用于在线同位素分离器的激光离子源的研制

本文介绍了一种新型的用于在线同位素分离器的离子源——激光离子源。这种离子源将会大大提高在线同位素分离器的化学选择性，给新核素的合成及其衰变性质研究注入巨大的活力。论文首先介绍了激光离子源的工作原理和国际上研制激光离子源的情况。其次介绍了我们在研制热管式激光离子源方面取得的以下进展：(1)激光器系统已经可以使用，完成了光路传输与合成系统；（2）研制了一个用于研究激光离子源特性的离线实验装置；(3)获得了铥元素的激光多步共振电离信号，测量了Ta，Nb-Zr合金和内表面涂有了TaC的Nb-Zr合金电离管表面电离电流及激光共振电离电流随温度纷变化曲线，得到了热管式激光离子源的化学选择性，对元素铥的化学选择性可达封50-10000，论文最后对将要做的工作提出了进一步的设想，对激光离子源的前景做了展望。

Catalytic performance of MCM-22 zeolite for alkylation of toluene with methanol

MCM-22 zeolite with mid-strong acidity and openings of 10-membered ring channels may obtain a high catalytic activity and selectivity for alkylation of toluene with methanol. The acidic sites, for catalyzing alkylation of toluene with methanol, are weaker than that for catalyzing toluene disproportionation. Compared with silicon as a modifier, modification of MCM-22 with La(NO3)(3) is a promising way to improve the catalytic selectivity of para-xylene. In addition, the experimental results also clearly indicate the characteristics of MCM-22 structure consisting of large intracrystalline cages, some of which may locate on surface of MCM-22. (C) 2004 Elsevier B.V. All rights reserved.

Fischer-Tropsch reaction over cobalt catalysts supported on zirconia-modified activated carbon

An attractive Fischer-Tropsch catalyst was prepared using an activated carbon as carrier to support cobalt based catalysts. Zr promoted Co/AC catalysts remarkably enhanced the activity and the selectivity toward diesel distillates and lower the methane selectivity. This modification may be attributed to specific behavior of activated carbon with high surface area and the weak interaction between metallic cobalt active sites and activated carbon. It was emphasized that the pore size of activated carbon played a very important role in restricting the growth of carbon chain to wax.

Correlation between the characteristics and catalytic performance of Ni-V-O catalysts in oxidative dehydrogenation of propane

Ni - V - O series catalysts for the oxidative dehydrogenation (ODH) of propane were prepared and characterized by BET, XRD, H-2- TPR, O-2-TPD-MS and electrical conductivity. At 425 degreesC a C3H6 selectivity of 49.9% was observed on Ni0.9V0.1OY at a C3H8 conversion of 19.4%, and the obtained selectivity is almost two times higher than that over NiO at the roughly same conversion of C3H8. The mobile oxygen species created by the interaction of NiO and V2O5 has been found in the composite catalysts by O-2-TPD-MS and electrical conductivity studies, which seems to be responsible for the enhanced selectivity of the propane oxidative dehydrogenation.

The mechanism studies of ethanol oxidation on PdO catalysts by TPSR techniques

The paper studies the direct oxidation of ethanol and CO on PdO/Ce0.75Zr0.25O2 and Ce(0.75)Zr(0.2)5O(2) catalysts. Characterization of catalysts is carried out by temperature-programmed desorption (TPD), temperature-programmed surface reaction (TPSR) techniques to correlate with catalytic properties and the effect of supports on PdO. The simple Ce0.75Zr0.25O2 is in less active for ethanol and CO oxidation. After loaded with PdO, the catalytic activity enhances effectively. Combined the ethanol and CO oxidation activity with CO-TPD and ethanol-TPSR profiles, we can find the more intensive of CO2 desorption peaks, the higher it is for the oxidation of CO and ethanol. Conversion versus yield plot shows the acetaldehyde is the primary product, the secondary products are acetic acid, ethyl acetate and ethylene, and the final product is CO2. A simplified reaction scheme (not surface mechanism) is suggested that ethanol is first oxidized to form intermediate of acetaldehyde, then acetic acid, ethyl acetate and ethylene formed going with the formation of acetaldehyde, acetic acid, ethyl acetate; finally these byproducts are further oxidized to produce CO2. PdO/Ce0.75Zr0.25O2 catalyst has much higher catalytic activity not only for the oxidation of ethanol but also for CO oxidation. Thus the CO poison effect on PdO/Ce0.75Zr0.25O2 catalysts can be decreased and they have the feasibility for application in direct alcohol fuel cell (DAFC) with high efficiency.

