Mn-containing AlPO-11 and SAPO-11 catalysts for simultaneous isomerization and dehydrogenation of n-butane

MnAPO-11 and MnAPSO-11 were synthesized hydrothermally, and supported Mn-AlPO-11 and Mn-SAPO-11 were also prepared for comparison. Characterization results showed that there were differences in acidity and reducibility caused by the different incorporation methods of manganese. The manganese species in the samples also weakened the metallic properties of the palladium particles when the latter was added into the catalysts. Catalytic testing results for dehydroisomerization of n-butane indicated that incorporation of manganese increased the selectivity toward isomerization products. The highest isobutene selectivity (34.86%) could be obtained over a Pd/MnAPO-11 catalyst. When a combined catalyst system containing Pd/SAPO-11 and MnAPSO-11 was used in a single bed of two layers, the isobutene selectivity could be greatly improved, as compared to the single catalyst alone.

Performance of palladium-containing supported catalysts in the oxidation of 1-butene

Performance of palladium-containing supported catalysts in the oxidation of 1-butene was investigated in a fixed-bed flow microreactor. The Pd-Fe-HCl/Ti-Al catalyst is the best among the five Pd-Fe-HCl/X (A = SiO2, gamma-Al2O3, Al-Ti, TiO2, MCM-22) catalysts for the oxidation of I-butene to butanone. It is interesting that high propionic acid selectivity can be obtained when V and H2SO4 are added to the palladium-containing supported catalysts.

Determination of sulfur-containing compounds in diesel oils by comprehensive two-dimensional gas chromatography with a sulfur chemiluminescence detector

This article reports an analytical method for separating, identifying and quantitating sulfur-containing compounds and their groups in diesel oils (170-400degreesC) using comprehensive two-dimensional gas chromatography coupled with a sulfur chemiluminescence detector. The identification of target compounds and their groups was based on standard substances, the group separation feature and the-effect of comprehensive two-dimensional gas chromatography. The quantitative analysis on major sulfur compounds and total sulfur was carried out based on the linear response of sulfur chemiluminescence detector and the internal standards method. The results of total sulfur determination in the samples were compared with those from ASTM D 4294 standard method, the R.S.D. percentage were <6.02%, correctness of this method can meet the industrial requirement. To the end, the method developed was used to investigate the sulfur-containing compounds in different diesel oils, the result shows that the distribution of sulfur-containing compounds in diesel oils from different process units are apparently different. The sulfur compounds in fluid catalytic cracking (FCC), residuum fluid catalytic cracking (RFCC) diesel oils mainly exist in the form of alkyl-substituted dibenzothiophenes that add up to about 40-50% of the total sulfur, while this number is only 6-8 and 20-28% in visbreaking (VB) and delayed-coking (DC) diesel oils, respectively. (C) 2003 Elsevier B.V. All rights reserved.

Sorption of metals on humic acid

The sorption on humic acid (HA) of metals from an aqueous solution containing Hg(II). Fe(III), Pb, Cu, Al, Ni, Cr(III), Cd, Zn, Co and Mn, was investigated with special emphasis on effects of pH, metal concentration and HA concentration. The sorption efficiency tended to increase with rise in pH, decrease in metal concentration and increase in HA concentration of the equilibrating solution. At pH 2.4. the order of sorption was: Hg Fe Pb Cu=Al Ni Cr=Zn=Cd=Co=Mn. At pH 3.7. the order was: Hg and Fe were always most readily removed, while Co and Mn were sorbed least readily. There were indications of competition for active sites (CO2H and phenolic OH groups) on the HA between the different metals. We were unable to find correlations between the affinities of the eleven metals to sorb on HA and their atomic weights, atomic numbers, valencies, and crystal and hydrated ionic radii. The sorption of the eleven metals on the HA could be described by the equation Full-size image (1K), where Y = % metal removed by HA; X = mgHA; and A and B are empirical constants

Calibration of a solid-state copper ion-selective electrode in cupric ion buffers containing chloride

It is shown that near-Nernstian calibration slopes can be obtained with a Cu1.8Se electrode in a range of cupric ion buffers in spite of a high chloride content. Best results are obtained with the ligands ethylenediamine, glycine and histidine. The onset of cupric ion toxicity towards marine organisms falls within the pCu calibration range obtained with glycine, and the Cu1.8Se electrode could, therefore, be useful for monitoring cupric ion activity in bioassays in sea-water media.

The Synthesis and Characterization of a Novel (E,E)-Dioxime and its Mono- and Heterotrinuclear Complexes Containing an 18-Membered Dioxadithiadiazamacrocycle

The novel (E,E)-dioxime, 5,6:17,18-dibenzo-11,12-(4-nitrobenzo)-2,3-bis(hydroxyimino)-7,16-dithia-10,13-dioxa-1,4-diazacyclooctadecane) (H2L), has been synthesized from reaction of (E,E)-dichloroglyoxime (1) with 2,3:14,15-dibenzo 8,9-(4-nitrobenzo)-4,13-dithia-7,10-dioxa-1,16-diazahegzadecane (2). The mononuclear Co(III) complex (4) of this dioxime was prepared by oxidation of the cobalt (II) complex. The -capped Co(III) complex (5) was synthesized by using a precursor Co(III) complex and boron trifluoride dietherate. The heterotrinuclear complexes (6) and (7) were prepared by reaction of (5) with NiCl2·6H2O and CdCl2·H2O, respectively. In addition, the homotrinuclear Cu(II) complex (8), has also been prepared by the reaction of this dioxime with CuCl2·H2O. The structures of the dioxime and its complexes were identified by using elemental analysis, 1H- and 13C-NMR, IR, and mass spectral data.

