旱地土壤硝态氮与氮素平衡、氮肥利用的关系

利用长期肥料试验资料研究了土壤氮素平衡、氮肥利用率和土壤硝态氮之间的相互关系。结果表明,小麦不同施肥处理的氮肥利用率(NUE)为30.9%～65.8%,平均53.6%;土壤硝态氮累积率为2.3%～44.1%,平均13.2%;氮素表观损失率25.0%～42.7%,平均33.2%。一般情况下,氮素盈余值与氮肥用量呈正相关,与磷肥用量呈负相关;土壤中硝态氮的数量与氮素盈余值呈正比,与氮肥利用率呈反比。黄土旱塬地区,小麦在经济合理施氮条件下,氮素盈余值为13.79 kg/hm~2,硝态氮累积量为23.00 kg/hm~2,说明过量施用一定数量的氮肥对保持作物生产力和土壤氮素营养是必要的。

Pressurized capillary electrochromatography separation of peptides with strong cation exchange and hydrophilic interaction

A pressurized capillary electrochromatography (pCEC) instrument with solvent gradient capability has been used for the separation of a peptide mixture. Retention mechanism and selectivity of the peptides were studied by pCEC using a strong cation exchange (SCX) column. The effects of applied voltage, supplementary pressure, organic modifier concentration, ionic strength,, and pH value on pCEC separation were investigated. It was found that the retention mechanism of the peptides in this system is based on a mixed mode of hydrophilic interaction, strong cation exchange, and electrophoresis. Compared with the separation results obtained by reverse phase pCEC and capillary electrophoresis (CE), this mixed-mode pCEC is more powerful for the separation of hydrophilic peptides with similar charge-to-mass ratio.

General Solution to Two-Dimensional Nonslipping JKR Model with a Pulling Force in an Arbitrary Direction

In this paper, a generalized JKR model is investigated, in which an elastic cylinder adhesively contacts with an elastic half space and the contact region is assumed to be perfect bonding. An external pulling force is acted on the cylinder in an arbitrary direction. The contact area changes during the pull-off process, which can be predicted using the dynamic Griffith energy balance criterion as the contact edge shifts. Full coupled solution with an oscillatory singularity is obtained and analyzed by numerical calculations. The effect of Dundurs' parameter on the pull-off process is analyzed, which shows that a nonoscillatory solution can approximate the general one under some conditions, i.e., larger pulling angle (pi/2 is the maximum value), smaller a/R or larger nondimensional parameter value of Delta gamma/E*R. Relations among the contact half width, the external pulling force and the pulling angle are used to determine the pull-off force and pull-off contact half width explicitly. All the results in the present paper as basic solutions are helpful and applicable for experimenters and engineers.

Analysis of ingredient and heating value of municipal solid waste

Great differences between municipal solid wastes(MSW)produced at different places and different times in terms of such parameters as physical ingredient and heating value lead to difficulty in effective handling of MSW. In this paper, ingredient, heating value and their temporal varying trends of typical MSW in Beijing were continuously measured and analyzed. With consideration of the process in pyrolysis and incineration, correlation between physical ingredients and heating values was induced, favorable for evaluation of heating value needed in handling of MSW from simple analysis of physical ingredients of it.

Preliminary report on the energy balance for nonlinear oscillations

In this paper, a reliable technique for calculating angular frequencies of nonlinear oscillators is developed. The new algorithm offers a promising approach by constructing a Hamiltonian for the nonlinear oscillator. Some illustrative examples are given. (C) 2002 Published by Elsevier Science Ltd.

A simple approach to solve boundary-value problems in gradient elasticity

We outline a procedure for obtaining solutions of certain boundary value problems of a recently proposed theory of gradient elasticity in terms of solutions of classical elasticity. The method is applied to illustrate, among other things, how the gradient theory can remove the strain singularity from some typical examples of the classical theory.

