Determination of ultra-trace concentrations of elements in high purity tellurium by inductively coupled plasma mass spectrometry after Fe(OH)(3) coprecipitation

In this work, a method was established for the determination of impurities in high purity tellurium by inductively coupled plasma mass spectrometry (ICP-MS) after Fe(OH)(3) coprecipitation. After comparison of coprecipitation ability and separation efficiency between Fe(OH), and Al(OH)(3), Fe(OH)(3) was chosen as the precipitate. A separation factor of 160 for 200 mg tellurium was obtained under conditions of pH 9 and 2 mg of Fe3(+). The 13 elements, such as Bi, Sn, Pb, In, Tl, Cd, Cu, Co, Ni, Zn, Ti, Be and Zr, could be almost completely coprecipitated under these conditions. In addition, Te memory effect imposed on the ICP-MS instrument was assessed, as well as Te matrix effect that caused the low recovery of Ga, As, Sb and V in real sample was discussed. Finally, the method was evaluated through recovery test and was applied to practical sample analysis, with detection limits of most of the elements being below 0.15 mug g(-1) and R.S.D. below or at approximately 10%, which indicated that this method could fully satisfy the requirements for analysis of 99.999% similar to 99.9999% high purity Te.

PB-g-PMMA核壳粒子的合成及其在PVC中的分散

聚丁二烯(PB)橡胶粒子与聚氯乙烯(PVC)不相容。采用乳液聚合手段,在聚丁二烯乳胶粒表层接枝与聚氯乙烯相容的聚甲基丙烯酸甲酯(PMMA)充当增容剂制备了聚丁二烯接枝聚甲基丙烯酸甲酯(PB g PMMA ,MB)核壳粒子。用熔融共混法制备了PVC/MB共混物。SEM照片表明,这种核壳结构的粒子在聚氯乙烯中的分散情况随着核壳比的不同而改变,当核壳质量比小于93/7时能够完全均匀地分散在PVC基体中,核壳质量比大于94/6时根本不能分散在PVC基体中,核壳质量比为93/7是粒子能否分散开的转折点。共混物的力学性能数据表明,当MB加入量改变时,共混物也存在脆韧转变点,但受MB粒子的核壳比影响。

ABS树脂合成中影响PB-g-SAN接枝共聚物接枝率的因素

采用种子乳液聚合方式 ,以 K2 S2 O8为引发剂引发聚合 ,合成了一系列 PB- g- SAN接枝共聚物。考察了引发剂用量、分子量调节剂 (TDDM)用量和橡胶 (PB)含量对 PB- g- SAN接枝共聚物接枝率的影响。并将 K2 S2 O8引发剂与氧化 -还原引发体系做了比较。结果表明 ,随着引发剂 K2 S2 O8用量逐渐增加 ,PB- g- SAN接枝共聚物的接枝率逐渐降低。引发剂用量太少时 ,不能满足聚合要求 ,PB- g- SAN接枝共聚物的接枝率也会降低。随着分子量调节剂 (TDDM)用量的增加 ,PB- g- SAN接枝共聚物的接枝率逐渐降低。随胶含量的增加 ,PB- g- SAN接枝共聚物的接枝率逐渐降低。采用氧化 -还原引发体系引发聚合有利于接枝反应的进行 ,在 PB含量相同时 ,采用氧化 -还原引发体系合成的 PB- g- SAN接枝共聚物的接枝率比采用 K2 S2 O8合成的接枝共聚物接枝率高。

Bonding and Mossbauer isomer shifts in (Tl, Pb)-1223 cuprate

By using the clinical bond theory of dielectric description, the chemical bond parameters of (Tl.Pb) - 1223 was calculated. The results show that the Sr-O, Tl-O, and Ca-O types of bond have higher ionic character and the Cu-O types of bond have more covalent, character. Mossbauer isomer shifts of Fe-57 and Sn-119 doped in (Tl, Pb) -1223 were calculated by using the chemical environmental factor, h, defined by covalency and electronic polarizability. Four valence state tin and three valence iron sites were identified ill Fe-57, and Sn-119 doped (Tl, Pb) -1223 superconductor. We conclude that all of' the Fe atoms substitute the Cu at square planar Cu (H site, whereas Sn prefers to Substitute the square pyramidal Cu (2) site.