平菇菌丝体对Cd、Pb及其复合污染的生长与富集响应

在PDA平板培养条件下,研究Cd、Pb及其复合污染对平菇菌丝体生长的影响以及平菇菌丝体对生长基质中Cd、Pb的生物富集作用.结果表明,在实验浓度范围内,菌丝生长势、菌落直径和菌丝体干重等均随着重金属浓度的增大而减弱(小)或降低.平菇菌丝体对Cd、Pb均具有生物富集作用,并且随着重金属浓度的增大菌丝体中重金属含量逐渐增大.Cd、Pb复合污染能促进平菇菌丝体对Pb的吸收,而抑制对Cd的吸收.

土壤有效态Pb和Cd与大蒜吸收Pb和Cd的关系

通过对大蒜的重金属添加土培试验,采用DTPA(二乙基胺五乙酸)为有效态铅、镉提取剂,对受试土壤进行浸提检测,分析Pb和Cd在大蒜不同部位的吸收、积累及其与土壤中有效态含量的相关性。根据GB 2762-2005《食品中污染物限量标准》中对食品中Pb、Cd的限量要求,初步确定了本试验条件下,土壤中重金属Pb、Cd有效态的临界值,并以此临界点评价该种土壤中Pb、Cd对大蒜的潜在污染。

细河流域土壤中Hg、Cd、Pb和Zn含量的空间分布特征

利用地统计学方法研究了沈阳市细河流域表层土壤中Hg、Cd、Pb和Zn含量的空间结构及其分布特征。结果表明,土壤中Hg、Cd、Pb和Zn的平均含量均高于其背景值;土壤Cd和Zn含量属中等程度的空间相关,Hg和Pb属于空间弱相关,其空间变异均为随机性因素和结构性因素共同作用的结果,但Cd和Zn含量主要受结构性因素影响,而Hg和Pb主要受随机性因素影响。土壤中Hg、Cd、Pb和Zn空间分布特征表明,4种重金属含量在上游较高,顺流而下含量明显下降;土壤中Hg和Pb含量最大值在四方台地区,Cd和Zn含量最大值分布在甘官和富官一带。细河流域土壤Hg、Cd、Pb和Zn含量空间分异是污水灌溉、固体废弃物堆放、农业生产及交通尾气等因素综合作用的结果。

Hole-transporting polymers containing carbazol-3,9-diyl and 1,4-phenylene fragments in the main chain

New carbazole-based polymers, which contain various content of electro-active fragments in the main chain connected via alkylene spacers, have been synthesized by Ni(0)-catalyzed Yamamoto-type aryl-aryl coupling reactions. These compounds represent amorphous materials of high thermal stability with glass-transition temperatures of 139-151 degrees C and thermal decomposition starting at temperatures above 400 degrees C. UV-vis absorption and photoluminescence emission spectra of the materials confirmed that the conjugated segments in the macromolecules are rather short.

Two novel molybdenum complexes containing [Mo2O2S2](2+) fragment: synthesis, crystal structures and catalytic studies

Mo2O2S2(HGly)(GlY)(2) 1 and K-6[Mo2O2S2(nta)(2)][Mo2O2S2(ntaH)(2)]center dot 4H(2)O 2 were synthesized by the reactions of (NH4)(2)MoS4 and amino acids L (L = glycine, nitrilotriacetic acid) in ethanol-water medium at ambient temperature. The two complexes were characterized by elemental analysis, infrared spectra, UV-visible spectra, TG-DTA and XPS.

Stripping voltammetric determination of Pb(II) and Cd(II) based on the multiwalled carbon nanotubes-Nafion-bismuth modified glassy carbon electrodes

In this work, a new method for the simultaneous determination of Pb(II) and Cd(II) on the multiwalled carbon nanotubes (MWNT)-Nafion-bismuth modified glassy carbon electrode (GCE) using square-wave anodic stripping voltammetry has been studied. Scanning electron microscopy was used to investigate the characteristics of the MWNT-Nafion-bismuth modified GCE.

Sensitive determination of Cd and Pb by differential pulse stripping voltammetry with in situ bismuth-modified zeolite doped carbon paste electrodes

Here we investigated the analytical performances of the bismuth-modified zeolite doped carbon paste electrode (BiF-ZDCPE) for trace Cd and Pb analysis. The characteristics of bismuth-modified electrodes were improved greatly via addition of synthetic zeolite into carbon paste. To obtain high reproducibility and sensitivity, optimum experimental conditions for bismuth deposition Were Studied.

Dynamic mechanical properties of gel polymer electrolytes containing ionic liquid

The copolymer of acrylonitrile (AN), methyl methacrylate (MMA) and poly(ethylene glycol) methyl ether methacrylate (PEGMEMA) is synthesized in 1-butyl-3-methylimidazolium tetrafluoroborate (BMImBF(4)). The dynamic mechanical properties of the resulting gel polymer electrolytes containing ionic liquid are measured.

Topological Diversity of Coordination Polymers Containing the Rigid Terephthalate and a Flexible N,N'-Type Ligand: Interpenetration, Polyrotaxane, and Polythreading

Reactions of zinc(II) or cadmium(II) salts with terephthalic acid (H(2)tp) and 1,3-bis(4-pyridyl) propane (bpp) have afforded four coordination polymers at room temperature, [Zn(mu-tp)(mu-bpp)](n)center dot 2nH(2)O (1), [Cd-2(mu-tp)(2)(mu-bpp)(3)](n)center dot 2nH(2)O (2), [Cd(mu-tp)(mu-bpp)(H2O)](n)center dot nH(2)O (3), and [Cd-2(mu-tp)(mu-bpp)(2)(bpp)(2)Br-2](n) (4). Single-crystal X-ray diffraction has revealed interesting topological features for these compounds.