Numerical-Value Perturbation Method with Application of Solving Convective-Diffusion Integral Equation

The convective--diffusion equation is of primary importance in such fields as fluid dynamics and heat transfer hi the numerical methods solving the convective-diffusion equation, the finite volume method can use conveniently diversified grids (structured and unstructured grids) and is suitable for very complex geometry The disadvantage of FV methods compared to the finite difference method is that FV-methods of order higher than second are more difficult to develop in three-dimensional cases. The second-order central scheme (2cs) offers a good compromise among accuracy, simplicity and efficiency, however, it will produce oscillatory solutions when the grid Reynolds numbers are large and then very fine grids are required to obtain accurate solution. The simplest first-order upwind (IUW) scheme satisfies the convective boundedness criteria, however. Its numerical diffusion is large. The power-law scheme, QMCK and second-order upwind (2UW) schemes are also often used in some commercial codes. Their numerical accurate are roughly consistent with that of ZCS. Therefore, it is meaningful to offer higher-accurate three point FV scheme. In this paper, the numerical-value perturbational method suggested by Zhi Gao is used to develop an upwind and mixed FV scheme using any higher-order interpolation and second-order integration approximations, which is called perturbational finite volume (PFV) scheme. The PFV scheme uses the least nodes similar to the standard three-point schemes, namely, the number of the nodes needed equals to unity plus the face-number of the control volume. For instanc6, in the two-dimensional (2-D) case, only four nodes for the triangle grids and five nodes for the Cartesian grids are utilized, respectively. The PFV scheme is applied on a number of 1-D problems, 2~Dand 3-D flow model equations. Comparing with other standard three-point schemes, The PFV scheme has much smaller numerical diffusion than the first-order upwind (IUW) scheme, its numerical accuracy are also higher than the second-order central scheme (2CS), the power-law scheme (PLS), the QUICK scheme and the second-order upwind(ZUW) scheme.

溶胶-凝胶多孔二氧化硅减反膜稳定性研究

多孔SiO2膜层经热处理后，具有很高的激光破坏阈值，但是结构中有许多Si-OH亲水基团，导致光学透过率受环境相对湿度的影响很大。实验目的是改善膜层内部结构，使膜层结构中的亲水基团转变为疏水基团。提高膜层的疏水性，增强膜层的透过率稳定性。系统地研究了膜层透过率随时间变化的规律，在氨气和六甲基二硅氮烷(HMDS)混合气氛下热处理膜层，处理后生成Si-O-Si(CH2)3非极性疏水基团，使膜层的疏水性大大提高，因而膜层的透过率稳定性有大幅度提高。稳定性的提高延长了膜层的寿命。处理后膜层的表面粗糙度良好，均方根表

暖温带落叶阔叶混交林能量生态学研究

本文是首篇研究中国暖温带落叶阔叶混交林能量生态学的论文。在文中，笔者以详实的第一手资料从能量环境、能量流动、能量组合以及能量平衡几个方面，全面、系统地阐述、分析了辽东栎林——这一暖温带落叶阔叶混交林典型自然群落代表的能量生态学特征。 在能量环境一章中，笔者从能量流动，能量平衡的角度出发重点研究了辽东栎群落的辐射能量环境特征。笔者以1991-1993年的观测资料为基础，从乔木、灌木和草本三个层次分析了生长季总辐射、散射辐射、直射辐射、反射辐射、净辐射、先合有效辐射、透射辐射、吸收辐射以及乔木层和灌木层反射率的季节动态和日进程特征，并从天文因子、气象因子和群落自身发育特征几方面解释分析了辐射能量环境的这种时空动态特征，同时，分析了这种变化特征对群落能量流动、分配和平衡过程可能产生的影响。 另外，笔者也对群落湿度和风速环境的时空动态特征进行了分析。 在能量流动一章，笔者以1992-1993年的野外实验资料为依据，沿季节动态、月际变化和日进程的时间轴，从群落、乔木层、灌木层、草本层以及各乔、灌木种群的空间尺度详细分析、阐述了太阳辐射能在森林群落内的流动和转化特征，并从能量环境和群落发育的角度解释分析了能量在群落内的这种时空分布和转化特征。所讨论的能流对象包括群落、乔、灌、草各层及各乔、灌木种群的总能流固定量、叶片呼吸耗能量、剩余能流固定量以及沿枯枝落叶流出的能流量。 与分析能流过程同步，笔者从上述的时、空尺度分别以生长季内太阳总辐射和光合有效辐射为基础计算、分析了森林群落的光能转化率特征。 在这一章的最后，笔者概述性地介绍了辽东栎群落的能量平衡特征 在第四章，笔者从能值的角度出发，以能量密度为标准讨论了能量沿群落各层及各乔、灌木种群的积累、分配和组合特征，并讨论了能量流动和光能转化率与热值和能量密度的关系。 辽东栎群落能量生态学的研究不但为了解暖温带落叶阔叶林生态系统的结构和功能，为恢复和重建退化的森林生态系统提供了丰富详实的理论信息，而且，也为山区人工林优化模式的组建提供了理论依据和实践指南。