Kinetics of dissociative water adsorption on stepped Si(001), on Si(115), Si(113), Si(5,5,12) and Si(112)

We present photoelectron spectroscopic and low energy electron diffraction measurements of water adsorption on flat Si samples of the orientations (001), (115), (113), (5,5,12) and (112) as well as on curved samples covering continuously the ranges (001)-(117) and (113)-(5,5,12)-(112). On all orientations, water adsorption is dissociative (OH and H) and non-destructive. On Si(001) the sticking coefficient S and the saturation coverage Theta(sat) are largest. On Si(001) and for small miscuts in the [110]-azimuth, S is constant nearly up to saturation which proves that the kinetics involves a weakly bound mobile precursor state. For (001)-vicinals with high miscut angles (9-13 degrees), the step structure breaks down, the precursor mobility is affected and the adsorption kinetics changed. On (115), (113), (5,5,12) and (112), the values of S and Theta(sat) are smaller which indicates that not all sites are able to dissociate and bind water. For (113) the shape of the adsorption curves Theta versus exposure shows the existence of two adsorption processes, one with mobile precursor kinetics and one with Langmuir-like kinetics. On (5,5,12), two processes with mobile precursor kinetics are observed which are ascribed to adsorption on different surface regions within the large surface unit cell. From the corresponding values of S and Theta(sat), data for structure models are deduced. (C) 1997 Elsevier Science B.V.

42 MeV/u~(12)C与~(115)In反应的靶余核

本实验使用放射化学方法测定了42 MeV/u (12)C与~(115)In相互作用靶余核的生成截面。借助高斯电荷分布的假设得到了靶余核的质量分布。将实验得到的质量分布与熔合碎裂模型和级联的两体衰变模型进行了比较。特别值得注意的是，使用统计的两体衰变模型Monte Carlo GEMINI程序计算第一次与实验结果符合得非常满意。同时计算结果也表明：在42MeV/u的轰击能量下，完全熔合对靶余核的产物仍然有很大的贡献。在同样的假设下，得到了靶余核的同位素分布。可以看到，同位素分布的宽度随靶余核原子序数的增加而增加，在此对利用中能重离子反应生成新的远离β稳定线的缺中子核素进行了讨论

46.7 MeV/u~(12)C轰击~(58)Ni、~(115)In、~(197)Au反应中粒子发射研究中子皮及中子分布弥散度对核势的影响

用能量密度公式及小液滴模型给出的费米密度分布，并引入中子皮及中子分布弥散度随中子过剩自由度增加而增加这一因素，计算了重离子反应在相互作用势及熔合位垒。熔合位垒的计算值和实验值符合很好，特别是在中重核区域，改善了以前的计算结果。详细研究了亲近势标度，发现用中子皮及中子分布弥散度的变化能较好地解释中子过剩自由度对新近势标度偏离的影响。本工作对奇异核结构与核反应性质的研究无疑是有用的。我们利用HIRFL提供的46.7MeV/u ~(12)C束轰击~(58)Ni、~(115)In、~(197)Au研究了反应中发射的α粒子角分布和能谱。从速度表象中洛仑兹不变截面等高图中明显看到发射α粒子的三个源。用这三个源的运动模型成功拟合了α粒子能谱，所提取的参数符合费米气体模型计算结果，并讨论了能谱及拟合参数对靶的依赖关系。认为快速源实质上来自弹核碎裂或类弹核碎裂

LY-12铝高温凝聚态动力学性质研究——高温冲塞剪切破坏强度的测量

本文介绍Ly-12铝合金从常温到400℃高温下,动态冲塞剪切破坏强度的测试及研究结果,并给出了该种材料静态压剪破坏强度的测量结果。在上述温度范围内,Ly-12铝的动态冲塞剪切破坏强度与其静态结果之比为1.3∶1～4∶1,表明随着温度的升高,动态的强度远大于同温度的静态结果。

25MeV/u~(40)Ar+~(115)In反应中前中角区碎片发射研究

从 2 5MeV/u4 0 Ar+115In反应前中角区出射碎片的能谱、角分布和Z电荷分布出发 ,讨论了碎片发射机制随出射角和核电荷数Z的渐进变化 ;用改进的量子分子动力学 (MQMD)模型研究了碎片角分布及Z电荷分布 ,理论计算和实验值整体上符合较好 ,但在前角区MQMD模型低估了碎片的产额 ,在中角区对于Z接近弹核的碎片 ,理论计算比实验值偏高 ;碎片产物的角分布及Z电荷分布还与统计模型GEMINI进行了比较 ,发现在前角区平衡蒸发的成分所占比例很小 ,中角区所占的比例有所增加 ,但仍然是较小的比例 .随着碎片核电荷数Z的减小 ,平衡核的蒸发成分逐渐减少 ,非平衡的中速成分逐渐占主导地位

CRYSTAL-STRUCTURE OF [YB (NO3)3 (PHEN) (H2O)]CENTER-DOT(12-CROWN-4)

The title complex was prepared by reacting Yb(NO3)3 (12-crown-4) with 1, 10-phenanthiroline (hereafter phen) in acetone. It crystallized in the triclinic space group P1BAR with a = 10.095(5), b = 17.415(4), c = 8.710(2) angstrom; alpha = 92.45(2), beta = 115.83(3), gamma = 74.08(3)degrees and D(c), = 1.85 g cm-3; Z = 2. The metal ion in this complex is nine-coordinated to three bidentate nitrate ions, two nitrogen atoms of a phen and a water molecule. The crown ligand is hydrogen bonded to the coordination water molecule. The symmetry change of the crown ether is also discussed.

