国产12种苔藓植物的染色体数目

报道了中国产 1 2种苔藓植物染色体数目 ,结果为 :壶苞苔Blasiapusilla ,n =9;艳绿光苔Cy athodiumsmaragdinum ,n =9;紫背苔Plagiochasmarupestre,n =9;石地钱Rebouliahemisphaerica ,n =9;宽片叶苔Riccardialatifrons,n =1 0 ;尖叶美喙藓Eurhynchiumeustegium ,n =1 1 ;东亚沼羽藓Helodiumsachali nense,n =1 1 ;白齿藓Leucodonsciuroides,n =1 1 ;齿边细枝藓Lindbergiaserrulatus,n =1 1 ;疣小金发藓Pogonatumurnigerum ,n =7;台湾拟金发藓Polytrichastrumformosum ,n =7;金发藓Polytrichumcommune,n=7。其中艳绿光苔、齿边细枝藓和东亚沼羽藓的染色体数目为首次报道。

结缕草构件种群年龄结构与动态的研究(英文)

研究了沈阳辉山野生结缕草叶片的生死动态,确定了不同生活年限的结缕草分蘖和根状茎的形态特点。通过形态鉴别的方法确定了结缕草各构件的年龄特征,研究了构件种群的年龄构成及其动态变化规律。结缕草的分蘖和根状茎的最高生活年限均为3年。在一个生长季中,2年生分蘖株和根状茎的绝对优势地位逐渐被1年生分蘖株和根状茎取代。芽库在生长季初和生长季末储量较高,旺盛生长季节基本稳定。结缕草分蘖、芽和根状茎的季节动态是维持结缕草无性系种群持续稳定存在的一个根本保证。图4表2参12。

科尔沁退化草地改良的工程措施及效果

针对草地退化的实际问题,以科尔沁乌兰敖都退化草地为例,采用围栏封育、深翻松土、补播豆科牧草等工程措施对该退化草地进行工程改良,并评价改良措施对土壤性质及草地植被生物多样性的影响。重度退化草地土壤有机碳和全氮含量较低且随土层深度增加而明显降低,土壤pH增高,10～30cm土层深度可溶性盐积累；与重度草地相比,退化改良3年草地土壤有机碳和全氮含量显著提高(P＜0.01),土壤pH降低,其中10～30cm深度土层的差异达到显著水平(P＜0.05)；10～30cm深度电导率呈现出降低的趋势。经过改良,可以缓解土壤盐碱化,提高土壤肥力及物种多样性,达到提高草地质量、改善生态环境的效果。

辽西地区水分亏缺与树木生长关系

利用修正的Thornthwaite最大蒸发力公式,计算了辽西地区不同市的水分亏缺量。各市最大潜在蒸发散计算结果是:朝阳1180.6 mm,锦州1146.0 mm,葫芦岛1140.1 mm,阜新1030.3 mm;水分亏缺量计算结果为:朝阳-658.3 mm,锦州-538.4 mill,葫芦岛-544.8 mm,阜新-626.9 mm。利用美国spss数理统计软件计算了油松与蒙古栎的胸径连年生长量和对应的各年1—12月份的月均温、月降雨量、平均相对湿度的回归关系,表明油松生长与温度紧密,蒙古栎生长与水分关系紧密。

汶川5.12大地震地表次生灾害评价与分析

针对汶川5.12大地震,对由地震引起的地质次生灾害发生的坡度和坡向进行了统计,分析了地表破坏的易发坡度、坡向及其与震中的关系等。另外,分别以不同震中距为缓冲区、以平行中央断裂带的各级缓冲区、以等烈度区为缓冲区对地震引起的地表破坏的空间分布以及发生地表破坏的坡度在各级缓冲区中的变化进行了分析。结果表明:①地震引发的滑坡及滑坡群共5093个,总面积大约958km2;②在30°～44°坡度区间地表破坏发生的数量最大,42°坡度为地表破坏发生概率的拐点。主要的地表破坏发生在迎着地震波传播的坡向上;③随着震中距的增

Effects of pH on the Interactions and Conformation of Bovine Serum Albumin: Comparison between Chemical Force Microscopy and Small-Angle Neutron Scattering

