小叶锦鸡儿防风固沙林稳定性研究

针对科尔沁沙地小叶锦鸡儿固沙林在持续高温干旱条件下出现稳定性波动的问题 ,选择 2、5、15、35 a人工群落和天然群落进行对比研究 ,探讨了人工小叶锦鸡儿防风固沙林物种多样性在 35 a间的变化以及对大气持续干旱的抵抗力和对外界干扰的恢复能力。流动沙丘固定后 ,固沙林内草本植物迅速侵入 ,其后则缓慢发展并处于相对稳定状态 ,植物种类数保持在 2 0～ 2 3种。但在人工固沙群落中 1年生植物在种类数和数量上始终处于优势地位 ,而天然群落则是多年生植物占优势。人工固沙群落物种多样性指数逐年提高 ,但明显低于天然群落。在受到大气持续高温干旱的干扰时 ,人工群落土壤条件极度恶化 ,出现了明显的干沙层 ,最深达 14 0 cm ,叶片含水量极度降低 ,植物生长停止。沙地植物群落对牲畜取食均具有一定的补偿的能力 ,在啃食较轻时表现为超补偿现象。通过建立数学模型分析 ,人工群落个体的补偿点和超补偿点明显低于天然群落。采用冗余理论对植物群落稳定性机制进行了论述 ,认为冗余结构的变化是导致群落稳定性变化的内在原因。对现有人工小叶锦鸡儿固沙林的稳定性进行了评价 ,并认为 15 a左右人工固沙林正处于相对稳定并缓慢发展状态。对于稳定的人工固沙群落应具备以下条件 :(1)适于当地环境条件 ;(2 )对外界

中国的褐褶菌属(担子菌门,非褶菌目)的研究(英文)

对中国褐褶菌属Gloeophyllum的种类进行了研究,并记录了此属中10个种。其中喜干褐褶菌Gloeophyllumprotractum是中国的新记录种,发现于黑龙江和四川省的针叶树倒木上。根据中国的材料详细描述了此种,并列出褐褶菌属的检索表。

湘西多金属矿区汞铅污染土壤的环境质量

以湘西典型多金属矿区为现场,研究了矿区土壤中汞、铅等重金属污染状况及成因.结果表明,湘西矿区是汞、铅污染严重的区域,与中国土壤元素背景值相比,汞矿区土壤中汞、铅含量分别增加1315倍和3.1倍,铅锌矿区土壤中汞、铅含量分别增加14.8倍和16.1倍.运用Muller地积指数进行风险评价,证实湘西矿区是汞、铅等重金属的复合污染区,汞矿区汞污染以极重污染为主,铅污染以中度和轻污染为主;铅锌矿区铅污染以中度和中-重污染为主,汞污染以中-重污染为主.矿区土壤中的重金属污染物来源和分布受原生地球化学条件的控制,而人为采矿活动对矿区土壤中汞、铅的污染格局产生重要影响.

Relationship between charge transfer energies of Yb3+ and Sm3+ and crystal environmental factor

Relationship between charge transfer energies E-CT of Yb3+ and Sm3+ and environmental factors h(e) in various crystals was investigated using a dielectric chemical bond method. Both results show that they have an exponential relation E-CT = A+B exp(-kh(e)), but the exponential factors are different, which indicates that the interaction between the rare earth ions and environment is connected with the kind of rare earth ion. This result provides a method of determining charge transfer energies of Yb3+ and Sm3+ from a crystal structure.

Novel proton exchange membranes based on water resistant sulfonated poly[bis(benzimidazobenzisoquinolinones)]

Novel water resistant sulfonated poly[bis(benzimidazobenzisoquinolinones)] (SPBIBIs) were synthesized from 6,6'-disulfonic-4,4'-binaphthy]-1,1',8,8'-tetracarboxylic dianhydride (SBTDA) and various aromatic ether tetraamines. The resulting polymers with IEC in the range of 2.17-2.87 mequiv g(-1) have a combination of desired properties such as high solubility in common organic solvents, film-forming ability, and excellent thermal and mechanical properties. Flexible and tough membranes, obtained by casting from m-cresol solution, had tensile strength, elongation at break, and tensile modulus values in the range of 87.6-98.4 MPa, 35.8-52.8%, and 0.94-1.07 GPa. SPBIBI membranes with a high degree of sulfonation displayed high proton conductivity and a good resistance to water swelling as well. SPBIBI-b with IEC of 2.80 mequiv g(-1) displayed the conductivity of 1.74 x 10(-1) S cm(-1) at 100 degrees C, which was comparable to that of Nafion (R) 117 (1.78 x 10(-1) S cm(-1), at 100 degrees C).

