A Q-swicthed all-solid-state single-longitudinal-mode laser with adjustable pulse-width and high repetition rate

A single-longitudinal-mode (SLM) laser-diode pumped Nd: YAG laser with adjustable pulse width is developed by using the techniques of pre-lasing and changing polarization of birefingent crystal. The Q-switching voltage is triggered by the peak of the pre-lasing pulse to achieve the higher stability of output pulse energy. The output energy of more than 1 mJ is obtained with output energy stability of 3% (rms) at 100 Hz. The pulse-width can be adjusted from 30 ns to 300 ns by changing the Q-switching voltage. The probability of putting out single-longitudinal-mode pulses is almost 100%. The laser can be run over four hours continually without mode hopping.

纳米ZnO粉末中受激辐射现象的研究

1999年，Cao等用皮秒级激光脉冲抽运ZnO颗粒（直径约为100nm）制成的粉末薄层，观察到了谱线宽度非常窄的激光辐射。本文初步研究了在纳秒级（脉宽8ns，频率30Hz）Nd：YAG脉冲激光器的抽运下，纳米ZnO粉末的发散光。

Ba（NO3）2晶体受激拉曼散射的角度分布和脉冲压缩(英文)

报道了利用重复频率为30HZ，波长为532nm的Nd：YAG倍频激光单次通过抽运硝酸钡（Ba（NO3）2）晶体（晶体由水溶液降温法生长，长度为48mm，横截面为10mm×10mm），获得高效率的一阶（563nm），二阶（599nm）和三阶（639nm）斯托克斯光的实验结果．硝酸钡晶体沿着[110]晶轴方向切割．观测到一、二、三阶斯托克斯光呈锥形环分布，一、二、三阶斯托克斯光的散射外边缘与抽运光轴线间的夹角大小分别为1．7°，3．5°，5．0°．同时也观测到Ba（NO3）2的SRS角度分布与抽运光强度无关．

高效率599nmBa（NO3）2外腔喇曼激光器

橘黄色波段固体激光器在基于荧光探测的生物医学诊断和显示等众多方面有着广泛的实际应用．报道了利用532nm的Nd：YAG倍频激光抽运外置喇曼腔内的硝酸钡晶体，获得高效率的599nm橘黄色喇曼激光的实验结果．对外置喇曼腔实验装置和运转参量进行了优化，喇曼振荡腔由对二阶斯托克斯光有最优化反射率的腔镜构成，对实验中所得到的二阶斯托克斯喇曼激光脉宽压缩及出现双尖峰的现象进行了分析．当抽运光功率达到4．1W时，获得二阶斯托克斯喇曼激光功率为710mW，输出光中心波长为599．38nm，半峰全宽（FWHM）为1．1nm

光在随机增益介质中的放大

结合环形腔理论。运用蒙特卡罗法模拟了光子在介质中的随机行走。研究了倍频Nd：YAG（脉宽6ns，频率20Hz）脉冲激光器作为泵浦光，在TiO2／若丹明B有机增益介质中，散射微粒的颗粒密度和泵浦光面积对随机激光器阈值强度的影响。模拟结果表明：随机激光阈值和光子在增益介质中的随机行走路程长度和光子通过边界返回增益区和非增益区的几率有关。随着泵浦光面积的增加，随机激光器阈值降低；增益介质中散射颗粒密度的增加降低了随机激光器的阈值。

激光诱导等离子体开关控制脉宽实验研究

利用激光诱导等离子体开关技术，在1064nm的Nd：YAG固体激光器上获得了脉宽4．4～6．4ns的短脉冲激光输出。激光电离空气产生的等离子体开关控制脉冲宽度时，聚焦透镜焦距越短，压缩后的脉宽越窄，但激光能量损耗越大。压缩后的激光脉宽与激光能量近似成双曲线关系。在控制脉宽光路的焦点处放置带孔的Cu薄片可抑制等离子体的扩散，得到了脉宽最短可达4．4ns的激光输出。

纳米ZnO粉末中随机激光现象

实验采用三倍频Nd：YAG（波长355nm，脉宽8ns，频率30Hz）脉冲激光器作为抽运光源，在ZnO纳米粉末（直径～100nm）中发现了类似激光现象．并用环形腔理论模拟了ZnO的颗粒密度对平均自由程的影响，从理论上证明在纳秒级激光器的抽运下，ZnO纳米粉末也可以发射激光．

A kilowatt diode-pumped solid-state heat-capacity double-slab laser

A kilowatt diode-pumped solid state heat capacity laser is fabricated with a double-slab Nd:YAG. Using the theoretical model of heat capacity laser output laser characteristics, the relationships between the output power, temperature and time are obtained. The slab is 59 x 40 4.5mm(3) in size. The average pump power is 11.2kW, the repetition rate is 1kHz, and the duty cycle 20%. During the running time of 1s, the output energy of the laser has a fluctuation with the maximal output energy at 2.06J, and the maximal output average power is 2.06kW. At the end of the second, the output energy declines to about 50% compared to the beginning. The thermal effects can be improved with one slab cooled by water. The experimental results are consistent with calculation data.