平阴玫瑰花芽分化期叶片内源激素的变化

对平阴玫瑰花芽分化期叶片甲醇提取物进行IAA、ZR、GA3、ABA的分离、纯化和测定。结果发现,所测的几种激素均表现出明显的变化规律,其中IAA和GA3在花芽分化期含量逐渐下降,且在分化临界期出现一低峰,而ZR和ABA则完全相反。同时经比较分析得出ABA/GA3,ABA/IAA,ZR/GA3,ZR/IAA也表现明显的变化规律,即比值总体趋势是逐渐提高,且均在分化临界期含量出现一飞跃,显然ABA/GA3,ABA/IAA,ZR/GA3,ZR/IAA在平阴玫瑰的花芽分化过程中起着重要的调控作用,由此推测,增加植物体内的ABA、ZR的含量或降低IAA、GA3的含量,都可以促进玫瑰的花芽分化;反之则抑制其花芽分化。

土壤镉污染毒性效应的多指标综合评价

以草甸棕壤为供试土壤,以蚕豆幼苗根尖有丝分裂指数、染色体畸变率以及微核率,幼苗叶片内抗氧化酶活性、植物内源激素含量为指标,采用盆栽方法研究了0~10 mg.kg-1镉胁迫对植物细胞的遗传和生态毒性效应.结果表明,在此浓度范围内,蚕豆根尖细胞有丝分裂指数、染色体畸变率以及微核率均随镉浓度增加呈显著的剂量-效应正相关关系,其中微核率变化最为明显,处理组微核率分别为对照组的1.43~3.22倍;蚕豆幼苗叶片内的SOD和POD活性变化呈先升高后下降的趋势;而CAT活性随镉浓度增加其变化规律与SOD、POD相反.此外,镉胁迫下植物激素脱落酸(ABA)、赤霉素(GA3)与细胞分裂素类的玉米素和玉米素核苷总含量(Z&ZR)均表现出低浓度下诱导和较高浓度下诱导率降低的趋势,在镉浓度为2.5 mg.kg-1时3种植物激素含量均达到最高值,分别比对照组增加了6.6%、4.0%和12.6%.研究表明,各指标对污染物的毒性具有响应且响应的域值及其敏感度不同,将各指标综合使用可使土壤镉污染的遗传和生态毒性诊断更为有效.

植物生长调节剂对水曲柳组培苗生长及内源激素的影响

以水曲柳成熟种子为外植体材料,在不同增殖培养基中培养,应用间接酶联免疫法(ELISA)测定脱落酸(ABA)、吲哚乙酸(IAA)和玉米素核苷(ZR)3种内源激素,探讨不同细胞分裂素质量浓度和配比对水曲柳组培苗生长及内源激素的影响。研究结果表明:当年采收的水曲柳种子,消毒、浸泡处理后,播出种胚,可以解除水曲柳种子的休眠。增殖培养基中添加不同细胞分裂素都抑制了组培苗的高生长和生物量,但却可以解除组培苗顶端优势,诱导腋芽生长。与此同时,腋芽发生率与内源激素ABA、IAA和ZR质量分数不存在相关性,而与IAA/ZR比值存在负相关,但相关性并不显著。IAA/ZR比值的减少有可能有利于腋芽的诱导。

