Enhancement of three-photon absorption cross-sections in a novel class of symmetrical charge transfer fluorene-based molecules

The three-photon absorption effect (3PA) of two novel symmetrical charge transfer fluorene-based molecules (abbreviated as BASF and BMOSF) has been determined by using a Q-switched Nd:YAG laser pumped with 38 ps pulses at 1064 nm in DMF. The measured 3PA cross-sections are 84 x 10(-78) and 114 x 10(-78) cm(6) s(2), respectively. The geometries and electronic excitations of these two molecules are systematically studied by PM3 and ZINDO/S methods. The relationships between 3PA cross-sections and intramolecular charge transfer are discussed micromechanically. The experimental and theoretical results have shown that the larger intramolecular charge transfer, which was characterized by the charge density difference between the ground state (SO) and the first excited state (S-I), the greater enhancement of the 3PA cross-sections. (c) 2005 Elsevier B.V. All rights reserved.

Large three-photon absorption cross-section in a novel class of bis-(N-carbazolyl) fluorene derivatives

Two novel symmetrical charge transfer fluorene derivatives (abbreviated as BCZF and BVCZF) with carbazole end-group as the donor moieties have been synthesized. Three-photon absorption cross-sections of these two compounds have been determined by using a Q-switched Nd:YAG laser pumped with 38 ps pulses at 1064 nm in DMF. The measured 3PA cross-sections are 140 x 10(-78) and 400 x 10(-78) cm(6) s(2) for BCZF and BVCZF, respectively. The geometries, electronic structures and electronic spectra of these two compounds are systematically studied by AM1 and ZINDO/S methods. On the basis of correct UV-vis spectra, the influence of different molecular structure on three-photon absorption cross-sections is discussed micromechanically. (C) 2005 Elsevier B.V. All rights reserved.

Large three-photon absorption and intramolecular charge transfer of the bis-donor fluorene-based molecules

Three-photon absorption (3PA) of two fluorene-based molecules with D-pi-D structural motifs (abbreviated as BPAF and BCZF) has been determined by using a Q-switched Nd: YAG laser pumped with 38 ps pulses at 1064 nm in DMF. The measured 3PA cross-sections are 222 and 140 x 10(-78) cm(6) s(2) for BPAF and BCZF, respectively. AM1 calculations show that attaching different donors changes the charge density distribution of the fluorene skeleton, and it is observed that the 3PA cross-section can be enhanced with increasing intramolecular charge transfer character, measured by the parameter Delta p(1)/Delta p(2)/Delta p(1)'. (c) 2005 Elsevier B.V. All fights reserved.

Two- and three-photon absorption in a novel fluorene-based compound

A novel symmetrical charge transfer fluorene-based compound 2,7-bis (4-methoxystyryl)-9, 9-bis (2-ethylhexyl)-9H-fluorene (abbreviated as BMOSF) was synthesized and its nonlinear absorption was investigated using two different laser systems: a 140-fs, 800-nm Ti:sapphire laser operating at 1-kHz repetition rate and a 38-ps, 1064-nm Nd:YAG pulsed laser operating at 10-Hz repetition rate, respectively. Unique nonlinear absorption properties in this new compound were observed that rise from multiphoton absorption. The nonlinear absorption coefficients were measured to be 6.02

两种新型芴类衍生物的三光子吸收特性研究

研究了两种新型芴类衍生物9，9-二(2-乙基已基)-2，7-二咔唑-9H-芴(简记为DCZF)和9，9-二(2-乙基已基)-2，7-二(2-(4-甲氧基)苯-2，1-乙烯基)芴(简记为BMOSF)在N，N-二甲基甲酰胺(DMF)中的线性吸收和单光子荧光行为，并用脉冲宽度为38ps，重复频率为10Hz的1064 nm Nd：YAG脉冲激光研究了两种化合物的三光子吸收性质．结果表明：两种新材料的最大线性吸收峰分别位于330和380nm，吸收区域覆盖了270-420nm波段．两种化合物的荧光带位于蓝-紫区，中心

Thiophene-fluorene derivatives with high three-photon absorption activities and their application to optical power limiting

The three-photon absorption (3PA) properties of two thiophene-fluorene derivatives (abbreviated as MOTFTBr and ATFTBr) have been determined by using a Q-switched Nd:YAG laser pumped wish 38ps pulses at 1064nm in DMF. The measured 3PA cross-sections are 152x10(-78)cm(6)s(2) and 139x10(-78)cm(6)s(2), respectively. The optimized structures were obtained by AM1 calculations and the results indicate that these two molecules show nonplanar structures, and attaching different donors has different effects on the molecular structure. The charge density distributions during the excitation were also systematically studied by using AM1 method. In addition, an obvious optical power limiting effect induced by 3PA has been demonstrated for both derivatives.

