Space experiments of thermocapillary convection in two-liquid layers

In 1999, the space experiments on the Marangoni convection and thermocapillary convection in a system of two immiscible liquid layers in microgravity environment were conducted on board the Chinese scientific satellite SJ-5. A new system of two-layer liquids such as FC-70 liquid and paraffin was used successfully, with the paraffin melted in the space. Two different test-cells are subjected to a temperature gradient perpendicular or parallel to the interface to study the Marangoni convection and thermocapillary convection, respectively. The experimental data obtained in the first Chinese space experiment of fluid are presented. Two-dimensional numerical simulations of thermocapillary convections are carried out using SIMPLEC method A reasonable agreement between the experimental investigation and the numerical results is obtained.

On crack path stability in a layered material

Crack paths in an elastic layer on top of a substrate are considered. Crack growth is initiated from an edge crack in the layer. The plane of the initially straight crack forms an angle to the free surface. The load consists of a pair of forces applied at the crack mouth and parallel to the interface. Crack paths are calculated using a boundary element method. Crack growth is assumed to proceed along a path for which the mode II stress intensity factor vanishes. The inclination and the length of the initial crack are varied. The effect of two different substrates on the crack path evolution is demonstrated. A crack path initially leading perpendicularly to the interface is shown to be directionally unstable for a rigid substrate. Irrespective of its initial angle, the crack does not reach the interface, but reaches the free surface if the layer is infinitely long. At finite layer length the crack reaches the upper free surface if the initial crack inclination to the surface is small enough. For an inextendable flexible substrate, on the other hand, the crack reaches the interface if its initial inclination is large enough. For the flexible substrate an unstable path parallel with the sides of an infinitely long layer is identified. The results are compared with experimental results and discussed in view of characterisation of directionally unstable crack paths. The energy release rate for an inclined edge crack is determined analytically.

3-dimensional transient wave response in a cracked elastic solid

The three-dimensional transient wave response problem is presented for an infinite elastic medium weakened by a plane crack of infinite length and finite width. Tractions are applied suddenly to the crack, which simulates the case of impact loading. The integral transforms are utilized to reduce the problem to a standard Fredholm integral equation in the Laplace transform variable and sequentially invert the Laplace transforms of the stress components by numerical inversion method. The dynamic mode I stress intensity factors at the crack tip are obtained and some numerical results are presented in graphical form.

Influence Of Micro-Impurity On Protein Crystal Growth Studied By The Etch Figure Method

The investigation of the effect of micro impurity on crystal growth by optical microscopy has been validated. The results showed that the growth rate of a lysozyme crystal was affected even if the concentration of impurity of fluorescent-labeled lysozyme (abbreviation, F-lysozyme) was very small. Different concentrations of F-lysozyme had different effects on crystal growth rate. The growth rate decreased much more as F-lysozyme concentration increased. The density of incorporated F-lysozyme on different grown layers of a lysozyme crystal during crystal growth was obtained from the results of flat-bottomed etch pits density. (C) 2008 Elsevier B.V. All rights reserved.

Constrained high-order statistical blind deconvolution of spectral data

A constrained high-order statistical algorithm is proposed to blindly deconvolute the measured spectral data and estimate the response function of the instruments simultaneously. In this algorithm, no prior-knowledge is necessary except a proper length of the unit-impulse response. This length can be easily set to be the width of the narrowest spectral line by observing the measured data. The feasibility of this method has been demonstrated experimentally by the measured Raman and absorption spectral data.

Phase control of switching from positive to negative index material in a four-level atomic system

Electric and magnetic responses of the medium to the probe field are analysed in a four-level loop atomic system by taking into account the relative phase of the applied fields. An interesting phenomenon is found: under suitable conditions, a change of the refractive index from positive to negative can occur by modulating the relative phase of the applied fields. Then the medium can be switched from a positive index material to a negative index material in our scheme. In addition, a negative index material can be realized in different frequency regions by adjusting the relative phase. It may give us a convenient way to obtain the desired material with positive or negative index.

光纤光栅滤波的瓦斯传感系统的研究

差分吸收法是进行瓦斯远距离监测的重要方法，根据瓦斯在近红外波段的吸收特性，报道了一种新型的远距离光纤瓦斯传感系统。采用1．3μm超辐射发光二极管为光源，利用光纤布拉格光栅(FBG)优良的窄带滤波特性实现了对瓦斯的差分吸收测量。和传统的干涉滤光片相比，光纤光栅滤波器插入损耗低、制备简单。系统具有全光纤化、结构简单、工作距离远、稳定性好的特点。工作距离10km，测量灵敏度为0．1％，是瓦斯爆炸极限的2％。

高吸收强度下的波长调制光谱

基于洛伦兹线型近似，研究了高吸收强度下波长调制吸收光谱中谐波信号的行为。得到了二、四、六次谐波幅度与吸收强度的关系的近似解析表达式。解析表达式的结果与数值计算得到的相符合。理论分析的结果在一个用于瓦斯传感的波长调制光谱系统上得到了验证。发现各偶次谐波随吸收强度的变化不仅有最大值还有零点，这一结论对瓦斯传感器的设计具有实际意义。

A high-speed image sensing technique with adjustable frame rate based on an ordinary CCD

