叶时元素的迁移主要发生在叶、枝、根和干之间，叶中８～４８％的Ａｓ、Ｚｎ迁移至主干的皮与材中，而Ｃｕ、Ｐｂ、Ｃｄ贮量均有增加，Ｚｎ、Ａｓ的内循环占总循环量的４０％，Ｃｄ、Ｐｂ、Ｃｕ表现为外循环，占总贮量的１７～２７％．同时分析了植物对土壤重金属污染的净化效率．

内蒙古陈巴尔虎旗饮茶型氟铝联合中毒调查

目的查明内蒙古陈巴尔虎旗饮茶型氟、铝联合中毒原因。方法在陈巴尔虎旗3个牧区嘎查随机抽取93名20~50岁牧民进行发、血清、尿含氟、铝水平测定,并拍摄前臂、小腿、骨盆正位及腰椎正侧位X线片,同时检测饮水、牛奶、砖茶等氟和铝水平,以扎兰屯市地方病防治研究所的34名23~50岁职工为对照组。结果陈巴尔虎旗牧民发、血清、尿及饮用的奶茶含铝量分别是(22.34±8.06)mg/kg、(1.13±0.48)mg/L、(3.78±1.62)mg/L、(6.02±1.77)mg/L,含氟量分别是(1.21±0.63)mg/kg、(0.092±0.042)mg/L、(2.08±1.16)mg/L、(3.00±1.11)mg/L,饮水、牛奶含铝量分别是(39±16)μg/L、(0.553±0.179)mg/L,含氟量分别是(0.50±0.39)、(0.063±0.032)mg/L;对照组发、血清、尿铝分别是(5.80±2.14)mg/kg,(0.203±0.101)mg/L、(2.19±1.34)mg/L,含氟量分别是(1.17±0.68)mg/kg、(0.033±0.008)mg/L、(0.57±0.32)mg/L,牧民发、血清、尿铝及血清、尿氟均高于对照组(P<0.001)。牧民X线改变硬化型22.2%(20/88),疏松型37.5%(33/88),退行性变86.4%(79/88),对照组退行性变13.3%(4/30),其余改变未检出。结论陈巴尔虎旗牧区饮茶型氟中毒实际为饮茶型氟、铝联合中毒。

气象要素空间化方法精度的比较研究:以平均气温为例

以国家气象局1971年~2000年30年整编资料中的东北、华中地区1978年、1984年、1990年、1996年4年的1月份、7月份及年平均气温数据为数据源,采用直接插值法(反距离权重法和普通克里格法)、趋势面模拟+残差内插法、空间化气候值+年际距平空间插值方法、空间化气候值+年际距平趋势面模拟+残差内插等4种方法,进行了空间化精度的比较研究。通过平均绝对误差(MAE)、平均相对误差(MRE)以及交叉验证等几种评估标准的比较,认定在具有30年月平均气温栅格数据库作为背景的前提下,采用空间化气候值+年际距平

Sulfonated poly(ether ether ketone)/aminopropyltriethoxysilane/phosphotungstic acid hybrid membranes with non-covalent bond: Characterization, thermal stability, and proton conductivity

Sulfonated poly(ether ether ketone) (SPEEK) and aminopropyltriethoxysilane (KH550) hybrid membranes doped with different weight ratio of phosphotungstic acid (PWA) were prepared by the casting procedure, as well as PWA as a catalyst for sol-gel process of KH550. The chemical structures of hybrid membranes were characterized by energy dispersive X-ray spectrometry (EDX) and Fourier transform infrared spectroscopy (FTIR). The morphology of hybrid membranes was investigated by scanning electron microscopy (SEM) and atomic force microscopy (AFM). The results had proved the uniform and homogeneous distribution of KH550 and PWA in these hybrid membranes.

Dynamic mechanical properties of gel polymer electrolytes containing ionic liquid

The copolymer of acrylonitrile (AN), methyl methacrylate (MMA) and poly(ethylene glycol) methyl ether methacrylate (PEGMEMA) is synthesized in 1-butyl-3-methylimidazolium tetrafluoroborate (BMImBF(4)). The dynamic mechanical properties of the resulting gel polymer electrolytes containing ionic liquid are measured.

