聚己内酯和聚氧化乙烯共混体系中的两类片晶相间堆砌

对聚(ε-己内酯)(PCL)/聚氧化乙烯(PEO)共混物的相差显微镜、广角X-射线衍射(WAXD)、小角X-射线散射(SAXS)及示差扫描量热计(DSC)等的研究表明,只有当共混物中PCL(或PEO)的含量低于20％时,两组份是相容的.当PCL含量低于20％时,在共混物中形成了PEO片晶和PCL片晶相间堆砌的结晶形态,当PEO含量不超过20％时,PEO则完全以非晶形式混入PCL的非晶区,同时阻碍了PCL的结晶.可见在结晶过程中,相容的两组份对共混体系形态结构的影响却不尽相同.

聚硅氧烷-聚醚接枝共聚物的合成及其碱金属盐络合物离子电导的研究

本文采用环氧乙烷与环氧丙烷共聚合成了一系列低分子量的聚醚(PEP),并用PEP的单烯丙基醚借助氢化硅烷基化反应(Hydrosilylation)制备出一种新型聚硅氧烷接枝聚醚的高分子电解质主体材料(PAEPS).分别讨论了共聚物组成、盐的种类和浓度等因素对交联PAEPS与碱金属盐络合物电解质膜离子电导的影响.结果表明,PAEPS与碱金属盐络合物的室温电导率较纯线型PEO提高两至三个数量级,电导率随温度变化关系基本上符合VTF方程,属于典型的非晶电解质行为.

RADIATION-INDUCED CROSS-LINKING OF POLY(METHYL METHACRYLATE)-POLY(ETHYLENE OXIDE) BLEND

Radiation-induced crosslinking of poly(methyl methacrylate) (PMMA)-poly(methylene oxide) (PEO) blends was studied. It was found that PMMA in PMMA-PEO blend can be crosslinked in the range of certain doses (1 approximately 20 x 10(4) Gy) and composition (PMMA% = 30 approximately 70) under the absence of oxygen. Moreover, it was also found that the crosslinking degree of PMMA in the blend in which the content of PMMA is 70% is the largest. The crosslinking degree of PMMA in the blend is closely related with the polymer miscibility. The crosslinking degree of the blend prepared at 60-degrees-C is far higher than one at ambient temperature.

THE MISCIBILITY AND MORPHOLOGY OF EPOXY-RESIN POLY(ETHYLENE OXIDE) BLENDS

Poly(ethylene oxide) (PEO) was found to be miscible with uncured epoxy resin, diglycidyl ether of bisphenol A (DGEBA), as shown by the existence of a single glass transition temperature (T(g)) in each blend. However, PEO with M(n) = 20 000 was judged to be immiscible with the highly amine-crosslinked epoxy resin (ER). The miscibility and morphology of the ER/PEO blends was remarkably affected by crosslinking. It was observed that phase separation in the ER/PEO blends occurred as the crosslinking progressed. This is considered to be due to the dramatic change in the chemical and physical nature of ER during the crosslinking.

COMPATIBILIZING EFFECT OF POLY(ETHYLENE OXIDE)-B-POLYSTYRENE-B-POLY(ETHYLENE OXIDE) IN PHENOLPHTHALEIN POLY(ETHER ETHER KETONE) POLY(2,6-DIMETHYL-1,4-PHENYLENE OXIDE) BLENDS

The morphology and mechanical behaviour of phenolphthalein poly(ether ether ketone) (PEK-C)/poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) blends has been investigated. A poly(ethylene oxide)-b-polystyrene-b-poly(ethylene oxide) (PEO-PS-PEO) triblock copolymer was used as compatibilizer. It was found that PEO-PS-PEO has a compatibilizing effect on the PEK-C/PPO blends. The addition of PEO-PS-PEO to the blends greatly improves phase dispersion and interfacial interfacial adhesion and also enhances the ultimate tensile strength and Young's modulus at compositions ranging from 30 to 70% PEK-C. However, all the values of the ultimate tensile strength within the whole composition range are lower than those expected by simple additivity, probably owing to the poor mechanical properties of PEO-PS-PEO copolymer.

