利用块状介质进行飞秒强激光脉冲的腔外压缩

高强度飞秒激光脉冲的腔外压缩是获得高次谐波阿秒脉冲驱动源的必要手段。实验研究了超强超短飞秒激光脉冲在经过块状介质后的光谱展宽和色散补偿压缩现象。单脉冲能量0．26mJ，脉宽50fs的激光脉冲经透镜在空气中聚焦后再入射到块状材料上，出射脉冲光谱被展宽到接近40nm。由于在块状材料中的自聚焦效应，出射光束质量变好并保持较小的空间啁啾。利用熔融石英棱镜对补偿带有正色散的出射脉冲，最后得到〉0．1mJ，19fs的压缩脉冲。利用SPIDER装置测量了出射脉冲的脉宽和光谱相位。整个系统的能量效率大约为35％，压缩后的

脉冲啁啾对于阿秒脉冲的影响

采用单电子近似和软核势模型，通过数值求解一维含时薛定谔方程，理论研究了当脉冲分别带有正、负啁啾的情况下所产生的阿秒脉冲，分析了不同脉冲啁啾特性对阿秒脉冲的强度和宽度的影响，研究结果表明，无论是正啁啾还是负啁啾，随着啁啾量的增加，都将使激光脉冲由产生单个阿秒脉冲趋向于产生阿秒脉冲链，正啁啾和负啁啾对于阿秒脉冲宽度的影响是不同的，负啁啾对于阿秒脉冲宽度影响很小，适当的负啁啾有利于缩小阿秒脉冲的宽度；而正啁啾脉冲产生的阿秒脉冲较无啁啾时展宽，且随着啁啾量的增加，其阿秒脉冲宽度迅速增大。

飞秒强激光经氩气和氩团簇的传播

通过数值求解三维电场传播方程，理论模拟了飞秒强激光脉冲（50fs，10^16w／cm^2）在氩气和中等尺寸氩团簇中的传播效应．结果表明，飞秒强激光脉冲经氩气传播将发生频谱蓝移展宽和光束发散；而经中等尺寸氩团簇传播，则存在一定程度的自聚焦效应．

双色激光场中激光强度和脉宽对线性多原子分子离子电离的影响

利用强激光场电离和离解分子来研究分子激发态的波包结构是强场物理的重要研究方向。利用短时指数传播子对称分割法和快速傅里叶变换技术。数值求解了一维含时Schr（oe）dinger方程，探讨了双色激光场中激光的基波和谐波强度之间的不同配比以及脉宽对线性多原子分子离子电离的影响。理论计算结果表明：基波和谐波的相对相位为π时，尽管随着激光的基波和谐波强度之间配比的变化，电离几率随原子间距变化的趋势基本保持不变，但在一定的激光基波强度下(1．2×10^13～1．2×10^15W／cm^2)，激光基波强度的变化可以明显

影响单电子非线性汤姆孙散射因素的研究

应用电子汤姆孙散射的经典理论，通过理论分析和计算机模拟，研究了超短超强激光脉冲作用下电子产生的辐射脉冲的性质．计算表明，在这种情况下，电子的辐射通常以阿秒脉冲列的形式出现．讨沦了不同激光场参数(包括激光强度、脉宽、初相位和偏振态)、不同电子初始状态(初始速度和位置)对辐射脉冲的时间和空间特性的影响．通常在相对论光强条件下，激光强度越大，电子辐射越强，脉宽越窄，中心频率越大，并且方向性越好；电子在线偏振激光中产生的辐射效率，比在同样强度下圆偏振激光中产生的效率更高；无论入射光是线偏振光，还是圆偏振光，辐射场

超短激光脉冲在不同色散参量光子晶体光纤中传输的数值模拟

为了使得数值模拟更为精确, 采用广义非线性薛定谔方程(GNSE)描述超短激光脉冲在光子晶体光纤中的传输演化过程, 并利用二阶分步傅里叶方法通过求解方程, 数值计算了相同脉宽和能量的超短脉冲在不同色散参量的光子晶体光纤中非线性传输和超连续谱的产生。比较了超短脉冲在光纤不同色散区传输时, 高阶色散和非线性效应对超连续谱的产生以及对脉冲波形演化的影响。结果表明, 相对于超短脉冲中心波长位于光子晶体光纤的正常和反常色散区, 可以相应获得短波波段和长波波段的超连续谱输出, 当超短脉冲中心波长位于零色散波长点时, 通

极紫外阿秒脉冲在高次谐波产生过程中引起的非偶极效应

当红外强激光和极紫外（XUV）阿秒脉冲共同作用于原子分子时，电离出去的电子通常会吸收和辐射激光光子而发生能量扩展．讨论了由于XUV阿秒脉冲的短波长与扩展后的电子波包尺度可相比拟时在高次谐波产生过程中引起的非偶极效应．采用彤作为模型分子，并把分子轴置于激光场的传播方向，通过解二维含时薛定谔方程并比较考虑非偶极效应和采用偶极近似两种方法计算得到的结果，两者相比，前者的谐波强度降低，谐波频率向低级次稍有移动，电子能谱的能带内出现了更多的光电子峰．在相同的光电子能量处，两种方法计算得到的信号强度相差2—5倍．并且

Conical emission by femtosecond pulses with different spectral bandwidths

Conical emission (CE) has been investigated experimentally by laser pulses with different pulse durations and spectral bandwidths. The results show that the overall CE curve will shift as the varying of spectral bandwidth of pump laser pulse. But for pump laser pulses which have same spectral bandwidth but different pulse duration, the CE angles will be same at the spectral region close to the pump wavelength while will be different at the spectral region far away from the pump wavelength. We have also fitted the measured CE angles with X-wave model. The calculated curves and the measured CE curves match reasonably well. The best fits indicate that the group velocity of the filament pulse may be greatly controlled by controlling the spectral bandwidth of pump laser pulse. (C) 2008 Elsevier B.V. All rights reserved.