溶胶-凝胶法制备纳米Pb(Zr_(0.52)Ti_(0.48))O_3

以醋酸铅 ,硝酸氧锆 ,钛酸四丁酯为原料用溶胶 -凝胶法制备了纳米 Pb( Zr0 .52 Ti0 .48) O3 ( PZT)。结果表明 ,随溶剂中乙二醇单甲醚与水的比例的增大 ,PZT粉体的晶化温度增高 ,晶粒的粒径尺寸也增大 ,当V( C3 H8O2 ) / V( H2 O) =4 .4 7时 ,不仅凝胶完成时间短 ,且可得到粒度分布集中、晶化温度低的 PZT粉体。用原子力显微镜测定 PZT的粒径为 6 0～ 70 nm,用 TG-DTA分析确定在 4 43℃即可发生晶化反应 ,在 5 0 0℃下结晶完善。通过对不同温度下热处理的粉体的红外光谱和 X射线衍射的分析 ,对溶胶 -凝胶法制备 PZT粉体形成钙钛矿结构的过程进行了研究。

Charge carrier mobility and electroluminescence in a green-emitting alternating block copolymer with a methoxy Bi-substituted chromophore

We determine the mobility of positive and negative charge carriers in a soluble green-emitting alternating block copolymer with, a methoxy bi-subsbituted conjugated segment. The negative charge carrier mobility of 6 x 10(-11) cm(2)/V.s is directly determined using space-charge-limited current analytical expressions. Positive charge carrier transport is also space-charge-limited, with a mobility of I x 10(-8) cm(2)/V.s. The electron trap distribution is exponential, with a characteristic energy of similar to 0.12 eV. A hole trap with energy similar to 0.4 eV was observed. This copolymer is used as emissive material in organic light-emitting diodes that present brightness of similar to 900 cd/m(2) at 12.5 V.

Hydrothermal synthesis and structure of [{Mo8V4O36(VO4)(VO)(2)}(n)](7n-) bi-capped alpha-Keggin fragments linked to a chain

The title compound, (H(2)en)(3)H3O {MO8V4O36 (VO4) (VO)(2)} . 4H(2)O, was hydrothermally synthesized and structurally characterized by means of IR, ESR spectrum and single crystal X-ray diffraction. It crystallized in a monoclinic system with space group P2(1)/c, a=1. 980 4(4) nm, b=2. 063 4(4) nm, c=1. 192 0(2) nm, (beta =94. 76(3)degrees and deep black colour. The compound contains V-centered bi-capped alpha -Keggin fragments {Mo8V7O42} that are linked together by edge-shared units (VO5)-O-N via V-O-V bonds, forming a chain.

Hydrothermal synthesis and structure of a bi-capped Keggin polyoxoanion, [(As2AsMo8V4O40)-As-III-Mo-V-O-IV](5-)

The title compound, [NH3CH2CH2CH2NH2][NH3CH2CH2CH2NH3](2)[As-2(III) As-v Mo-8 V-4(IV) O-40] (.) 5H(2)O, was hydrothermally synthesized and structurally characterized by single crystal X-ray diffraction. Crystal data: monoclinic, C2/c, a = 45.375(9) Angstrom, b = 11.774(2) Angstrom, c = 23.438(5) Angstrom, beta = 96.62(3)degrees. X-ray crystallographic study showed that the crystal structure was constructed by bi-capped alpha -Keggin fragments [(As2AsMo8V4O40)-As-III-Mo-v-O-IV](5-) polyoxoanion. (C) 2001 Elsevier Science B.V. All rights reserved.

