Fractal Pattern Formation In Anodic Bonding Of Pyrex Glass/Al/Si

Anodic bonding of Pyrex glass/Al/Si is an important bonding technique in micro/nanoelectromechanical systems (MEMS/NEMS) industry. The anodic bonding of Pyrex 7740 glass/Aluminum film/Silicon is completed at the temperature from 300 degrees C to 375 degrees C with a bonding voltage between 150 V and 450 V. The fractal patterns are formed in the intermediate Al thin film. This pattern has the fractal dimension of the typical two-dimensional diffusion-limited aggregation (2D DLA) process, and the fractal dimension is around 1.7. The fractal patterns consist of Al and Si crystalline grains, and their occurrences are due to the limited diffusion, aggregation, and crystallization of Si and Al atoms in the intermediate Al layers. The formation of the fractal pattern is helpful to enhance the bonding strength between the Pyrex 7740 glass and the aluminum thin film coated on the crystal silicon substrates.

On separated shear layer of blunt circular cylinder

Separated shear layer of blunt circular cylinder has been experimentally investigated for the Reynolds numbers (based on the diameter) ranging from 2.8 x 10(3) to 1.0 x 10(5), with emphasis on evolution of separated shear layer, its structure and distribution of Reynolds shear stress and turbulence kinetic energy. The results demonstrate that laminar separated shear layer experiences 2 similar to 3 times vortex merging before it reattaches, and turbulence separated shear layer takes 5 similar to 6 times vortex merging. In addition, relationship between dimensionless initial frequencies of K-H instability and Reynolds numbers is identified, and reasons for the decay of turbulence kinetic energy and Reynolds shear stress in reattachment region are discussed.

用空间推进法来解钝锥三维粘性绕流

本文将文献［１］中提出的方法推广应用于三维可压缩Ｎ－Ｓ方程，文中给出了钝锥超声速三维粘性绕流的结果。得到了背风面分离的流动图画，计算结果与实验相吻合。

摄动法在研究弹-粘塑性波问题中的应用

采用控制金属材料宏观塑性流动的两个无量纲物理参数作为小参数,将一维弹/粘-塑性问题的解摄动展开,从而,求解非线性波动方程的问题可以转化成求解相应的齐次或非齐次电报方程的问题,用Laplace积分变换或级数展开技术首先得到零次精确解。然后,用Riemann函数方法可获得一次和高次摄动解。与非线性问题的数值解比较,在恒应力或恒速度边界条件下,一次摄动解给出了波动问题的良好近似。这就表明,摄动技术在研究一类广泛的弹/粘-塑波问题中是有效的。

岩石在不同围压、温度、应变速率下的力学效应

<正> 近年来,研究工作者越来越重视岩石在静态和动态条件下基本力学性质的研究。其主要原因是,人们已经认识到与岩石有关的许多实际工程力学问题的解决,都有赖于弄清岩石的破坏机理、破坏准则、模型以及本构关系的建立。而研究这样一些岩石的力学性状,又必须研究岩石在各种围压、温度、应变速率等条件(即各种应力场与温度场)下的力学效应。 本文综合评述在这一领域中,国外研究者的一些主要研究结果。

超跨声速扩压叶栅未启动堵塞工况计算

本文研究了超跨声速叶栅未启动堵塞工况的运行攻角.在下游节流和轴向密流比变化时,也能算出有用的结果,并获得相应的其他叶栅性能,如总压损失系数、压比、气流折转角等.同国外已有工作比较,本文方法可以考虑更多的变化条件.计算结果的比较说明本方法是可信的.由于方法比较简单,可用来分析叶栅性能,分析叶栅的几何参数和动力参数变化时叶栅性能的变化.

