Combustion and Ignition of Thermally Cracked Kerosene in Supersonic Model Combustors

A series of experiments were conducted to characterize the self-ignition and combustion of thermally cracked kerosene in both a Mach 2.5 model combustor with a combustor entrance height of 51 mm and a Mach 3.0 model combustor with an entrance height of 70 mm. A unique kerosene heating and delivery system was developed, which can prepare heated kerosene up to 950 K at a pressure of 5.5 MPa with negligible fuel coking. The extent of China no. 3 kerosene conversion under supercritical conditions was measured using a specially designed system. The compositions of gaseous products as a result of thermal cracking were analyzed using gas chromatography. The mass flow rates of cracked kerosene were also calibrated and measured using sonic nozzles. With the injection of thermally cracked kerosene, the ability to achieve enhanced combustion performance was demonstrated under a variety of airflow and fuel conditions. Furthermore, self-ignition tests of cracked kerosene in a Mach 2.5 model combustor over a range of fuel injection conditions and with the help of different amounts of pilot hydrogen were conducted and discussed.

用空间推进法来解钝锥三维粘性绕流

本文将文献［１］中提出的方法推广应用于三维可压缩Ｎ－Ｓ方程，文中给出了钝锥超声速三维粘性绕流的结果。得到了背风面分离的流动图画，计算结果与实验相吻合。

线性迭代算法基本定理

<正> 我们考虑非定线性方程组:Ax=b。 定理1 线性迭代法x~(k+1)=Sx~k+d,k=1,2,…对任意初值x~0都收敛的充要条件是: (1) x=Sx+d有解。

高雷诺数下平面Poiseuille流稳定性渐近分析

本文主要讨论高雷诺数下平面Poiseuille流稳定性问题.应用多层结构分析理论,求出了描述该流体稳定性的Orr-Sommerfeld方程特征值的较为合理的逼近式及相应的特征函数的渐近解析解.

关于具有剪应力的普通湍流理论发展

本文叙述了周培源1945年发表具有剪应力的普通湍流理论以后,各种湍流模式理论的主要发展概况.

The asymptotic near-tip solution for mode-iii crack in steady growth in power hardening media

Two local solutions, one perpendicular and one parallel to the direction of solar gravitational field, are discussed. The influence of gravity on the gas-dynamical process driven by the piston is discussed in terms of characteristic theory, and the flow field is given quantitatively. For a typical piston trajectory similar to the one for an eruptive prominence, the velocity of the shock front which locates ahead the transient front is nearly constant or slightly accelerated, and the width of the compressed flow region may be kept nearly constant or increased linearly, depending on the velocity distribution of the piston. Based on these results, the major features of the transient may be explained. Some of the fine structure of the transient is also shown, which may be compared in detail with observations.

Pipeline Corrosion Analyzed by Fuzzy Reliability Methods

Fuzzy reliability methods are used to study the corrosion of pipelines. Three methods are used. They consist of using fracture failure modes, failure assessment diagram (FAD) and residual strength for establishing fuzzy reliability. Calculations are made by application of JC, improved GA-JC and Mente-carlo methods. Examples for oilfield injecting water pipeline show the residual strength well agree with field data. Mente-carlo methods appear to yield results that have better agreement with field data.

Rarefied gas dynamics: fundamentals, simulations and micro flows

考虑介质微观非均质特征的乳状液渗流模型

油水乳化渗流是三元复合驱和热力采油过程中常见的现象,地层介质的微观孔隙结构特征对乳状液流动有着重要影响.现有描述乳状液渗流的理论模型都属于确定性方法,只能反映出介质孔隙结构的体积平均效果.当介质内部微观非均质性相比其尺寸不能被忽略时,采用确定性方法描述会与实验结果存在偏差.基于连续时间随机游走理论建立了描述乳状液渗流的随机理论模型.该模型引入反映液滴微观运动特征的跃迁时间和跃迁位移两个概率分布函数来反映多孔介质微观非均质特征.研究结果表明该模型能很好地刻画实验曲线中出现的与介质尺度相关的拖尾现象,可作为更一般的过滤模型.

参变过程中的群速延迟对晶体匹配长度的影响

基于能量守恒和三波耦合波方程, 建立了超短脉冲在参变过程中二次谐波产生时的I类和II类相位匹配条件、基波与谐波之间的群速延迟时间、以及群速失配对晶体长度限制的理论基础。以负单轴非线性光学晶体CsLiB6O10为例, 分析和数值计算了超短脉冲宽度为100 fs时, 谐波的群速匹配长度随基波波长变化的规律。研究结果表明在I类相位匹配条件下, 基波波长为642 nm时, 群速延迟最小, 相应的群速匹配晶体长度最长为19.1 mm;在II类相位匹配条件下, 基波波长为767 nm, 群速延迟最小, 群速匹配长度最

Study of near-infrared nonvolatile two-center holographic recording in LiNbO3:Fe:Rh crystal

The near-infrared nonvolatile holographic recording has been realized in a doubly doped LiNbO3:Fe:Rh crystal by the traditional two-center holographic recording scheme, for the first time. The recording performance of this crystal has been investigated by recording with 633 nm red light, 752 nm red light and 799 nm near-infrared light and sensitizing with 405 nm purple light. The experimental results show that, co-doped with Fe and Rh, the near-infrared absorption and the photovoltaic coefficient of shallow trap Fe are enhanced in this LiNbO3:Fe:Rh crystal, compared with other doubly doped LiNbO3 crystals Such as LiNbO3:Fe:Mn. It is also found that the sensitizing light intensity affects the near-infrared recording sensitivity in a different way than two-center holographic recording with shorter wavelength, and the origin of experimental results is analyzed. (C) 2007 Elsevier GrnbH. All rights reserved.

隔板玻璃表面宽光谱增透膜的制备与性能

利用溶胶-凝胶提拉方法在隔板玻璃表面涂制得到由TiO2与SiO2组成的λ/2-λ/4型宽光谱增透膜。通过溶胶粘度、凝胶时间及红外光谱等研究了TiO2涂膜溶胶的稳定性与相应膜层性能，测试了双层增透膜的透过率、抗高能氙灯辐照性能及使用性能等。结果表明，控制合适的原料配比、降低薄膜烘烤升温速率，可得到适于大面积涂膜的稳定TiO2溶胶，有效改善TiO2膜层质量；隔板玻璃表面增透膜在450-900nm光谱范围内平均透过率高达约98％，使“神光-Ⅱ”第九路主放大器的实际增益提高5．5％-6．5％且具有良好的抗高能氙灯

单晶硅材料的1064nmNd：YAG脉冲激光损伤特性研究

作为微电子和光电子系统中普遍使用的一种结构材料，单晶硅一直是人们研究的焦点。长期以来，人们对其电学性质进行了非常深入细致的研究，却疏于对其抗击强激光辐照特性的研究。随着激光通讯和光电对抗技术的发展，对光学材料的激光破坏特性和加固技术进行研究的需求也显得越来越迫切。本文主要对单晶硅的抗激光损伤特性进行研究，研究了单晶硅材料在1064nmNd：YAG激光自由脉冲输出模式和单脉冲输出模式作用下的损伤特性，通过对两种激光作用下单晶硅损伤形貌的分析，在热效应与热力耦合模型的基础上，对单晶硅的激光损伤机制进行了探索。