Investigations on the adsorption behavior of Neutral Red on mercaptoethane sulfonate protected gold nanoparticles

A detailed investigation on the adsorption behavior of Neutral Red (NR) molecules on mercaptoethane sulfonate-monolayer protected gold clusters (MES-MPCs) has been conducted by the spectroscopic method. It is found that cationic NR molecules are adsorbed on the negatively charged MPCs surfaces via electrostatic attractive forces. The absorption study shows that the optical properties of NR molecules are significantly influenced upon the adsorption. Based on the electrostatic adsorption nature and the excellent stability of MES-MPCs against the electrolytes, this association can be released by the addition of electrolyte salts, which can be monitored by both absorption and fluorescence spectroscopy. In addition, dication Ca2+ is found to be more effective in the release of NR than univalent Na+. Moreover, the MES-MPCs exert energy transfer quenching of NR fluorescence by both static and dynamic quenching. However, static quenching seems to be the dominating quenching mechanism. Furthermore, this energy transfer quenching exhibits strong dependence of Au core size, and 5.0 nm MPCs show stronger ability in quenching the NR fluorescence than that of 2.7 nm MPCs.

The microstructure and mechanical properties of Mg-8Zn-8Al-4RE magnesium alloy

The Mg-8Zn-8Al-4RE (RE = mischmetal, mass%) magnesium alloy was prepared by using casting method. The microstructure and mechanical properties of as-cast alloy, solid solution alloy and aged alloy samples have been investigated. Optical microscopy, X-ray diffractometery and scanning electron microscope attached energy spectrometer were used to characterize the microstructure and phase composition for the alloy. Net shaped tau-Mg-32(Al,Zn)(49) phase was obtained at the grain boundary, and needle-like or blocky Al11RE3 phase disperses in grain boundary and alpha-Mg matrix. The tau-Mg-32(Al,Zn)(49) phase disappeared during solution treatment and a new phase of Al(2)CeZn2 formed during subsequent age treatment. The mechanical properties were performed by universal testing machine at room temperature, 150 degrees C and 200 degrees C, separately. The ultimate tensile strength of as-cast alloy is lower compared to an age treatment alloy at 200 degrees C for 12h. The strengths decreased with enhancing test temperature, but elongation has not been effect by age treatment.

Mesoporous acid solid as a carrier for metallocene catalyst in ethylene polymerization and a catalyst in catalytic degradation of polyethylene

The possibility of mesoporous acid solid as a carrier for metallocene catalyst in ethylene polymerization and catalyst for polyethylene (PE) catalytic degradation was investigated. Here, HMCM- 41 and AIMCM-41, and mesoporous silicoaluminophosphate molecular sieves (SAPO1 and SAPO2) were synthesized and used as acid solid. Much more gases were produced during catalytic degradation in PE/acid solid mixtures via in situ polymerization than those via physical mixing. The particle size distribution results exhibited that the particle size of SAPO1 in the PE/SAPO1 mixture via in situ polymerization was about 1/14 times of that of the original SAPO1 or SAPO1-supported metallocene catalyst. This work shows a novel technology for chemical recycling of polyolefin.

应用基质辅助激光解吸电离飞行时间质谱法测定牛甲状腺球蛋白的分子量

应用基质辅助激光解吸电离飞行时间质谱法测定了牛甲状腺球蛋白的纯度与相对分子量．选择芥子酸为适宜的基质，并对所得的结果进行了讨论．实验结果表明分析方法具有灵敏度高、重现性好、信息直观等特点，明显优于其他传统测定蛋白质的方法.

Synthesis, crystal structure, and density of (W1-xAlx)C

A new solid solution system of Al in WC, with the stoichiometry of (W1-xAlx)C (x = 0.10, 0.25, 0.50, 0.75, 0.86), has been synthesized by a solid-state reaction between W1-xAlx alloys and carbon at around 1673 K in vacuum. Environment scanning electron microscope, energy- dispersive analysis of X-ray, X-ray photoelectron spectroscopy, and inductively coupled plasma analyses are used to certify the formation of the products. The mechanism of the solid-state reaction is also discussed. (W1-xAlx)C is identified to crystallize in the hexagonal space group P6m2 (No. 187) and belongs to the WC structure type. The atoms of W and Al occupy the same lattice site (la site) in the cell of (W1-xAlx)C. The cell parameters for each specimen in the phase of W-AI-C are quite close to that of WC, while their densities are far lower than that of WC.

Effect of poly(propylene carbonate) on the crystallization and melting behavior of poly(beta-hydroxybutyrate-co-beta-hydroxyvalerate)

The crystallization and melting behavior of poly(beta-hydroxybutyrate-co-beta-hydroxyvalerate) (PHBV) and a 30/70 (w/w) PHBV/poly(propylene carbonate) (PPC) blend was investigated with differential scanning calorimetry (DSC) and Fourier transform infrared (FTIR). The transesterification reaction between PHBV and PPC was detected in the melt-blending process. The interaction between the two macromolecules was confirmed by means of FTIR analysis. During the crystallization process from the melt, the crystallization temperature of the PHBV/PPC blend decreased about 8 degreesC, the melting temperature was depressed by 4 degreesC, and the degree of crystallinity of PHBV in the blend decreased about 9.4%; this was calculated through a comparison of the DSC heating traces for the blend and pure PHBV. These results indicated that imperfect crystals of formed, crystallization was inhibited, and the crystallization ability of PHBV was weakened in the blend. The equilibrium melting temperatures of PHBV and the 30/70 PHBV/PPC blend isothermally crystallized were 187.1 and 179 degreesC, respectively.