聚环氧乙烷(PE0)与聚双酚A羟基醚(PBHE)共混体系的研究

用偏光显微镜(PLM)、扭辫(TBA)、IR及WAXD对PEO/PBHE共混体系结晶形态进行了研究。结果表明,PEO含量在50％以上的共混体系,几乎完全被PEO球晶充满,非晶态PBHE作为微区分散在大球晶之间或球晶之中。PEO含量为40％和30％的照片上呈现树枝晶。PEO含量为20％以下时照片中不再看到结晶出现,PEO与PBHE形成单一非晶相。PEO/PBHE共混体系的组分之间存在着氢键相互作用,这种作用强于PBHE分子间的氢键作用。共混体系的结晶度及T_g随PBHE组分含量的增加,前者减小后者增加并符合FOX方程揭示的规律。PEO与PBHE具有很好的相容性。

环氧乙烷-烯丙基缩水甘油醚共聚物LiClO_4聚合物电解质的制备及性能

自Wright和Armand报道了有关聚醚-碱金属盐络合物的电导及其应用以来,高分子固体电解质已成为近几年来迅速发展起来的一种新型功能材料。由于它具有较高的离子电导率、可塑性强、电化学稳定性等优点,使它在全固态高能密锂电池及电化学元件的应用上显示出了很大的优越性,但线型PEO的高结晶度(>75％)导致PEO-碱金属盐络合物的室温电导率很低(～10~(-8)S·cm~(-1)),限制了它的使用范围。因此,对PEO进行各种改性,以提高电

聚氧乙烯/聚酚氧共混体系的结晶行为及相容性研究

对聚氧化乙烯/聚酚氧(PEO/PH)共混体系的研究表明,随共混体系中非晶组份PH含量的增加,Avrami指数n值由2.0～2.3变为1.5～2.0,体系的结晶由盘状生长转化为纤维状生长;成核方式由方式Ⅰ转化为方式Ⅱ.PEO/PH共混体系的平衡熔点随PH含量的增加而降低,相互作用能量密度B=-1.46cal/mol,说明体系是互容的。

高分子固体电解质研究的进展

高分子固体电解质是近年来开发的可用于全固态电池等方面的新型材料,它具有优良的成膜性和粘弹性等一般无机固体电解质所不具备的特点。但由于室温电导率很低,应用受到限制。为了改进这一点,已进行了许多研究,并取得了不少进展。目前改性聚氧乙烯(PEO)的室温电导率可达10~(-4)S·cm~(-1)。本文主要讨论提高高分子固体电解质性能的途径,其中大部分是关于PEO的化学和物理改性,例如共聚、共混和交联等,同时也介绍了非聚醚、非氧型及自电离聚合物,并对今后的发展前景作了简要探讨,

环氧树脂/聚氧化乙烯共混物及其与硫氰化钠络合物的结构研究(Ⅰ)

对不同分子量聚氧乙烯(PEO)以不同比例与双酚A二缩水甘油醚型环氧树脂(ER)制得的交联共混物ER/PEO,以及再与NaSCN络合后的产物用WAXD,SAXS,DSC和SEM等方法进行了研究,结果表明:随着ER含量的增加,ER/PEO共混物由晶态转为非晶态。ER/PEO属单斜晶系;与NaSCN络合后,体系结晶性变差。ER/PEO-NaSCN属三斜晶系,其长周期比相应ER/PEO交联共混物的长周期值大。EP的加入使非晶层增厚,结晶片层变薄,长周期值增加。

Characterization of polyethylene glycol-modified proteins by semi-aqueous capillary electrophoresis

A new program to characterize polyethylene glycol-modified (PEGylated) proteins is outlined using capillary zone electrophoresis (CZE). PEGylated ribonuclease A and lysozyme were selected as examples. Five separation procedures were compared to select out the mixed buffer of acetonitrile-water (1:1, v/v) at pH 2.5 as the best to characterize the PEGylated proteins without sample pretreatment. Polyethylene oxide (PEO) with a high molecular mass of 8X10(6) was applied to rinse the capillary to form a dynamic coating which would decrease the undesirable proteins adsorbed to the inner wall of the silica. The electroosmotic flow (EOF) mobility of the five procedures was determined, respectively. It is found that acetonitrile is mainly responsible for the good resolution of PEGylated proteins with the help of PEO coating in the semi-aqueous system. The low EOF mobility and current in the semi-aqueous system might also have some responsibility for the high resolution. The semi-aqueous procedure described in this paper also demonstrates higher resolution of natural proteins than aqueous ones. (C) 2001 Elsevier Science B.V. All rights reserved.

Preparation of a novel polysulfone/polyethylene oxide/silicone rubber multilayer composite membrane for hydrogen-nitrogen separation

A novel poly sulfone/polyethylene oxide/silicone rubber (PSOPEO/SR) multilayer composite membrane was fabricated by double coating polysulfone substrate membrane with polyethylene oxide and silicone rubber. Gas permeation experiments were performed at 30 degrees C for hydrogen and nitrogen. PSf(PEO/SR membrane displayed high and steady performance for H-2/N-2: permeances of H-2 and N-2 of 49.51 and 0.601 GPU, respectively, and H-2/N-2 ideal separation factor of 82.3. It was explained that layer interfaces due to the introduction of PEO layer act as the permselective media and are responsible for the higher H-2/N-2 ideal separation factor which has exceeded the intrinsic permselectivities of the three polymers used in this study. (c) 2005 Elsevier B.V. All rights reserved.