温度对Ti_(45)Zr_(35)Ni_(20)合金电化学贮氢性能的影响

采用真空熔炼法制备了Ti45Zr35Ni20合金,研究了合金在不同温度下的电化学贮氢性能。结果表明,Ti45Zr35-Ni20电极的电化学性能随着温度而变化,温度从323 K升高到343 K时,电极的活化次数从22次减少到8次,放电容量从86.1 mAh/g增到135.0 mAh/g,快速放电能力也有所提高,然而,高温使电极的循环稳定性显著下降,自放电率增大。

Structure and electrochemical characteristics of melted composite Ti0.10Zr0.15V0.35Cr0.10Ni0.30-LaNi5 hydrogen storage alloys

The structure and electrochemical characteristics of melted composite Ti0.10Zr0.15V0.35Cr0.10Ni0.30+x% LaNi5 (x=0, 1, 5 and 10) hydrogen storage alloys have been investigated systematically. XRD shows that the matrix phase structure of V-based solid solution phase with a BCC structure and C14 Laves phase with hexagonal structure is not changed after adding LaNi5 alloy. However, the amount of the secondary phase increases with increasing LaNi5 content. Field emission scanning electron microscopy-energy dispersive spectroscopy (FESEM-EDS) shows that the C14 Laves phase contains more Zr and the white lard phase has a composition close to (Zr, Ti)(V, Cr, Ni, La)(2).

Aging behavior and mechanical properties of Mg-Gd-Ho alloys

The Mg-8Gd-0.6Zr-xHo (x = 1, 3 and 5, mass%) alloys were prepared by casting technology, and structures, aging strengthening mechanism and mechanical properties of the alloys were investigated. The age behaviors and the mechanical properties are improved by adding Ho addition. The structures of the alloys are characterized by the present of rosette-shaped equiaxed grains. The peak hardness value of the Mg-8Gd-0.6Zr-3Ho alloy is 100 Hv, which is about 30% higher than that of Mg-8Gd-0.6Zr alloy.

Microstructure and Strengthening Mechanism of Die-Cast Mg-Gd Based Alloys

Mg-8Gd-2Y-Nd-0.3Zn (wt%) alloy was prepared by the high pressure die-cast technique. The microstructure, mechanical properties in the temperature range from room temperature to 573 K, and strengthening mechanism were investigated. It was confirmed that the Mg-Gd-based alloy with high Gd content exhibited outstanding die-cast character. The die-cast alloy was mainly composed of small cellular equiaxed dendrites and the matrix. The long lamellar-shaped stacking compound of Mg3X (X: Gd, Y, Nd, and Zn) and polygon-shaped.

Microstructure and mechanical property of Mg-8.31Gd-1.12Dy-0.38Zr alloy

The Mg-8.31Gd-1.12Dy-0.38Zr (mass%) alloy was prepared by casting technology, and the microstructure, age hardening behavior and mechanical property have been investigated. It is noted that the alpha-Mg and the different Mg-RE (RE = Gd/Dy) compounds are subsistent in the as-cast and annealed state samples. The age hardening behavior is observed during the investigated temperature range, and the alloy exhibits high Vickers hardness, excellent ultimate tensile strength and yield strength at peak hardness.

Fabrication and spectroscopic broadening properties for 1.5 mu m amplification of Er3+-doped BaF2 nanoparticles

We show the potential application of Er3+-doped BaF2 nanoparticles prepared from microemulsion technology for 1.5 mu m amplification in telecommunication. Nanoparticles with different sizes of about 8, 10, and 20.5 nm were prepared. The XRD patterns showed the excursion of diffraction peaks. When the particle size is smaller or the diffraction angle is larger, this kind of excursion will be more serious.

Age hardening and mechanical properties of Mg-Gd-Er alloy

The Mg-8Gd-0.6Zr-xEr (x = 1, 3 and 5 mass%) alloys were prepared by casting technology, and the microstructures, age hardening behaviors and mechanical properties of alloys have been investigated. Microstructures of the alloys are characterized by the presence of rosette-shaped equiaxed grains. The age hardening behaviors and the tensile properties are enhanced by adding Er element. The maximum aged hardness of Mg-8Gd-0.6Zr-5Er alloy is 97, it is nearly 1.24 times higher than that of Er-free alloy.