Determination of the impurities elements in high-purity cadmium by inductively coupled plasma mass spectrometry

A method for the determination of impurity elements in high purity cadmium by inductively coupled plasma mass spectrometry was developed. The spectral interference arising from Cd was discussed and the magnitude of interference by the polyatomic ion of Cd was compared. The effect of the high concentration Cd on the analyte signal was studied. The results showed that Cd possessed both significant suppression effects on the light mass elements signal and enhancement effects on the heavy mass elements signal,and the effects can be corrected by the use of internal standard elements. In this paper, Y and Bi was employed for the light mass elements and the heavy mass elements,respectively. As, Be, Co, Cu, Ga, Ge, Mn, Mo, Pb, Ni, Sr, Au, Tl, Th, V and U in high purity cadmium were determined. Detection limits are 0.005-0.052 mu g L-1,and the recoveries of standard addition are 82%-108%.

Luminescence of unusual bismuth in barium berates BaB8O13 : Bi)

The luminescence of unusual divalent bismuth (Bi2+) in BaB8O13 is reported. The emission band with maximum peak at 592 nm corresponds to the P-2(3/2)-->P-2(1/2) transition of Bi2+ in the matrix and the excitation spectrum with two bands peaked at 470 and 580 nm respectively corresponds to two split crystal-field levels of P-2(3/2) state. The small Stokes shift (similar to 350 cm(-1)) reflects the rigid structure of the host for the Bi2+ ions.

Structure and luminescent properties of YAG : Eu, Bi synthesized by sol-gel method

(Y1-xEux)(3)Al5O12 and (Y1-x-yEuxBiy)(3)Al5O12 were prepared by so-gel method. Their structures of the luminophor are similar to that of YAG, which is recorded on the ASTM card and belongs to a cubic system. The luminescent properties show that the reaction temperature of the current sol-gel method is in the range of 400-500 degrees C, which is lower than that of the conventional solid state reaction. The luminophors have the strongest emission intensity when the values of x and y are 0.06 and 0.013, respectively.

YAG∶Eu~(3+)、Bi~(3+)的溶胶-凝胶法合成及其结构和发光性能

溶胶－凝胶法以其各组分混合均匀性好、反应温度低、节省能源等诸多优点而引起了人们极大兴趣［１，２］．近年来，利用该法研制玻璃和陶瓷等无机材料的报道越来越多［３，４］．但研制稀土固体发光材料的报道则较少．钇铝石榴石Ｙ３Ａｌ５Ｏ１２（ＹＡＧ）是一种很好的基…

盐酸介质中 P_(507) 萃取 Pb(Ⅱ)的平衡

通过实验，研究了２－乙基已基膦酸单（２－乙基已基）酯，在盐酸介质中萃取铅的规律和机理，为荧光级稀土生产提供了理论依据。

Synthesis and properties of optically active aromatic polyimides derived from optically pure 1,1'-bi-2-naphthol

A series of new optically active aromatic polyimides containing axially dissymmetric 1,1'-binaphthalene-2,2-diyl units were prepared from optically pure (R)-(+)-or (S)-(-)-2,2'-bis(3,4-dicarboxyphenoxy)-1,1'-binaphthalene dianhydrides and various aromatic diamines via a conventional two-step procedure that included ring-opening polycondensation and chemical cyclodehydration. The optically pure isomer of dianhydride was prepared by a nucleophilic substitution of optically pure (R)-(+)or (S)-(-)1,1'-bi-2-naphthol with 4-nitrophthalonitrile in aprotic polar solvent and subsequent hydrolysis of the resultant tetranitrile derivatives, followed by the dehydration of the corresponding tetracarboxylic acids to obtain the dianhydrides. These polymers were readily soluble in common organic solvents such as N,N-dimethylacetamide, N-methyl-2-pyrrolidone, and m-cresol, etc., and have glass transition temperatures of 251-296 degrees C, and 5% weight loss occurs not lower than 480 degrees C. The specific rotations of the optically active polyimides ranged from +196 degrees to +263 degrees, and the optical stability and chiroptical properties of them were also studied. (C) 1997 John Wiley & Sons, Inc.