Synthesis and properties of novel soluble polyimides having a spirobisindane-linked dianhydride unit

A new synthetic procedure was elaborated allowing the preparation of semiaromatic dianhydride. N-Methyl protected 4-chlorophthalic anhydride was nitrated with HNO3 to produce N-methyl-4-chloro-5-nitrophthalimide (1). The aromatic nucleophilic substitution reaction between 5,5',6,6'-tetrahydroxy-3,3,3',3'-tetramethyl-1,1-spirobisindane and 1 afforded spirobisindane-linked bis(N-methylphthalimide) (2), which was hydrolyzed and subsequently dehydrated to give the corresponding dianhydride (3). The latter was polymerized with five different aromatic diamines to afford a series of aromatic polyimides. The properties of polyimides such as inherent viscosity, solubility, UV transparency and thermal stability were investigated to illustrate the contribution of the introduction of spirobisindane groups into the polyimide backbone. The resulting polyimides were readily soluble in polar solvents such as chloroform, THF and N-methyl-2-pyrrolidone. The glass-transition temperatures of these polyimides were in the range of 254-292 degrees C. The tensile strength, elongation at break, and Young's modulus of the polyimide film were 68.8-106.6 MPa, 5.9-9.8%, 1.7-2.0 GPa, respectively. The polymer films were colorless and transparent with the absorption cutoff wavelength at 286-308 nm.

Preparation of Ga2O3 nanoribbons and tubes by electrospinning

A simple way to synthesize beta-Ga2O3 nanoribbons and tubes by electrospinning is introduced. The diameters of the electrospun fibers range from 150 nm to 2.5 mu m and their lengths reach up to several millimeters. The relationship among precursors, precursor concentrations, and crystal growth of beta-Ga2O3 nanoribbons and tubes are discussed. The structures of beta-Ga2O3 fibers have been investigated by various methods such as thermogravimetric (TG) and differential thermal analysis (DTA), X-ray diffraction, FT-IR, Raman spectra, scanning electron micrograph (SEM), and transmission electron micrograph (TEM).

Microstructures and properties of melt-spun and as-cast Mg-20Gd binary alloy

Mg-20Gd(%, mass fraction) samples were prepared using melt-spinning and copper mold casting techniques. Microstructures and properties of the Mg-20Gd were investigated. Results show that the melt-spun ribbon is mainly composed of supersaturated alpha-Mg solid solution phase and the as-east ingot mainly contains alpha-Mg solid solution and Mg5Gd phase. The differential scanning calorimeter (DSC) curve of the ribbon exhibits a small exothermic peak in the temperature range from 630 to 680 K, which indicates that the ribbon contains a metastable phase (amorphous). Tensile strength at room temperature of the melt-spun ribbon and as-cast specimen are 308 and 254 MPa, respectively. The elongations of the two samples are less than 2%. The fracture surfaces demonstrate that the fracture mode of the as-cast Mg-20Gd is a typical cleavage fracture and that of the melt-spun sample is a combination of brittle fracture and ductile fracture.

气相碱度与质子亲合势的基本概念及其测定方法

介绍了气相碱度和质子亲合势的基本概念 ,对气相碱度及质子亲合势的测定方法进行了详细评述 ,包括 :电离阈值法、理论计算法、气相平衡常数法、插入法、动力学法、热力学法等。

Eu(TTA)_3/MCM-41介孔复合体的溶胶凝胶法组装

利用溶胶 凝胶法将稀土配合物Eu(TTA) 3 组装到MCM 41介孔分子筛的孔道中 ,并初步认定客体分子Eu(TTA) 3 是以加合物形式包裹于表面活性剂胶束中。该法制得的介孔复合体Eu(TTA) 3/MCM 41,用XRD、HRTEM技术证实具有短程有序的、规整的六方介孔结构和大小分布均匀的纳米晶粒。对其光致发光和荧光寿命的研究发现 :与乙醇溶液中相比 ,Eu3 +的荧光寿命没有发生改变 ,但Stokes位移却明显增大 ;复合体中 ,能量是从主体MCM 41传递到客体Eu(TTA) 3 上。

Synchronous fluorescence spectra of myoglobin

The synchronous fluorescence spectra of myoglobin were studies for the first time. The fluorescence peals observed in the spectra were assigned, When the wavelength interval (Delta lambda) is 80 nm, the main peak at 335 nm is originated from the tryptophan residues in the myoglobin molecule. When Delta lambda is 20 nn, the peak at 308 nm is mainly due to the tyrosine residues in the myoglobin molecule and in a small part due to the tryptophan residues. Two peaks at 322 and 596 nm were observed in the spectrum of myoglobin for Delta lambda = 40 nm. The peak at 322 nm is due to both tyrosine and tryptophan residues. The peak at 596 nm is attributed to the heme group in the myoglobin molecule.