Sulfonated poly(arylene-co-imide)s as water stable proton exchange membrane materials for fuel cells

A novel sulfonated poly(arylene-co-imide)s were synthesized by Ni(0) catalytic copolymerization of sodium 3-(2,5-dichlorobenzoyl)benzenesulfonate and naphthalimide dichloride monomer. The synthesized copolymers with the - SO3H group on the side-chain of polymers possessed high molecular weights revealed by their high viscosity and the formation of tough and flexible membranes. Because of the introduction of electron donating phenoxy groups into naphthalimide moieties, the hydrolysis of the imide rings was depressed. The resulting copolymers exhibited excellent water stability. The copolymer membranes display no apparently change in appearance, flexibility, and toughness after a soaking treatment in pressurized water at 140 degrees C for 250 h.

Platinum-macrocycle co-catalysts for electro-oxidation of formic acid

In this paper, it was found that the electrocatalytic activity of a Pt electrode for the electro-oxidation of formic acid could be dramatically enhanced with the modification of macrocycle compounds, such as iron-tetrasulfophthalocyanine (FeTSPc). The electro-oxidation of formic acid on a modified Pt electrode with FeTSPc occurs mainly through a direct pathway. A series of macrocycle compounds were also investigated as modifiers and exhibited a promotion effect similar to the Pt electrode.

Effects of polymerization conditions on hydrophilic groups in aromatic polyamide thin films

For polyamide used in reverse osmosis (RO) membranes, the content of pendant acid groups is critical to its performance. In this work, FTIR was used to analyze the acid contents in the polyamide films prepared via interfacial polymerization of trimesic acid trichloride (TMC) in hexane and 1,3-phenylenediamine (MPDA) in water, and the effects of reaction conditions, including monomer concentrations, time, and temperature, were studied. It was found that more pendant acid groups are present in the polyramide film at higher TMC concentrations or lower MPDA concentrations, and longer reaction times and lower temperatures also favor the formation of the free acids. These results can be explained by the monomer diffusion in the interfacial polymerization process. This work may help the design and fabrication of RO membranes with different hydrophilicity and target performance.

水基导电聚苯胺/二氧化硅杂化材料的防腐性能研究

利用羧基同导电聚苯胺(cPANI)主链上的氮原子的相互作用,制备了静电作用型水基导电聚苯胺/二氧化硅杂化材料,研究了杂化材料涂层对冷轧钢板的防腐性能.在3.5%NaCl中,含11 wt%cPANI的杂化材料涂层的腐蚀电位比纯二氧化硅涂层正移了200 mV,腐蚀电流从13.4μA降到2.4μA,下降了5倍,表明含cPANI的静电作用型杂化涂料使冷轧钢板表面变得更惰性.阻抗分析结果表明,cPANI含量为11 wt%的静电作用型杂化材料的阻抗比纯无机二氧化硅涂层大一个数量级,而且在碱性介质中浸泡10天后,杂化材料涂层的阻抗仍然保持稳定,而纯无机二氧化硅涂层的阻抗比初始值下降了一个数量级.杂化材料的形态分析结果表明,cPANI在静电作用型cPANI/二氧化硅杂化材料中的分布比在普通cPANI/二氧化硅杂化材料中更加均匀一致,从而使得它比普通的cPANI/二氧化硅杂化材料具有更好的防腐效果.

Synthesis, structure and optical properties of new organic-inorganic haloplumbates complexes (C5H10N3)PbX4 (X = Br, Cl), (C2H2N4)PbBr3

Layered organic-inorganic composite materials (C5H10N3)PbX4 (X = Br 1, Cl 2) containing histaminium dications were grown via a solution-cooling process, and their structure and optical properties were determined. The organic ligand-histaminium introduced into the corner-sharing octahedra of the 'PbX4- layer' contains both primary ammonium and imidazolium different from the traditionally primary amine found in this system. As comparison, another analogous amine of 3-amino-1,2,4-triazol was used as ligand to coordinate with PbBr2 in acid solution. A novel complex (C2H2N4)PbBr3 (3) was obtained with zigzag PbBr2 chains different from the PbX4 layer in compound as 1 and 2. The hybrid (C5H10N3)PbX4 show exciton absorption at 339 nm for X = Cl and 419 nm for X = Br with the corresponding emission at 360 and 436 nm, respectively. The different PbBr2 chain structure of compound 3 does not show photo luminescence.