The conformation of bovine serum albumin (BSA), as well as its interactions with negatively charged mica surfaces in saline solutions of different pH values, have been studied by small-angle neutron scattering (SANS) and chemical force microscopy (CFM), respectively. A new approach to extract the contribution of elementary interactions from the statistically averaged force-extension curves through self-consistent fitting was proposed and used to understand the effects of pH on the interactions and conformation of BSA in saline solutions. When pH increases, the SANS results reveal that the sizes of BSA molecules increase slightly, while the statistical analysis of the CFM results shows that the averaged pull-off force for the elongation monotonously decreases. The decrease of pull-off force with the increase of pH results from the decrease in the strength of hydrogen bonding and the number of interaction pairs, as well as the slight increase of the strength of van der Waals interaction. When pH approaches the isoelectric point (pI) of BSA, results from both SANS and CFM suggest a loss of long-range interactions in BSA molecules. Our results also suggest that the force-extension curve is mainly contributed by the van der Waals interaction. The combination of SANS and CFM provides new insight to understand the interactions and conformation of BSA molecules

Microstructure and mechanical properties of Mg-12.3Zn-5.8Y-1.4Al alloy

Microstructure and mechanical properties of as-cast and heat-treated Mg-12.3Zn-5.8Y-1.4Al (ZYA1261) alloy were investigated. The phase compositions of the as-cast alloy are alpha-Mg, Mg3YZn6 (I-phase), Mg(3)y(2)Zn(3) (W-phase), Mg12YZn (Z-phase), Mg24Y5, MgZn and a small quantity of Al-containing phase.

Nanoporous In2O3 nanocrystal clusters: One-step synthesis, thermal stability and optical property

Nanoporous In2O3 nanocrystal clusters with high surface areas have been synthesized by a one-step solvent-thermal method at a relatively low temperature. On the basis of our experimental data and nanomaterial growth mechanism, a template-assistant dehydration accompanied by aggregation mechanism was proposed to explain their formation. Besides, the influence of the high-temperature treatment on their porous structure and optical properties were studied and compared by various technologies.

Quantum dot electrochemiluminescence in aqueous solution at lower potential and its sensing application

The unique strategy for electrochemiluminescence (ECL) sensor based on the quantum dots (QDs) oxidation in aqueous solution to detect amines is proposed for the first time. Actually, there existed two QDs ECL peaks in anhydrous solution, one at high positive potential and another at high negative potential. However, here we introduced the QDs oxidation ECL in aqueous solution to fabricate a novel ECL sensor. Such sensor needed only lower positive potential to produce ECL, which could prevent the interferences resulted from high potential as that of QDs reduction ECL in aqueous solution. Therefore, the present work not only extended the QDs oxidation ECL application field from anhydrous to aqueous solution but also enriched the variety of ECL system in aqueous solution. Furthermore, we investigated the QDs oxidation ECL toward different kinds of amines, and found that both aliphatic alkyl and hydroxy groups could lead to the enhancement of ECL intensity. Among these amines, 2-(dibutylamino)ethanol (DBAE) is the most effective one, and accordingly, the first ECL sensing application of the QDs oxidation ECL toward DBAE is developed; the as-prepared ECL sensor shows wide linear range, high sensitivity, and good stability.

Assembly of 12-tungstosilicic acid and 4-aminobenzo-15-crown-5 ether based on the electrostatic attraction through bridging of oxonium ions on different substrates

Based on the electrostatic attraction Keggin-type polyoxometalate H4SiW12O40 (SiW12) and small molecule 4-aminobenzo-15-crown-5 ether (4-AB15C5) were alternately deposited on poly (allylamine hydrochloride) (PAH)-derived indium tin oxide (ITO) substrate through a layer-by-layer (LBL) self-assembly, forming a supramolecular multilayer film (film-A). SiW12 was also deposited on a glassy carbon electrode (GCE) derived by 4-AB15C5 via covalent bonding in 0.1 M NaCl aqueous solution and formed a composite monolayer film (film-B). UV-vis absorption spectroscopy, X-ray photoelectron spectroscopy (XPS) and Fourier-transform infrared (FTIR) spectroscopy measurements demonstrated that the interactions between SiW12 and 4-AB15C5 in both two film electrodes were the same and caused by the bridging action of oxonium ions. But, the nanostructure in the two film electrodes was different. 4-AB15C5 in film-A was oriented horizontally to ITO substrate, however, that in film-B was oriented vertically to GCE. Namely film-A corresponded to a layer structure, and film-B corresponded to an intercalation structure.