Isothermal and non-isothermal crystallization kinetics of syndiotactic polypropelene

Isothermal and non-isothermal crystallization kinetics of a syndiotactic polypropylene(sPP) sample synthesized by new metallocene catalyst at different annealing temperatures and different cooling rates have been investigated by using differential scanning calorimetry(DSC) and density analysis. The equilibrium melting temperature( T-m(0)) is 158 degrees C by Hoffman-Weeks method. The equilibrium heat of fusion(Delta H-m(0)) is 88J/g in terms of the density analysis and DSC methods. The lateral and end surface free energies derived from the Lauritzen-Hoffman spherulitic growth rate equation are sigma = 5.2erg/cm(2) and sigma(e) = 69erg/cm(2), respectively. The work of chain folding is determined to be q = 33.75kJ/mol. Modified Avrami equation and Ozawa equation can be used to describe the non-isothermal crystallization behavior. And a new and convenient approach by combining the Avrami equation and Ozawa equation in a same crystallinity is used to describe the non-isothermal behavior as well. The crystallization activation energies are evaluated to be 73.7kJ/mol and 73.1kJ/mol for isothermal crystallization and non-isothermal crystallization, respectively. The Avrami exponent n is 1.5 similar to 1.6 for isothermal crystallization procedure, while the Avrami exponent n,is 2.5 similar to 3.5 for non-isothermal crystallization procedure. This indicated the difference of nucleation and growth between the two procedures.

Interactions of thiamine with anions: (Hthiamine)(thiamine) heptaiododimercurate dihydrate and its dimethanol monohydrate

In the title compounds, 3-[(4-amino-2-methyl-5-pyrimidinio)methyl] -5-(2-hydroxyethyl)-4-methylthiazolium(2+) 3-[(4-amino-2-mcthyl-5-pyrimidinyl)methyl]-5-(2-hydroxyethyl)-4-methylthiazolium( 1+) heptaiododimercurate dihydrate, (C12H18N4OS)(C12H17N4OS)[Hg2I7]. 2H(2)O, (I), and its dimethanol monohydrate, (C12H18N4OS)(C12H17N4OS)[Hg2I7]. 2CH(3)OH . H2O (2), a crystallographic centre of symmetry in (1) or a twofold axis in (2) is imposed between the protonated and deprotonated thiamine molecules, resulting in a statistically half-occupied proton attached at N1' of the pyrimidine ring. The Hg2I73- anion, residing on the centre of symmetry in (1) or on the twofold axis in (2), interacts with two thiamine molecules, each through a C2-H ... I ... pyrimidine-ring interaction. This bridging interaction is a characteristic of thiamine in the F conformation.

茂金属间规立构聚丙烯结晶动力学研究

用ＤＳＣ和密度法对茂金属间规立构聚丙烯(sPP)样品进行了等温和非等温结晶动力学研究．测得平衡熔点T0m为158℃，平衡熔融热焓ΔH0m为3.7kJ/mol，侧表面自由能σ＝5.2erg/cm2，折叠链表面自由能σe＝69erg/cm2，链堆砌功ｑ＝33.75kJ/mol．对非等温结晶过程研究表明，由熔体结晶的ｓＰＰ具有非均相成核，三维球状生长机理．成核与生长活化能ΔE＝73.1kJ/mol

含间位联苯聚芳醚酮结晶熔融行为

含间位联苯聚芳醚酮玻璃态结晶是两步结晶过程。第一步结晶发生在玻璃化转变温度和255℃之间，是一个慢结晶过程（与第二步结晶相比），且与聚合物的分子量密切相关，所形成的晶体规整度差（熔点255℃左右）。第二步结晶发生在255℃和熔点之间，是一个快结晶过程。此过程是在第一步结晶基础上的晶体增厚或熔融重结晶，所形成的晶体规整度高（熔点308℃左右）两步结晶的晶体结构无明显差别

The influence of muffin-tin approximation on energy band gap

The influence of muffin-tin approximation on energy band gap was studied using LMTO-ASA (Linear Muffin-Tin Orbital-Atomic Sphere Approximation) approach. Since the diverse data are available for LaX(X=N, P, As, Sb), they are presented in our research as an example in order to test the reliability of our results. Four groups of muffin-tin radii were chosen, they were the fitted muffin-tin radii based on the optical properties of the crystals (the first), 1 : 1 for La : X(the second), 1.5 : 1 for La : X(the third), and a group of radii derived by making the charge in the interstitial space to be zero(the fourth). The results show that the fitted muffin-tin radii (the first group) give the best results compared with experimental values, and the predicted energy band gaps are very sensitive to the choice of muffin-tin radius in comparison with the other groups. The second and the third delivered results somewhere in between, while the fourth provided the worst results compared with the other groups. For the same crystal, with the increase of muffin-tin radius of lanthanum, the calculated energy band gaps decreased, going from semi-conductor to semimetal. This again clearly indicated the sensitivity of energy band structure on muffin-tin approximation.

Organic electroluminescent devices using rare earth complex Eu(DBM)(3) as an emitter

Eu3+ narrow band emitting EL device with PPV, Alq(3) as hole and electron transportation layers has been prepared. The emitting layer, which consists of PVK, Eu(DBM)(3) and PBD is formed by spin-casting method. A maximum luminance of 52cd.m(-2) is achieved from the device.

压力式细管粘度计

压力式细管粘度计＊张秀梅张兆谟＊＊王遵立（中国科学院长春物理所长春１３００２１）＊＊（中国科学院长春应用化学研究所）０引言粘度测定在许多工业部门和科学研究领域的重要性是人所共知的，利用各种毛细管粘度计测定溶液粘度的方法已具有悠久的历史。一般，用细管式…

EFFECTS OF STRUCTURE MULTIPLICITY ON MECHANISM OF RADIATION CROSS-LINKING OF POLYMERS

In an attempt to explore the effects of structural multiplicity of polymers on the mechanism of radiation crosslinking, the adaptability of the Charlesby-Pinner's equation and its various modified versions are examined. It is recognized that both chemical