紫黑色春小麦新品种-高原115

高原115（原代号96-115号）是中国科学院西北高原生物研究所于1992年以（太谷核不育系*91-233）F_1为母本，{加拿大11号*[繁6*（R211*苦瓜）F_4]F_5}F_5紫黑色小麦为父本进行杂交，采用系谱法选育而成的春小麦品种。2001年12月通过青海省农作物品种审定委员会审定。

Shear Strength Measurements in LY-12 Aluminium Alloy During Shock Loading

Lateral stress of LY-12 alummium alloy under plate impact shock loading was measured. Based on the measured data, the Hugoniot relation and shear strength were obtained. The result has demonstrated that the shear strenath of the tested material increases remarkably with the increasing longitudinal stress. This means that the assumption of constant shear strength usually adopted in shock stress calculation is not suitable for the present material.

The Evolution of Fatigue bocks in Aluminum Alloy LY-12 under Shock beading

对LY12铝合金在低周疲劳条件下的裂纹情况和随后进行的动态拉伸条件下裂纹的发展给予了观察和统计分析。发现裂纹的累积数密度分布在损伤演化过程中保持指数形式,用NAG模型对实验结果进行分析,得出该材料裂纹演化发展方程的各种参数。

LY-12铝高温凝聚态动力学性质研究——高温弹性模量的测定

金属材料的高温动态力学性能是材料科学领域中的重要方面。本文介绍LY-12合金铝在常温至450℃的温度区间内和动载下(应变率为 10~3/秒),材料弹性模量的研究。此项研究采用的试验装置为一维Hopkinson压杆及管式高温炉。应用一维弹性应力波传播理论,测得LY-12铝试件在不同温度T条件下的声速c(T),按照c(T)=[E(T)/ρ(T)]~(1/2),获得杨氏模量E(T)随温度的变化曲线。

结构弛豫对Zr_(64.13)Cu_(15.75)Ni_(10.12)Al_(10)块体非晶合金硬度和剪切带特征的影响

通过接近玻璃转变温度的等温退火获得不同弛豫状态的Zr64.13Cu15.75Ni10.12Al10块体非晶合金样品。利用维氏显微硬度计和洛氏硬度计研究结构弛豫对合金硬度和压痕周围剪切带特征的影响规律。结果表明:在590K等温退火处理使Zr64.13Cu15.75Ni10.12Al10块体非晶合金发生焓弛豫行为,其维氏显微硬度随退火时间的延长较快增加后趋于稳定,而大载荷洛氏硬度对结构弛豫不敏感。通过洛氏压痕周围剪切带特征的研究,定量比较了结构弛豫对剪切带间距、数量的影响规律。

Nd：Y3Sc（1．5）Al（3．5）O（12）透明陶瓷的光谱性能以及激光输出

采用燃烧法制备了Nd：YSAG粉体,经过成型、素烧,最终在氢气气氛中烧结制备了Nd：YSAG透明陶瓷.测试结果表明,Nd：YSAG透明陶瓷具有荧光谱线较宽,荧光寿命较长的特点.激光实验得到的激光输出,斜率效率为23.6%,输出功率为0.36W,输出激光的谱线分布较宽.

Dual-wavelength competitive output in Nd:Y3Sc1.5Al3.5O12 ceramic disk laser

In this paper, we demonstrated a dual-wavelength competitive output in Nd:Y3SC1.5Al3.5O12 ceramic disk laser. Different dual-wavelength output behaviors for Nd:YSAG and Nd:YAG ceramic disk laser were investigated and discussed. By applying the energy transfer model, we suggested the reasonable explanation for this new phenomenon as the disordered replacing of Al3+ ions by Sc3+ ions. The main advantage of the dual-wavelength ceramic laser is the possibility to serve as the seed source to generate Terahertz radiation. (C) 2008 Elsevier B.V. All rights reserved.

Generation of 1.5-12 ns width-tunable 532 nm pulses by adopting laser-induced plasma shutter technique

The pulse-shaping technique has found widespread applications in nonlinear optics and material processing. Experimental research on laser-induced plasma shutter to control the 532 nm pulse width is conducted. The impacts of the total pulse output energy on pulse compression are investigated, and a useful conclusion can be drawn that there exists an optimal value of pulse energy at which the shortest output pulse of 3.23 ns can be obtained without a device for delay-time. Once the device for delay-time is employed to change the optical differences between two laser paths, the pulse width can be further shortened to 1.51 ns. In short, the 1.5-12 ns width-tunable 532 nm laser pulses have been obtained by adopting the laser-induced plasma shutter technique. (C) 2007 Elsevier GmbH. All rights reserved.