机载测深激光雷达千赫兹全固态激光器设计及特性研究

将千赫兹高功率全固态Nd：YAG激光器的增益介质当作厚透镜处理，使用矩阵的方法对等效热透镜腔进行分析。采用多条半导体激光列阵侧向紧凑抽运结构设计，提高了增益介质光抽运的均匀性。根据实际抽运功率，通过模拟计算，设计了平凸非稳腔。选择的凸面全反镜的最佳曲率半径有效地补偿了增益介质热透镜效应，激光器实现了动态稳腔运转，激光脉冲能量输出斜度效率大于13％，光束发散角优于1.3mrad。

掺钕陶瓷激光器获得236W高功率激光输出

随着1999年陶瓷制备工艺的突破性进展，透明陶瓷作为激光增益介质取得了可与单晶相比拟的光学质量。Nd：YAG单晶是目前应用最广泛的固体激光介质，然而传统提拉法生长的单晶的固有缺陷限制了它的进一步发展。

高重复率紧凑型微脉冲全固态激光器

本文设计并实现了一台高重复率，紧凑型微脉冲全固态激光器。YAG晶体， Nd:YAG晶体和Cr4+:YAG晶体键合为一个单块晶体作为谐振腔。优化计算了Cr4+:YAG晶体的初始透过率，耦合输出透射率和泵浦光斑大小。对激光器的性能进行了测试，结果表明该激光器适合于空间激光测距。

半导体抽运的叠片热容激光器理论和实验研究

报道了半导体抽运的Nd：YAG叠片热容激光器的理论与实验研究，并用热容激光器的理论模型计算了在一定的工作时间和介质温升内激光输出特性，用Zemax软件对其抽运结构进行了模拟计算。实验中采用的4片Nd：YAG晶体尺寸均为63．5mm×38．5mm×7mm，抽运平均功率约110W，重复频率为10Hz，占空比为0．2％，获得了最大19．1W的1064nm激光输出，光光效率约17．4％。最后对两种抽运结构的叠片激光器进行了比较，提出了下一步的改进方案。

热畸变对单板条热容激光器输出的影响

开展了激光二极管(LD)抽运的全固态热容激光器的理论与实验研究, 数值模拟了在热容工作条件下侧面抽运的Nd:YAG板条激光器的热透镜效应, 分析了热透镜效应对激光输出的影响, 并进行了相应的实验论证。实验中采用的晶体尺寸为57 mm×40 mm×4 mm, 激光二极管阵列的抽运峰值功率为12 kW, 重复频率为1 kHz, 占空比为20%, 为了获得较高的增益, 将抽运光通过光学系统进行聚焦, 抽运光在晶体侧面的光斑大小为15 mm×57 mm。实验中观察了1 s内的脉冲能量输出的波动情况, 在开始工作的

双调Q开关热退偏补偿全固态激光器

为了有效地补偿激光二极管(LD)侧向抽运1000 Hz重复率电光调Q Nd:YAG激光器棒状增益介质内存在的热致双折射损耗，设计了一种新颖的双调Q晶体开关复合谐振腔结构。实验结果表明，设计的双调Q晶体开关结构Nd:YAG激光器输出激光脉冲能量比单调Q晶体开关结构的非补偿腔输出能量提高了56%，当侧面抽运半导体激光器输出功率达到450 W时，激光输出达到30 mJ/pulse，输出光束偏振度优于10:1，激光脉冲宽度约14 ns。并获得6.7%的光-光转换效率。通过对双调Q开光激光谐振腔进行建模，并用求解速

高性能透明激光陶瓷及陶瓷激光器的最新应用进展

激光陶瓷的出现,为固体激光材料向高功率、大尺寸、多功能发展提供了全新的途径,从而为激光技术的发展提供了更加灵活广阔的设计空间。介绍了近年来国际国内透明激光陶瓷及陶瓷激光器发展的最新进展,并展望了陶瓷激光器的未来发展价值。高功率陶瓷激光器方面:中科院上海光学精密机械研究所采用超均匀侧面泵浦技术在1at.%Nd:YAG陶瓷棒中获得输出功率236W,斜率效率62%的连续激光输出。美国利弗莫尔实验室采用Sm3+包边Nd:YAG复合结构陶瓷热容激光器实现了5Hz,67kW激光输出。陶瓷激光器方面,日本World-Labo.Co实验室采用掺杂浓度为15at.%的Yb:YSAG透明陶瓷,获得脉冲宽度280fs,平均输出能量为62mW的锁模脉冲激光输出。陶瓷自调Q脉冲激光器和陶瓷光纤激光器亦有很大进展。陶瓷激光器的开发和应用不仅延伸到传统固体激光器的各个研究领域,并且能够不断突破现有固体激光技术的局限,有望推动未来固体激光工程向更广阔的空间发展。

传导冷却的全固态zigzag板条激光器

报道了激光二极管泵浦的被动传导冷却的Q开关Nd:YAG zigzag 板条激光器，谐振腔采用平平腔和非稳腔。在20Hz运转时，得到脉宽均为10ns的150 mJ，光光效率19%的多模输出和100 mJ、13%光学效率的单模输出，并进行了相关的热效应测试，结果表明该激光器具有效率高、结构紧凑、光束质量好，在空间环境应用具有很好的发展潜力。

532 nm激光泵浦硝酸钡晶体产生外腔拉曼激光

由于硝酸钡晶体具有很强的对称振动（频率1047 cm^-1）和较高的拉曼增益,可以用来产生受激拉曼激光.采用单端泵浦的外置拉曼振荡腔与双棱镜分光装置进行了硝酸钡晶体拉曼激光实验,泵浦源为倍频Nd： YAG的532 nm激光,硝酸钡晶体通过水溶液降温法生长,尺寸为10 mm×10 mm×48 mm,采用特殊镀膜的腔镜对各阶斯托克斯光进行优化选择.在泵浦源达到65 mJ时,获得21 mJ一阶斯托克斯光,输出波长为563 nm,以及16 mJ的二阶斯托克斯光,输出波长为599 nm,受激拉曼散射SRS最大的整体