Tensile and compressive deformation of a short-glass-fiber-reinforced liquid-crystalline polymer

Results of tensile and compression tests on a short-glass-fiber-reinforced thermotropic liquid crystalline polymer are presented. The effect of strain rate on the compression stress-strain characteristics has been investigated over a wide range of strain rates epsilon between 10(-4) and 350 s-1. The low-strain-rate tests were conducted using a screw-driven universal tensile tester, while the high-strain-rate tests were carried out using the split Hopkinson pressure bar technique. The compression modulus was shown to vary with log10 (epsilon) in a bilinear manner. The compression modulus is insensitive to strain rate in the low-strain-rate regime (epsilon = 10(-4) - 10(-2) s-1), but it increases more rapidly with epsilon at higher epsilon. The compression strength changes linearly with log10 (epsilon) over the entire strain-rate range. The fracture surfaces were examined by scanning electron microscopy.

Simplified Navier-Stokes equations (SNSE)

Ten kinds of the simplified Navier-Stokes equations (SNSE) are reviewed and also used to calculate the Jeffery-Hamel flow as well as to analyze briefly the seven kinds of flows to which the exact solutions of the complete Navier-Stokes equations (CNSE) have been found. Analysis shows that the actual differences among the solutions of the different SNSE can go beyond the range of the order of magnitude of Re-1/2 and result even in different flow patterns, therefore, how to choose the viscous terms included in the SNSE is worthy of notice where Re=S∞u∞ L/μ∞ is the Reynolds numbers. For the aforesaid eight kinds of flows, the solutions to the inner-outer-layer-matched SNSE and to the thin-layer-2-order SNSE agree completely with the exact solutions to CNSE. But the solutions to all the other SNSE are not completely consistent with the exact solutions to CNSE and not a few of them are actually the solutions of the classical boundary layer theory. The innerouter-layer-matched SNSE contains the shear stress causing angular displacement of the inormal axis with respect to the streamwise axis and the normal stress causing expansion-contraction in the direction of the normal axis and the viscous terms being of the order of magnitude of the normal stress; and it can also reasonably treat the inertial terms as well as the relation between the viscous and inertial terms. Therefore, it seems promising in respects of both mechanics and mathematics.

第十四届国际材料强度大会简介

2006年6月5—9日，第十四届国际材料强度大会（14th International Conferenceon the Strength of Materials，IC-SMA14）在西安古都新世界大酒店举行，会议正式代表322人（其中境外代表200多人），这是该系列国际材料强度大会第一次在中国举办．大会由中国国家自然科学基金委员会、国家教育部、中国材料研究学会、西安交通大学、中国科学院沈阳金属研究所和西安市科技局等单位共同支持．大会主席为J．L．Martin教授，会议组织委员会主席由西安交通大学的孙军教授与中国科学院金属研究所的李守新研究员共同担任．

两层流体热毛细对流空间实验研究

1999年，在我国实践5号卫星上完成了两层流体空间实验，实验研究两层不相混合流体的纯Marangoni对流（温度梯度与界面垂直）与热毛细对流（温度梯度方向与流体界面平行）。前者存在发生Marangoni对流的最小临界温差值ΔTc，低于该值流体系统处于静止状态；后者中只要存在沿界面的温度梯度便会产生热毛细对流。空间实验采用石蜡和氟化 液两层流体新体系，实现了平整的液－液交界面，并从卫星上传回上万幅数字图像 。通过多幅图像叠加处理得到了定量的流速场。数值模拟计算分析了相应工况时对流流动的速度场，两者的流场结构和速度大小基本一致，实验验证了理论模型。

激光场控制双暗态原子系统中若干动力学行为研究

系统介绍了在激光场控制双暗态原子系统动力学行为研究中得到的若干新现象，其中包括相干叠加态的制备、四波混频转换效率的提高以及无吸收巨克尔非线性的实现等。

入射光偏振方向对LiNbO3晶体近光轴电光调制的影响

分析了在垂直LiNbO3晶体光轴方向加电压，光沿近光轴方向传播时，入射光偏振方向对电光调制器的影响。通过计算加电场后双折射光程差的变化和偏光振动方向的转动，画出在正交偏振镜下不同起偏方向的锥光干涉图，得到干涉图随起偏方向变化的规律：由偏光振动方向转动引起的消光区域随起偏方向的转动而转动，在起偏和检偏方向上始终消光，在与起偏方向成±45°角方向始终全透光，并且消光线的交点即感应双光轴头不随起偏方向的转动而变化，始终在折射率变大的感应主轴上。