Conical Emission Patterns by Femtosecond Pulses with Different Spectral Bandwidths

Different conical emission (CE) patterns are obtained experimentally at various incident powers and beam sizes of pump laser pulses with pulse durations of 7 fs, 44 fs and 100 fs. The results show that it is the incident power but not the incident power density that determines a certain CE pattern. In addition, the critical powers for similar CE patterns are nearly the same for the laser pulses with the same spectral bandwidth. Furthermore, as far as a certain CE pattern is concerned, the wider the spectral bandwidth of pump laser pulse is, the higher the critical power is. This will hopefully provide new insights for the generation of CE pattern in optical medium.

Red-shift conical emission by femtosecond pulses at low input power

Red-shift conical emission (CE) is observed by femtosecond laser pulse propagating in BK7 at a low input power (compared to those input powers for generation of blue-shift CE). With the increasing input power the blue-shift CE begins to appear whereas the red-shift CE ring (902 nm in our experiment) disappears accompanied by the augment of the central white spot size synchronously. The disappearing of red-shift CE in our experiment is explained such that the increase of axial intensity is much higher than that of ring emission and the augment of the central white spot size with the increasing input laser power.

Third harmonic enhancement due to Fano interference in semiconductor quantum well

We investigate the emission spectra of the semiconductor quantum well for few-cycle and sub-cycle pulse exciting. We find that Fano interference may induce third harmonic enhancement. Third harmonic enhancement varies with the magnitude and duration of the incident pulse, and may be enhanced by approximately one order of magnitude for the low intensity region of the sub-cycle incident pulse exciting.

Ion acceleration with mixed solid targets interacting with circularly polarized lasers

The interaction of a circularly polarized laser pulse with a mixed solid target containing two species of ions is studied by particle in cell simulations and analytical model. After the interaction tends to be stable, it is demonstrated that the acceleration is more efficient for the heavier ions than that in plasmas containing a single kind of heavy ion and the acceleration efficiency is higher when its proportion is lower. To obtain monoenergetic heavy-ion beams, a sandwich target with a thin mixed ion layer between two light ion layers and a microstructured target are proposed. The influences of parameters of the laser pulse and target on ion acceleration are discussed in detail. It is found that, when the target is thick enough, a cold target is more appropriate for heavy-ion acceleration than a warm target, and the velocity of the reflected heavy ions is proportional to the laser amplitude.

Guiding and confining fast electrons by transient electric and magnetic fields with a plasma inverse cone

The fast electron propagation in an inverse cone target is investigated computationally and experimentally. Two-dimensional particle-in-cell simulation shows that fast electrons with substantial numbers are generated at the outer tip of an inverse cone target irradiated by a short intense laser pulse. These electrons are guided and confined to propagate along the inverse cone wall, forming a large surface current. The propagation induces strong transient electric and magnetic fields which guide and confine the surface electron current. The experiment qualitatively verifies the guiding and confinement of the strong electron current in the wall surface. The large surface current and induced strong fields are of importance for fast ignition related researches.

飞秒激光微加工：激光精密加工领域的新前沿

飞秒激光微加工技术具有加工精度高、热效应小、损伤阈值低以及能够实现真正的三维微结构加工等优点,这些特性是传统的激光加工技术所无法取代的。首先回顾了激光微加工和超短脉冲激光技术的发展历史,然后介绍超短脉冲激光与金属和介质材料相互作用的机制,接着阐述了飞秒激光直写、干涉和投影制备等各种加工方法的原理,重点讨论飞秒激光在三维光子器件集成、微流体芯片制备及其在生化传感方面的应用等,最后展望了飞秒激光微加工领域所面临的机遇和挑战,指出了未来的研究方向。

Radiation damping effects on the ultrashort x-ray pulses generated by nonlinear Thomson backscattering

Nonlinear Thomson backscattering of an intense Gaussian laser pulse by a counterpropagating energetic electron is investigated by numerically solving the electron equation of motion taking into account the radiative damping force. The backscattered radiation characteristics are different for linearly and circularly polarized lasers because of a difference in their ponderomotive forces acting on the electron. The radiative electron energy loss weakens the backscattered power, breaks the symmetry of the backscattered-pulse profile, and prolongs the duration of the backscattered radiation. With the circularly polarized laser, an adjustable double-peaked backscattered pulse can be obtained. Such a profile has potential applications as a subfemtosecond x-ray pump and probe with adjustable time delay and power ratio. (c) 2006 American Institute of Physics.