Depolarization loss compensated resonator for electro-optic Q-switched solid-state laser

A novel laser resonator for compensating depolarization loss that is due to thermally induced birefringence in active rod is reported. As this new structure being applied to an electro-optic Q-switched LIDA side-pumped Nd:YAG laser operating at a repetition rate of 1000 Hz, substantial reduction in depolarization loss has been observed, the output pulse energy is improved about 56% from that of a traditional resonator without compensation structure. With incident pump energy of 450 mJ per pulse, linearly polarized output energy of 30 mJ per pulse is achieved, the pulse duration is less than 15 ns, and the peak power of pulse is about 2 MW. The extinction ratio of laser beam is better than 10:1, and the beam divergence is 1.3 mrad with beam diameter of around 2.5 mm. (c) 2006 Published by Elsevier B.V.

高效率,窄脉冲1198.5nm Ba(NO_3)_2喇曼激光器(英文)

利用1 064 nm的Nd∶YAG激光抽运振荡腔内的硝酸钡晶体,获得高效率、窄脉冲的喇曼激光输出.硝酸钡晶体由水溶液降温法生长,长度为48 mm.喇曼振荡腔由对抽运光、一阶、二阶斯托克斯光有不同反射率的双色平面镜构成.当抽运光功率达到4.5 W时,获得最高的一阶斯托克斯喇曼激光功率为1.48 W,相应的转换效率为32.9%,并测得斜率效率为40%.由于受激喇曼散射的作用,喇曼脉冲光由抽运脉冲光的19.8 ns压缩为2.4 ns,获得的喇曼激光脉冲波形具有的＂上升沿陡峭、下降沿缓慢＂的特性,对其形成过程作了

Numerical and experimental analysis on green laser crystallization of amorphous silicon thin films

The effect of laser fluence on the crystallization of amorphous silicon irradiated by a frequency-doubled Nd:YAG laser is studied both theoretically and experimentally. An effective numerical model is set up to predict the melting threshold and the optimized laser fluence for the crystallization of 200-nm-thick amorphous silicon. The variation of the temperature distribution with time and the melt depth is analyzed. Besides the model, the Raman spectra of thin films treated with different fluences are measured to confirm the phase transition and to determine the optimized fluence. The calculating results accord well with those obtained from the experimental data in this research. (C) 2008 Elsevier Ltd. All rights reserved.

Photoinduced stable second-harmonic generation in chalcogenide glasses

We report on photoinduced second-harmonic generation (SHG) in chalcogenide glasses. Fundamental and second-harmonic waves from a nanosecond pulsed Nd:YAG laser were used to induce second-order nonlinearity in chalcogenide glasses. The magnitude of SHG in 20Ge . 20As . 60S glass was 10(4) larger than that of tellurite glass with a composition of 15Nb(2)O(5) . 85TeO(2) (mol.%). Moreover, no apparent decay of photoinduced SHG in 20Ge . 20As . 60S glass was observed after optical poling at room temperature. We suggest that the large and stable value of X-(2) is due to the induced defect structures and large X-(3) of the chalcogenide glasses. (C) 2001 Optical Society of America

Space-selective precipitation of Au nanoparticles inside silica gel

Au colloids were prepared by irradiation with a Nd:YAG laser. Au nanoparticles were characterized by absorption spectra, transmission electron microscopy (TEM) and X-ray diffraction (XRD) analysis. It is found that the wavelength of the laser has no effect on the size but the number of the Au nanoparticles. By irradiating a transparent silica gel doped with gold ions with the focused laser in the gel and subsequent exposing in air, a space-selective pattern of letter "P" consisting of Au nanoparticles was observed inside the silica gel.

Deposition of Au/TiO2 film by pulsed laser

Au nanoparticles, which were photoreduced by a Nd:YAG laser in HAuCl4 solution containing TiO2 colloid and accompanied by the TiO2 particles, were deposited on the substrate surface. The film consisting of Au/TiO2 particles was characterized by the absorption spectra, scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis. The adhesion between the film and substrate was evaluated by using adhesive tape test. It was found that the presence of TiO2 dramatically enhanced the adhesion strength between the film and the substrate, as well as the deposition rate of film. The mechanism for the deposition of Au/TiO2 film was also discussed. (c) 2005 Elsevier B.V. All rights reserved.