Morphology evolutions of organically modified montmorillonite/polyamide 12 nanocomposites

Organically modified montmorillonites (OMMTs) by octadecylammonium chloride with two adsorption levels were dispersed in polyamide 12 (PA12) matrices with two molecular weights for different melt mixing times in order to investigate morphology evolutions and factors influencing fabrication of PA12 nanocomposites. Different adsorption levels of the modifier in the OMMTs provide different environments for diffusion of polymer chains and different attractions between MMT layers. Wide-angle X-ray diffraction (WAXD), transmission electron microscope (TEM) and gas permeability were used to characterize morphologies of the nanocomposites. Both OMMTs can be exfoliated in the PA12 matrix with higher molecular weight, but only OMMT with lower adsorption level can be exfoliated in the PA12 matrix with lower molecular weight. It was attributed to the differences in the levels of shear stress and molecular diffusion in the nanocomposites. The exfoliation of OMMT platelets results from a combination of molecular diffusion and shear. After intercalation of PA12 into interlayer of OMMT in the initial period of mixing, further dispersion of OMMTs in PA12 matrices is controlled by a slippage process of MMT layers during fabricating PA12 nanocomposites with exfoliated structure.

Chemical effects of cationic surfactant and anionic surfactant used in organically modified montmorillonites on degradation and fire retardancy of polyamide 12 nanocomposites

Three kinds of organically modified Na+-montmorillonites (OMMTs), including two kinds of octadecylammonium modified montmorillonite with different contents of octadecylammonium and a kind of sodium dodecylsulfonate (SDSo) modified montmorillonite, were used to prepare polyamide 12 (PA12)/OMMT nanocomposites. Effects of the modifiers on degradation and fire retardancy of PA12/OMMT nanocomposites were investigated. Acid sites formed in cationic surfactant modified MMT via Hoffman decomposition could accelerate degradation of PA12 at high temperature. However, catalytic effect of the acid sites on carbonization of the degradation products promoted char barrier formation, which reduced heat release rate (HRR). Higher content of cationic surfactant in OMMT is beneficial to fire retardancy of PA12 nanocomposites and the dispersion states of OMMT have assistant effects. In contrast, Na+-montmorillonite (Na-MMT) and anionic surfactant modified MMT (a-MMT) could not form acid sites on the MMT layers; in this case, fire retardancy of PA12/Na-MMT appears to have no improvement and PA12/a-MMT appears to have limited improvement.

Surface-appropriate lipophobicity - Application in isobutene oligomerization over Teflon-modified silica-supported 12-silicotungstic acid

A series of silica-supported 12-silicotungstic acid catalysts (H4SiW12O40, abbreviated as HSiW), modified with various loadings of Teflon (HSiW/SiO2-Teflon), were prepared by an impregnation method. The surface properties of the catalysts were studied by means of X-ray diffraction (XRD), scanning electron microscopy (SEM), BET, infrared (IR) spectroscopy, NH3-TPD and the Drop Shape Analysis (DSA). SEM results combined with energy-dispersive X-ray (EDX) measurements of HSiW/SiO2-Teflon revealed that F-compound (Teflon) is effectively coated on the catalyst surface. The contact angles for water and oil of 50 wt% HSiW/SiO2 and HSiW/SiO2-Teflon indicate that HSiW/SiO2-Teflon catalyst enhances not only the surface hydrophobicity but also the surface lipophobicity by means of the addition of Teflon. Silica-supported 12-silicotungstic acid modified with Teflon exhibits higher C-8(=) selectivity and longer lifetime than that of silica-supported 12-silicotungstic acid in isobutene oligomerization. Thus, surface-appropriate lipophobicity of catalysts may be effective for decreasing the interaction between coke precursors and the catalyst surface and for removing deposited coke more easily.