In the sinusoidal phase modulating interferometer technique, the high-speed CCD is necessary to detect the interference signals. The reason of ordinary CCD's low frame rate was analyzed, and a novel high-speed image sensing technique with adjustable frame rate based on ail ordinary CCD was proposed. And the principle of the image sensor was analyzed. When the maximum frequency and channel bandwidth were constant, a custom high-speed sensor was designed by using the ordinary CCD under the control of the special driving circuit. The frame rate of the ordinary CCD has been enhanced by controlling the number of pixels of every frame; therefore, the ordinary of CCD can be used as the high frame rate image sensor with small amount of pixels. The multi-output high-speed image sensor has the deficiencies of low accuracy, and high cost, while the high-speed image senor with small number of pixels by using this technique can overcome theses faults. The light intensity varying with time was measured by using the image sensor. The frame rate was LIP to 1600 frame per second (f/s), and the size of every frame and the frame rate were adjustable. The correlation coefficient between the measurement result and the standard values were higher than 0.98026, and the relative error was lower than 0.53%. The experimental results show that this sensor is fit to the measurements of sinusoidal phase modulating interferometer technique. (c) 2007 Elsevier GmbH. All rights reserved.

双包层光纤放大器获得133W高平均功率脉冲激光输出

双包层光纤激光器是国际上新近发展的一种高功率激光器件，由于其具有光束质量好、效率高、易于散热和易于实现高功率等特点，发展十分迅速，已成为高精度激光加工、激光雷达系统等领域中相干光源的重要候选者，在军事和航天上也有着广泛的应用。

多层介质膜光栅和介质膜反射镜抗激光损伤阈值研究

对多层介质膜光栅以及介质膜反射镜的激光损伤阈值进行了系统的研究。测试方法采用国际测试标准。测试结果表明，介质光栅的损伤阈值远低于未刻蚀的多层介质膜。对样品损伤形貌的扫描电镜照片分析发现，相比于未刻蚀的多层介质膜，介质膜光栅的初始损伤主要发生在光栅槽形的侧壁，且损伤主要是由驻波场的空间分布引起的本征吸收、制备过程中引入的杂质污染以及刻蚀过程中HfO2的化学计量机失衡引起的。

Influences of oxygen partial pressure on structure and related properties of ZrO2 thin films prepared by electron beam evaporation deposition

ZrO2 thin films were prepared by electron beam evaporation at different oxygen partial pressures. The influences of oxygen partial pressure on structure and related properties of ZrO2 thin films were studied. Transmittance, thermal absorption, structure and residual stress of ZrO2 thin films were measured by spectrophotometer, surface thermal lensing technique (STL), X-ray diffraction and optical interferometer, respectively. The results showed that the structure and related properties varied progressively with the increase of oxygen partial pressure. The refractive indices and the packing densities of the thin films decreased when the oxygen partial pressure increased. The tetragonal phase fraction in the thin films decreased gradually as oxygen partial pressure increased. The residual stress of film deposited at base pressure was high compressive stress, the value decreased with the increase of oxygen partial pressure, and the residual stress became tensile with the further increase of oxygen pressure, which was corresponding to the evolution of packing densities and variation of interplanar distances. (c) 2007 Elsevier B.V. All rights reserved.

博优210的选育、示范与推广

博优210是华南晚籼杂交稻的“高优”组合，1993和1994年通过省区试和大面积试种表证，1995年5月通过广东省品种委员会审定，具国内同类型品种领先水平。其主要技术经济指标：1、米质1级至特2级（达出口标准），精米率75％，正精米率71％；2、两年省区试产量名列第二位和第一位，比对照组合增产1％和2％，大田一般亩产450公斤；高产的552公斤，比主栽组合博优64增产30公斤；3、高抗稻瘟病，中抗白叶枯病，后期较耐低温；4、较早熟，全生育期118天，比主栽组合博优64早2至3天；5、制种容易，一般亩产200公斤。由于综合性状优良，而具有较高的经济效益和社会效益，种1亩博优210可增值219元，另因少施或不施农药，减少环境污染，而具有一定的生态效益。

博优210的选育及相关理论研究

博优210是华南晚籼杂交稻的“高优”组合，1993和1994年通过省区试和大面积试种表证，1995年5月通过广东省品种委员会审定，具国内同类型品种领先水平。其主要技术经济指标：1、米质1级至特2级（达出口标准），精米率75％，正精米率71％；2、两年省区试产量名列第二位和第一位，比对照组合增产1％和2％，大田一般亩产450公斤；高产的552公斤，比主栽组合博优64增产30公斤；3、高抗稻瘟病，中抗白叶枯病，后期较耐低温；4、较早熟，全生育期118天，比主栽组合博优64早2至3天；5、制种容易，一般亩产200公斤。由于综合性状优良，而具有较高的经济效益和社会效益，种1亩博优210可增值219元，另因少施或不施农药，减少环境污染，而具有一定的生态效益。博优210均适宜华南各省晚稻区种植，越南亦大量引进试种。种植面积发展异常迅速，1993年3600亩，1994年10万亩，1995年约90万亩，预计1996年将超过300万亩，行家预测，博优210在“九五”期间必将成为华南晚稻主栽组合。发表在《中国水稻科学》等7篇论文，是杂交稻优质育种和优质高产育种的规律性研究结果，对杂交稻育种具有一定指导意义。成果达国内领先水平。